Monoculture of three native air breathing fishes in homestead ditches and plastic barrels

Six on-farm trials were conducted from 1 August to 23 November 2004 in two different environments such as homestead ditches (10 to 17 square meters) and plastic barrels (240 liters) to develop techniques for nonoculture [sic] of climbing perch, Anabas testudineus, stinging catfish, Heteropneustes fossilis and walking catfish, Clarias batrachus for poor and landless people who have no access to pond. Stocking density for ditch was 10 fry/square meter while that for barrel was 20 fry/cubic meter. The fishes were fed with 3-test diets viz. low-cost formulated feed (rice bran 20%, wheat meal 10%, mustered [sic] oil cake 35%, poultry offal 35%), live foods (chopped snails and clams), and a commercial feed (Saudi-Bangla feed, starter 3: first month and grower-1: subsequent two months) and designated as T1, T2 and T3, respectively. Feeding rate was the same in all the treatments viz. 10% of body weight (first two months), 8% (third month) and 6% (fourth month). T1 and T2 had three replications while T3 had two replications. Water temperature was recorded weekly while fish growth was monitored monthly. After 4 months' rearing, H. fossilis and C. batrachus in ditches and barrels attained higher average weight in T2 followed by T3 and T1 while A. testudineus in barrels also attained higher average weight in T2. The variation in net weight gain by A. testudineus in ditch fed test diets T2 and T3 was not significantly different (P>0.05) though the net gain in both T2 and T3 was significantly (P<0.05) higher than that of T1. The yield of climbing perch as obtained from T1, T2 and T3 was 988, 1136 and 1185 kg/ha, respectively while that stinging catfish was 395, 242 and 444 kg/ha and walking catfish was 1605, 2,099 and 1,654 kg/ha respectively. All the three species showed significantly lower growth rate in barrels than in ditches.

Raman spectroscopy of shear and layer breathing modes in multilayer MoS2

We study by Raman scattering the shear and layer breathing modes in multilayer MoS2. These are identified by polarization measurements and symmetry analysis. Their positions change significantly with the number of layers, with different scaling for odd and even layers. A chain model can explain the results, with general applicability to any layered material, allowing a reliable diagnostic of their thickness. © 2013 American Physical Society.

Pressure-induced Raman-active radial breathing mode transition in single-wall carbon nanotubes

Using classical constant-pressure molecular dynamics simulations and the force constants model, radial breathing mode (RBM) transition of single-wall carbon nanotubes under hydrostatic pressure is reported. With the pressure increased, the RBM shifts linearly toward higher frequency, and the RBM transition occurs at the same critical pressure as the structural transition. The group theory indicates that the RBMs are all Raman-active; however, due to the effect of the frequency transition and the electronic structure change for tube radial deformation, the Raman intensity of the modes becomes so weak as not to be experimentally detected, which is in agreement with a recent experiment by S. Lebedkin [Phys. Rev. B 73, 094109 (2006)]. Furthermore, the calculated RBM transition pressure is well fitted to the cube of diameter (similar to 1/d(3)).

Accurate determination of electronic transition energy of carbon nanotubes from the resonant behavior of radial breathing modes and their overtones

The resonant Raman behavior of the radial breathing modes are very useful to analyze the electronic property of carbon nanotubes. We investigated the resonant behaviors of Stokes and anti-Stokes radial breathing mode and its overtone of a metallic nanotube, and show how to accurately determine the electronic transition energy of carbon nanotubes from radial breathing modes and their overtones. Based on the present results, the previously reported resonant Raman behavior of the radial breathing modes of SWINT bundles can be interpreted very well.

Study of sintered stainless steel fiber felt as gas diffusion backing in air-breathing DMFC

Adoption of a sintered stainless steel fiber felt was evaluated as gas diffusion backing in air-breathing direct methanol fuel cell (DMFC). By using a sintered stainless steel fiber felt as an anodic gas diffusion backing, the peak power density of an air-breathing DMFC is 24 mW cm(-2), which is better than that of common carbon paper. A 30-h-life test indicates that the degraded performance of the air-breathing DMFC is primarily due to the water flooding of the cathode. Twelve unit cells with each has 6 cm(2) of active area are connected in series to supply the power to a mobile phone assisted by a constant voltage diode. The maximum power density of 26 mW cm(-2) was achieved in the stack, which is higher than that in single cell. The results show that the sintered stainless steel felt is a promising solution to gas diffusion backing in the air-breathing DMFC, especially in the anodic side because of its high electronical conductivity and hydrophilicity. (C) 2004 Elsevier B.V. All rights reserved.

Sleep-disordered breathing and orthodontic variables in children-Pilot study

Introduction: Sleep Disordered Breathing (SDB) is a highly prevalent condition associated with orofacial and dentofacial characteristics.Objective: the aim of this study was to verify the association of dental malocclusion, molar relationship, crossbite, open bite, overjet, overbite, and crowding with SDB in children aged 7-9 years.Materials and methods: Participating schools were selected randomly from within the public elementary school system. in the first phase of the study, the parents of 1216 children aged between 7 and 9 years old completed the Sleep Disturbance Scale for Children (SDSC) questionnaire and the children had to participate in a dental examination. the evaluation of occlusion was divided into sagittal analysis, vertical analysis, and transverse analysis. in the second phase, 60 children were selected randomly to be undergone polysomnography (PSG) at a sleep clinic.Results: Among the children included, 242 (19.9%) children had normal occlusion. of the 60 children, 50 underwent PSG and 40(80%) had SDB. the crossbite and open bite showed association with SDB, p = 0.04 in both.Conclusion: Crossbite and open bite malocclusions were associated with SDB, and may be predictive of SDB in children. Studies with larger numbers of participants are needed to investigate the association of other malocclusions with SDB, and randomized clinical trials are also needed to see whether orthodontic and/or functional jaw orthopedic treatment is an option for treating children with malocclusion and SDB. (C) 2014 Elsevier Ireland Ltd. All rights reserved.

Questions of 'h' in Northern Ireland: Breathing New Life on the Aspiration Theory

This paper considers existing ideas concerning pronunciation of the letter name for (LNH) in Northern Irish English (NIE). Traditionally, the status of LNH realisation as an ethnic marker has gone unquestioned: Catholics are thought to say [het&Mac186;] while the Protestant norm is assumed to be [etS]. The phonetic difference between these realisations is consistently described as word-initial aspiration versus non-aspiration, with aspiration attributed exclusively to Irish language influence. Here, we show that an explanation based on aspiration alone is phonologically unsatisfying and question whether aspiration is, in fact, an Irish language or ethnically dictated phenomenon. It is further suggested here that the overwhelming stigmatisation of LNH realisation may be responsible for blocking a potential sound change in NIE. While this paper is not intended as a detailed account of ethnolinguistic differences in NI phonology, it engages critically with the over-simplistic and widespread notion that LNH realisation is a result of transfer from the Irish language to the English used by Catholics in Northern Ireland.