Technical note: a simple procedure for removing temporal discontinuities in ERA-Interim upper stratospheric temperatures for use in nudged chemistry-climate model simulations

This note describes a simple procedure for removing unphysical temporal discontinuities in ERA-Interim upper stratospheric global mean temperatures in March 1985 and August 1998 that have arisen due to changes in satellite radiance data used in the assimilation. The derived temperature adjustments (offsets) are suitable for use in stratosphere-resolving chemistry-climate models that are nudged (relaxed) to ERA-Interim winds and temperatures. Simulations using a nudged version of the Canadian Middle Atmosphere Model (CMAM) show that the inclusion of the temperature adjustments produces temperature time series that are devoid of the large jumps in 1985 and 1998. Due to its strong temperature dependence, the simulated upper stratospheric ozone is also shown to vary smoothly in time, unlike in a nudged simulation without the adjustments where abrupt changes in ozone occur at the times of the temperature jumps. While the adjustments to the ERA-Interim temperatures remove significant artefacts in the nudged CMAM simulation, spurious transient effects that arise due to water vapour and persist for about 5 yr after the 1979 switch to ERA-Interim data are identified, underlining the need for caution when analysing trends in runs nudged to reanalyses.

Technical development for deconstruction management

The Australian construction industry, particularly in the area of demolishing existing facilities, is responsible for up to 40% of the country's enormous solid waste streams, totalling about 14 million tonnes annually. The recently created concept of deconstruction, rather than destruction for demolishing a constructed facility, came about because of the rapidly increasing number of demolished buildings and changes in levels of environmental awareness. However,  reconstruction processes are now seen as only an interesting concept for reducing waste through reuse and recycling, but they fail to achieve widespread understanding or acceptance. The challenges faced by deconstruction are significant and diverse. The maturity of deconstruction practice depends on not only on tlle development of deconstruction techniques and management, but also on the enhancement of deconstruction awareness by the owners, designers, and construction teams, as well as the development of environmental regulations. These practical limitations are interrelated and mutually promotional. The technical developments in deconstruction management resulting from this research will have direct effects on various aspects, including the development of design and construction for deconstruction, deconstruction technology, reused material certification, recycl ing technology, and a method by which to calculate environmental benefits so that deconstruction would be promoted from an interesting concept mainly in theory to wide acceptance in practice. 

eCommerce in service industries : extending the socio-technical paradigm

The socio-technical framework (STF) is useful for describing how technologies are embedded in social systems and how people, groups and technologies are interrelated. This perspective, however, lacks theoretical specificity and has limited usefulness in explaining the dynamics of actual situations. In this paper we address the question of how to extend the STF to better analyse technologies in their social context. We build on the STF by including the concept of ‘information ecology’ and research on service provision to suggest a more empirically focussed way of analysing the relationships between people and technologies. In particular, we examine changes that have occurred as B2C eCommerce technologies have been implemented in service organisations, using case study findings from retail banking to introduce the concept of ‘Coactive Commerce Systems’. This concept provides a theoretically based descriptor for understanding the technologically-mediated interrelationships between organisations and their customers.

Malmquist indices of total factor productivity changes in the Australian construction industry

Construction is an important industry and forms a vital part of national economics in the world. Factors affecting the productivity of the construction industry should be measured appropriately to reflect its development situation and economic performance. The Malmquist index method with a novel decomposition technique is employed to estimate the total factor productivity of the Australian construction industry during the period 1990-2007 and to analyse the factors affecting the technological change in the industry. Research results exemplified by two input variables and one output variable elaborate how construction technology, pure technical efficiency and scale economy take effect in the change of construction productivity. In addition, based on temporal and spatial comparisons, the analysis for construction productivities reveals their changes over time and across the country. Proposals and recommendations are expected to be beneficial for policy making and strategic decisions to improve the performance of the Australian construction industry.

Impact of policy changes on the efficiency and returns-to-scale of Japanese financial institutions: an evaluation

This paper examines the impact of FSA's (Financial Services Agency) recent policy changes on the efficiency and returns-to-scale (RTS) of Japanese financial institutions including banks, securities companies and bank holding companies. Three kinds of efficiency are investigated namely, technical efficiency (TE), pure technical efficiency (PTE) and scale efficiency (SE) using the non-parametric methodology named data envelopment analysis (DEA). The DEA analysis shows a substantial improvement in the overall efficiency of Japanese banks, albeit a significant difference of efficiency scores between the major/city banks and the regional banks. Results are robust to alternative specifications of efficiency and scale changes.

Actor-Network Theory (ANT) based visualisation of socio-technical facets of RFID technology translation: an Australian hospital scenario

In the early 2000s, Information Systems researchers in Australia had begun to emphasise socio-technical approaches in innovation adoption of technologies. The ‘essentialist' approaches to adoption (for example, Innovation Diffusion or TAM), suggest an essence is largely responsible for rate of adoption (Tatnall, 2011) or a new technology introduced may spark innovation. The socio-technical factors in implementing an innovation are largely flouted by researchers and hospitals. Innovation Translation is an approach that purports that any innovation needs to be customised and translated in to context before it can be adopted. Equally, Actor-Network Theory (ANT) is an approach that embraces the differences in technical and human factors and socio-professional aspects in a non-deterministic manner. The research reported in this paper is an attempt to combined the two approaches in an effective manner, to visualise the socio-technical factors in RFID technology adoption in an Australian hospital. This research investigation demonstrates RFID technology translation in an Australian hospital using a case approach (Yin, 2009). Data was collected using a process of focus groups and interviews, analysed with document analysis and concept mapping techniques. The data was then reconstructed in a ‘movie script' format, with Acts and Scenes funnelled to ANT informed abstraction at the end of each Act. The information visualisation at the end of each Act using ANT informed Lens reveal the re-negotiation and improvement of network relationships between the people (factors) involved including nurses, patient care orderlies, management staff and non-human participants such as equipment and technology. The paper augments the current gaps in literature regarding socio-technical approaches in technology adoption within Australian healthcare context, which is transitioning from non-integrated nearly technophobic hospitals in the last decade to a tech-savvy integrated era. More importantly, the ANT visualisation addresses one of the criticisms of ANT i.e. its insufficiency to explain relationship formations between participants and over changes of events in relationship networks (Greenhalgh & Stones, 2010).

Changes on emitter discharge under different water temperature and pressure

The study was conducted at the Research Laboratory of Hydraulic and Irrigation Group in the Rural Engineering Department, Technical University of Madrid (Universidad Politecnica de Madrid), Madrid, Spain. Water temperatures of 20, 30, 40 degrees C and system pressures often encountered in irrigation practices of 80, 90, 100, 110, 120, 130, 140, 150, 160, 170, 180, 190 and 200 k Pa were applied to determine the effects of different water temperatures and pressures on emitter discharge. Non-pressure compensating in-line emitter which has turbulent flow regime with a long-path (labyrinth), emitter discharge was 4 L h(-1) at system pressure of 100 kPa according to the manufacturer recommended, was used. Emitters were spaced 20 cm along the drip laterals with 16 mm diameter. Discharge equations and coefficients of variation related to temperatures of 20, 30 and 40 degrees C were obtained as q = 0.375H(0.51), q = 0.358H(0.52), q = 0.346H(0.53) and 2.68, 2.09, 3.65, respectively. Discharge of the emitter was affected by different system pressures and increased as potentially (R = 0993-0996). In general. the emitter discharge increased with increasing temperature. However, especially in the common system pressures of 90-120 k Pa, differences of obtained emitter discharges between the different water temperatures were not significant (1%).

Evaluation of chronic periapical lesions by digital subtraction radiography by using adobe photoshop CS: A technical report

The purpose of this study was to describe a new technique by using Adobe Photoshop CS (San Jose, CA) image-analysis software to evaluate the radiographic changes of chronic periapical lesions after root canal treatment by digital subtraction radiography. Thirteen upper anterior human teeth with pulp necrosis and radiographic image of chronic periapical lesion were endodontically treated and radiographed 0, 2, 4, and 6 months after root canal treatment by using a film holder. The radiographic films were automatically developed and digitized. The radiographic images taken 0, 2, 4, and 6 months after root canal therapy were submitted to digital subtraction in pairs (0 and 2 months, 2 and 4 months, and 4 and 6 months) choosing image, calculation, subtract, and new document tools from Adobe Photoshop CS image-analysis software toolbar. The resulting images showed areas of periapical healing in all cases. According to this methodology, the healing or expansion of periapical lesions can be evaluated by means of digital subtraction radiography by using Adobe Photoshop CS software.

Changes in the urban female labour market

Includes bibliography

Technological changes and industrial dynamics in Latin America

Includes bibliography

Assessing the dynamic of structural changes in Cerrado vegetation of protected and non-protected areas using NDVI

The structure of Brazilian savannah, named locally as “cerrado”, tends to change if the human pressures, such as pasture and intensive fire, are suppressed showing a densification of the physiognomies throughout the time. Vegetation Index acquired from remotely sensed data has been a proper way to study and monitoring large areas, and the Normalized Difference Vegetation Index (NDVI) is one of the most used for this purpose. The aim of this study was to assess the dynamic of structural changes in protected and non-protected areas of cerrado vegetation using NDVI. For this purpose, three cerrado fragments in the state of São Paulo, Brazil, were evaluated for a 26 year time span from 1985 and 2011, being two of them protected against anthropogenic interference. Landsat 5 –Thematic Mapper images were used and processed in ArcGIS. In the protected areas NDVI indicated that the vegetation followed the expected trend of changes for cerrado, with more open physiognomies tending to be denser throughout this period of 26 years, whereas in the non-protected fragment the NDVI evidences human pressure, showing lower phytomass in 2011. NDVI showed to be efficient in detecting and monitoring changes in cerrado vegetation structure, and can be useful to study both, the natural dynamics of cerrado vegetation and the anthropogenic interference in protected areas.

Changes on emitter discharge under different water temperature and pressure

The study was conducted at the Research Laboratory of Hydraulic and Irrigation Group in the Rural Engineering Department, Technical University of Madrid (Universidad Politecnica de Madrid), Madrid, Spain. Water temperatures of 20, 30, 40 degrees C and system pressures often encountered in irrigation practices of 80, 90, 100, 110, 120, 130, 140, 150, 160, 170, 180, 190 and 200 k Pa were applied to determine the effects of different water temperatures and pressures on emitter discharge. Non-pressure compensating in-line emitter which has turbulent flow regime with a long-path (labyrinth), emitter discharge was 4 L h(-1) at system pressure of 100 kPa according to the manufacturer recommended, was used. Emitters were spaced 20 cm along the drip laterals with 16 mm diameter. Discharge equations and coefficients of variation related to temperatures of 20, 30 and 40 degrees C were obtained as q = 0.375H(0.51), q = 0.358H(0.52), q = 0.346H(0.53) and 2.68, 2.09, 3.65, respectively. Discharge of the emitter was affected by different system pressures and increased as potentially (R = 0993-0996). In general. the emitter discharge increased with increasing temperature. However, especially in the common system pressures of 90-120 k Pa, differences of obtained emitter discharges between the different water temperatures were not significant (1%).

A bradykinin-potentiating peptide (BPP-10c) from Bothrops jararaca induces changes in seminiferous tubules

Abstract: Background: The testis-specific isoform of angiotensin-converting enzyme (tACE) is exclusively expressed in germ cells during spermatogenesis. Although the exact role of tACE in male fertility is unknown, it clearly plays a critical function in spermatogenesis. The dipeptidase domain of tACE is identical to the C-terminal catalytic domain of somatic ACE (sACE). Bradykinin potentiating peptides (BPPs) from snake venoms are the first natural sACE inhibitors described and their structure–activity relationship studies were the basis for the development of antihypertensive drugs such as captopril. In recent years, it has been showed that a number of BPPs – including BPP-10c – are able to distinguish between the N- and C-active sites of sACE, what is not applicable to captopril. Considering the similarity between tACE and sACE (and since BPPs are able to distinguish between the two active sites of sACE), the effects of the BPP-10c and captopril on the structure and function of the seminiferous epithelium were characterized in the present study. BPP-10c and captopril were administered in male Swiss mice by intraperitoneal injection (4.7 μmol/kg for 15 days) and histological sections of testes were analyzed. Classification of seminiferous tubules and stage analysis were carried out for quantitative evaluation of germ cells of the seminiferous epithelium. The blood-testis barrier (BTB) permeability and distribution of claudin-1 in the seminiferous epithelium were analyzed by hypertonic fixative method and immunohistochemical analyses of testes, respectively. Results: The morphology of seminiferous tubules from animals treated with BPP-10c showed an intense disruption of the epithelium, presence of atypical multinucleated cells in the lumen and degenerated germ cells in the adluminal compartment. BPP-10c led to an increase in the number of round spermatids and total support capacity of Sertoli cell in stages I, V, VII/VIII of the seminiferous epithelium cycle, without affecting BTB permeability and the distribution of claudin-1 in the seminiferous epithelium. Interestingly, no morphological or morphometric alterations were observed in animals treated with captopril. Conclusions: The major finding of the present study was that BPP-10c, and not captopril, modifies spermatogenesis by causing hyperplasia of round spermatids in stages I, V, and VII/VIII of the spermatogenic cycle.