Detection of transgenic and endogenous plant DNA fragments in the blood, tissues, and digesta of broilers

The aim was to determine the fate of transgenic and endogenous plant DNA fragments in the blood, tissues, and digesta of broilers. Male broiler chicks (n = 24) were allocated at 1 day old to each of four treatment diets designated T1-T4. T1 and T2 contained the near isogenic nongenetically modified (GM) maize grain, whereas T3 and T4 contained GM maize grain [cry1a(b) gene]; T1 and T3 also contained the near isogenic non-GM soybean meal, whereas T2 and T4 contained GM soybean meal (cp4epsps gene). Four days prior to slaughter at 39-42 days old, 50% of the broilers on T2-T4 had the source(s) of GM ingredients replaced by their non-GM counterparts. Detection of specific DNA sequences in feed, tissue, and digesta samples was completed by polymerase chain reaction analysis. Seven primer pairs were used to amplify fragments (similar to 200 bp) from single copy genes (maize high mobility protein, soya lectin, and transgenes in the GM feeds) and multicopy genes (poultry mitochondrial cytochrome b, maize, and soya rubisco). There was no effect of treatment on the measured growth performance parameters. Except for a single detection of lectin (nontransgenic single copy gene; unsubstantiated) in the extracted DNA from one bursa tissue sample, there was no positive detection of any endogenous or transgenic single copy genes in either blood or tissue DNA samples. However, the multicopy rubisco gene was detected in a proportion of samples from all tissue types (23% of total across all tissues studied) and in low numbers in blood. Feed-derived DNA was found to survive complete degradation up to the large intestine. Transgenic DNA was detected in gizzard digesta but not in intestinal digesta 96 h after the last feeding of treatment diets containing a source of GM maize and/or soybean meal.

Synthesis of fused cyclic systems containing medium-sized rings through tandem ROM-RCM of norbornene derivatives embedded in a carbohydrate template

A general approach for the synthesis of fused cyclic systems containing medium-sized rings (7-9) has been developed. The key steps involve a diastereoface-selective Diels-Alder reaction of the dienophiles 4a-d attached to a furanosugar with cyclopentadiene and ring opening (ROM)-ring closing metathesis (RCM) of the resulting norbornene derivatives 10a-d and 11a-d. Diels-Alder reaction of the dienophiles 4a-d with cyclopentadiene in the absence of a catalyst produced 10a-d as the major product arising through addition of the diene to the unhindered Si-face. The most interesting and new aspect of the Diels-Alder reaction of these dienophiles is the accessibility of the Re-face that was blocked by the alkenyl chains under Lewis acid catalysis producing the diastereoisomers 11a-d exclusively. The reversal of facial selectivity from an uncatalyzed reaction to a catalyzed one is unprecedented. The observed stereochemical dichotomy is attributed to rotation of the enone moiety along the or bond linking the sugar moiety during formation of the chelate 13. This makes the Re-face of the enone moiety in 4a-d unhindered. Diels-Alder reaction of the carbocyclic analogue 15 under Lewis acid catalysis produced a 1: 1 mixture of the adducts 16 and 17 confirming the participation of sugar ring oxygen in chelate formation. Finally ROM-RCM of 10a-d and 11a-d with Grubbs' catalyst afforded the cis-syn-cis and cis-anti-cis bicyclo-annulated sugars 21a-d and 23a-d, respectively, containing 7-9 membered rings.

The influence of hydration on the tensile and compressive properties of avian keratinous tissues

Despite recent research exploring the elastic properties of avian keratins, data on failure properties are less common in the literature. In this paper we present data on the failure properties and moduli of both avian feather and claw keratin in tension and the modulus of claw keratin in compression. Increased water content acts to decrease stiffness and strength but to increase strain at failure. The modulus of claw did not differ significantly when tested under tension and compression.

Distribution of [H-3]trans-resveratrol in rat tissues following oral administration

Resveratrol has been widely investigated for its potential health properties, although little is known about its metabolism in vivo. Here we investigated the distribution of metabolic products of [H-3]trans-resveratrol, following gastric administration. At 2 h, plasma concentrations reached 1 center dot 7 % of the administered dose, whilst liver and kidney concentrations achieved 1 center dot 0 and 0 center dot 6 %, respectively. Concentrations detected at 18 h were lower, being only 0 center dot 5 % in plasma and a total of 0 center dot 35 % in tissues. Furthermore, whilst kidney and liver concentrations fell to 10 and 25 %, respectively, of concentrations at 2 h, the brain retained 43 % of that measured at 2 h. Resveratrol-glucuronide was identified as the major metabolite, reaching 7 mu m in plasma at 2 h. However, at 18 h the main form identified in liver, heart, lung and brain was native resveratrol aglycone, indicating that it is the main form retained in the tissues. No phenolic degradation products were detected in urine or tissues, indicating that, unlike flavonoids, resveratrol does not appear to serve as a substrate for colonic microflora. The present study provides additional information about the nature of resveratrol metabolites and which forms might be responsible for its in vivo biological effects.

Integrative workflow-embedded support for process automation and management

This paper presents the on-going research performed in order to integrate process automation and process management support in the context of media production. This has been addressed on the basis of a holistic approach to software engineering applied to media production modelling to ensure design correctness, completeness and effectiveness. The focus of the research and development has been to enhance the metadata management throughout the process in a similar fashion to that achieved in Decision Support Systems (DSS) to facilitate well-grounded business decisions. The paper sets out the aims and objectives and the methodology deployed. The paper describes the solution in some detail and sets out some preliminary conclusions and the planned future work.

A parallel convolutional coder including embedded puncturing with application to consumer devices

As consumers demand more functionality) from their electronic devices and manufacturers supply the demand then electrical power and clock requirements tend to increase, however reassessing system architecture can fortunately lead to suitable counter reductions. To maintain low clock rates and therefore reduce electrical power, this paper presents a parallel convolutional coder for the transmit side in many wireless consumer devices. The coder accepts a parallel data input and directly computes punctured convolutional codes without the need for a separate puncturing operation while the coded bits are available at the output of the coder in a parallel fashion. Also as the computation is in parallel then the coder can be clocked at 7 times slower than the conventional shift-register based convolutional coder (using DVB 7/8 rate). The presented coder is directly relevant to the design of modern low-power consumer devices

Uniformization of affine dependence programs for parallel embedded system design

This paper is concerned with the uniformization of a system of afine recurrence equations. This transformation is used in the design (or compilation) of highly parallel embedded systems (VLSI systolic arrays, signal processing filters, etc.). In this paper, we present and implement an automatic system to achieve uniformization of systems of afine recurrence equations. We unify the results from many earlier papers, develop some theoretical extensions, and then propose effective uniformization algorithms. Our results can be used in any high level synthesis tool based on polyhedral representation of nested loop computations.

Response of porcine intestinal in vitro organ culture tissues following exposure to Lactobacillus plantarum JC1 and Salmonella Typhimurium SL1344.

The development of novel intervention strategies for the control of zoonoses caused by bacteria such as Salmonella spp. in livestock requires appropriate experimental models to assess their suitability. Here, a novel porcine intestinal in vitro organ culture (IVOC) model utilizing cell crown (CC) technology (CCIVOC) (Scaffdex) was developed. The CCIVOC model was employed to investigate the characteristics of association of S. enterica serovar Typhimurium strain SL1344 with porcine intestinal tissue following exposure to a Lactobacillus plantarum strain. The association of bacteria to host cells was examined by light microscopy and electron microscopy (EM) after appropriate treatments and staining, while changes in the proteome of porcine jejunal tissues were investigated using quantitative label-free proteomics. Exposure of porcine intestinal mucosal tissues to L. plantarum JC1 did not reduce the numbers of S. Typhimurium bacteria associating to the tissues but was associated with significant (P < 0.005) reductions in the percentages of areas of intestinal IVOC tissues giving positive staining results for acidic mucins. Conversely, the quantity of neutrally charged mucins present within the goblet cells of the IVOC tissues increased significantly (P < 0.05). In addition, tubulin- was expressed at high levels following inoculation of jejunal IVOC tissues with L. plantarum. Although L. plantarum JC1 did not reduce the association of S. Typhimurium strain SL1344 to the jejunal IVOC tissues, detection of increased acidic mucin secretion, host cytoskeletal rearrangements, and proteins involved in the porcine immune response demonstrated that this strain of L. plantarum may contribute to protecting the pig from infections by S. Typhimurium or other pathogens.

Observations of ice multiplication in a weakly convective cell embedded in supercooled mid-level stratus

Simultaneous observations of cloud microphysical properties were obtained by in-situ aircraft measurements and ground based Radar/Lidar. Widespread mid-level stratus cloud was present below a temperature inversion (~5 °C magnitude) at 3.6 km altitude. Localised convection (peak updraft 1.5 m s−1) was observed 20 km west of the Radar station. This was associated with convergence at 2.5 km altitude. The convection was unable to penetrate the inversion capping the mid-level stratus. The mid-level stratus cloud was vertically thin (~400 m), horizontally extensive (covering 100 s of km) and persisted for more than 24 h. The cloud consisted of supercooled water droplets and small concentrations of large (~1 mm) stellar/plate like ice which slowly precipitated out. This ice was nucleated at temperatures greater than −12.2 °C and less than −10.0 °C, (cloud top and cloud base temperatures, respectively). No ice seeding from above the cloud layer was observed. This ice was formed by primary nucleation, either through the entrainment of efficient ice nuclei from above/below cloud, or by the slow stochastic activation of immersion freezing ice nuclei contained within the supercooled drops. Above cloud top significant concentrations of sub-micron aerosol were observed and consisted of a mixture of sulphate and carbonaceous material, a potential source of ice nuclei. Particle number concentrations (in the size range 0.1