Evaluation of the 3D symmetry of the knees when walking using na ambulatory inertia system: results 14 months after ACL Plasty.

Purpose of the study: Reconstruction of the anterior cruciate ligament (ACL) controls laxity but does not enable restoration of strictly normal 3D kinematics. The purpose of this study was to compare the kinematics of the pathological knee with that of the healthy knee after ACL plasty. This study applied a new ambulatory system using miniature captors. Material and method: Five patients with an isolated injury of the ACL participated in this study. The patients were assessed after injury (T1), at five months (T2), and at 14 months (T3) after surgery. The assessment included laxity (KT-1000), the IKDC score and the Lysholm score. The 3D angles of the knees were measured when walking 30 m on flat ground using a system composed of to small inertia units (3D accelerometer and 3D gyroscope) and a portable recorder. Functional settings were optimised and validating to ensure easy precise measurement of the 3D angles. Symmetry of the two knees was quantified using a symmetry index (SI) (difference in amplitude normalised in relation to mean amplitude) and the correlation coefficient CC. Results: Clinical indicators improved during the follow-up (IKDC T1: 3C, 2C; T2: 5B; T3: 2A, 3B; subjective IKD: 53-95; Lysholm 67-96). Mean laxity improved from 8.6m to 2.5 mm. The gait analysis showed increased symmetry in terms of amplitude for flexion-extension (SI: −17% at T1, −1% at T2, 1% at T3), and an increase in symmetry in terms of the rotation signature (CC: 0.16 at T1, 0.99 at T2, 0.99 at T3). There was no trend to varus-valgus. Discussion: This study demonstrates the clinical application of the new ambulatory system for measuring 3D angles of the knee joint. Joint symmetry increased after ACL plasty but still showed some perturbation at 14 months. The results observed here are in agreement with the literature. Other patients and other types of gait are being analysed. Conclusion: This portable system allows gait analysis outside the laboratory, before and after ACL injury. It is very useful for follow-up after surgery.

Simulation des caractéristiques ECG du syndrome de Brugada à l'aide d'un programme de modélisation 3D

Introduction : Le syndrome de Brugada, décrit en 1992 par Pedro et Josep Brugada, est un syndrome cardiaque caractérisé par un sus-décalage particulier du segment ST associé à un bloc de branche droit atypique au niveau des dérivations ECG V1 à V3. Les altérations ECG du syndrome de Brugada sont classifiées en 3 types dont seul le type 1 est diagnostique. Les mécanismes physiopathologiques exacts de ce syndrome sont pour le moment encore controversés. Plusieurs hypothèses sont proposées dans la littérature dont deux principales retiennent l'attention : 1) le modèle du trouble de repolarisation stipule des potentiels d'action réduits en durée et en amplitude liés à un changement de répartition de canaux potassiques 2) le modèle du trouble de dépolarisation spécifie un retard de conduction se traduisant par une dépolarisation retardée. Dans le STEMI, un sus-décalage ST ressemblant à celui du syndrome de Brugada est expliqué par deux théories : 1) le courant de lésion diastolique suggère une élévation du potentiel diastolique transformé artificiellement en sus-décalage ST par les filtres utilisés dans tous les appareils ECG.¦Objectif : Recréer les manifestations ECG du syndrome de Brugada en appliquant les modifications du potentiel d'action des cardiomyocytes rapportées dans la littérature.¦Méthode : Pour ce travail, nous avons utilisé "ECGsim", un simulateur informatique réaliste d'ECG disponible gratuitement sur www.ecgsim.org. Ce programme est basé sur une reconstruction de l'ECG de surface à l'aide de 1500 noeuds représentant chacun les potentiels d'action des ventricules droit et gauche, épicardiques et endocardiques. L'ECG simulé peut être donc vu comme l'intégration de l'ensemble de ces potentiels d'action en tenant compte des propriétés de conductivité des tissus s'interposant entre les électrodes de surface et le coeur. Dans ce programme, nous avons définit trois zones, de taille différente, comprenant la chambre de chasse du ventricule droit. Pour chaque zone, nous avons reproduit les modifications des potentiels d'action citées dans les modèles du trouble de repolarisation et de dépolarisation et des théories de courant de lésion systolique et diastolique. Nous avons utilisé, en plus des douze dérivations habituelles, une électrode positionnée en V2IC3 (i.e. 3ème espace intercostal) sur le thorax virtuel du programme ECGsim.¦Résultats : Pour des raisons techniques, le modèle du trouble de repolarisation n'a pas pu être entièrement réalisée dans ce travail. Le modèle du trouble de dépolarisation ne reproduit pas d'altération de type Brugada mais un bloc de branche droit plus ou moins complet. Le courant de lésion diastolique permet d'obtenir un sus-décalage ST en augmentant le potentiel diastolique épicardique des cardiomyocytes de la chambre de chasse du ventricule droit. Une inversion de l'onde T apparaît lorsque la durée du potentiel d'action est prolongée. L'amplitude du sus-décalage ST dépend de la valeur du potentiel diastolique, de la taille de la lésion et de sa localisation épicardique ou transmurale. Le courant de lésion systolique n'entraîne pas de sus-décalage ST mais accentue l'amplitude de l'onde T.¦Discussion et conclusion : Dans ce travail, l'élévation du potentiel diastolique avec un prolongement de la durée du potentiel d'action est la combinaison qui reproduit le mieux les altérations ECG du Brugada. Une persistance de cellules de type nodal au niveau de la chambre de chasse du ventricule droit pourrait être une explication à ces modifications particulières du potentiel d'action. Le risque d'arythmie dans la Brugada pourrait également être expliqué par une automaticité anormale des cellules de type nodal. Ainsi, des altérations des mécanismes cellulaires impliqués dans le maintien du potentiel diastolique pourraient être présentes dans le syndrome de Brugada, ce qui, à notre connaissance, n'a jamais été rapporté dans la littérature.

Comparability of clinical wear measurements by optical 3D laser scanning in two different centers.

OBJECTIVE: The purpose of this study was to compare the use of different variables to measure the clinical wear of two denture tooth materials in two analysis centers. METHODS: Twelve edentulous patients were provided with full dentures. Two different denture tooth materials (experimental material and control) were placed randomly in accordance with the split-mouth design. For wear measurements, impressions were made after an adjustment phase of 1-2 weeks and after 6, 12, 18, and 24 months. The occlusal wear of the posterior denture teeth of 11 subjects was assessed in two study centers by use of plaster replicas and 3D laser-scanning methods. In both centers sequential scans of the occlusal surfaces were digitized and superimposed. Wear was described by use of four different variables. Statistical analysis was performed after log-transformation of the wear data by use of the Pearson and Lin correlation and by use of a mixed linear model. RESULTS: Mean occlusal vertical wear of the denture teeth after 24 months was between 120μm and 212μm, depending on wear variable and material. For three of the four variables, wear of the experimental material was statistically significantly less than that of the control. Comparison of the two study centers, however, revealed correlation of the wear variables was only moderate whereas strong correlation was observed among the different wear variables evaluated by each center. SIGNIFICANCE: Moderate correlation was observed for clinical wear measurements by optical 3D laser scanning in two different study centers. For the two denture tooth materials, wear measurements limited to the attrition zones led to the same qualitative assessment.

Gestión y visualización de museos virtuales 3d en línea

Esta aplicación constará de una herramienta para administradores que permitirá ver una sala de exposiciones virtual vacía, y una biblioteca de obras de arte; se podrán añadir y quitar obras de la sala de exposiciones arrastrándolas de/a la biblioteca, creando así galerías de arte virtuales. Estas galerías se podrán visualizar por cualquier persona con un explorador web.

High-resolution selective three-dimensional magnetic resonance coronary angiography with navigator-echo technique: segment-by-segment evaluation of coronary artery stenosis.

PURPOSE: To investigate the feasibility of high-resolution selective three-dimensional (3D) magnetic resonance coronary angiography (MRCA) in the evaluation of coronary artery stenoses. MATERIALS AND METHODS: In 12 patients with coronary artery stenoses, MRCA of the coronary artery groups, including the coronary segments with stenoses of 50% or greater based on conventional x-ray coronary angiography (CAG), was performed with double-oblique imaging planes by orienting the 3D slab along the major axis of each right coronary artery-left circumflex artery (RCA-LCX) group and each left main trunk-left anterior descending artery (LMT-LAD) group. Ten RCA-LCX and five LMT-LAD MR angiograms were obtained, and the results were compared with those of conventional x-ray angiography. RESULTS: Among 70 coronary artery segments expected to be covered, a total of 49 (70%) segments were fully demonstrated in diagnostic quality. The identification of segmental location of stenoses showed as high an accuracy as 96%. The retrospective analysis for stenosis of 50% or greater yielded the sensitivity, specificity, and accuracy of 80%, 85%, and 84%, respectively. CONCLUSION: Selective 3D MRCA has the potential for segment-by-segment evaluation of major portions of the right and left coronary arteries with high accuracy.

Imaging and quantifying salt-tracer transport in a riparian groundwater system by means of 3D ERT monitoring

Determining groundwater flow paths of infiltrated river water is necessary for studying biochemical processes in the riparian zone, but their characterization is complicated by strong temporal and spatial heterogeneity. We investigated to what extent repeat 3D surface electrical resistance tomography (ERT) can be used to monitor transport of a salt-tracer plume under close to natural gradient conditions. The aim is to estimate groundwater flow velocities and pathways at a site located within a riparian groundwater system adjacent to the perialpine Thur River in northeastern Switzerland. Our ERT time-lapse images provide constraints on the plume's shape, flow direction, and velocity. These images allow the movement of the plume to be followed for 35 m. Although the hydraulic gradient is only 1.43 parts per thousand, the ERT time-lapse images demonstrate that the plume's center of mass and its front propagate with velocities of 2x10(-4) m/s and 5x10(-4) m/s, respectively. These velocities are compatible with groundwater resistivity monitoring data in two observation wells 5 m from the injection well. Five additional sensors in the 5-30 m distance range did not detect the plume. Comparison of the ERT time-lapse images with a groundwater transport model and time-lapse inversions of synthetic ERT data indicate that the movement of the plume can be described for the first 6 h after injection by a uniform transport model. Subsurface heterogeneity causes a change of the plume's direction and velocity at later times. Our results demonstrate the effectiveness of using time-lapse 3D surface ERT to monitor flow pathways in a challenging perialpine environment over larger scales than is practically possible with crosshole 3D ERT.

Mecano Virtual 3D

L'objectiu principal d'aquest projecte és crear un mecano virtual amb el qual l'usuari pugui manipular peces per a fer un muntatge i que pugui retocar aquest muntatge com vulgui.

Selective three-dimensional visualization of the coronary arterial lumen using arterial spin tagging.

Conventional coronary magnetic resonance angiography (MRA) techniques display the coronary blood-pool along with the surrounding structures, including the myocardium, the ventricular and atrial blood-pool, and the great vessels. This representation of the coronary lumen is not directly analogous to the information provided by x-ray coronary angiography, in which the coronary lumen displayed by iodinated contrast agent is seen. Analogous "luminographic" data may be obtained using MR arterial spin tagging (projection coronary MRA) techniques. Such an approach was implemented using a 2D selective "pencil" excitation for aortic spin tagging in concert with a 3D interleaved segmented spiral imaging sequence with free-breathing, and real-time navigator technology. This technique allows for selective 3D visualization of the coronary lumen blood-pool, while signal from the surrounding structures is suppressed.

PANG 3D

El projecte consisteix en una versió 3D del famós joc Pang. El joc original va ser publicat per Mitchell, una companyia que ja no existeix, el 1989 en format COIN-OP1. Des de la seva data de publicació va representar un gran èxit de públic i de vendes per a la companyia, que en va treure algunes versions més.