Effect of the root canal final rinse protocols on the debris and smear layer removal and on the push-out strength of an epoxy-based sealer

The aim of the present study was to evaluate the efficacy of QMiX, SmearClear, and 17% EDTA for the debris and smear layer removal from the root canal and its effects on the push-out bond strength of an epoxy-based sealer by scanning electron microscopy (SEM). Forty extracted human canines (n = 10) were assigned to the following final rinse protocols: G1-distilled water (control), G2–17% EDTA, G3-SmearClear, and G4-QMiX. The specimens were submitted to a SEM analysis to evaluate the presence of debris and smear layer, respectively, in the apical or cervical segments. In sequence, forty extracted human maxillary canines with the root canals instrumented were divided into four groups (n = 10) similar to the SEM analysis study. After the filling with AH Plus, the roots were transversally sectioned to obtain dentinal slices. The specimens were submitted to a push-out bond strength test using an electromechanical testing machine. The statistical analysis for the SEM and push-out bond strength studies were performed using the Kruskal–Wallis and Dunn tests (α = 5%). There was no difference among the G2, G3, and G4 efficacy in removing the debris and smear layer (P > 0.05). The efficacy of these groups was superior to the control group. The push-out bond strength values of G2, G3, and G4 were superior to the control group. The ability to remove the debris and smear layer by SmearClear and QMiX was as effective as the 17% EDTA. The final rinse with these solutions promoted similar push-out bond strength values.

Effect of passive ultrassonic instrumentation as a final irrigation protocol on debris and smear layer removal

This study sought to evaluate the efficacy of passive ultrasonic irrigation (PUI) on removing the smear layer and debris from root dentin using scanning electron microscopy (SEM). Twenty-five bovine incisors were manually prepared and divided into three groups according to the final irrigation protocol: EDTA, final irrigation with 12 mL of 17% EDTA for 3 minutes followed by 5 mL of 2.5% NaOCl; EDTA=PUI, final flush with 4 mL of 17% EDTA and PUI for 30 seconds. These procedures were repeated three times to standardize the volume of the irrigant. Control group, after preparation, the specimens were irrigated only with 17 mL of 2.5% NaOCl. The roots were fractured and analyzed using SEM. The intragroup analysis revealed that the EDTA=PUI protocol removed a higher amount of debris at the cervical third (P 5 0.03). The intergroup analysis revealed that EDTA=PUI presented the lowest amount of debris at the cervical third (P 5 0.007). Smear layer scores were higher in the control group compared with the EDTA and EDTA=PUI groups, but only at the cervical third (P 50.02). None of the final irrigant protocols completely removed the smear layer and debris. EDTA=PUI only improved the removal of debris at the cervical third.

A minimally destructive technique for removing the smear layer from dentine surfaces

OBJECTIVES: To develop a minimally destructive technique for removing the smear layer produced by cutting and polishing specimens of dentine prepared for use in experimental studies, e.g. on occlusion of dentinal tubules by oral health products. The aim was to avoid the damage caused by conventional techniques utilising short exposures to solutions with very low pH. METHODS: Two acetate buffers, pH 5.5, containing different concentrations of calcium and phosphate, with -log(ion activity product with respect to hydroxyapatite) (pI(HA)) of 55 or 56, were tested on slices of dentine using scanning electron microscopy (SEM). RESULTS: A solution which, from previous work, was slightly undersaturated with respect to dentine mineral, with a pI(HA) of 56, was found to remove smear layers produced by cutting and/or polishing after 15 min. However, to reliably remove debris occluding the tubules an exposure time of 2h, followed by brief ultrasonication, was necessary. After 2h treatment with this buffer, only a small amount of demineralization of the surface was detectable by SEM, while calcium and phosphorus were detectable by X-ray dispersive spectroscopy. CONCLUSION: It is possible to remove smear layers, and to open dentinal tubules, by a reasonably short exposure to an acidic buffer which is undersaturated with respect to dentine mineral.

Validation of candidate smear microscopy quality indicators, extracted from tuberculosis laboratory registers

SETTING: Kinshasa Province, Democratic Republic of Congo. OBJECTIVE: To identify and validate register-based indicators of acid-fast bacilli (AFB) microscopy quality. DESIGN: Selection of laboratories based on reliability and variation in routine smear rechecking results. Calculation of relative sensitivity (RS) compared to recheckers and its correlation coefficient (R) with candidate indicators based on a fully probabilistic analysis incorporating vague prior information using WinBUGS. RESULTS: The proportion of positive follow-up smears correlated well (median R 0.81, 95% credibility interval [CI] 0.58-0.93), and the proportion of first smear-positive cases fairly (median R 0.70, 95% CI 0.38-0.89) with RS. The proportions of both positive suspect and low positive case smears showed poor correlations (median R 0.27 and -0.22, respectively, with ranges including zero). CONCLUSIONS: The proportion of positives in follow-up smears is the most promising indicator of AFB smear sensitivity, while the proportion of positive suspects may be more indicative of accessibility and suspect selection. Both can be obtained from simple reports, and should be used for internal and external monitoring and as guidance for supervision. As proportion of low positive suspect smears and consistency within case series are more difficult to interpret, they should be used only on-site by laboratory professionals. All indicators require more research to define their optimal range in various settings.

Comparison of treatment outcomes of new smear-positive pulmonary tuberculosis patients by HIV and antiretroviral status in a TB/HIV clinic, Malawi

BACKGROUND Smear-positive pulmonary TB is the most infectious form of TB. Previous studies on the effect of HIV and antiretroviral therapy on TB treatment outcomes among these highly infectious patients demonstrated conflicting results, reducing understanding of important issues. METHODS All adult smear-positive pulmonary TB patients diagnosed between 2008 and 2010 in Malawi's largest public, integrated TB/HIV clinic were included in the study to assess treatment outcomes by HIV and antiretroviral therapy status using logistic regression. RESULTS Of 2,361 new smear-positive pulmonary TB patients, 86% had successful treatment outcome (were cured or completed treatment), 5% died, 6% were lost to follow-up, 1% failed treatment, and 2% transferred-out. Overall HIV prevalence was 56%. After adjusting for gender, age and TB registration year, treatment success was higher among HIV-negative than HIV-positive patients (adjusted odds ratio 1.49; 95% CI: 1.14-1.94). Of 1,275 HIV-infected pulmonary TB patients, 492 (38%) received antiretroviral therapy during the study. Pulmonary TB patients on antiretroviral therapy were more likely to have successful treatment outcomes than those not on ART (adjusted odds ratio : 1.83; 95% CI: 1.29-2.60). CONCLUSION HIV co-infection was associated with poor TB treatment outcomes. Despite high HIV prevalence and the integrated TB/HIV setting, only a minority of patients started antiretroviral therapy. Intensified patient education and provider training on the benefits of antiretroviral therapy could increase antiretroviral therapy uptake and improve TB treatment success among these most infectious patients.

Compilation of sedimentation rates and smear slide analysis of DSDP sites

A history of Mesozoie and Cenozoic palaeoenvironments of the North Atlantie Oeean has been developed based on a detailed analysis of the temporal and spatial distribution of major pelagie sediment facies, of hiatuses. of bulk sediment accumulation rates, and of concentrations and fluxes of the main deep-sea sediment components. The depositional history of the North Atlantic can be subdivided into three major phase: (a) Late Jurassie and Early Cretaceous phase: clastic terrigenous and biogenic pelagic sediment components accumulated rapidly under highly productive surface water masses over the entire occan basin; (b) Late Cretaceous to Early Miocene phase: relatively little terrigenous and pelagic biogenic sediment reached the North Atlantic Ocean floor, intensive hiatus formation occurred at variable rates, and wide stretches of the deep-ocean floor were covered by slowly accumulating terrigenous muds: (c) Middle Miocene to Recent phase: accumulation rates of biogenic and terrigenous deep-sea sediment components increased dramatically up to Quaternary times, rates of hiatus formation and the intensity of deep-water circulation inferred from them seem to have decreased. However, accumulation rate patterns of calcareous pelagic sediment components suggest that large scale reworking and di splacement of deep-sea sediments occurred at a variable rate over wide areas of the North Atlantic during this period.