Dopant extraction from scanning capacitance microscopy measurements of p-n junctions using combined inverse modeling and forward simulation

This article proposes a more accurate approach to dopant extraction using combined inverse modeling and forward simulation of scanning capacitance microscopy (SCM) measurements on p-n junctions. The approach takes into account the essential physics of minority carrier response to the SCM probe tip in the presence of lateral electric fields due to a p-n junction. The effects of oxide fixed charge and interface state densities in the grown oxide layer on the p-n junction samples were considered in the proposed method. The extracted metallurgical and electrical junctions were compared to the apparent electrical junction obtained from SCM measurements. (C) 2002 American Institute of Physics.

Techniques for detailed heat transfer measurements in cold supersonic blowdown tunnels using thermochromic liquid crystals

The paper presents methods for measurement of convective heat transfer distributions in a cold flow, supersonic blowdown wind tunnel. The techniques involve use of the difference between model surface temperature and adiabatic wall temperature as the driving temperature difference for heat transfer and no active heating or cooling of the test gas or model is required. Thermochromic liquid crystals are used for surface temperature indication and results presented from experiments in a Mach 3 flow indicate that measurements of the surface heat transfer distribution under swept shock wave boundary layer interactions can be made. (C) 2002 Elsevier Science Ltd. All rights reserved.

Boundary-layer transition measurements in hypervelocity flows in a shock tunnel

Experiments to investigate the transition process in hypervelocity boundary layers were performed in the T4 free-piston shock tunnel. An array of thin-film heat-transfer gauges was used to detect the location and extent of the transitional region on a 1500 mm long x 120 turn wide flat plate, which formed one of the walls of a duct. The experiments were performed in a Mach 6 flow of air with 6- and 12-MJ/kg nozzle-supply enthalpies at unit Reynolds numbers ranging from 1.6 x 10(6) to 4.9 x 10(6) m(-1). The results show that the characteristics typical of transition taking place through the initiation, growth, and merger of turbulent spots are evident in the heat-transfer signals. A 2-mm-high excrescence located 440 turn from the leading edge was found to be capable of generating a turbulent wedge within an otherwise laminar boundary layer at a unit Reynolds number of 2.6 x 10(6) m(-1) at the 6-MJ/kg condition. A tripping strip, located 100 mm from the leading edge and consisting of a line 37 teeth of 2 rum height equally spaced and spanning the test surface, was also found to be capable of advancing the transition location at the same condition and at the higher enthalpy condition.

Breeding for resistance to lentil Ascochyta blight

Ascochyta blight, caused by Ascochyta lentis , is one of the most globally important diseases of lentil. Breeding for host resistance has been suggested as an efficient means to control this disease. This paper summarizes existing studies of the characteristics and control of Ascochyta blight in lentil, genetics of resistance to Ascochyta blight and genetic variations among pathogen populations (isolates). Breeding methods for control of the disease are discussed. Six pathotypes of A. lentis have been reported. Many resistant cultivars/lines have been identified in both cultivated and wild lentil. Resistance to Ascochyta blight in lentil is mainly under the control of major genes, but minor genes also play a role. Current breeding programmes are based on crossing resistant and high-yielding cultivars and multilocation testing. Gene pyramiding, exploring slow blighting and partial resistance, and using genes present in wild relatives will be the methods used in the future. Identification of more sources of resistance genes, good characterization of the host-pathogen system, and identification of molecular markers tightly linked to resistance genes are suggested as the key areas for future study.

Minor genes are involved in ascochyta blight resistance in lentils

In addition to a gene with major effect, minor genes were found to contribute to the genetic regulation of foliar resistance to Ascochyta blight in two crosses between two resistant and one susceptible lentil cultivars (lines). This was established by comparing inbred lines with and without the major resistance gene. The effects of minor genes were not large enough to change the phenotypic performance determined by its major gene qualitatively (from resistant to susceptible, or vice versa) based on the measurement scale used. However, they did substantially and significantly modify the resistance level. The major gene for foliar resistance was linked to the gene(s) for seed infection rate and/or had a positive pleiotrophic effect on seed infection rate. Similarly, the major gene for foliar resistance was linked to the gene(s) for seed yield/plant in disease free environments and/or had negative pleiotrophic effects on yield/plant. Selection for resistance and yield among inbreds with the same major resistance gene may be necessary to enhance the resistance level, and to reduce the negative effect on yield of the major resistance gene.

Peanut resistance to Sclerotinia minor and S-sclerotiorum

The fungi Sclerotinia minor and S. sclerotiorum are the causal agents of two similar diseases of peanut (Arachis hypogaea L.). Both diseases cause significant losses in the Australian peanut industry. Development of cultivars with resistance to Sclerotinia will be an important component of integrated control. The aims of this project are to generate information that will assist in breeding for Sclerotinia resistance in peanut: to identify Sclerotinia-resistant peanut germplasm, to understand the inheritance and estimate heritability of resistance, and to test the effectiveness of identified sources of resistance against both S. minor and S. sclerotiorum. This study has clearly established that material that shows resistance to S. minor in the USA is resistant to S. minor and likely to be resistant to S. sclerotiorum in Australia. The high level of resistance to both S. minor and S. sclerotiorum in germplasm from Texas, particularly TxAG-4, was confirmed. VA 93B showed good resistance in the field, which is primarily due to the open bush type rather than physiological resistance. Physiological resistance to S. minor was also identified in a cultivar and a landrace from Indonesia and a rust-resistant line from Queensland. All germplasm found to have high physiological resistance to S. minor belonged to the Spanish type. Inheritance of physiological resistance to S. minor was studied using a Generation Means Analysis (GMA) of the cross TxAG-4/VA 93B and its reciprocal. The broad-sense heritability of physiological resistance on a single plant basis was estimated at 47%, much higher than earlier estimates obtained in field studies. The average gene action of Sclerotinia resistance genes from TxAG-4 was found to be additive. No dominance effects were detected in the GMA. A small but significant reciprocal effect between TxAG-4 and VA 93B indicated that VA 93B passed on some physiological resistance maternally. An experiment was conducted to confirm the value of resistance against both S. minor and S. sclerotiorum. TxAG-4 was found to have physiological resistance to both S. minor and S. sclerotiorum. This resistance was expressed against both Sclerotinia species by progeny that were selected for resistance to S. minor. On the basis of the information obtained, the comparative advantages of 3 strategies for Sclerotinia-resistant cultivar development are discussed: (1) introduction of germplasm; (2) recurrent backcrossing with screening and crossing in the BCnF1 generation; and (3) pedigree selection. At present, introduction and backcrossing are recommended as the preferred strategies.

Effect of the movement speed of resistance training exercises on sprint and strength performance in concurrently training elite junior sprinters

The aim of this study was to determine the effects of 7 weeks of high- and low-velocity resistance training on strength and sprint running performance in nine male elite junior sprint runners (age 19.0 +/- 1.4 years, best 100 m times 10.89 +/- 0.21 s; mean +/- s). The athletes continued their sprint training throughout the study, but their resistance training programme was replaced by one in which the movement velocities of hip extension and flexion, knee extension and flexion and squat exercises varied according to the loads lifted (i.e. 30-50% and 70-90% of 1-RM in the high- and low-velocity training groups, respectively). There were no between-group differences in hip flexion or extension torque produced at 1.05, 4.74 or 8.42 rad . s(-1), 20 m acceleration or 20 m 'flying' running times, or 1-RM squat lift strength either before or after training. This was despite significant improvements in 20 m acceleration time (P < 0.01), squat strength (P< 0.05), isokinetic hip flexion torque at 4.74 rad . s(-1) and hip extension torque at 1.05 and 4.74 rad . s(-1) for the athletes as a whole over the training period. Although velocity-specific strength adaptations have been shown to occur rapidly in untrained and non-concurrently training individuals, the present results suggest a lack of velocity-specific performance changes in elite concurrently training sprint runners performing a combination of traditional and semi-specific resistance training exercises.

An assessment of maturity from anthropometric measurements

Purpose: The range of variability between individuals of the same chronological age (CA) in somatic and biological maturity is large and especially accentuated around the adolescent growth spurt. Maturity assessment is an important consideration when dealing with adolescents, from both a research perspective and youth sports stratification. A noninvasive, practical method predicting years from peak height velocity (a maturity offset value) by using anthropometric variables is developed in one sample and cross-validated in two different samples. Methods: Gender specific multiple regression equations were calculated on a sample of 152 Canadian children aged 8-16 yr (79 boys; 73 girls) who were followed through adolescence from 1991 to 1997, The equations included three somatic dimensions (height, sitting height, and leg length), CA, and their interactions. The equations were cross-validated on a Combined sample of Canadian (71 boys, 40 girls measured from 1964 through 1973) and Flemish children (50 boys, 48 girls measured from 1985 through 1999). Results: The coefficient of determination (R2) for the boys' model was 0.92 and for the girls' model 0.91 the SEEs were 0.49 and 0.50, respectively, Mean difference between actual and predicted maturity offset for the verification samples was 0.24 (SD 0.65) yr in boys and 0,001 (SD 0.68) yr in girls. Conclusion: Although the cross-validation meets statistical standards or acceptance, caution 1, warranted with regard to implementation. It is recommended that maturity offset be considered as a categorical rather than a continuous assessment. Nevertheless, the equations presented are a reliable, noninvasive and a practical solution for the measure of biological maturity for matching adolescent athletes.

Physical outcome measurements via the Internet: reliability at two Internet speeds

We have developed a software application to enable interactive rehabilitation via the Internet. The reliability of the telemedicine application was examined by comparing it with face-to-face assessment. The physical outcome measures assessed were knee range of motion, quadriceps muscle strength, limb girth and an assessment of gait. One therapist performed both in-person and Internet-based measurements of all outcome measures on 20 normal subjects. There was good agreement between the two techniques (the 95% limits of agreement included zero for all the variables studied). Internet assessments were conducted at two bandwidths: ISDN at 128 kbit/s and the telephone network at 17 kbit/s. Bandwidth had no significant influence on any of the measures. This study suggests that Internet-based physiotherapy interventions delivered to the home are suitable for further development.

Mechanisms and diversity of resistance to sorghum midge, Stenodiplosis sorghicola in Sorghum bicolor

Sorghum midge, Stenodiplosis sorghicola (Coquillett) is the most important pest of grain sorghum worldwide, and plant resistance is an important component for the control of this pest. To identify sorghum genotypes with diverse mechanisms of resistance to sorghum midge, we studied oviposition, larval survival, and midge damage in 27 sorghum midge-resistant genotypes, and a susceptible check under greenhouse conditions. Observations were also recorded on floral characteristics and compensation in grain mass. Of the 28 sorghum genotypes tested, 19 showed high levels of antixenosis to oviposition as a component of resistance, and had

Yield response of rice (Oryza sativa L.) genotypes to different types of drought under rainfed lowlands - Part 3. Plant factors contributing to drought resistance

A series of experiments were conducted in drought-prone northeast Thailand to examine the magnitude of yield responses of diverse genotypes to drought stress environments and to identify traits that may confer drought resistance to rainfed lowland rice. One hundred and twenty eight genotypes were grown under non-stress and four different types of drought stress conditions. Under severe drought conditions, the maintenance of PWP of genotypes played a significant role in determining final grain yield. Because of their smaller plant size (lower total dry matter at anthesis) genotypes that extracted less soil water during the early stages of the drought period, tended to maintain higher PWP and had a higher fertile panicle percentage, filled grain percentage and final grain yield than other genotypes. PWP was correlated with delay in flowering (r = -0.387) indicating that the latter could be used as a measure of water potential under stress. Genotypes with well-developed root systems extracted water too rapidly and experienced severe water stress at flowering. RPR which showed smaller coefficient of variation was more useful than root mass density in identifying genotypes with large root system. Under less severe and prolonged drought conditions, genotypes that could achieve higher plant dry matter at anthesis were desirable. They had less delay in flowering, higher grain yield and higher drought response index, indicating the importance of ability to grow during the prolonged stress period. Other shoot characters (osmotic potential, leaf temperature, leaf rolling, leaf death) had little effect on grain yield under different drought conditions. This was associated with a lack of genetic variation and difficulty in estimating trait values precisely. Under mild stress conditions (yield loss less than 50%), there was no significant relationship between the measured drought characters and grain yield. Under these mild drought conditions, yield is determined more by yield potential and phenotype than by drought resistant mechanisms per se. (C) 2002 Elsevier Science B.V. All rights reserved.

Patterns of resistance to angular leaf spot, anthracnose and common bacterial blight in common bean germplasm

Diseases and insect pests are major causes of low yields of common bean (Phaseolus vulgaris L.) in Latin America and Africa. Anthracnose, angular leaf spot and common bacterial blight are widespread foliar diseases of common bean that also infect pods and seeds. One thousand and eighty-two accessions from a common bean core collection from the primary centres of origin were investigated for reaction to these three diseases. Angular leaf spot and common bacterial blight were evaluated in the field at Santander de Quilichao, Colombia, and anthracnose was evaluated in a screenhouse in Popayan, Colombia. By using the 15-group level from a hierarchical clustering procedure, it was found that 7 groups were formed with mainly Andean common bean accessions (Andean gene pool), 7 groups with mainly Middle American accessions (Middle American gene pool), while 1 group contained mixed accessions. Consistent with the theory of co-evolution, it was generally observed that accessions from the Andean gene pool were resistant to Middle American pathogen isolates causing anthracnoxe, while the Middle American accessions were resistant to pathogen isolates from the Andes. Different combinations of resistance patterns were found, and breeders can use this information to select a specific group of accessions on the basis of their need.