930 resultados para fetal weight
Resumo:
The need to integrate cost into the early product definition process as an engineering parameter is addressed. The application studied is a fuselage panel that is typical for commercial transport regional jets. Consequently, a semi-empirical numerical analysis using reference data was coupled to model the structural integrity of thin-walled structures with regard to material failure and buckling: skin, stringer, flexural, and interrivet. The optimization process focuses on direct operating cost (DOC) as a function of acquisition cost and fuel burn. It was found that the ratio of acquisition cost to fuel burn was typically 4:3 and that there was a 10% improvement in the DOC for the minimal DOC condition over the minimal weight condition because of the manufacturing cost saving from having a reduced number of larger-area stringers and a slightly thicker skin than that preferred by the minimal weight condition. Also note that the minimal manufacturing cost condition was slightly better than the minimal weight condition, which highlights the key finding: The traditional minimal weight condition is a dated and suboptimal approach to airframe structural design.
Resumo:
Ultra-high molecular weight polyethylene (UHMWPE) is used for wear applications in total hip prostheses and total knee prostheses. Sterilisation of these prostheses is commonly by gamma-irradiation. This process creates reactive free radicals in the UHMWPE, greatly increasing its susceptibility to oxidative degradation. This study has investigated the influence of air and vacuum packaging on the properties of gamma-irradiated UHMWPE (GUR1050) following 3 years of shelf ageing. The findings indicate that vacuum packaging minimises oxidative degradation reactions that occur for UHMWPE during shelf ageing. However, gamma-irradiation of vacuum-packaged UHMWPE promotes a degree of cross-linking. It is proposed that this may enhance the wear performance of UHMWPE. Accelerated ageing studies indicate that 3 years of shelf ageing would also seem to reduce the susceptibility of gamma-irradiated UHMWPE to oxidative degradation upon removal from its vacuum packaging.
Resumo:
Deficient trophoblast invasion and spiral artery remodeling are associated with pregnancy complications such as pre-eclampsia (PE) and fetal growth restriction (FGR). Using a model in which pregnant Wistar rats are given daily, low-dose, injections of bacterial lipopolysaccharide (LPS; 10 – 40 µg/kg) on gestational days (GD) 13.5 – 16.5, our group has shown that abnormal maternal inflammation is causally linked to shallow trophoblast invasion, deficient spiral artery remodeling, and altered utero-placental hemodynamics leading to FGR/PE; these alterations were shown to be mediated by TNF-a. The present research evaluated certain consequences of decreased placental perfusion; this was accomplished by examining placental alterations indicative of decreased placental perfusion. Additionally, the role of glyceryl trinitrate (GTN) was determined as a potential therapeutic to prevent the consequences of decreased placental perfusion. Results indicated that dams experiencing heightened maternal inflammation showed significantly greater expression of hypoxia-inducible factor-1a (HIF-1a) and nitrotyrosine, both of which are markers of decreased perfusion and oxidative/nitrosative stress. Contrary to expectations, inflammation did not appear to affect nitric oxide (NO) bioavailability, as revealed by a lack of change in placental or plasma levels of cyclic guanosine monophosphate (cGMP). However, continuous transdermal administration of GTN (25 µg/hr) on GD 12.5 – 16.5 prevented the accumulation of HIF-1a and nitrotyrosine in placentas from LPS-treated rats. These results support the concept that maternal inflammation contributes to placental hypoxia and oxidative/nitrosative stress. Additionally, they indicate that GTN has potential applications in the treatment and/or prevention of pregnancy complications associated with abnormal maternal inflammation.
Resumo:
Objective Within the framework of a health technology assessment and using an economic model, to determine the most clinically and cost effective policy of scanning and screening for fetal abnormalities in early pregnancy. Design A discrete event simulation model of 50,000 singleton pregnancies. Setting Maternity services in Scotland. Population Women during the first 24 weeks of their pregnancy. Methods The mathematical model was populated with data on uptake of screening, prevalence, detection and false positive rates for eight fetal abnormalities and with costs for ultrasound scanning and serum screening. Inclusion of abnormalities was based on the relative prevalence and clinical importance of conditions and the availability of data. Six strategies for the identification of abnormalities prenatally including combinations of first and second trimester ultrasound scanning and first and second trimester screening for chromosomal abnormalities were compared. Main outcome measures The number of abnormalities detected and missed, the number of iatrogenic losses resulting from invasive tests, the total cost of strategies and the cost per abnormality detected were compared between strategies. Results First trimester screening for chromosomal abnormalities costs more than second trimester screening but results in fewer iatrogenic losses. Strategies which include a second trimester ultrasound scan result in more abnormalities being detected and have lower costs per anomaly detected. Conclusions The preferred strategy includes both first and second trimester ultrasound scans and a first trimester screening test for chromosomal abnormalities. It has been recommended that this policy is offered to all women in Scotland.