Turbidity and the suspended sediment load of the regulated River Tees

The physical effects of river regulation in the U.K. by impoundments have attracted most attention from hydrologists and engineers concerned with predicting and maintaining discharge regimes for water supply. Grimshaw & Lewin (1980) suggested two basic methods to investigate the effects of regulation on suspended sediment discharge: (i) Compare the river load before and after reservoir construction, and (ii) adopt a paired catchment approach. The former method assumes stationarity of process in the natural system. The latter method, involving selecting two adjacent catchments of similar physical attributes, one regulated and one unregulated, assumes constancy of process spatially. In this report both approaches are adopted to examine the turbidity and suspended sediment concentration regime of the regulated River Tees. Neither approach was entirely satisfactory in the present case. This report examines the discharge and turbidity record consisting of approximately 4000 paired data points, representative of an 11-year post-impoundment period, that has been examined for the River Tees at Broken Scar, Darlington. A small amount of suspended sediment concentration data was also processed: these data are representative of both the pre-impoundment and post-impoundment sediment regime.

Assessment of the heavy metals among suspended particulates and dissolved phases in Suez Canal water

The concentrations and distribution of particulate and dissolved heavy metals, viz: Cu, Zn, Pb, Cd, Fe and Mn have been determined seasonally during 2003 in water samples collected from the Suez Canal. The presented data clarifies that the metals exhibited clear differences in their distribution between particulate and dissolved forms. The concentration of particulate heavy metals ranged between 0.09-3.13, 0.57-15.02, 0.18-3.87, 0.02-0.73, 2.74-49.62 and 0.15-5.08 µg/L for Cu, Zn, Pb, Cd, Fe and Mn, respectively. In the same respect, these values for dissolved forms were 0.28-4.12, 0.57-9.08, 0.27-2.50, 0.02-1.24, 1.94-42.50 and 0.11-3.65 µg/L. The concentrations of particulate metals viz: Zn, Pb, Cd, Fe and Mn were high was compared to the dissolved forms. Dissolved copper, rather than particulate, showed the highest percentage of total copper. The particulate forms of Pb, Cd, Fe and Mn always had higher concentrations than the dissolved forms during the course of study except in the summer season. The northern part of the Suez Canal at Port Said showed mean concentrations of particulate and dissolved Cu=1.43 and 2.10, Zn=8.61 and 3.17, Pb=1.72 and 1.23, Cd=0.35 and 0.35, Fe= 23.49 and 15.83 and Mn=2.09 and 1.82 µg/L. These high concentrations may be attributed to the greater activities, particularly loading and unloading operations at Port Said harbour s industrial effluents and domestic drainage of Port Said city. In contrast, the Sinai side could be considered as reference site, as it was almost clean, i.e., without harmful outfalls, where Cu=0.16 and 0.56, Zn=2.14 and 0.94, Pb=6.29 and 3.44, Cd=0.055 and 0.088, Fe=6.29 and 3.44 and Mn=0.56 and 0.26 µg/L for particulate and dissolved metals respectively.

Eccentricity effects on acoustic radiation from a spherical source suspended within a thermoviscous fluid sphere.

Acoustic radiation from a spherical source undergoing angularly periodic axisymmetric harmonic surface vibrations while eccentrically suspended within a thermoviscous fluid sphere, which is immersed in a viscous thermally conducting unbounded fluid medium, is analyzed in an exact fashion. The formulation uses the appropriate wave-harmonic field expansions along with the translational addition theorem for spherical wave functions and the relevant boundary conditions to develop a closed-form solution in form of infinite series. The analytical results are illustrated with a numerical example in which the vibrating source is eccentrically positioned within a chemical fluid sphere submerged in water. The modal acoustic radiation impedance load on the source and the radiated far-field pressure are evaluated and discussed for representative values of the parameters characterizing the system. The proposed model can lead to a better understanding of dynamic response of an underwater acoustic lens. It is equally applicable in miniature transducer analysis and design with applications in medical ultrasonics.

Electrical actuation and readout in a nanoelectromechanical resonator based on a laterally suspended zinc oxide nanowire.

In this paper, we present experimental results describing enhanced readout of the vibratory response of a doubly clamped zinc oxide (ZnO) nanowire employing a purely electrical actuation and detection scheme. The measured response suggests that the piezoelectric and semiconducting properties of ZnO effectively enhance the motional current for electromechanical transduction. For a doubly clamped ZnO nanowire resonator with radius ~10 nm and length ~1.91 µm, a resonant frequency around 21.4 MHz is observed with a quality factor (Q) of ~358 in vacuum. A comparison with the Q obtained in air (~242) shows that these nano-scale devices may be operated in fluid as viscous damping is less significant at these length scales. Additionally, the suspended nanowire bridges show field effect transistor (FET) characteristics when the underlying silicon substrate is used as a gate electrode or using a lithographically patterned in-plane gate electrode. Moreover, the Young's modulus of ZnO nanowires is extracted from a static bending test performed on a nanowire cantilever using an AFM and the value is compared to that obtained from resonant frequency measurements of electrically addressed clamped–clamped beam nanowire resonators.

Generating suspended cell monolayers for mechanobiological studies.

Cell monolayers line most of the surfaces and cavities in the human body. During development and normal physiology, monolayers sustain, detect and generate mechanical stresses, yet little is known about their mechanical properties. We describe a cell culture and mechanical testing protocol for generating freely suspended cell monolayers and examining their mechanical and biological response to uniaxial stretch. Cells are cultured on temporary collagen scaffolds polymerized between two parallel glass capillaries. Once cells form a monolayer covering the collagen and the capillaries, the scaffold is removed with collagenase, leaving the monolayer suspended between the test rods. The suspended monolayers are subjected to stretching by prying the capillaries apart with a micromanipulator. The applied force can be measured for the characterization of monolayer mechanics. Monolayers can be imaged with standard optical microscopy to examine changes in cell morphology and subcellular organization concomitant with stretch. The entire preparation and testing protocol requires 3-4 d.

Phosphorus in suspended matter and sediments of a hypertrophic lake. A case study: Lake Dianchi, China

From June 2004 to December 2004, Lake Dianchi, which had large scale of cyanobacterial blooms was investigated in order to study P-fractionation in the suspended matter and the sediment. The investigation improves our understanding of phosphorus in Lake Dianchi and the relationship between phosphorus and cyanobacterial blooms. It contributes to the available literature on the behavior of P in hypertrophic lakes. The distribution of P-fractions in Lake Dianchi was not uniform from northwest to south, but was closely related to the trophic status of the whole lake. The concentrations of total phosphorus, labile P (NH4Cl-P), Organic P (NaOH-NRP) and loss on ignition in suspended matter were positively correlated with the strength of cyanobacterial blooms. Total phosphorus in suspended matter was relatively stable for almost half an year and closely related to Chl. a concentration. The main content of organic phosphorus is in the cyanobacterial blooms. The concentrations of phosphorus bound to metal oxides and carbonates (NaOH-SRP and HCl-P) in sediment were similar to NaOH-SRP and HCl-P in the corresponding suspended matter. The latter two forms of P in suspended matter were not affected by cyanobacterial blooms, indicating that the inorganic phosphorus is derived from the sediment after resuspension from the sediment due to wind and wave action. The contribution of the different P-fractions to TP in sediment and in suspended matter indicates that NH4Cl-P in the suspended matter is an important buffer for maintaining dissolved phosphorus in water.