Wheat blast and its effect on technological quality of grain from two sowing dates.

2016

Effects of sowing dates and wheat genetic resistance in FHB control.

2016

Planting times and spacing of carrot crops in the São Francisco Valley, Pernambuco state, Brazil.

Climate variations over the year and plant density tend to strongly affect the agronomic performance of carrot crops. Thus, the objective of this work was to evaluate the performance of the cultivar Brasilia in crops under mild (winter) and high (summer) temperatures. An experiment was conducted from May 2011 to February 2012, using a randomized block design and treatments arranged in split plot, with three replications. The plots consisted of planting seasons (winter and summer) and the subplots of plant spacing (4, 6, 8 and 10 cm). The height of plants presented a linear decrease, from 53.4 to 51.0 cm, with an increase in spacing in summer planting, while in winter the greatest height (50.7 cm) was obtained with spacing of 8.0 cm between plants. The lowest commercial yields were found in summer crops and with the widest spacing between plants. The smallest spacing between plants (4 cm) had yields of 45.9 Mg ha -1in summer and of 63.1 Mg ha-1 in winter crops. The winter planting had higher fresh root weight (89.9 g root - 1 ) compared to the summer (81.4 g root - 1 ), reaching higher weight with increasing plant spacing. Higher yields are achieved with plant spacing of 4 cm during winter. The carrot can be grown throughout the year in the Submiddle of the São Francisco Valley.

Growth and survival of Sclerolobium paniculatum vogel and the relationship between rainfall and the increment in diameter at different planting spacings.

Sclerolobium paniculatum Vogel is a species that has good potential for reclamation of degraded soils. The aim of the investigation was to evaluate the growth and survival of the species and the influence of rainfall on growth in diameter as a function of different spacings (4 m x 2 m, 4 m x 3 m, and 4 m x 4 m). The results indicate that the temporal analysis (period from November 2007 to August 2013) detected significant differences (p ? 0.05) in height between the 4 m x 2 m and 4 m x 4 m spacings, while no significant difference in diameter was found between the 4 m x 2 m and 4 m x 3 m spacings. However, the statistical differences did not persist when the data was analyzed at seven and half years old. Regarding survival, a significant difference was observed only between the 4 m x 4 m spacing and the others, with superiority to the former. A strong correlation was found between rainfall and the increment in diameter of individuals in the broader spacings (R = 0.80 in the 4 m x 3 m spacing and R = 0.77 in the 4 m x 4 m spacing), while in the denser spacing the correlation was moderate (R = 0.56 in the 4 m x 2 m spacing). Since the spacings adopted did not influence tree growth by the end of the period, the choice will depend on other factors such as survival and costs of implementation and forestry management. Plantations in regions with larger rainfall amplitude may benefit the productivity of the species.

Productivity and chemical composition of food-type soybeans sown on different dates.

ABSTRACT. The objective of this study was to investigate the effect of different sowing dates on the yield, 100-grain weight, oil, protein and isoflavone contents of food-type soybean breeding lines UEL 110, UEL 115 and UEL 123 and a cultivar BRS 257. The materials were seeded on four sowing dates, and the experiment was conducted in a randomized block design with four replications. The productivity and 100- grain weight varied with the sowing dates and soybean genotypes. The protein content ranged from 36.40 to 42.44%, and the oil content ranged from 18.29 to 22.71%. No significant interaction was found between the genotype and sowing dates for the protein content. The isoflavone content also varied with the sowing dates and soybean genotypes. The cultivar BRS 257 had the highest isoflavone content, including the β- glucoside, malonyl glucoside and aglycones forms. The different sowing dates influenced the productivity, 100-grain weight, oil and protein content and isoflavone levels. Higher temperatures and lower rainfall during the grain filling decreased the productivity and isoflavone content and increased the protein content. For all sowing dates, the BRS 257 soybean food-type cultivar showed the highest isoflavone content, indicating that the effect of genotype is more important. Keywords: soybean, oil, protein, isoflavones. RESUMO. O objetivo deste trabalho foi investigar o efeito das diferentes épocas de semeadura na produtividade, massa de 100 grãos, teor de proteínas, óleo e isoflavonas de linhagens de soja tipo alimento UEL 110, UEL 115 e UEL 123 e cultivar BRS 257. O material foi semeado em quatro épocas de semeadura e o experimento foi conduzido em blocos casualizados com quatro repetições. A produtividade e a massa de 100 grãos variaram com a época de semeadura e com os diferentes genótipos. O teor de proteínas variou de 36,40 a 42,44% e o de óleo de 18,29 a 22,71%. Não foi encontrada interação entre genótipo e épocas de semeadura para o teor de proteínas. O teor de isoflavonas variou com as épocas de semeadura e com os genótipos. A cultivar BRS 257 apresentou maior teor de β-glicosídeos, malonil-glicosídeos e agliconas. As diferentes épocas de semeadura influenciam a produtividade, massa de 100 grãos, conteúdo de óleo, proteínas e isoflavonas. Altas temperaturas e baixas precipitações durante o enchimento dos grãos reduzem a produtividade e teor de isoflavonas e aumentam o teor de proteínas. A cultivar BRS 257 apresenta o maior teor de isoflavonas indicando que o efeito genético é mais importante.

Development and productivity of apple tree cv. MaxiGala on different planting depth.

2016

Soil management and planting methods effects on tangolagrass and forage peanut establishment.

This study aimed to compare four establishment methods of mixed swards of Tangolagrass and forage peanut (Arachis pintoi).

Research Monograph: Constructing online collaborative environmental decision making systems

The use of computing to support environmental planning and the development of land use models dates back to the late 1950s. The main thrust of computing applications, which by the early 1980s increasingly included the use of geospatial technologies, is their contribution to better planning and decision making. The computing tools and technologies are designed to enhance the planners’ capability to deal with complex environments and to plan for prosperous and livable communities. This paper examines the role of Information Technologies (IT) and particularly Internet Based Geographic Information Systems (Internet GIS) as spatial decision support systems to aid community based local decision making. The paper also covers the advantages and challenges of these internet based mapping applications and tools for collaborative decision making on the environment.

Village green

For a communal garden in Copenhagen, Stig L. Andersson uses grasses of varying texture and height, creating a new view or spatial experience from every angle. The idea of vegetation texture being an important constituent of planting design is pervasive. Gardening books tell aspiring designers that "colour, texture and form" are the central aspects of planting arrangements. While these elements contribute to this language, they have tended to limit the language of planting to a singular, two dimensional paradigm, where planting is designed in static elevation. This has developed from a perennial-border approach demonstrated by the early 20th century garden designer Gertrude Jekyll, where the viewer is parallel to the bed, and the planting is layered to address this view. If one were to characterise the difference between a garden design and a landscape architectural approach, the latter would seem self-conscious in its use of space, movement and vision.

Living walls - a way to green the built environment

Actions Towards Sustainable Outcomes Environmental Issues/Principal Impacts The increasing urbanisation of cities brings with it several detrimental consequences, such as: • Significant energy use for heating and cooling many more buildings has led to urban heat islands and increased greenhouse gas emissions. • Increased amount of hard surfaces, which not only contributes to higher temperatures in cities, but also to increased stormwater runoff. • Degraded air quality and noise. • Health and general well-being of people is frequently compromised, by inadequate indoor air quality. • Reduced urban biodiversity. Basic Strategies In many design situations, boundaries and constraints limit the application of cutting EDGe actions. In these circumstances, designers should at least consider the following: • Living walls are an emerging technology, and many Australian examples function more as internal feature walls. However,as understanding of the benefits and construction of living walls develops this technology could be part of an exterior facade that enhances a building’s thermal performance. • Living walls should be designed to function with an irrigation system using non-potable water. Cutting EDGe Strategies • Living walls can be part of a design strategy that effectively improves the thermal performance of a building, thereby contributing to lower energy use and greenhouse gas emissions. • Including living walls in the initial stages of design would provide greater flexibility to the design, especially of the facade, structural supports, mechanical ventilation and watering systems, thus lowering costs. • Designing a building with an early understanding of living walls can greatly reduce maintenance costs. • Including plant species and planting media that would be able to remove air impurities could contribute to improved indoor air quality, workplace productivity and well-being. Synergies and References • Living walls are a key research topic at the Centre for Subtropical Design, Queensland University of Technology: http://www.subtropicaldesign.bee.qut.edu.au • BEDP Environment Design Guide: DES 53: Roof and Facade Gardens • BEDP Environment Design Guide: GEN 4: Positive Development – Designing for Net Positive Impacts (see green scaffolding and green space frame walls). • Green Roofs Australia: www.greenroofs.wordpress.com • Green Roofs for Healthy Cities USA: www.greenroofs.org

United Arab Emirates

The United Arab Emirates (UAE) is part of the geographic region known as the Middle East. With a land mass of 82,000 square kilometres, predominantly desert and mountains it is bordered by Oman, Saudi Arabia and the Arabian Gulf. The UAE is strategically located due to its proximity to other oil rich Middle Eastern countries such as Kuwait, Iraq, Iran, and Saudi Arabia. The UAE was formed from a federation of seven emirates (Abu Dhabi, Dubai, Sharjah, Ras Al Khaimah, Ajman, Fujuriah, and Um Al Quain) in December 1971 (Ras Al Khaimah did not join the federation until 1972) (Heard-bey, 2004, 370). Abu Dhabi is the political capital, and the richest emirate; while Dubai is the commercial centre. The majority of the population of the various Emirates live along the coast line as sources of fresh water often heavily influenced the site of different settlements. Unlike some near neighbours (Iran and Iraq) the UAE has not undergone any significant political instability since it was formed in 1971. Due to this early British influences the UAE has had very strong political and economic ties with first Britain, and, more recently, the United States of America (Rugh, 2007). Until the economic production of oil in the early 1960’s the different Emirates had survived on a mixture of primary industry (dates), farming (goats and camels), pearling and subsidies from Britain (Davidson 2005, 3; Hvit, 2007, 565) Along with near neighbours Kuwait, Bahrain, Oman, Qatar and Saudi Arabia, the UAE is part of the Gulf Cooperation Council (GCC), a trading bloc. (Hellyer, 2001, 166-168).

The relative age effect in Australian Football League players

Youth sports teams are usually grouped into yearly age groups based on fixed cut-off date (September 1st in the UK and January 1st in Australia). Children born just after this cut-off will be the oldest and most mature in their age group. This gives them an advantage in competitive sport, an advantage which has persisted into adulthood as shown by seasonal patterns in the dates of birth of professional ice hockey, football and basketball players. We were interested in whether a similar seasonal pattern exists in professional Australian Football League (AFL) players. We examined all AFL players in the 2009 season excluding foreign-born players. We compared the observed number of players’ born in each month with the expected number based on national statistics. There was a marked and statistically significant seasonality in players’ dates of birth. There were 33% more players than expected with dates of birth in January, and 25% fewer in December. Players who are relatively older in youth AFL teams have a better chance of turning professional.

A comparison of two business cycle dating methods

We study the suggestion that Markov switching (MS) models should be used to determine cyclical turning points. A Kalman filter approximation is used to derive the dating rules implicit in such models. We compare these with dating rules in an algorithm that provides a good approximation to the chronology determined by the NBER. We find that there is very little that is attractive in the MS approach when compared with this algorithm. The most important difference relates to robustness. The MS approach depends on the validity of that statistical model. Our approach is valid in a wider range of circumstances.

The regulation of health professionals

This chapter is about the role of law in the management of the health workforce in Australia. Health professionals play an important role in the health system as the providers of treatment and care — without health professionals health systems would not function. The relationship between health professionals and patients has always been complex and is often subject to some form of regulation by the state. The first surviving written reference to such legal regulation dates from 1795-1750 BCE when the Babylonian Code of Hammurabi stated: “If a physician make a large incision with the operating knife, and kill him, or open a tumor with the operating knife, and cut out the eye, his hands shall be cut off.” Alexander the Great recommended the crucifixion of health professionals who killed their patients. Fortunately, the law in Australia prescribes lesser penalties for erring health professionals, but at the heart of modern regulation are similar concerns to those that underpinned the ancient Babylonian Code — to create conditions to ensure the safety of patients and the provision of quality services by health professionals.