987 resultados para experimental manipulation


Relevância:

20.00% 20.00%

Publicador:

Resumo:

Dissertação para obtenção do Grau de Mestre em Engenharia Civil – Perfil de Estruturas e Geotecnia

Relevância:

20.00% 20.00%

Publicador:

Resumo:

This study presents the results of T. mentagrophytes inoculation in the cheek pouch of the hamster, an immunologically privileged site. Forty two animals were used: 21 inoculated with 10(6) fungi in the cheek pouch (group 1) and 21 inoculated initially with 10(6) fungi in the foot pad and 15 days later in the cheek pouch, with the same amount of fungi (group 2). Animals were sacrificed at 20 hours, 3, 7, 14, 30, 60, and 120 days; samples from inoculated cheek pouch, and foot pads submitted to the foot pad test (FPT), were collected. Independent of group and time of evolution of infection, animals did not develop delayed hypersensitivity evaluated through the FPT. The pre-inoculation of fungi in the foot pad did not change the morphology of lesions induced in the cheek pouch. Therefore, in animals of group 1 and 2, the introduction of the fungus in the cheek pouch resulted in focal lesion composed of a sterile acute inflammatory infiltrate, with abscess formation that evolved to a macrophagic reaction, and later to resolution even in the absence of immune response detectable by FPT. Our results indicate that in spite of the important role of the immune response in the spontaneous regression of dermatophytosis, other factors are also an integral part in the defense against this fungal infection.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para obtenção do Grau de Mestre em Engenharia Civil – Perfil de Construção

Relevância:

20.00% 20.00%

Publicador:

Resumo:

In order to study B. henselae transmission among cats, five young cats were kept in confinement for two years, one of them being inoculated by SC route with B. henselae (10(5) UFC). Only occasional contact among cats occurred but the presence of fleas was observed in all animals throughout the period. Blood culture for isolation of bacteria, PCR-HSP and FTSZ (gender specific), and BH-PCR (species-specific), as well as indirect immunofluorescence method for anti-B. henselae antibodies were performed to confirm the infection of the inoculated cat as well as the other naive cats. Considering the inoculated animal, B. henselae was first isolated by blood culture two months after inoculation, bacteremia last for four months, the specific antibodies being detected by IFI during the entire period. All contacting animals presented with bacteremia 6 months after experimental inoculation but IFI did not detect seroconversion in these animals. All the isolates from these cats were characterized as Bartonella (HSP and FTSZ-PCR), henselae (BH-PCR). However, DNA of B. henselae could not be amplified directly from peripheral blood by the PCR protocols used. Isolation of bacteria by blood culture was the most efficient method to diagnose infection compared to PCR or IFI. The role of fleas in the epidemiology of B. henselae infection in cats is discussed.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Oral transmission of Trypanosoma cruzi has been suspected when epidemic episodes of acute infection were observed in areas devoid of domiciled insect vectors. Considering that the distribution of T. cruzi biodemes differs in sylvatic and domestic cycles, results of studies on biodemes can be of interest regarding oral transmission. The infectivity of T. cruzi strains of different biodemes was tested in mice subjected to infection by the digestive route (gavage). Swiss mice were infected either with the Peruvian strain (Biodeme Type I, Z2b) or the Colombian strain (Biodeme Type III, Z1, or T. cruzi I); for control, intraperitoneal inoculation was performed in a group of mice. The Colombian strain revealed a similar high infectivity and pathogenicity when either route of infection was used. However, the Peruvian strain showed contrasting levels of infectivity and pathogenicity, being high by intraperitoneal inoculation and low when the gastric route was used. The higher infectivity of the Colombian strain (Biodeme Type III) by gastric inoculation is in keeping with its role in the epidemic episodes of acute Chagas disease registered in the literature, since strains belonging to Biodeme III are most often found in sylvatic hosts.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Ammonia is an important gas in many power plants and industrial processes so its detection is of extreme importance in environmental monitoring and process control due to its high toxicity. Ammonia’s threshold limit is 25 ppm and the exposure time limit is 8 h, however exposure to 35 ppm is only secure for 10 min. In this work a brief introduction to ammonia aspects are presented, like its physical and chemical properties, the dangers in its manipulation, its ways of production and its sources. The application areas in which ammonia gas detection is important and needed are also referred: environmental gas analysis (e.g. intense farming), automotive-, chemical- and medical industries. In order to monitor ammonia gas in these different areas there are some requirements that must be attended. These requirements determine the choice of sensor and, therefore, several types of sensors with different characteristics were developed, like metal oxides, surface acoustic wave-, catalytic-, and optical sensors, indirect gas analyzers, and conducting polymers. All the sensors types are described, but more attention will be given to polyaniline (PANI), particularly to its characteristics, syntheses, chemical doping processes, deposition methods, transduction modes, and its adhesion to inorganic materials. Besides this, short descriptions of PANI nanostructures, the use of electrospinning in the formation of nanofibers/microfibers, and graphene and its characteristics are included. The created sensor is an instrument that tries to achieve a goal of the medical community in the control of the breath’s ammonia levels being an easy and non-invasive method for diagnostic of kidney malfunction and/or gastric ulcers. For that the device should be capable to detect different levels of ammonia gas concentrations. So, in the present work an ammonia gas sensor was developed using a conductive polymer composite which was immobilized on a carbon transducer surface. The experiments were targeted to ammonia measurements at ppb level. Ammonia gas measurements were carried out in the concentration range from 1 ppb to 500 ppb. A commercial substrate was used; screen-printed carbon electrodes. After adequate surface pre-treatment of the substrate, its electrodes were covered by a nanofibrous polymeric composite. The conducting polyaniline doped with sulfuric acid (H2SO4) was blended with reduced graphene oxide (RGO) obtained by wet chemical synthesis. This composite formed the basis for the formation of nanofibers by electrospinning. Nanofibers will increase the sensitivity of the sensing material. The electrospun PANI-RGO fibers were placed on the substrate and then dried at ambient temperature. Amperometric measurements were performed at different ammonia gas concentrations (1 to 500 ppb). The I-V characteristics were registered and some interfering gases were studied (NO2, ethanol, and acetone). The gas samples were prepared in a custom setup and were diluted with dry nitrogen gas. Electrospun nanofibers of PANI-RGO composite demonstrated an enhancement in NH3 gas detection when comparing with only electrospun PANI nanofibers. Was visible higher range of resistance at concentrations from 1 to 500 ppb. It was also observed that the sensor had stable, reproducible and recoverable properties. Moreover, it had better response and recovery times. The new sensing material of the developed sensor demonstrated to be a good candidate for ammonia gas determination.

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Dissertação apresentada à Faculdade de Ciências e Tecnologias da Universidade Nova de Lisboa para obtenção do grau Mestre em Engenharia Civil – Reabilitação de Edifícios

Relevância:

20.00% 20.00%

Publicador:

Resumo:

RESUMO - Os sistemas de saúde deparam-se, actualmente, com novos paradigmas, ao nível da qualidade da prestação de cuidados de saúde, bem como no que se refere à necessidade de controlo dos custos com o sector da saúde, obrigando as organizações a adaptarem-se por forma a fornecerem a resposta mais adequada às crescentes necessidades dos indivíduos. O reconhecimento desta realidade tem levado os governos de muitos países a definir políticas orientadas para problemas de saúde específicos e a adoptar estratégias de intervenção que privilegiam uma abordagem integrada com o objectivo de melhorarem progressivamente o nível de saúde das populações, a qualidade dos cuidados prestados e a eficiência na utilização de recursos. Em Portugal, a aplicação dos princípios que estiveram na base dos modelos de gestão da doença, deu origem ao modelo experimental de Gestão Integrada da Doença, que incorpora a gestão clínica da doença, centrada no doente, com especial enfoque na sua autogestão e na clarificação das melhores práticas profissionais, visando a sua uniformização; a reorganização do modelo de prestação de cuidados, com a criação de Centros de Elevada Diferenciação e Centros de Tratamento, com especiais preocupações no que concerne à orientação do doente no sistema para que os cuidados lhe seja ministrados no nível mais adequado; um modelo de financiamento específico, indexado aos resultados, que reflicta a adopção das melhores práticas; um sistema de informação que permita a monitorização e avaliação constante deste processo. O desenvolvimento deste modelo organizacional tem-se revelado como uma estratégia inovadora e como uma ferramenta de elevado potencial para a melhoria da prestação de cuidados de saúde e para a promoção de uma maior efectividade e eficiência, tal como poderá, ainda, constituirse como um veículo, importante e permanente, de informação de apoio à decisão em Saúde. Este modelo visa, no fundo, promover uma acção concertada no sentido da obtenção de uma intervenção precisa, através da mobilização de recursos adequados, que permitam uma melhoria do estado de saúde, da qualidade de vida e do bem-estar global dos doentes. Esta abordagem passa pela colaboração e coordenação dos diferentes níveis de prestação de cuidados, no sentido de oferecerem cuidados integrados de saúde, com níveis de qualidade elevados em termos de prevenção, diagnóstico, tratamento, reabilitação e acompanhamento. ------------------------ --ABSTRACT – The health systems are faced with new paradigms, on one hand in the healthcare services delivered to the populations, and on the other hand, in the need to control costs in the health sector, forcing organizations to adapt and provide the most appropriate response to the individuals growing needs. The magnitude of this problem, in terms of public health, requires the adoption of a directed, targeted, planned and integrated action, based on clear and well defined strategies in order to obtain health gains, improving the quality of care and streamlining the costs. In Portugal, the application of those principles forming the basis of the disease management models, led to the Integrated Disease Management model which, apart from the clinical management of the disease, also incorporates the healthcare delivery structure reorganization, a specific financing model based on an information system that allows the process monitoring and evaluation. The development of Integrated Disease Management models is a central strategy and a tool for improving healthcare delivery, more effectively and efficiently, and can even be an important and permanent vehicle of information for health decision support. Therefore, it is important to promote a concerted action towards achieving a precise intervention, mobilizing the resources, improving the health status, quality of life and the overall patients’ wellbeing. This action means increasing collaboration and coordination of the different levels of care, offering integrated healthcare s

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Dissertação para obtenção do Grau de Mestre em Engenharia Civil – Perfil de Construção

Relevância:

20.00% 20.00%

Publicador:

Resumo:

Abdominal angiostrongyliasis is a zoonotic infection produced by a metastrongylid intra-arterial nematode, Angiostrongylus costaricensis. Human accidental infection may result in abdominal lesions and treatment with anti-helminthics is contra-indicated because of potential higher morbidity with excitement or death of worms inside vessels. To evaluate the effect of mebendazole on localization of the worms, male Swiss mice, 5 week-old, were infected with 10 third stage larvae per animal. Twelve infected mice were treated with oral mebendazol, at 5 mg/kg/day, for 5 consecutive days, begining 22 days after inoculation. As control groups, 12 infected but non-treated mice and other 12 non-infected and non-treated mice were studied. The findings at necropsy were, respectively for the treated (T) and control (C) groups: 92% and 80% of the worms were inside the cecal mesenteric arterial branch; 8% and 10% were located inside the aorta. Only in the group C some worms (10%) were found inside the portal vein or splenic artery. These data indicate that treatment with mebendazole does not lead to distal or ectopic migration of A. costaricensis worms.