Determination of domain sizes in blends of poly(ethylene) and poly(styrene) formed in the presence of supercritical carbon dioxide

Well-mixed blends of poly(ethylene) and poly(styrene) have been synthesized using supercritical carbon dioxide as a solvent. The morphology of the blends has been conclusively characterized using differential scanning calorimetry (DSC), small-angle X-ray scattering (SAXS), Raman microprobe microscopy, and C-13 solid-state cross-polarization magic angle spinning NMR (C-13 CPMAS NMR). DSC measurements demonstrate that poly(styrene) in the blends resides solely in the amorphous regions of the poly(ethylene) matrix; however, corroborative evidence from the SAXS experiments shows that poly(styrene) resides within the interlamellar spaces. The existence of nanometer-sized domains of poly(styrene) was shown within a blend of poly(styrene) and poly(ethylene) when formed in supercritical carbon dioxide using Raman microprobe microscopy and C-13 CPMAS NMR spectroscopy coupled with a spin diffusion model. This contrasts with blends formed at ambient pressure in the absence of solvent, in which domains of poly(styrene) in the micrometer size range are formed. This apparent improved miscibility of the two components was attributed to better penetration of the monomer prior to polymerization and increased swelling of the polymer substrate by the supercritical carbon dioxide solvent.

Miscibility and phase separation in blends of phenolphthalein poly(aryl ether ketone) and poly(ethylene oxide): a differential scanning calorimetric study

Miscibility and phase separation in the blends of phenolphthalein poly(aryl ether ketone) (PPAEK) and poly(ethylene oxide) (PEO) were investigated by means of differential scanning calorimetry (DSC). The PPAEK/PEO blends prepared by solution casting from N,N-dimethylformamide (DMF) displayed single composition-dependent glass transition temperatures (T-g), intermediate between those of the pure components, suggesting that the blend system is miscible in the amorphous state at all compositions. All the blends underwent phase separation at higher temperatures and the system exhibited a lower critical solution temperature (LCST) behavior. A step-heating thermal analysis was designed to determine the phase boundaries with DSC. The significant changes in the thermal properties of blends were utilized to judge the mixing status for the blends and the phase diagram was thus established. (C) 2004 Elsevier B.V. All rights reserved.

Rheological Properties of Organoclay Suspensions in Epoxy Network Precursors

This paper deals with the evolution of the state of dispersion of organically modified montmorillonites in epoxy or amine precursors. The epoxy prepolymer is a diglycidyl ether of bisphenol A (DGEBA) and the curing agent is an aliphatic diamine with a polyoxypropylene backbone (Jeffamine D2000). The clay dispersion is evaluated at the platelet scale (nanoscopic scale) from X-ray spectrometry [wide-angle X-ray diffraction (WAXD) and small-angle X-ray scattering (SAXS)] and at the aggregates scale (microscopic scale) from rheological analysis. The organoclays used form gels in the monomers above the percolation threshold if no shear is applied and present a mechanical gel/sol transition when shear stress increases. Gel strength and viscosity at high shear rates are linked to the nanometric state of dispersion and reveal the existence of two different organizations depending on organoclay/monomer interactions: (i) When the clay shows good interactions with the monomer, a significant swelling of the clay galleries by the monomer is obtained. These swollen particles lead to formation of weak gels which after shearing give high relative viscosity fluids. (ii) When the clay develops poor interactions with the monomer, the clay tends to reduce its exchange surface with the monomer and leads to a strongly connected gel. Shear breaks down this physical network leading to a very low relative viscosity fluid composed of nonswollen particles keeping a high aspect ratio. (C) 2003 Elsevier B.V All rights reserved.

Seasonal variations of phenolic compounds in Australia-grown tea (Camellia sinensis)

Seasonal variations of phenolic compounds in fresh tea shoots grown in Australia were studied using an HPLC method. Three principal tea flavanols [epigallocatechin gallate (EGCG), epicatechin gallate (ECG), and epigallocatechin (EGC)] and four grouped phenolics [total catechins (Cs), total catechin gallates (CGs), total flavanols (Fla), and total polyphenols (PPs)] in fresh tea shoots were analyzed and compared during the commercial harvest seasons from April 2000 to May 2001. The levels of EGCG, ECG, and CGs in the fresh tea shoots were higher in the warm months of April 2000 (120.52, 34.50, and 163.75 mg/g, respectively) and May 2000 (128.63, 44.26, and 183.83 mg/g, respectively) and lower during the cool months of July 2000 (91.39, 35.16, and 132.30 mg/g, respectively), August 2000 (91.31, 31.56, and 128.64 mg/g, respectively), and September 2000 (96.12, 33.51, and 136.90 mg/g, respectively). Thereafter, the levels increased throughout the warmer months from October to December 2000 and remained high until May 2001. In the warmer months, the levels of EGCG, ECG, and CGs were in most cases significantly higher (P < 0.05) than those in the samples harvested in the cooler months. In contrast, the levels of EGC and Cs were high and consistent in the cooler months and low in the warmer months. The seasonal variations of the individual and grouped catechins were significant (P < 0.05) between the cooler and warmer months. This study revealed that EGCG and ECG could be used as quality descriptors for monitoring the seasonal variations of phenolics in Australia-grown tea leaves, and the ratio (EGCG + ECG)/EGC has been suggested as a quality index for measuring the differences in flavanol levels in fresh tea shoots across the growing seasons. Mechanisms that induce seasonal variations in tea shoots may include one or all three of the following environmental conditions: day length, sunlight, and/or temperature, which vary markedly across seasons. Therefore, further studies under controlled conditions such as in a greenhouse may be required to direct correlate flavonoid profiles of green tea leaves with their yields and also to with conditions such as rainfall and humidity.

Phenolic acids in Australian Melaleuca, Guioa, Lophostemon, Banksia and Helianthus honeys and their potential for floral authentication

Eight phenolic acids and two abscisic acid isomers in Australian honeys from five botanical species (Melaleuca, Guioa, Lophostemon, Banksia and Helianthus) have been analyzed in relation to their botanical origins. Total phenolic acids present in these honeys range from 2.13 mg/100 g sunflower (Helianthus annuus) honey to 12.11 mg/100 g tea tree (Melaleuca quinquenervia) honey, with amounts of individual acids being various. Tea tree honey shows a phenolic profile of gallic, ellagic, chlorogenic and coumaric acids, which is similar to the phenolic profile of an Australian Eucalyptus honey (bloodwood or Eucalyptus intermedia honey). The main difference between tea tree and bloodwood honeys is the contribution of chlorogenic acid to their total phenolic profiles. In Australian crow ash (Guioa semiglauca) honey, a characteristic phenolic profile mainly consisting of gallic acid and abscisic acid could be used as the floral marker. In brush box (Lophostemon conferta) honey, the phenolic profile, comprising mainly gallic acid and ellagic acid, could be used to differentiate this honey not only from the other Australian non-Eucalyptus honeys but also from a Eucalyptus honey (yellow box or Eucalyptus melliodora honey). However, this Eucalyptus honey could not be differentiated from brush box honey based only on their flavonoid profiles. Similarly, the phenolic profile of heath (Banksia ericifolia) honey, comprising mainly gallic acid, an unknown phenolic acid (Phl) and coumaric acid, could also be used to differentiate this honey from tea tree and bloodwood honeys, which have similar flavonoid profiles. Coumaric acid is a principal phenolic acid in Australian sunflower honey and it could thus be used together with gallic acid for the authentication. These results show that the HPLC analysis of phenolic acids and abscisic acids in Australian floral honeys Could assist the differentiation and authentication of the honeys. © 2005 Elsevier Ltd. All rights reserved.

Compatibilization of starch-polyester blends using reactive extrusion

Maleic anhydride (MA) and dicumyl peroxide (DCP) were used as crosslinking agent and initiator respectively for blending starch and a biodegradable synthetic aliphatic polyester using reactive extrusion. Blends were characterized using dynamic mechanical and thermal analysis (DMTA). Optical micrographs of the blends revealed that in the optimized blend, starch was evenly dispersed in the polymer matrix. Optimized blends exhibited better tensile properties than the uncompatibilized blends. Xray photoelectron spectroscopy supported the proposed structure for the starch-polyester complex. Variation in the compositions of crosslinking agent and initiator had an impact on the properties and color of the blends.

Phenolic compounds in tea from Australian supermarkets

Phenolic compounds constitute 50-70% of tea water extract and are the main quality parameters for teas. Theaflavins (TF), thearubigins (TR) and theabrownins (TB) are the major polyphenols that determine the quality of black tea. These compounds were measured in 56 leaf teas and teabags sampled from Australian supermarkets in Queensland. The various quantities of TF, ranging from 0.29% to 1.25%, indicate a quality difference that exists among the teas studied. Low TF content in black tea may be due to over-fermenting and/or long periods of storage. The solubility of TR and TB from teabags ranged from 82% to 92%, indicating that the permeability of teabags was variable. Variable quantities of TF in Australian teas show instability and a tendency of TF to oxidize during storage. Total polyphenols in green teas ranged from 14% to 34%, indicating a large variation, which was not reflected in price. The solubility of total polyphenols from teabags has been proposed as a useful quality index of the filtering paper used for the teabags. This chemical analysis of phenolic compounds in commercial teas may be a potential tool for the quality control of Australian manufactured and imported teas in Australian markets. (C) 2005 Elsevier Ltd. All rights reserved.