993 resultados para Material Co-ordinates
Resumo:
This work introduces two major changes to the conventional protocol for designing plastic antibodies: (i) the imprinted sites were created with charged monomers while the surrounding environment was tailored using neutral material; and (ii) the protein was removed from its imprinted site by means of a protease, aiming at preserving the polymeric network of the plastic antibody. To our knowledge, these approaches were never presented before and the resulting material was named here as smart plastic antibody material (SPAM). As proof of concept, SPAM was tailored on top of disposable gold-screen printed electrodes (Au-SPE), following a bottom-up approach, for targeting myoglobin (Myo) in a point-of-care context. The existence of imprinted sites was checked by comparing a SPAM modified surface to a negative control, consisting of similar material where the template was omitted from the procedure and called non-imprinted materials (NIMs). All stages of the creation of the SPAM and NIM on the Au layer were followed by both electrochemical impedance spectroscopy (EIS) and cyclic voltammetry (CV). AFM imaging was also performed to characterize the topography of the surface. There are two major reasons supporting the fact that plastic antibodies were effectively designed by the above approach: (i) they were visualized for the first time by AFM, being present only in the SPAM network; and (ii) only the SPAM material was able to rebind to the target protein and produce a linear electrical response against EIS and square wave voltammetry (SWV) assays, with NIMs showing a similar-to-random behavior. The SPAM/Au-SPE devices displayed linear responses to Myo in EIS and SWV assays down to 3.5 μg/mL and 0.58 μg/mL, respectively, with detection limits of 1.5 and 0.28 μg/mL. SPAM materials also showed negligible interference from troponin T (TnT), bovine serum albumin (BSA) and urea under SWV assays, showing promising results for point-of-care applications when applied to spiked biological fluids.
Resumo:
6th Graduate Student Symposium on Molecular Imprinting
Resumo:
JORNADAS DE ELECTROQUÍMICA E INOVAÇÃO 2013
Resumo:
This work presents the development of a low cost sensor device for the diagnosis of breast cancer in point-of-care, made with new synthetic biomimetic materials inside plasticized poly(vinyl chloride), PVC, membranes, for subsequent potentiometric detection. This concept was applied to target a conventional biomarker in breast cancer: Breast Cancer Antigen (CA15-3). The new biomimetic material was obtained by molecularly-imprinted technology. In this, a plastic antibody was obtained by polymerizing around the biomarker that acted as an obstacle to the growth of the polymeric matrix. The imprinted polymer was specifically synthetized by electropolymerization on an FTO conductive glass, by using cyclic voltammetry, including 40 cycles within -0.2 and 1.0 V. The reaction used for the polymerization included monomer (pyrrol, 5.0×10-3 mol/L) and protein (CA15-3, 100U/mL), all prepared in phosphate buffer saline (PBS), with a pH of 7.2 and 1% of ethylene glycol. The biomarker was removed from the imprinted sites by proteolytic action of proteinase K. The biomimetic material was employed in the construction of potentiometric sensors and tested with regard to its affinity and selectivity for binding CA15-3, by checking the analytical performance of the obtained electrodes. For this purpose, the biomimetic material was dispersed in plasticized PVC membranes, including or not a lipophilic ionic additive, and applied on a solid conductive support of graphite. The analytical behaviour was evaluated in buffer and in synthetic serum, with regard to linear range, limit of detection, repeatability, and reproducibility. This antibody-like material was tested in synthetic serum, and good results were obtained. The best devices were able to detect 5 times less CA15-3 than that required in clinical use. Selectivity assays were also performed, showing that the various serum components did not interfere with this biomarker. Overall, the potentiometric-based methods showed several advantages compared to other methods reported in the literature. The analytical process was simple, providing fast responses for a reduced amount of analyte, with low cost and feasible miniaturization. It also allowed the detection of a wide range of concentrations, diminishing the required efforts in previous sample pre-treating stages.
Resumo:
1st ASPIC International Congress
Resumo:
Dissertação para obtenção do Grau de Mestre em Conservação e Restauro, Especialização em Ciências da Conservação
Resumo:
Hepatitis C virus (HCV) and human immunodeficiency virus (HIV) share the same transmission mechanisms. The prevalence of HCV in the HIV-infected population varies from region to region, throughout the world, depending on different exposure factors to both viruses. Co-infection with HIV accelerates the progression of the disease caused by HCV, appears to worsen the progression of the HIV infection and increases HCV transmission. Therefore, clinical management and treatment of HCV is a priority in medical facilities that receive HIV-infected patients. Clinical management of these patients involves specific diagnostic procedures and appropriately trained medical staff. The indication of treatment should meet specific clinical and laboratory criteria. There are a number of drugs currently available to treat hepatitis C in co-infected patients.
Resumo:
Trypsin is required in the hemagglutinin (HA) cleavage to in vitro influenza viruses activation. This HA cleavage is necessary for virus cell entry by receptor-mediated endocytosis. Bacteria in the respiratory tract are potential sources of proteases that could contribute to the cleavage of influenza virus in vivo. From 47 samples collected from horses, pigs, and from humans, influenza presence was confirmed in 13 and these samples demonstrated co-infection of influenza with flagellated bacteria, Stenotrophomonas maltophilia from the beginning of the experiments. Despite treatment with antibiotics, the bacteria remained resistant in several of the co-infected samples (48.39%). These bacteria, considered opportunistic invaders from environmental sources, are associated with viral infections in upper respiratory tract of hosts. The protease (elastase), secreted by Stenotrophomonas maltophilia plays a role in the potentiation of influenza virus infection. Proteolytic activity was detected by casein agar test. Positive samples from animals and humans had either a potentiated influenza infectivity or cytopathic effect (CPE) in MDCK and NCI H292 cells, Stenotrophomonas maltophilia were always present. Virus and bacteria were observed ultrastructurally. These in vitro findings show that microbial proteases could contribute to respiratory complications by host protease activity increasing inflammation or destroying endogenous cell protease inhibitors.
Resumo:
Paper presented at the 5th European Conference Economics and Management of Energy in Industry, Vilamoura, Algarve. Apr. 14-17, 2009, 11p. URL: http:// www.cenertec.pt/ecemei/
Resumo:
In this study, the epidemiological and clinical features observed in solely HTLV-II-infected individuals were compared to those in patients co-infected with HIV-1. A total of 380 subjects attended at the HTLV Out-Patient Clinic in the Institute of Infectious Diseases "Emilio Ribas" (IIER), São Paulo, Brazil, were evaluated every 3-6 months for the last seven years by infectious disease specialists and neurologists. Using a testing algorithm that employs the enzyme immuno assay, Western Blot and polymerase chain reaction, it was found that 201 (53%) were HTLV-I positive and 50 (13%) were infected with HTLV-II. Thirty-seven (74%) of the HTLV-II reactors were co-infected with HIV-1. Of the 13 (26%) solely HTLV-II-infected subjects, urinary tract infection was diagnosed in three (23%), one case of skin vasculitis (8%) and two cases of lumbar pain and erectile dysfunction (15%), but none myelopathy case was observed. Among 37 co-infected with HIV-1, four cases (10%) presented with tropical spastic paraparesis/HTLV-associated myelopathy (TSP/HAM) simile. Two patients showed paraparesis as the initial symptom, two cases first presented with vesical and erectile disturbances, peripheral neuropathies were observed in other five patients (13%), and seven (19%) patients showed some neurological signal or symptoms, most of them with lumbar pain (five cases). The results obtained suggest that neurological manifestations may be more frequent in HTLV-II/HIV-1-infected subjects than those infected with HTLV-II only.
Resumo:
Feldspato é o nome dado a uma importante família de minerais, do grupo dos tectossilicatos, que compõem o material rochoso de mais de 60% da crusta terrestre. Estes minerais são constituintes essenciais da maior parte das rochas cristalinas e a sua importância é tal que o seu estudo constitui um capítulo fundamental da petrografia. Dada a sua grande incidência na crusta terrestre, os feldspatos ocorrem em diversos cenários geológicos, desde os depósitos pegmatitos, aos aplitos, granitos, sienitos nefelínicos e ainda areias feldspáticas. As suas características químicas, físicas e mineralógicas fazem com que este grupo de minerais esteja presente nas mais diversificadas indústrias, tais como a vidreira, cerâmica, tintas, borrachas, plásticos, abrasivos ligeiros, elétrodos de soldadura, entre outros. Em Portugal, as principais unidades produtoras de feldspatos encontram‐se distribuídas pelo Norte e Centro do país, mais concretamente pelos distritos de Viana do Castelo, Braga, Vila Real, Porto, Viseu e Guarda. Novos estudos geológicos acompanhados de prospeções, nomeadamente na região do maciço central, têm sido efetuados com vista à descoberta de novos depósitos com potencial para exploração deste importante mineral. O depósito aplítico da Argemela, no concelho do Fundão apresenta‐se como um depósito cujas dimensões e qualidade apresentadas indicam a possibilidade de exploração. Nesse sentido, o presente trabalho consiste em analisar e caracterizar os materiais presentes na quele depósito mineral, tendo em vista a respectiva aplicação industrial, e posteriormente propor uma instalação de processamento do material para que o mesmo seja comercializado. Também será objeto deste trabalho a análise da viabilidade económica do projeto, mais concretamente fazendo a previsão do investimento inicial de modo a somar os custos de produção correntes e avaliar o retorno com base na comercialização do material no modo “Ex Works”.
Resumo:
This paper reports a toxoplasmosis, erhlichiosis and distemper co-infection in a dog with an exuberant neuropathological clinical picture. Primary involvement was discussed based on information collected in the analysis of the clinical case, such as neurological impairment, epidemiological data, poor immunoprophylactic scheme of the dog affected and the role of these diseases on immunosuppression. Canine distemper and ehrlichiosis were diagnosed based on epidemiologic data, clinical signs, hematological and cytological evaluation. Toxoplasma gondii was isolated and genetically characterized as Type I using restriction analysis (RFLP) with SAG-2 genes. Immunosuppression features of both dogs and human beings are discussed, as well as implications on animal and public health. This is the first report on toxoplasmosis, ehrlichiosis and distemper co-infection in a dog in Brazil, associated with genotyping determination of the T. gondii strain involved.
Resumo:
As ligações adesivas são frequentemente utilizadas na fabricação de estruturas complexas que não poderiam ou não seriam tão fáceis de ser fabricadas numa só peça, a fim de proporcionar uma união estrutural que, teoricamente, deve ser pelo menos tão resistente como o material de base. As juntas adesivas têm vindo a substituir métodos como a soldadura, e ligações parafusadas e rebitadas, devido à facilidade de fabricação, menor custo, facilidade em unir materiais diferentes, melhor resistência, entre outras características. Os materiais compósitos reforçados com fibra de carbono são amplamente utilizados em muitas indústrias, tais como de construção de barcos, automóvel e aeronáutica, sendo usados em estruturas que requerem elevada resistência e rigidez específicas, o que reduz o peso dos componentes, mantendo a resistência e rigidez necessárias para suportar as diversas cargas aplicadas. Embora estes métodos de fabricação reduzam ao máximo as ligações através de técnicas de fabrico avançadas, estas ainda são necessárias devido ao tamanho dos componentes, limitações de projecto tecnológicas e logísticas. Em muitas estruturas, a combinação de compósitos com metais tais como alumínio ou titânio traz vantagens de projecto. Este trabalho tem como objectivo estudar, experimentalmente e por modelos de dano coesivo (MDC), juntas adesivas em L entre componentes de alumínio e compósito de carbono epóxido quando solicitados a forças de arrancamento, considerando diferentes configurações de junta e adesivos de ductilidade distinta. Os parâmetros geométricos abordados são a espessura do aderente de alumínio (tP2) e comprimento de sobreposição (LO). A análise numérica permitiu o estudo da distribuição das tensões, evolução do dano, resistência e modos de rotura. Os testes experimentais validam os resultados numéricos e fornecem mecanismos de projecto para juntas em L. Foi mostrado que a geometria do aderente em L (alumínio) e o tipo de adesivo têm uma influência directa na resistência de junta.
Resumo:
Dissertação apresentada como requisito parcial para obtenção do grau de Mestre em Gestão de Informação
Resumo:
A role for proteolytic bacteria in the exacerbation of influenza virus has been shown in natural hosts such as pigs and humans. Four hundred seven samples were collected from the respiratory tract of individuals presenting clinical manifestations, during influenza season (2003-2005) in São Paulo City. The aim of this study was to evaluate the incidence of determined bacteria co-infecting virus in human respiratory tract. Tests, such as bacteriological, immunofluorescence (IF), RT/PCR and hemagglutination (HA) were used for bacterial and viral investigation. Thirty seven (9.09%) positive for influenza virus were screened by IF. The RT/PCR confirmed the presence of influenza virus in these samples. Bacterial and agar casein tests demonstrated that 18 (48.64%) individuals were infected with proteolytic bacteria such as Staphylococcus spp., Streptococcus spp. and Pseudomonas spp. Among these samples, 13 (35.13%) were co-infected with influenza A virus. Influenza type B, co-infecting bacteria were found in five (13.51%) samples. In vitro the S. aureus protease increased the influenza HA titer after contact for 30 min at 25 ºC. Results revealed the occurrence of co-infection with proteolytic bacteria and influenza in the evaluated individuals. This finding corroborates that virus versus bacteria synergism could be able to potentiate respiratory infection, increasing damage to hosts.