Study of beam aberrations in a germanium XXIII XUV laser amplifier

A beam of amplified spontaneous emission at 23.2/23.6 nm from a GeXXIII XUV laser has been injected into a separate amplifier plasma and the astigmatic aberrations introduced by plasma density gradients in the amplifier have been estimated from analysis of images of the amplified beam.

Characterisation of pavement profile heights using accelerometer readings and a combinatorial optimisation technique

Pavement surface profiles induce dynamic ride responses in vehicles which can potentially be used to classify road surface roughness. A novel method is proposed for the characterisation of pavement roughness through an analysis of vehicle accelerations. A combinatorial optimisation technique is applied to the determination of pavement profile heights based on measured accelerations at and above the vehicle axle. Such an approach, using low-cost inertial sensors, would provide an inexpensive alternative to the costly laser-based profile measurement vehicles. The concept is numerically validated using a half-car roll dynamic model to infer measurements of road profiles in both the left and right wheel paths.

Excitation of low-profile equilateral-triangular dielectric resonator antenna using a conducting conformal strip

A new configuration that employs a conducting conformal strip to excite the low-profile equilaterial-triangular dielectric resonator antenna (DRA) of very high permittivity is proposed. As compared with the previous aperture-coupling configuration, the new configuration has a wider impedance bandwidth (- 5.5%) and a higher front-to-back radiation ratio. The return loss, radiation patterns, and antenna gain are measured and discussed

Stability of plasmid profile of highly virulent races of Xanthomonas campestris pv. malvacearum during storage and subculturing

Four races of Xanthomonas campestris pv. mal-vacearum (Xcm) viz. races 23, 27 and 32 (isolated from Gossypium hirsutum) and race 23b (from Gossypium barbadense) were studied. The plasmid profile of the natural isolates showed four plasmids in races 23 and 23b (ca. 60, 40, 23, 8.2 kb), five in race 27 (ca. 60, 40, 23, 8.2 and 3.7 kb) and six in race 32 (ca. 60, 40, 23, 8.2, 3.7 and 1.6 kb). Continuously sub-cultured laboratory isolates of the Xcm races resulted in the loss of all but two plasmids, ca. 60 and 40 kb in size. When the laboratory isolates were passed through cotton (Gossypium hirsutum), they regained certain plasmids so that four plasmids were found in race 23 and 23b (ca. 60, 40, 23 and 8.2 kb), five in race 27 (ca. 60, 40, 23, 8.2 and 3.7 kb) and six in race 32 (ca. 60, 40, 23, 8.2, 3.7 and 1.6 kb), which was more or less similar to the original isolates. The isolates recovered from cotton maintained their plasmid profile (except for minor changes in the miniplasmids) after storage for six months at -70degreesC in 50% glycerol. It is suggested that plasmid profiles among highly virulent races of Xcm are unstable during repeated sub-culturing at room temperature, resulting in rapid loss of some plasmids. However, when the cultures were sub-cultured and stored at -70degreesC the plasmid profile was fairly stable except for the miniplasmids (ca. 3.7 and 1.6 kb).

Femtosecond laser ablation on dental hard tissues-Analysis of ablated profile near an interface using local effective intensity

This study evaluated the process of ablation produced by a Ti:Sapphire femtosecond laser under different average powers taking place at the enamel/dentin interface. Based on the geometry of ablated microcavities the effective intensity for ablation was obtained. This study shows the validity for the local effective intensity analysis and allows a quantification of the variation in the ablation geometry taking place at the interface of two naturally different materials. It shows that the variation of the diameter of the ablated region as a function of the cavity depth comes essentially from a mechanism of effective intensity attenuation, as a result of a series of complex effects. Additionally, our data are sufficient to predict that a discontinuity on the ablation profile will occur on the interface between two biological media: enamel-dentin, showing a suddenly jump on the ablated cavity dimensions.

3D roll-forming of hat-profile with variable depth and width

The use of roll-formed products in automotive, furniture, buildings etc. increases every year due to the low part-production cost and the complicated cross-sections that can be produced. The limitation with roll-forming until recent years is that one could only produce profiles with a constant cross-section in the longitudinal direction. About eight years ago ORTIC AB [1] developed a machine in which it was possible to produce profiles with a variable width (“3D roll-forming”) for the building industry. Experimental equipment was recently built for research and prototyping of profiles with variable cross-section in both width and depth for the automotive industry. The objective with the current study is to investigate the new tooling concept that makes it possible to roll-form hat-profiles, made of ultra high strength steel, with variable cross-section in depth and width. The result shows that it is possible to produce 3D roll-formed profiles with close tolerances.

Evaluation of electrophoretic profile and albumin quota in the cerebrospinal fluid of dogs with distemper showing or not neurvous signs

Estudaram-se o perfil eletroforético das proteínas liquóricas e a cota de albumina em cães sem e com cinomose na fase neurológica e não-neurológica. A punção da cisterna magna para a obtenção de amostras de liquor realizou-se em 30 cães. Analisaram-se teores de proteínas totais, cota de albumina e fracionamento eletroforético das proteínas liquóricas em gel de agarose. Os resultados foram semelhantes nos cães normais e nos cães com cinomose sem sinais neurológicos e significativamente elevados no grupo de cães com cinomose apresentando sinais neurológicos. O estudo do quadro protéico do líquido cérebroespinhal foi útil e contribuiu significativamente na detecção de lesões ao sistema nervoso central e de danos à barreira hematoencefálica durante a fase neurológica da cinomose.

Pre-Prosthetic Orthodontic Treatment Using Personalized Elastic Separators for Optimization of Emergence Profile in Esthetic Crowns: A Clinical Report

Restoring a misaligned tooth with an inadequate contact point is a challenge to the practitioner. In some instances, teeth that could be repositioned and adequately restored are extracted. Thus, the aim of this article was to describe a treatment using orthodontic and prosthetic techniques to restore esthetics and function in a patient with a distally drifted maxillary lateral incisor. The patient's functional and esthetic expectations were successfully met with the outlined treatment.

Evaluation of lipid profile and oxidative stress in STZ-induced rats treated with antioxidant vitamin

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Femtosecond laser ablation on dental hard tissues-Analysis of ablated profile near an interface using local effective intensity

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Analysis of susceptibility profile of Pseudomonas spp. and prevalence of bacterial samples from the surfaces of dental consulting-rooms

The aim of this research was to evaluate the susceptibility profile of Pseudomonas spp. and the prevalence of bacterial samples isolated from horizontal surfaces surrounding wash-basins used by dentists in several adjoined consulting-rooms, at points next to and at a distance from the basin, before and after surgical procedures. Our results showed a high percentage of Gram-positive cocci and Gram-negative bacilli; 34.66% were Staphylococcus spp. and 30.12% were non-fermentative Gram-negative bacilli among which Pseudomonas spp. (40.90%) was the commonest genus. Analysis of the susceptibility profile of Pseudomonas spp. isolates by determining the minimal inhibitory concentration (MIC) of 14 antibiotics showed a great variation among the strains and high rates of resistance to cefazolin, ceftazidime and aztreonan. Of the 14 antibiotics tested, 59.03% were found to be active against all the environmental isolates. Strains were resistant to aztreonan (62.82%), while susceptibility to third generation cephalosporins was variable.

Quality of life profile and correlated factors in chronic leg ulcer patients in the mid-west of São Paulo State, Brazil

BACKGROUND: Chronic leg ulcer may have an impact on patients' quality of life.OBJECTIVES:This study aimed to identify the impact of leg ulcers on patient's quality of life using the Dermatology Life Quality Index and to define the main factors correlated with this perception.METHOD:Cross-sectional, non-probabilistic sampling study. We included patients with chronic leg ulcers being treated for at least 3 months. A sociodemographic and clinical survey was conducted to assess the profile of the ulcers. We administered a screening for depressive symptoms and the Dermatology Life Quality Index. We performed a descriptive statistical analysis, chi-square test and Mann-Whitney test for categorical data, Pearson for numeric variables, and multiple regression for categorical data.RESULTS:Forty-one patients were assessed. Their mean age was 61.78 years. Venous ulcers (48.8%) were the most prevalent. Seventy-three percent of the sample perceived no impact/low impact on quality of life in the past week, and 26.8% perceived moderate/high impact. A multiple regression analysis identified the causes of lesion, pain related to the ulcers, time of onset, and severity of the depressive symptoms as the variables that had an influence on quality of life.CONCLUSIONS:The majority of the sample perceived low or no impact of the condition on the quality of the life. The variables etiology of the lesion (p<0.001), pain related to the ulcers (p=0.001), time of onset (p=0.006), and severity of the depressive symptoms (p<0.001) had an influence on the quality of life, suggesting the need for further studies with more robust designs to confirm the causal relationship between these characteristics and quality of life.

A matheuristic for the selection of beam directions and dose distribution in radiotherapy planning

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)