Reversible polyelectrolyte capsules as carriers for protein delivery

A reversible drug delivery system based on spontaneous deposition of a model protein into preformed microcapsules has been demonstrated for protein delivery applications. Layer-by-Layer assembly of poly(allylamine hydrochloride) (PAH) and poly(methacrylic acid) (PMA) onto polystyrene sulfonate (PSS) doped CaCO3 particles, followed by core removal yielded intact hollow microcapsules having a unique property to induce spontaneous deposition of bovine serum albumin (BSA) at pH below its isoelectric point of 4.8, where it was positively charged. These capsules showed reversible pH dependent open and closed states to fluorescence labeled dextran (FITC-Dextran) and BSA (FITC-BSA). The loading capacity of BSA increased from 9.1 x 10(7) to 2.03 x 10(8) molecules per capsule with decrease in pH from 4.5 to 3.The loading of BSA-FITC was observed by confocal laser scanning microscopy (CLSM), which showed homogeneous distribution of protein inside the capsule. Efficient loading of BSA was further confirmed by atomic force microscopy (AFM) and scanning electron microscopy (SEM).The interior capsule concentration was as high as 209 times the feeding concentration when the feeding concentration was increased from 1 to 10 mg/ml. The deposition was initially controlled by spontaneous loading mechanism at lower BSA concentration followed by diffusion controlled loading at higher concentration; which decreased the loading efficiency from 35% to 7%. Circular dichroism (CD) measurements and Fourier transform infrared spectroscopy (FTIR) confirmed that there was no significant change in conformation of released BSA in comparison with native BSA. The release was initially burst in the first 0.5 h and sustained up to 5 h. The hollow capsules were found to be biocompatible with mouse embryonic fibroblast (MEF) cells during in vitro cell culture studies. Thus these pH sensitive polyelectrolyte microcapsules may offer a promising delivery system for water soluble proteins and peptides. (C) 2010 Elsevier B.V. All rights reserved.

Determination of carbon disulphide by chloramine-T

Carbon disulphide, on treatment with alcoholic potash, can readily be oxidised quantitatively by chloramine-T, converting all the sulphur to sulphuric acid. Fourteen equivalents of the oxidant are consumed for every mole of carbon disulphide. Since excess of chloramine-T may be determined iodimetrically, this reaction may be used for the determination of carbon disulphide. It may also be applied to the determination of xanthates.

The Open Access Scientific Journal: An Empirical Study

The open access (OA) model for journals is compared to the open source principle for computer software. Since the early 1990s nearly 1,000 OA scientific journals have emerged – mostly as voluntary community efforts, although recently some professionally operating publishers have used author charges or institutional membership. This study of OA journals without author charges shows that their impact is still relatively small, but awareness of it is increasing. The average number of research articles per year is lower than for major scientific journals but the publication times are shorter.

Multiple Perspectives on Networks: Conceptual Development, Application and Integration in an Entrepreneurial Context

Multiple Perspectives on Networks: Conceptual Development, Application and Integration in an Entrepreneurial Context. The purpose of this thesis is to enhance cross-fertilization between three different approaches to network research. The business network approach may contribute in terms of how relationships are created, developed and how tie content changes within ties, not only between them. The social network approach adds to the discussion by offering concepts of structural change on a network level. The network approach in entrepreneurship contributes by emphasizing network content, governance and structure as a way of understanding and capturing networks. This is discussed in the conceptual articles, Articles 2 and 3. The ultimate purpose of this thesis is to develop a theoretical and empirical understanding of network development processes. This is fulfilled by presenting a theoretical framework, which offers multiple views on process as a developmental outcome. The framework implies that change ought to be captured both within and among relationships over time in the firm as well as in the network. Consequently, changes in structure and interaction taking place simultaneously need to be included when doing research on network development. The connection between micro and macro levels is also stressed. Therefore, the entrepreneur or firm level needs to be implemented together with the network level. The surrounding environment impacts firm and network development and vice versa and hence needs to be integrated. Further, it is necessary to view network development not only as a way forward but to include both progression and regression as inevitable parts of the process. Finally, both stability and change should be taken into account as part of network development. Empirical results in Article 1 show support for a positive impact of networks on SME internationalization. Article 4 compares networks of novice, serial and portfolio entrepreneurs but the empirical results show little support for differences in the networks by type of entrepreneur. The results demonstrate that network interaction and structure is not directly impacted by type of entrepreneur involved. It indicates instead that network structure and interaction is more impacted by the development phase of the firm. This in turn is in line with the theoretical implications, stating that the development of the network and the firm impacts each other, as they co-evolve.

Adhesion-Induced Instability in Asperities

Adhesive forces between two approaching asperities will deform the asperities, and under certain conditions this will result in a sudden runaway deformations leading to a jump-to-contact instability. We present finite element-based numerical studies on adhesion-induced deformation and instability in asperities. We consider the adhesive force acting on an asperity, when it is brought near a rigid half-space, due to van der Waals interaction between the asperity and the half-space. The adhesive force is considered to be distributed over the volume of the asperity (body force), thus resulting in more realistic simulations for the length scales considered. Iteration scheme based on a ``residual stress update'' algorithm is used to capture the effect of deformation on the adhesion force, and thereby the equilibrium configuration and the corresponding force. The numerical results are compared with the previous approximate analytical solutions for adhesion force, deformation of the asperity and adhesion-induced mechanical instability (jump-to-contact). It is observed that the instability can occur at separations much higher,and could possibly explain the higher value of instability separation observed in experiments. The stresses in asperities, particularly in case of small ones, are found to be high enough to cause yielding before jump -to-contact. The effect of roughness is considered by modeling a spherical protrusion on the hemispherical asperity.This small-scale roughness at the tip of the asperities is found to control the deformation behavior at small separations, and hence are important in determining the friction and wear due to the jump-to-contact instability.

A study of geotechnical properties of Cochin Marine Clays

Most of the Greater Cochin area, which is undergoing rapid industrialisation, consists of extremely soft marine clay calling for expensive deep foundations. This paper presents a study on the physical properties and engeering characteristics of Cochin marine clays. These marine clays are characterised by high Atterberg limits and natural water contents. They are moderately sensitive with liquidity indices ranging over 0.46 to 0.87.The grain size distribution shows almost equal fractions of clay and silt size with sand content varying around 20%. Use of a dispersing agent in carrying out grain size distribution test plays an important role. The fabric of these clays had been identified as flocculant. The pore water has low salinity which results in marginal changes in properties on washing.Consolidation test results showed a preconsolidation pressure of up to about 0.5 kg/cm2 with high compression indices. Compression index vs liquid limit yielded a correlation comparable to that of published data. The undisturbed samples have a much larger coefficient of secondary consolidation as a result of flocculant fabric. These clays have very low undrained shear strength.

Medium access control schemes for local area networks with multiple priority function

This paper deals with the development and performance evaluation of three modified versions of a scheme proposed for medium access control in local area networks. The original scheme implements a collision-free and fair medium arbitration by using a control wire in conjunction with a data bus. The modifications suggested in this paper are intended to realize the multiple priority function in local area networks.

Simultaneous display of image and spectrum in the same plane: a generalized analysis

A generalized analysis, using the Vander Lugt operational notation, of the building block optical system comprising a single holographic optical element (HOE) for achieving simultaneous display of the spectrum and the image of an object in a single plane, has been carried out. The salient features of this analysis are: (1) it allows comprehensive characterization of the HOE, (2) it provides insights into the many possible configurations for the system, and (3) it explains the existing results in a consistent manner.

Structure-Reactivity Correlations of Benzoin Alkyl Ethers. Structures of 2-Methoxy-1,2-diphenylethanone (I) and 2-Isopropoxy-1,2-diphenylethanone (II)

(I): C15H1402, Mr---226.27, triclinic, Pi,a=8.441 (2), b= 10.276 (1), c= 15.342 (2)A, a=91.02 (2), ~ t= 79.26 (2), y= 105.88 (2) °, V=1256.8 (4)A 3, Z=4, D,,= 1.209 (flotation in KI),D x - 1.195 g cm -3, #(Mo, 2 = 0.7107/~) = 0.44 cm -~,F(000) = 480, T= 293 K, R -- 0.060 for 1793 significant reflections. (II): C~THlsO2, Mr= 254.83, orthorhombic, Pca21, a=8.476 (1); b= 16.098 (3), c=10.802(3)A, V=1473.9 (5) A s, Z=4, Dm=1.161 (flotation in KI), Dx= 1.148gem -3, /~(Mo, 2=0.7107 A) =0.41 cm -~, F(000) = 544, T= 293 K, R = 0.071 for 867 significant reflections. Both (I) and (II) crystallize in a cisoid conformation for the carbonyl group and alkoxy groups. Compounds (I) and (II) are photostable on irradiation in the solid state in spite of the favourable conformation of the functional groups for intramolecular H abstraction. Absence of photoreaction of (I)and (II) in the solid state is rationalized in the light of unfavourable intramolecular geometry.

Neural network based approach to standard cell placement

We propose a novel algorithm for placement of standard cells in VLSI circuits based on an analogy of this problem with neural networks. By employing some of the organising principles of these nets, we have attempted to improve the behaviour of the bipartitioning method as proposed by Kernighan and Lin. Our algorithm yields better quality placements compared with the above method, and also makes the final placement independent of the initial partition.

A finite element analysis of dynamic fracture initiation by ductile failure mechanisms in a 4340 steel

In some recent dropweight impact experiments [5] with pre-notched bend specimens of 4340 steel, it was observed that considerable crack tunneling occurred in the interior of the specimen prior to gross fracture initiation on the free surfaces. The final failure of the side ligaments happened because of shear lip formation. The tunneled region is characterized by a flat, fibrous fracture surface. In this paper, the experiments of [5] (corresponding to 5 m/s impact speed) are analyzed using a plane strain, dynamic finite element procedure. The Gurson constitutive model that accounts for the ductile failure mechanisms of micro-void nucleation, growth and coalescence is employed. The time at which incipient failure was observed near the notch tip in this computation, and the value of the dynamic J-integral, J d, at this time, compare reasonably well with experiments. This investigation shows that J-controlled stress and deformation fields are established near the notch tip whenever J d , increases with time. Also, it is found that the evolution of micro-mechanical quantities near the notch root can be correlated with the time variation of J d .The strain rate and the adiabatic temperature rise experienced at the notch root are examined. Finally, spatial variations of stresses and deformations are analyzed in detail.

Human Ecology in India Some Historical Perspectives

Before the spread of extensive settled cultivation, the Indian subcontinent would have been inhabited by territorial hunter–gatherers and shifting cultivators with cultural traditions of prudent resource use. The disruption of closed material cycles by export of agricultural produce to centres of non-agricultural population would have weakened these traditions. Indeed, the fire-based sacrificial ritual and extensive agricultural settlements might have catalysed the destruction of forests and wildlife and the suppression of tribal peoples during the agricultural colonization of the Gangetic plains. Buddhism, Jainism and later the Hindu sects may have been responses to the need for a reassertion of ecological prudence once the more fertile lands were brought under cultivation. British rule radically changed the focus of the country's resource use pattern from production of a variety of biological resources for local consumption to the production of a few commodities largely for export. The resulting ecological squeeze was accompanied by disastrous famines and epidemics between the 1860s and the 1920s. The counterflows to tracts of intensive agriculture have reduced such disasters since independence. However, these are quite inadequate to balance the state-subsidized outflows of resources from rural hinterlands. These imbalances have triggered serious environmental degradation and tremendous overcrowding of the niche of agricultural labour and marginal cultivator all over the country.