Influence of Photoactivation Protocol and Light Guide Distance on Conversion and Microleakage of Composite Restorations

Purpose: To evaluate the effect of light guide distance and the different photoactivation methods on the degree of conversion (DC) and microleakage of a composite. Methods and Materials: Three photoactivation protocols (600mW/cm(2) x 40 seconds; 400 mW/cm(2) x 60 seconds or 200 mW/cm(2) x 20 seconds, followed by 500 mW/cm(2) X 40 seconds) and three distances from the light source (0, 3 or 7 mm) were tested. Cylindrical specimens (5 nun diameter; 2 mm tall; n=3) were prepared for the DC test (FT-Raman). Class V cavities were made in 90 bovine incisors to conduct the microleakage test. The specimens were conditioned for 15 seconds with phosphoric acid (37%), followed by application of the adhesive system Prime & Bond NT (Dentsply/Caulk). The preparations were restored in bulk. The specimens were stored for 24 hours in distilled water (37 degrees C) before being submitted to the silvernitrate microleakage protocol. The restorations were sectioned and analyzed under 25x magnification. Results: Statistical analyses (two-way ANOVAs and Tukey test, alpha=0.05) found significance only for the factor distance (p=0.015) at the top of the composite for the DC test. Conversion was statistically lower for the 7 mm groups compared to the 0 and 3 mm groups, which were equivalent to each other. At the bottom of the specimens, none of the factors or interactions was significant (p<0.05). The Kruskal-Wallis test showed that, in general, the soft-start method led to lower microleakage scores when compared to the continuous modes, mainly when associated with a distancing of 7 mm (p<0.01). With the exception of specimens irradiated with 400mW/cm(2) that did not demonstrate variations on scores for the distances tested, higher microleakage was observed for shorter distances from the light source. Conclusions: Soft-start methods may reduce microleakage when the light guide distancing provides a low level of irradiance, which also causes a discrete reduction in the DC.

Effect of curing protocol on the polymerization of dual-cured resin cements

Objectives. The purpose of this study was to evaluate how curing protocol affects the extent of polymerization of dual-cured resin cements. Methods. Four commercial resin cements were used (DuoLink, Panavia F 2.0, Variolink II and Enforce). The extent of polymerization of the resin cements cured under different conditions was measured using a (1)H Stray-Field MRI method, which also enabled to probe molecular mobility in the kHz frequency range. Results. Resin cements show well distinct behaviours concerning chemical cure. Immediate photo-activation appears to be the best choice for higher filler loaded resin cements (Panavia F 2.0 and Variolink). A photo-activation delay (5 min) did not induce any significant difference in the extent of polymerization of all cements. Significance. The extent of polymerization of dual-cured resin cements considerably changed among products under various curing protocols. Clinicians should optimize the materials choice taking into account the curing characteristics of the cements. (C) 2010 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.

Cleft Palate Obturation With Branemark Protocol Implant-Supported Fixed Denture and Removable Obturator

A 41-year-old man with cleft palate presented with a wide dehiscence and missing teeth. Six implants had been placed for fabrication of an overdenture, which was unsatisfactory. A bar was waxed and cast for connection to the implants; precision attachments were placed laterally for retention. A fixed partial denture was fabricated, and milled crowns were fabricated at the molar region to provide a guiding plane for insertion of a removable palatal obturator. Good swallowing and speech outcomes were achieved. This technique provided functional and esthetic benefits, enhanced oral hygiene, and improved the psychological condition of the patient.

A modified orthodontic protocol for advanced periodontal disease in Class II division 1 malocclusion

An interdisciplinary approach is often the best option for achieving a predictable outcome for an adult patient with complex clinical problems. This case report demonstrates the combined periodontal/orthodontic treatment for a 49-year-old woman presenting with a Class II Division 1 malocclusion with moderate maxillary anterior crowding, a 9-mm overjet, and moderate to severe bone loss as the main characteristics of the periodontal disease. The orthodontic treatment included 2 maxillary first premolar extractions through forced extrusion. Active orthodontic treatment was completed in 30 months. The treatment outcomes, including the periodontal condition, were stable 17 months after active orthodontic treatment. The advantages of this interdisciplinary approach are discussed. Periodontally compromised orthodontic patients can be satisfactorily treated, achieving most of the conventional orthodontic goals, if a combined orthodontic/periodontic approach is used. (Am J Orthod Dentofacial Orthop 2011; 139:S133-44)

Influence of curing protocol on selected properties of light-curing polymers: Degree of conversion, volume contraction, elastic modulus, and glass transition temperature

Objectives. The purpose of this study was to investigate the effect of light-curing protocol on degree of conversion (DC), volume contraction (C), elastic modulus (E), and glass transition temperature (T(g)) as measured on a model polymer. It was a further aim to correlate the measured values with each other. Methods. Different light-curing protocols were used in order to investigate the influence of energy density (ED), power density (PD), and mode of cure on the properties. The modes of cure were continuous, pulse-delay, and stepped irradiation. DC was measured by Raman micro-spectroscopy. C was determined by pycnometry and a density column. E was measured by a dynamic mechanical analyzer (DMA), and T(g) was measured by differential scanning calorimetry (DSC). Data were submitted to two-and three-way ANOVA, and linear regression analyses. Results. ED, PD, and mode of cure influenced DC, C, E, and T(g) of the polymer. A significant positive correlation was found between ED and DC (r = 0.58), ED and E (r = 0.51), and ED and T(g) (r = 0.44). Taken together, ED and PD were significantly related to DC and E. The regression coefficient was positive for ED and negative for PD. Significant positive correlations were detected between DC and C (r = 0.54), DC and E (r = 0.61), and DC and T(g) (r = 0.53). Comparisons between continuous and pulse-delay modes of cure showed significant influence of mode of cure: pulse-delay curing resulted in decreased DC, decreased C, and decreased T(g). Influence of mode of cure, when comparing continuous and step modes of cure, was more ambiguous. A complex relationship exists between curing protocol, microstructure of the resin and the investigated properties. The overall performance of a composite is thus indirectly affected by the curing protocol adopted, and the desired reduction of C may be in fact a consequence of the decrease in DC. (C) 2009 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.

Managing youth transitions in the Network Society

Castells argues that society is being reconstituted according to the global logic of networks. This paper discusses the ways in which a globalised network logic transforms the nature young people's transitions from school to work. Furthermore, the paper explores the ways in which this network logic restructured the manner in which youth transitions are managed via the emergence of a Vocational Education and Training (VET) agenda in Australian post compulsory secondary schooling. It also notes the implications of the emergence of the 'network society' for locality generally and for selected localities specific to the research upon which this paper is based. It suggests that schools represent nodes in a range of VET and other networks, and shows how schools and other agencies in particular localities mobilise their expertise to construct such networks. These networks are networked, funded and regulated at various levels - regionally, nationally and globally. But, they are also facilitated by personal networking opportunities and capacities. The paper also points to the ways in which the 'reflexivity chances' of young people are shaped by this network logic - a situation that generates new forms of responsibility, for schools and teachers, with regard to the management of youth transitions.

Comparing physical activity questionnaires for youth: Seasonal vs annual format

Background: In large cohort studies of older children, self-report is the only practical way to assess physical activity. Assessing usual activity over the entire year is desirable, but children and adolescents may overestimate activities with high seasonal variability. Use of questionnaires in which individuals report each activity by season may improve accuracy. Methods: A total of 6782 girls and 5110 boys, aged 9–14 years in 1996, completed self-administered activity questionnaires in 1996 and in 1997. In 1996, participants reported the average time spent in each of 17 activities during the previous 12 months; in 1997, we also asked for the average time spent in the previous year, but within each of the four seasons. Results: Girls reported a median of 12.8 hours/week total activity in 1996 and 10.4 hours/week in 1997. For boys, the estimates were 15.5 hours/week and 13.4 hours/week, respectively. Girls and boys within 1-year age strata (e.g., comparison of 10-year olds in 1996 with 10-year olds in 1997) reported an average of 3.7 and 3.1 fewer hours per week, respectively, on the 1997 seasonal format versus the 1996 annual format questionnaire. In longitudinal analyses, the difference between the annual and the seasonal estimates was greater if participants did the activity in fewer seasons in 1997. Conclusions: In comparison to an annual format questionnaire, a seasonal format questionnaire may improve accuracy of self-report of physical activity by reducing over-reporting of activities in which pre-adolescents and adolescents engage in fewer seasons.

Anxious futures: Magpie2 and 'new generationalism' in Australian youth-specific theatre

The field of contemporary youth-specific theatre in Australia is one of change and, in some cases, anxiety. While Drama Studies continue to grow in popularity in schools, previously conventional developmental paradigms have become less mandatory for theatre, for, by, and about young people outside the school context. Instead, 'new generation' approaches in youth-specific performance are placing greater value on young people's own preferences in cultural activity. Yet this development is being tempered and further complicated by a cultural 'generationalism', particularly in larger arts organization as the youth sector becomes a more integral part of marketing strategies for the future. The resulting ambiguity in the representation, value, and positioning of young people and youth-specific arts in Australia's theatre industry is considered by focusing on Magpie2, a former youth-specific company attached to the State Theatre Company of South Australia. Magpie2 ceased operation in 1998 after experimenting with a 'new generation' approach to theatre for young people in the State Theatre realm. Both the artistic policy of Magpie2 Director, Benedict Andrews, and the critical reception of his two productions in 1997, Future Tense and Features of Blown Youth, demonstrate how competing systems of cultural value characterize the field of youth-specific theatre in Australia.

On the nonlocality of the quantum channel in the standard teleportation protocol

By exhibiting a violation of a novel form of the Bell-CHSH inequality, Żukowski has recently established that the quantum correlations exploited in the standard perfect teleportation protocol cannot be recovered by any local hidden variables model. In the case of imperfect teleportation, we show that a violation of a generalized form of Żukowski's teleportation inequality can only occur if the channel state, considered by itself, already violates a Bell-CHSH inequality. On the other hand, the fact that the channel state violates a Bell-CHSH inequality is not sufficient to imply a violation of Żukowski's teleportation inequality (or any of its generalizations). The implication does hold, however, if the fidelity of the teleportation exceeds ≈ 0.90. © 2001 Elsevier Science B.V. All rights reserved.