Tooth wear and erosion: methodological issues in epidemiological and public health research and the future research agenda

This paper addresses methodological issues in the field of tooth wear and erosion research including the epidemiological indices, and identifies future work that is needed to improve knowledge about tooth wear and erosion.

Prosthetic rehabilitation and treatment outcome of partially edentulous patients with severe tooth wear: 3-years results

The purpose of this study was to report on the management and treatment outcomes of partially edentulous elderly patients with severe tooth wear.

Influence of curing rate on softening in ethanol, degree of conversion, and wear of resin composite

PURPOSE: To investigate the effect of curing rate on softening in ethanol, degree of conversion, and wear of resin composites. METHOD: With a given energy density and for each of two different light-curing units (QTH or LED), the curing rate was reduced by modulating the curing mode. Thus, the irradiation of resin composite specimens (Filtek Z250, Tetric Ceram, Esthet-X) was performed in a continuous curing mode and in a pulse-delay curing mode. Wallace hardness was used to determine the softening of resin composite after storage in ethanol. Degree of conversion was determined by infrared spectroscopy (FTIR). Wear was assessed by a three-body test. Data were submitted to Levene's test, one and three-way ANOVA, and Tukey HSD test (alpha = 0.05). Results: Immersion in ethanol, curing mode, and material all had significant effects on Wallace hardness. After ethanol storage, resin composites exposed to the pulse-delay curing mode were softer than resin composites exposed to continuous cure (P< 0.0001). Tetric Ceram was the softest material followed by Esthet-X and Filtek Z250 (P< 0.001). Only the restorative material had a significant effect on degree of conversion (P< 0.001): Esthet-X had the lowest degree of conversion followed by Filtek Z250 and Tetric Ceram. Curing mode (P= 0.007) and material (P< 0.001) had significant effect on wear. Higher wear resulted from the pulse-delay curing mode when compared to continuous curing, and Filtek Z250 showed the lowest wear followed by Esthet-X and Tetric Ceram.

Off-label use of misoprostol for labor induction: a nation-wide survey in Switzerland

Off-label use of drugs is frequent in obstetrical practice. No data however are available about nation-wide off-label use in obstetrics regarding frequency and patient information. The objective of our study was to assess the clinical practice of off-label use of misoprostol for labor induction.

A Dynamic Approach to Stakeholder Theory: A Case Study of Labor - Management Relations at General Motors

The purpose of this thesis is to identify areas for improvement in the current stakeholder management literature. The current stakeholder management theories were analyzed to determine their benefits and detriments. To determine how these theories work in a corporation, General Motors was selected as a single-case study to determine the patterns of stakeholder management over time. These patterns demonstrated the need for dynamic stakeholder management over time, with an emphasis on collaboration and the necessity of recognizing the greater stakeholder network surrounding the corporation. Proper stakeholder management in the early years of General Motors would have prevented its failure, while the organizational culture as a path-dependent variable made it difficult for General Motors to alter long-standing stakeholder relationships.

Do alpine skiers and snowboarders wear protective equipment more often after an accident?

QUESTIONS UNDER STUDY/PRINCIPLES: Analysis of changes in the behaviour of wearing protective equipment by alpine skiers and snowboarders after injury, performed at a level I trauma centre in Switzerland.

Wear of double crown systems: electroplated vs. casted female part

The wear of telescopic crowns is a common problem often reducing the patient's satisfaction with the denture and resulting in a renewal of the denture. The study aims to compare the wear behavior of conical crowns using electroplated copings (group E ) with standard telescopic crowns with cast female parts (group C).