A study of slag corrosion of oxides and oxide-carbon refractories during steel refining

The use of ceramic material as refractories in the manufacturing industry is a common practice worldwide. During usage, for example in the production of steel, these materials do experience severe working conditions including high temperatures, low pressures and corrosive environments. This results in lowered service lives and high consumptions of these materials. This, in turn, affects the productivity of the whole steel plant and thereby the cost. In order to investigate how the service life can be improved, studies have been carried out for refractories used in the inner lining of the steel ladles. More specifically, from the slag zone, where the corrosion is most severe. By combining thermodynamic simulations, plant trails and post-mortem studies of the refractories after service, vital information about the behaviour of the slagline refractories during steel refining and the causes of the accelerated wear in this ladle area has been achieved. The results from these studies show that the wear of the slagline refractories of the ladle is initiated at the preheating station, through reduction-oxidation reactions. The degree of the decarburization process is mostly dependent on the preheating fuel or the environment. For refractories without antioxidants, refractory decarburization is slower when coal gas is used in ladle preheating than when a mixture of oil and air is used. In addition, ladle preheating of the refractories without antioxidants leads to direct wear of the slagline refractories. This is due to the total loss of the matrix strength, which results in a sand-like product. Thermal chemical changes that take place in the slagline refractories are due to the MgO-C reaction as well as the formation of liquid phases from impurity oxides. In addition, the decrease in the system pressure during steel refining makes the MgO-C reaction take place at the steel refining temperatures. This reduces the refractory’s resistance to corrosion. This is a serious problem for both the magnesia-carbon and dolomite-carbon refractories. The studies of the reactions between the slagline refractories and the different slag compositions showed that slags rich in iron oxide lead mostly to the oxidation of carbon/graphite in the carbon-containing refractories. This leads to an increased porosity and wettability and therefore an enhanced penetration of slag into the refractory structure. If the slag contains high contents of alumina and or silica (such as the steel refining slag), reactions between the slag components and the dolomite-carbon refractory are promoted. This leads to the formation of low-temperature melting phases such as calcium-aluminates and silicates. The state of these reaction products during steel refining leads to an accelerated wear of the dolomite-carbon refractory. The main products of the reactions between the magnesia-carbon refractory and the steel refining slag are MgAl2O4 spinels, and calcium-aluminates, and silicates. Due to the good refractory properties of MgAl2O4 spinels, the slag corrosion resistance of the magnesiacarbon refractory is promoted.

Should personality traits be considered when refining substance misuse treatment programs?

The interplay between stable personality characteristics and environmental factors is emphasised in most contemporary approaches to individual differences. This interaction appears to be important in understanding the development of substance use and misuse. Impulsivity related personality traits such as sensation-seeking, novelty seeking, reward-sensitivity and behavioural disinhibition, are strongly linked to adolescent and adult substance use and misuse. The role of anxiety-related traits, in the development of substance misuse is less clear. Nonetheless, anxiety disorders are very common amongst adult substance misusers and almost certainly play a critical role in the maintenance of a substance use disorder and influence treatment effectiveness. The data suggest that personality influences treatment outcomes and yet these individual differences are generally not addressed in treatment. We argue in this review that interventions which are matched to these relevant personality traits may improve treatment outcomes for substance misusers. [Staiger PK, Kambouropoulos N, Dawe S. Should personality traits be considered when refining substance misuse treatment programs?

Dancing between diversity and consistency: refining assessment in postgraduate degrees in dance

Guidelines for best practice in Australian Doctoral and Masters by Research Examination, encompassing the two primary modes of investigation, written and multi-modal theses, their distinctiveness and their potential interplay.

Pseudomonas aeruginosa LBI production as an integrated process using the wastes from sunflower-oil refining as a substrate

Pseudomonas aeruginosa LBI produced surface active rhamnolipids when cultivated on waste from the sunflower-oil process under different conditions. These biosurfactants, which reduce the superficial and interfacial tensions between fluids, offer advantages over their chemical counterparts, especially because of their ecological acceptability. These molecules can be used in fields as diverse as chemical, pharmaceutical and petrochemical industries. In this work, we present the effect of C/N ratio on growth and production yield. The best production yields (Y-P/S) were achieved for C/N ratios (in g/g) of 8/1 (0.22) and 6.4/1 (0.23). The product concentration was very satisfactory (7.3 g/L) at C/N ratio of 8/1, especially when considering that the substrate was basically composed of wastes that would otherwise constitute an environmental disposal problem. (c) 2007 Elsevier Ltd. All rights reserved.

Cypsela or achene? Refining terminology by considering anatomical and historical factors

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Refining the intestinal motility test in mice to reduce animal stress

A new protocol using 3-h fast animal for intestinal motility test was developed in our laboratory aiming the 3R's concept to reduce the stress of animals. Our results may aid in formulating recommendations that can be included in revised guidelines with regard to fasting time of mice.

The manufacture of basic industrial equipment in Argentina: II: The production, transport and refining of petroleum and natural gas: the petrochemical industries = Estudio sobre la fabricación de equipos industriales de base en la Argentina: II: Producción, transporte y refinación de petróleo y gas natural: industrias petroquímicas

Includes bibliography

Alkaline sulfite/anthraquinone pretreatment followed by disk refining of Pinus radiata and Pinus caribaea wood chips for biochemical ethanol production

BACKGROUND: Alkaline sulfite/anthraquinone (ASA) cooking of Pinus radiata and Pinus caribaea wood chips followed by disk refining was used as a pretreatment for the production of low lignified and high fibrillated pulps. The pulps produced with different delignification degrees and refined at different energy inputs (250, 750 and 1600 Wh) were saccharified with cellulases and fermented to ethanol with Saccharomyces cerevisiae using separated hydrolysis and fermentation (SHF) or semi-simultaneous saccharification and fermentation (SSSF) processes. RESULTS: Delignification of ASA pulps was between 25% and 50%, with low glucans losses. Pulp yield was from 70 to 78% for pulps of P. radiata and 60% for the pulp of P. caribaea. Pulps obtained after refining were evaluated in assays of enzymatic hydrolysis. Glucans-to-glucose conversion varied from 20 to 70%, depending on the degree of delignification and fibrillation of the pulps. The best ASA pulp of P. radiata was used in SHF and SSSF experiments of ethanol production. Such experiments produced maximum ethanol concentration of 20 g L-1, which represented roughly90% of glucose conversion and an estimated amount of 260 L ethanol ton(-1) wood. P. caribaea pulp also presented good performance in the enzymatic hydrolysis and fermentation but, due to the low amount of cellulose present, only 140 L ethanol would be obtained from each ton of wood. CONCLUSION: ASA cooking followed by disk refining was shown to be an efficient pretreatment process, which generated a low lignified and high-fibrillated substrate that allowed the production of ethanol from the softwoods with high conversion yields. (C) 2012 Society of Chemical Industry

Refining the definition of hypereosinophilic syndrome

Because of advances in our understanding of the hypereosinophilic syndrome (HES) and the availability of novel therapeutic agents, the original criteria defining these disorders are becoming increasingly problematic. Here, we discuss shortcomings with the current definition of HES and recent developments in the classification of these disorders. Despite significant progress in our understanding of the pathogenesis of some forms of HES, the current state of knowledge is still insufficient to formulate a new comprehensive etiologic definition of HESs. Nevertheless, we suggest a new working definition that overcomes some of the most obvious limitations with the original definition.