High quantum efficiency and high concentration erbium-doped silica glasses fabricated by sintering nanoporous glasses

A new method was used to prepare erbium-doped high silica (SiO2% > 96%) glasses by sintering nanoporous glasses. The concentration of erbium ions in high silica glasses can be considerably more than that in silica glasses prepared by using conventional methods. The fluorescence of 1532 nm has an FWHM (Full Wave at Half Maximum) of 50 nm, wider than 35 nm of EDSFA (erbium-doped silica fiber amplifer), and hence the glass possesses potential application in broadband fiber amplifiers. The Judd-Ofelt theoretical analysis reflects that the quantum efficiency of this erbium-doped glass is about 0.78, although the erbium concentration in this glass (6 x 103) is about twenty times higher than that in silica glass. These excellent characteristics of Er-doped high silica glass will be conducive to its usage in optical amplifiers and microchip lasers.

Ti:sapphire laser pumped high average power laser crystal Nd:GGG with high efficiency output

High-quality neodymium doped GGG laser crystals have been grown by Czochralski (Cz) method. Results of Nd:GGG thin chip laser operating at 1.064 μm pumped by Ti:sapphire laser operating at 808 nm were reported. The slop efficiency was as high as 20%.

Note sur les premiers essais de capture du crabe profond Geryon quinquedens en Côte d'Ivoire

First experiments to trap the deep sea red crab Geryon quinquedens off Côte d'Ivoire have had good success. The yields obtained are similar to those observed off the northeastern coast of the United States and off Angola, where commercial fisheries have been developed for some years.

Design of high-efficiency diffraction gratings based on total internal reflection for pulse compressor

We present designs of high-efficiency compression grating based on total internal reflection (TIR) for picosecond pulse laser at 1053 nm. The setup is devised by directly etching gratings into the bottom side of a prism so that light can successfully enter (or exit) the compression grating. Dependence of the -1 order diffraction efficiencies on the constructive parameters is analyzed for TE- and TM-polarized incident light at Littrow angle by using Fourier modal method in order to obtain optimal grating structure. The electric field enhancement within the high-efficiency TIR gratings is regarded as another criterion to optimize the structure of the TIR gratings. With the criterion of high diffraction efficiency, low electric field enhancement and sufficient manufacturing latitude, TIR compression gratings with optimized constructive parameters are obtained for TE- and TM-polarized incident light, respectively. The grating for TE-polarized light exhibits diffraction efficiencies higher than 0.95 within 23 nm bandwidth and relatively low square of electric field enhancement ratio of 5.7. Regardless of the internal electric field enhancement, the grating for TM-polarized light provides diffraction efficiencies higher than 0.95 within 42 nm bandwidth. With compact structure, such TIR compression gratings made solely of fused silica should be of great interest for application to chirped pulse amplification (CPA) systems. (c) 2007 Elsevier B.V. All rights reserved.

Design of high-efficiency diffraction gratings based on rigorous coupled-wave analysis for 800nm wavelength

We report on the design of a high diffraction efficiency multi-layer dielectric grating with wide incident angle and broad bandwidth for 800 nm. The optimized grating can achieve > 95% diffraction efficiency in the first order at an incident angle of 5 degrees from Littrow and a wavelength from 770nm to 830 nm, with peak diffraction efficiency of > 99.5% at 800 nm. The electric field distribution of the optimized multi-layer dielectric grating within the gratings ridge is 1.3 times enhancement of the incidence light, which presents potential high laser resistance ability. Because of its high-efficiency, wide incident, broad bandwidth and potential high resistance ability, the multi-layer dielectric grating should have practical application in Ti:sapphire laser systems.

Efficiency improvement of organic light-emitting diodes using 8-hydroxy-quinolinato lithium as an electron injection layer

Organic light-emitting diodes (OLEDs) using tris-(8-hydroxy-quinolinato) aluminum (Alq(3)) as an emitter, 8-hydroxy-quinolinato lithium (Liq) as an electron injection layer, were prepared. Experimental results show that the efficiency of device with Liq is three times higher than that without Liq. The device using Liq as an injection layer is less sensitive in efficiency to the Liq thickness than that using LiF. In addition to the Alq3 based devices, Liq is also very effective as an electron injection layer for 4,4'-bis(2,2-diphenylvinyl)-1,1'-biphenyl based blue OLED and poly (2-methoxy,5-(2-ethyl-hexyloxy)-1,4-phenylenevinylene) based orange polymer OLED. (c) 2004 Elsevier B.V. All rights reserved.

Effects of lunar cycle and fishing operations on longline-caught pelagic fish: fishing performance, capture time, and survival of fish

Commercial longline fishing data were analyzed and experiments were conducted with gear equipped with hook timers and timedepth recorders in the Réunion Island fishery (21°5ʹS lat., 53°28ʹE long.) to elucidate direct and indirect effects of the lunar cycle and other operational factors that affect catch rates, catch composition, fish behavior, capture time, and fish survival. Logbook data from 1998 through 2000, comprising 2009 sets, indicated that swordfish (Xiphias gladius) catch-per unit of effort (CPUE) increased during the first and last quarter of the lunar phase, whereas albacore (Thunnus alalunga) CPUE was highest during the full moon. Swordfish were caught rapidly after the longline was set and, like bigeye tuna (Thunnus obesus), they were caught during days characterized by a weak lunar illumination—mainly during low tide. We found a significant but very low influence of chemical lightsticks on CPUE and catch composition. At the time the longline was retrieved, six of the 11 species in the study had >40% survival. Hook timers indicated that only 8.4% of the swordfish were alive after 8 hours of capture, and two shark species (blue shark [Prionace glauca] and oceanic whitetip shark [Carcharhinus longimanus]) showed a greater resilience to capture: 29.3% and 23.5% were alive after 8 hours, respectively. Our results have implications for current fishing practices and we comment on the possibilities of modifying fishing strategies in order to reduce operational costs, bycatch, loss of target fish at sea, and detrimental impacts on the environment.

Statistical inference about the relative efficiency of a new survey protocol, based on paired-tow survey calibration data

Paired-tow calibration studies provide information on changes in survey catchability that may occur because of some necessary change in protocols (e.g., change in vessel or vessel gear) in a fish stock survey. This information is important to ensure the continuity of annual time-series of survey indices of stock size that provide the basis for fish stock assessments. There are several statistical models used to analyze the paired-catch data from calibration studies. Our main contributions are results from simulation experiments designed to measure the accuracy of statistical inferences derived from some of these models. Our results show that a model commonly used to analyze calibration data can provide unreliable statistical results when there is between-tow spatial variation in the stock densities at each paired-tow site. However, a generalized linear mixed-effects model gave very reliable results over a wide range of spatial variations in densities and we recommend it for the analysis of paired-tow survey calibration data. This conclusion also applies if there is between-tow variation in catchability.

Catches in ghost-fishing octopus and fish traps in the northeastern Atlantic Ocean (Algarve, Portugal)

Ghost fishing is the term used to describe the continued capture of fish and other living organisms after a fisherman has lost all control over the gear. Traps may be lost for a variety of reasons including theft, vandalism, abandonment, interactions with other gear, fouling on the bottom (i.e., traps and ropes are caught on rocky substrate), bad weather, and human error (Laist, 1995). Annual trap loss can be as high as 20% to 50% of fished traps in some fisheries (Al-Masroori et al., 2004). Because lost traps can continue to fish for long periods, albeit with decreasing efficiency over time (e.g., Smolowitz, 1978; Breen, 1987, 1990; Guillory, 1993), ghost fishing is a concern in fisheries worldwide.