Determination of sulfate in ethanol fuel using an electrode chemically modified with polypyrrole by flow injection analysis

In this work, an electrode chemically modified with polypyrrole (PCME) was employed for determination of sulfate in ethanol fuel using a FIA system. The PCME was prepared by polymerization of pyrrole at a glassy carbon electrode by means of cyclic voltammetry technique. An analytical curve from 1.0 x 10−5 to 8.0 x 10−5 mol L−1 was obtained in flow injection system based on the PCME. An amperometric sensibility of 2.3 x 10−3 A mol−1 L and a detection limit of 2.5 x 10−6 mol L−1 were achieved. The proposed method was employed for determination of sulfate ions in commercial samples of ethanol fuel. The results were in good agreement with those obtained by the ionic chromatographic method.

Gold electrodes from recordable CDs for mercury quantification by flow injection analysis

The development of a new methodology for the construction of very efficient flow cells for mercury detection by potentiometric stripping analysis, employing the thin gold layer of recordable CDs as working electrode is reported. This new source of electrodes (CDtrodes) show very attractive performance, similar to that obtained with commercial gold electrodes, with superior versatility. The low cost of this new source of gold electrodes allows a frequent replacement of the electrode, avoiding cumbersome clean-up treatments. Various experimental parameters have been optimized to yield low detection limits (0.25 ng/mL of mercury for 5 min deposition at 0.3 V) and good precision (standard deviation of 1.9% was obtained for 15 repetitive measurements using 10 ng/mL of mercury). Standard curves were found to be linear over the range of 0.5-100 μg L-1 of mercury. The flow cells developed were used for the quantification of mercury in oceanic and tap water. © Springer-Verlag 2000.

Flow injection analysis of free glycerol in biodiesel using a copper electrode as an amperometric detector

The main goal of this work was to develop a simple analytical method for quantification of glycerol based on the electrocatalytic oxidation of glycerol on the copper surface adapted in a flow injection system. Under optimal experimental conditions, the peak current response increases linearly with glycerol concentration over the range 60-3200 mg kg(-1) (equivalent to 3-160 mg L(-1) in solution). The repeatability of the electrode response in the flow injection analysis (FIA) configuration was evaluated as 5% (n = 10), and the detection limit of the method was estimated to be 5 mg kg(-1) in biodiesel (equivalent to 250 mu g L(-1) in solution) (S/N = 3). The sample throughput under optimised conditions was estimated to be 90 h(-1). Different types of biodiesel samples (B100), as in the types of vegetable oils or animal fats used to produce the fuels, were analysed (seven samples). The only sample pre-treatment used was an extraction of glycerol from the biodiesel sample containing a ratio of 5 mL of water to 250 mg of biodiesel. The proposed method improves the analytical parameters obtained by other electroanalytical methods for quantification of glycerol in biodiesel samples, and its accuracy was evaluated using a spike-and-recovery assay, where all the biodiesel samples used obtained admissible values according to the Association of Official Analytical Chemists. Crown Copyright (C) 2011 Published by Elsevier Ltd. All rights reserved.

Female-biased sex ratios in marine pelagic copepods: Response to Hirst et al. (2013)

Hirst et al. (2013; Mar Ecol Prog Ser 489:297-298) suggest that Gusmão et al. (2013; Mar Ecol Prog Ser 482:279-298) misinterpreted the findings of Hirst et al. (2010; Limnol Oceanogr 55:2193-2206). They restate that the major factors determining sex ratio in pelagic copepods act upon the adult stage, but they place less emphasis on the idea that predation on male copepods is a likely determinant, and highlight the role of physiological longevity. Here we reconsider the data and confirm our position that at present there is limited evidence to support the theory of male-skewed predation. However, we agree that sex determination is governed by a combination of factors, with the relative emphasis being the main point of contention between the 2 parties.

Effects of diets, with different levels of n-3 HUFA, designed specifically for gilthead seabream (Sparus auratus L.) broodstock on spawning quality

The effects of dietary lipid levels in the spawning quality has been studied in several cultured fish species. Works like those of Watanabe et al. (1984 a); Mourente et al. (1989); Dhert et al. (1991); Bruce et al. (1993); Navas et al. (1997); Rodriguez et al. (1998); Lavens et al. (1999); Furuita et al. (2002, 2003 b); Mazorra et al. (2003); Fernandez- Palacios (2005) and Aijun et al. (2005) show that lipids and fatty acids are the dietetic components that have more influence in the spawning quality, specially in those species with continuous spawning which display short vitellogenesis periods and are able to incorporate these dietetic components in eggs during the spawning period. Diets for gilthead sea bream (Sparus aurata) broodstock with dietary levels of 2.84% n-3 HUFA, combined with levels of 250 mg/kg vitamine E rasure good spawning quality. Putting so indicative the importance for an effective utilization of essential fatty acids the use of adequate levels of antioxidants.

Distribución y seguimiento de Dictyota cyanoloma Tronholm et al. en las costas mediterráneas españolas

Laboratori de Botànica, Facultat de Farmàcia, Universitat de Barcelona

Automated Analysis Methods for the Assessment of Bicycle Infrastructure and Demand

A first phase of the research activity has been related to the study of the state of art of the infrastructures for cycling, bicycle use and methods for evaluation. In this part, the candidate has studied the "bicycle system" in countries with high bicycle use and in particular in the Netherlands. Has been carried out an evaluation of the questionnaires of the survey conducted within the European project BICY on mobility in general in 13 cities of the participating countries. The questionnaire was designed, tested and implemented, and was later validated by a test in Bologna. The results were corrected with information on demographic situation and compared with official data. The cycling infrastructure analysis was conducted on the basis of information from the OpenStreetMap database. The activity consisted in programming algorithms in Python that allow to extract data from the database infrastructure for a region, to sort and filter cycling infrastructure calculating some attributes, such as the length of the arcs paths. The results obtained were compared with official data where available. The structure of the thesis is as follows: 1. Introduction: description of the state of cycling in several advanced countries, description of methods of analysis and their importance to implement appropriate policies for cycling. Supply and demand of bicycle infrastructures. 2. Survey on mobility: it gives details of the investigation developed and the method of evaluation. The results obtained are presented and compared with official data. 3. Analysis cycling infrastructure based on information from the database of OpenStreetMap: describes the methods and algorithms developed during the PhD. The results obtained by the algorithms are compared with official data. 4. Discussion: The above results are discussed and compared. In particular the cycle demand is compared with the length of cycle networks within a city. 5. Conclusions

Aerobic biodegradation of chlorinated solvents and plastics in batch and continuous-flow bioreactors: process development, and identification of suitable chemical pre-Treatments

The purpose of the first part of the research activity was to develop an aerobic cometabolic process in packed bed reactors (PBR) to treat real groundwater contaminated by trichloroethylene (TCE) and 1,1,2,2-tetrachloroethane (TeCA). In an initial screening conducted in batch bioreactors, different groundwater samples from 5 wells of the contaminated site were fed with 5 growth substrates. The work led to the selection of butane as the best growth substrate, and to the development and characterization from the site’s indigenous biomass of a suspended-cell consortium capable to degrade TCE with a 90 % mineralization of the organic chlorine. A kinetic study conducted in batch and continuous flow PBRs and led to the identification of the best carrier. A kinetic study of butane and TCE biodegradation indicated that the attached-cell consortium is characterized by a lower TCE specific degredation rates and by a lower level of mutual butane-TCE inhibition. A 31 L bioreactor was designed and set up for upscaling the experiment. The second part of the research focused on the biodegradation of 4 polymers, with and with-out chemical pre-treatments: linear low density polyethylene (LLDPE), polyethylene (PP), polystyrene (PS) and polyvinyl chloride (PVC). Initially, the 4 polymers were subjected to different chemical pre-treatments: ozonation and UV/ozonation, in gaseous and aqueous phase. It was found that, for LLDPE and PP, the coupling UV and ozone in gas phase is the most effective way to oxidize the polymers and to generate carbonyl groups on the polymer surface. In further tests, the effect of chemical pretreatment on polyner biodegrability was studied. Gas-phase ozonated and virgin polymers were incubated aerobically with: (a) a pure strain, (b) a mixed culture of bacteria; and (c) a fungal culture, together with saccharose as a co-substrate.

Prozessevaluation einer kognitiv-verhaltenstherapeutischen Gruppentherapie bei Diabetes und Depression : Entwicklung und Validierung der Patienten- und Therapeuten- Gruppentherapiestundenbögen (GTS-P, GTS-T, GTS-TP) zur Vorhersage des Therapieerfolgs

Untersucht werden Prozess-Ergebnis-Zusammenhänge einer kognitiv-verhaltenstherapeutischen Gruppentherapie für Diabetes und Depression im Rahmen der DAD-Studie. rnAufgrund des Mangels an geeigneten Erhebungsinstrumenten der validen, ökonomischen und komplementären Sitzungsbewertung von Gruppenpatienten und -therapeuten wurden angelehnt an einen Patienten- (GTS-P) zwei Therapeutenstundenbögen entwickelt: der GTS-T zur Bewertung der Gesamtgruppe und der GTS-TP zur Bewertung einzelner Patienten. Die GTS-Bögen zeigen bei der Überprüfung der Testgüte insgesamt gute Itemparameter und Reliabilitäten. Das in den exploratorischen Faktorenanaylsen des GTS-P identifizierte zweifaktorielle Modell (1. wahrgenommene Zuversicht hinsichtlich der Gruppentherapie, 2. wahrgenommene persönliche Beteiligung) kann in den konfirmatorischen Faktorenanalysen bestätigt werden. Dazu wurden GTS-P-Daten aus einer Untersuchung mit Patienten mit somatoformen Störungen (Schulte, 2001) einbezogen. Den Ergebnissen der Item- und Faktorenanalysen folgend, wurden zwei Items des GTS-P und zwei weitere Items des GTS-T aus den Instrumenten ausgeschlossen. Für den GTS-T zeigt sich eine einfaktorielle, für den GTS-TP eine zum GTS-P parallele zweifaktorielle Struktur. rnIn den Mehrebenenanalysen zur Vorhersage des Therapieergebnisses (Post-Depressionssymptomatik) zeigt sich die Skala Zuversicht des GTS-P zu Therapiebeginn (1.-4. Sitzung) kontrolliert an der Skala Beteiligung und der Prä-Symptomatik, als valider Prädiktor. Das Item 5 „Anregungen“ (Skala Zuversicht) und Item 2 „Aktive Mitwirkung“ (Skala Beteiligung) sind am stärksten an diesem Effekt beteiligt, da diese Itemkombination das Therapieergebnis ebenfalls valide vorhersagen kann. Die Prognose ist schon durch die Werte der ersten Gruppentherapiesitzungen in der Remoralisierungsphase (Howard et al., 1993) möglich und verbessert sich nicht bei Berücksichtigung aller 10 Gruppensitzungen. Die Therapeutenbögen zeigen keine prädiktive Validität. Bedeutsame Zusammenhänge der Patienten- und Therapeutenbewertungen finden sich lediglich für den GTS-P und GTS-TP. Weitere Prädiktoren, wie der Diabetestyp, Diabeteskomplikationen und die Adhärenz, konnten nicht zur Verbesserung der Vorhersage beitragen. Für sekundär überprüfte Kriterien gelang die Prognose lediglich für ein weiteres Maß der Depressionssymptomatik und für eine Gesamtbewertung der Gruppentherapie durch die Patienten zu Therapieende. Bei der deskriptiven Betrachtung der Prozessqualität der DAD-Gruppentherapien zeigen sich positive, über den Verlauf der Gruppe zunehmende und nach Therapiephasen differenzierbare Bewertungsverläufe. rnDie Ergebnisse der Studie sprechen für die Relevanz von unspezifischen Wirkfaktoren für das Therapieergebnis von kognitiv-behavioralen Gruppentherapien. Die von den Gruppenpatienten wahrgenommene Zuversicht und Beteiligung als Zeichen der Ansprechbarkeit auf die Therapie sollte mit Hilfe von Stundenbögen, wie den GTS-Bögen, von Gruppentherapeuten zur Prozessoptimierung und Prävention von Therapieabbrüchen und Misserfolgen beachtet werden. rn

From anionic polymerization in continuous flow to macromolecular architectures and stimuli-responsive surfaces

The thesis can be divided in four parts and summarized as follows:(i) The investigation and development of a continuous flow synthesis procedure affording end-functional polymers by anionic polymerization and subsequent termination in one reaction step and on a multigram scale was carried out. Furthermore, the implementation of not only a single hydroxyl but multiple orthogonal functionalities at the chain terminus was achieved by utilizing individually designed, functional epoxide-based end-capping reagents.(ii) In an additional step, the respective polymers were used as macroinitiators to prepare in-chain functionalized block copolymers and star polymers bearing intriguing novel structural and material properties. Thus, the second part of this thesis presents the utilization of end-functional polymers as precursors for the synthesis of amphiphilic complex and in some cases unprecedented macromolecular architectures, such as miktoarm star polymers based on poly(vinyl pyridine), poly(vinyl ferrocene) and PEO.(iii) Based on these structures, the third part of this thesis represents a detailed investigation of the preparation of stimuli-responsive ultrathin polymer films, using amphiphilic junction point-reactive block copolymers. The single functionality at the block interface can be employed as anchor group for the covalent attachment on surfaces. Furthermore, the change of surface properties was studied by applying different external stimuli.(iv) An additional topic related to the oxyanionic polymerizations carried out in the context of this thesis was the investigation of viscoelastic properties of different hyperbranched polyethers, inspired by the recent and intense research activities in the field of biomedical applications of multi-functional hyperbranched materials.