Supported Cu(II) polymer catalysts for aqueous phenol oxidation

Supported Cu(II) polymer catalysts were used for the catalytic oxidation of phenol at 30 degrees C and atmospheric pressure using air and H(2)O(2) as oxidants. Heterogenisation of homogeneous Cu(II) catalysts was achieved by adsorption of Cu(II) salts onto polymeric matrices (poly(4-vinylpyridine), Chitosan). The catalytic active sites were represented by Cu(II) ions and showed to conserve their oxidative activity in heterogeneous catalysis as well as in homogeneous systems. The catalytic deactivation was evaluated by quantifying released Cu(II) ions in solution during oxidation, from where Cu-PVP(25) showed the best leaching levels no more than 5 mg L(-1). Results also indicated that Cu-PVP(25) had a catalytic activity (56% of phenol conversion when initial Cu(II) catalytic content was 200 mg L(Reaction)(-1)) comparable to that of commercial catalysts (59% of phenol conversion). Finally, the balance between activity and copper leaching was better represented by Cu-PVP(25) due to the heterogeneous catalytic activity had 86% performance in the heterogeneous phase, and the rest on the homogeneous phase, while Cu-PVP(2) had 59% and CuO/gamma-Al(2)O(3) 68%.

El heroismo de los asediados

Esta ponencia pretende centrar el relato en el heroísmo de pueblos asediados que por defender su suelo, no vacilaron en ofrendarse como víctimas. Se habla de Sagunto, Numancia, Thala y Masada, todos ellos relacionados con el mundo romano. Se trata de ver las actitudes en común que tuvieron estos pueblos, lo que hay de esencial en estos verdaderos suicidios colectivos.

Major ion concentrations and chlorine isotope composition of water-soluble chloride and structurally bound chloride in DSDP/ODP serpentinized ultramafic rocks

Eight DSDP/ODP cores were analyzed for major ion concentrations and d37Cl values of water-soluble chloride (d37Clwsc) and structurally bound chloride (d37Clsbc) in serpentinized ultramafic rocks. This diverse set of cores spans a wide range in age, temperature of serpentinization, tectonic setting, and geographic location of drilled serpentinized oceanic crust. Three of the cores were sampled at closely spaced intervals to investigate downhole variation in Cl concentration and chlorine isotope composition. The average total Cl content of all 86 samples is 0.26±0.16 wt.% (0.19±0.10 wt.% as water-soluble Cl (Xwsc) and 0.09±0.09 wt.% as structurally bound Cl (Xsbc)). Structurally bound Cl concentration nearly doubles with depth in all cores; there is no consistent trend in water-soluble Cl content among the cores. Chlorine isotope fractionation between the structurally bound Cl**- site and the water-soluble Cl**- site varies from -1.08? to +1.16?, averaging to +0.21?. Samples with negative fractionations may be related to reequilibration of the water-soluble chloride with seawater post-serpentinite formation. Six of the cores have positive bulk d37Cl values (+0.05? to +0.36?); the other two cores (173-1068A (Leg-Hole) and 84-570) have negative bulk d37Cl values (-1.26? and -0.54?). The cores with negative d37Cl values also have variable Cl**-/SO4**2- ratios, in contrast to all other cores. The isotopically positive cores (153-920D and 147-895E) show no isotopic variation with depth; the isotopically negative core (173-1068A) decreases by ~1? with depth for both the water-soluble and structurally bound Cl fractions. Non-zero bulk d37Cl values indicate Cl in serpentinites was incorporated during original hydration and is not an artifact of seawater infiltration during drilling. Cores with positive d37Cl values are most likely explained by open system fractionation during hydrothermal alteration, with preferential incorporation of 37Cl from seawater into the serpentinite and loss of residual light Cl back to the ocean. Fluid / rock ratios were probably low as evidenced by the presence of water-soluble salts. The two isotopically negative cores are characterized by a thick overlying sedimentary package that was in place prior to serpentinization. We believe the low d37Cl values of these cores are a result of hydration of ultramafic rock by infiltrating aqueous pore fluids from the overlying sediments. The resulting serpentinites inherit the characteristic negative d37Cl values of the pore waters. Chlorine stable isotopes can be used to identify the source of the serpentinizing fluid and ultimately discern chemical and tectonic processes involved in serpentinization.

Concentration of C2-C6 hydrocarbon gases in dry sediments of ODP Sites 180-1109 and 180-1115

Low molecular weight hydrocarbon (LMWH) distributions were examined in sediments from Sites 1109 and 1115 in the western Woodlark Basin using purge-trap thermal adsorption/desorption gas analysis. A number of different hydrocarbon components >C1, which were not detected during shipboard gas analysis, were detected at both sites using the purge-trap procedure. Concentrations of ethane, propane, and butane remained relatively low (<100 pmol/g) throughout Site 1109 and had no consistent trend with depth. In contrast, the longer-chain components increased in concentration with depth. Hexane concentrations rose to 716 pmol/g at the base of the site with a concomitant increase in both 2-methyl- and 3-methylpentane. At Site 1115, concentrations of ethane, propane, butane, and isobutylene + 1-butene remained low (<60 pmol/g) throughout the site and again had no consistent trend with depth. 2-Methylpentane, 3-methylpentane, and hexane concentrations had a subsurface maximum that coincided with sediments containing abundant plant-rich material. The LMWH downhole profiles plus low in situ temperatures suggest that the LMWH components were formed in situ by low-temperature biological processes. Purge-trap analysis has indicated the presence of some unexpected deep low-temperature bacterial reactions, which demonstrates that further analysis of LMWH may provide valuable information at future Ocean Drilling Program sites.

(Table 1) Primary production in the Arabian Sea in May-July 1966

A radiocarbon survey of primary production in the Arabian Sea was carried out during May to July 1966. Production ranged from 0.8 to 30 mg C/m**3 per day at the surface, and from 0.1 to 3 g C/m**2 per day in the photosynthetic layer. At most stations photosynthesis was found to be maximum at depths of 25-30 m, and its lower limit was at 75 m.

Chemical composition of Ninetyeast Ridge basalts

On Leg 121 of the Ocean Drilling Program, we recovered basaltic rocks from a total of three basement sites in the southern, central, and northern regions of Ninetyeast Ridge. These new sites complement the previous four basement holes drilled during Legs 22 and 26 of the Deep Sea Drilling Project, and confirm the predominantly tholeiitic, light rare earth element-enriched character of the basalts that cap the ridge. The basalts show marked iron enrichment; ferrobasalts occur at Sites 214 and 216 and oceanic andesites at Site 253. All of the basalts recovered during Leg 121 are altered, and range from aphyric olivine tholeiites (Site 756), to strongly plagioclase-phyric basalts (Site 757). Basalts from Site 758, which were clearly erupted in a submarine environment (pillow basalts are present in the section), are sparsely to strongly plagioclase-phyric. The basalts recovered at any one hole are isotopically homogeneous (except for the basalts from Site 758, which show a range of Pb isotopes), and it is possible to relate the magmas at any one site by high-level fractionation processes. However, there are significant variations in isotope ratios and highly incompatible element ratios between sites, which suggest that the mantle source for the ridge basalts was compositionally variable. Such variation, in view of the large volume of magmatic products that form the ridge system, is not surprising. There is not, however, a systematic variation in basalt composition along the ridge. We agree with previous models that relate Ninetyeast Ridge to a mantle plume in the southern Indian Ocean. The tholeiitic, iron-enriched, and voluminous character of the ridge basalts is typical of oceanic islands associated with plumes on or near a mid-ocean ridge (e.g., Iceland, Galapagos Islands, and St. Paul/Amsterdam islands). The absence of recovered alkalic suites is inconsistent with an intraplate setting, such as the Hawaiian Islands or Kerguelen Island. Thus, the major element data, like the gravity data, strongly suggest that the ridge was erupted on or very close to an active spreading center. Isotopically, the most likely plume that created the excess magmatism on the Ridge is the Kerguelen-Heard plume system, but the Ninetyeast Ridge basalts do not represent a simple mixing of the Kerguelen plume and mid-ocean Ninetyeast Ridge basalt mantle.

Climate reconstructions from the Tibet Plateau (PKDB286426)

Fluid inclusions of protogenous halite, which were collected from two boreholes in the Charhan Salt Lake in the north part of the Qinghai-Xizang Plateau, werea nalyzed for their hydrogen and oxygen isotopes and for their Na, Mg etc. ions.On these grounds, the evolution of lake environment in this region during the last 50 000 years are discussed in this paper. The emphasis is to discuss the time range of extremely arid and cold climate at the last Glacial stage and the geological event of playa associated with such a climate.The guanidine hydrochloride method was used for measurement of hydrogen and oxygen stable isotopes. The measurement of Na, Mg etc. ions were achieved by determination of crystallization temperature of hydrohalite under microscope and then by calculation of chemical compositions of inclusion fluid using a thermodynamic model.The results obtained show that protogenous halite in the Charhan Lake area was formed in three different environment conditions: (1) In fluid inclusions of halite formed in the early period (50 000-30 000 a B. P. ), dD averages -14.9 per mil, d(18)O averages 8.37 per mil, and Mg(2+)ranges from 0.42 to 1.59 mol/L. Their plotting points fall on the right top part of the evaporation line of the present Charhan Lake area, indicating that the Lake water at that time had a higher concentration of brine, and the climate was hot and dry. (2) In fluid inclusions of halite formed in the middle period (30 000-15 000 a B. P.), SD average -66.0 per mil, d(18)O averages 1.00 pr mil, and Mg(2+) 1 mol/L. Their plotting points fall on the left low part of the evaporation line, indicating that the lake water at that time had a concentration of brine lower than that in the early period, and the environment was cold and dry. (3) In fluid inclusions of halite formed in the late period (15 000-present), dD averages 30.8 per mil, d(18)O averages 5.85 per mil, and Mg(2+) M 1 mol/L. Their plotting fall on the evaporation line, indicating that the climate environment at that time was warm and dry, almost the same as the present.The temperature variation of the last 50 000 years in the Charhan Lake area was calculated using the conversion equation proposed by Lorious et al. The time range of the Great ice age of the Last Glacial Stage is about 21 000-15 000 a B.P., which basically coincides with the time of a worldwide low sea level. The temperature in that period was below 0°C and 6-7°C lower than now. Because of lower temperatures, water supply to the lake area decreased rapidly and the concentration of lake water increased sharply. Therefore the Mg(2+) concentration in inclusion fluid reaches or closes to 2mol/L and the Mg/Na ratio varies within a very wide range. These show that the Charhan Lake at that time entered its playa stage. The Charhan Salt Lake is a typical one in the north part of the Qinghai-Xizang Plateau. It can be supposed that the extremely arid and cold climate of the Great Ice Age made most lakes in the north part of the Qinghai-Xizang Plateau enter their playa stage. This event is of importance for formation of salt resources.