Carbonate and Aluminium accumulation in the central equatorial Pacific Ocean

We examined the flux of Al to sediment accumulating beneath the zone of elevated productivity in the central equatorial Pacific Ocean, along a surface sediment transect at 135°W as well as downcore for a 650 kyr record at 1.3°N, 133.6°W. Across the surface transect, a pronounced, broadly equatorially symmetric increase in Al accumulation is observed, relative to Ti, with Al/Ti ratios reaching values 3-4 times that of potential detrital sources. The profile parallels biogenic accumulation and the modeled flux of particulate 234Th, suggesting rapid and preferential adsorptive removal of Al from seawater by settling biogenic particles. Normative calculations confirm that most Al is unsupported by the terrigenous fraction. The observed distributions are consistent with previous observations of the relative and absolute behavior of Al and Ti in seawater, and we can construct a reasonable mass balance between the amount of seawater-sourced Al retained in the sediment and the amount of seawater Al available in the overlying column. The close tie between Al/Ti and biogenic accumulation (as opposed to concentration) emphasizes that biogenic sedimentary Al/Ti responds to removal-transport phenomena and not bulk sediment composition. Thus, in these sediments dominated by the biogenic component, the bulk Al/Ti ratio reflects biogenic particle flux, and by extension, productivity of the overlying seawater. The downcore profile of Al/Ti at 1.3°N displays marked increases during glacial episodes, similar to that observed across the surface transect, from a background value near Al/Ti of average upper crust. The excursions in Al/Ti are stratigraphically coincident with maxima in both bulk and CaCO3 accumulation and the excess Al appears to not be preferentially affiliated with opaline or organic phases. Consistent with the similar behavioral removal of Al and 234Th, the latter of which responds to the total particle flux, the Al flux reflects carbonate accumulation only because carbonate comprises the dominant flux in these particular deposits. These results collectively indicate that (1) Al in biogenic sediment and settling biogenic particles is strongly affected by a component adsorbed from seawater. Therefore, the common tenet that Al is dominantly associated with terrestrial particulate matter, and the subsequent use of Al distributions to calculate the abundance and flux of terrestrial material in settling particles and sediment, needs to be reevaluated. (2) The Al/Ti ratio in biogenic sediment can be used to trace the productivity of the overlying water, providing a powerful new paleochemical tool to investigate oceanic response to climatic variation. (3) The close correlation between the Al/Ti productivity signal and carbonate maxima downcore at 1.3°N suggests that the sedimentary carbonate maxima in the central equatorial Pacific Ocean record increased productivity during glacial episodes.

Hydrate, ice and quartz content of eight holes of Leg 204

The state of preservation of natural gas hydrate samples, recovered from 6 sites drilled during ODP Leg 204 at southern summit of Hydrate Ridge, Oregon Margin, has been investigated by X-ray diffraction (XRD) and cryo-scanning-electron-microscopy (cryo-SEM) techniques. A detailed characterization of the state of decomposition of gas hydrates is necessary since no pressurized autoclave tools were used for sampling and partial dissociation must have occurred during recovery prior to the quench and storage in liquid nitrogen. Samples from 16 distinct horizons have been investigated by synchrotron X-ray diffraction measurements at HASYLAB/ Hamburg. A full profile fitting analysis ("Rietveld method") of synchrotron XRD data provides quantitative phase determinations of the major sample constituents such as gas hydrate structure I (sI), hexagonal ice (Ih) and quartz. The ice content (Ih) in each sample is related to frozen water composed of both original existing pore water and the water from decomposed hydrates. Hydrate contents as measured by diffraction vary between 0 and 68 wt.% in the samples we measured. Samples with low hydrate content usually show micro-structural features in cryo-SEM ascribed to extensive decomposition. Comparing the appearance of hydrates at different scales, the grade of preservation seems to be primarily correlated with the contiguous volume of the original existing hydrate; the dissociation front appears to be indicated by micrometer-sized pores in a dense ice matrix.