Investigation of the Loss of Prestress in Prestressed Concrete Beams due to Steam Curing, HR-62, 1961

Mass production of prestressed concrete beams is facilitated by the accelerated curing of the concrete. The ·method most commonly used for this purpose is steam curing at atmospheric pressure. This requires concrete temperatures as high as 150°F. during the curing period. Prestressing facilities in Iowa are located out of doors. This means that during the winter season the forms are set and the steel cables are stressed at temperatures as low as 0°F. The thermal expansion of the prestressing cables should result in a reduction of the stress which was placed in them at the lower temperature. If the stress is reduced in the cables, then the amount of prestress ultimately transferred to the concrete may be less than the amount for which the beam was designed. Research project HR-62 was undertaken to measure and explain the difference between the initial stress placed in the cables and the actual stress which is eventually transferred to the concrete. The project was assigned to the Materials Department Laboratory under the general supervision of the Testing Engineer, Mr. James W. Johnson. A small stress bed complete with steam curing facilities was set up in the laboratory, and prestressed concrete beams were fabricated under closely controlled conditions. Measurements were made to determine the initial stress in the steel and the final stress in the concrete. The results of these tests indicate that there is a general loss of prestressing force in excess of that caused by elastic shortening of the concrete. The exact amount of the loss and the identification of the factors involved could not be determined from this limited investigation.

Comparison of methods for estimation of needle losses in Scots pine following defoliation by Bupalus piniaria

Abstract

Nitrogen and phosphorus losses from a feedlot for suckler cows

Selostus: Typpi- ja fosforikuormitus emolehmien ulkotarhassa

Reduced tillage: influence on erosion and nutrient losses in a clayey field in southern Finland

Selostus: Aurattoman viljelyn vaikutus eroosioon ja ravinnehuuhtoumiin eteläsuomlaisella, savimaalla sijaitsevalla pellolla

New Method for Breaking High Strength Prestress Cable, MLR-97-6, 1997

A new method was developed for breaking high strength prestressed cable. The old method used an aluminum oxide grit packed into a special gripping jaw. The new method uses aluminum shims wrapped around the cable and then is gripped with a V-grip. The new method gives nearly 100% "good breaks" on the cable compared to approximately 10% good breaks with the old method. In addition, the new cable breaking method gives higher ultimate tensile strengths, is more reproducible, is quicker, cleaner and easier on equipment.

Averting risk in the face of large losses: Bernoulli vs. Tversky and Kahneman

We experimentally question the assertion of Prospect Theory that people display risk attraction in choices involving high-probability losses. Indeed, our experimental participants tend to avoid fair risks for large (up to ? 90), high-probability (80%) losses. Our research hinges on a novel experimental method designed to alleviate the house-money bias that pervades experiments with real (not hypothetical) loses.Our results vindicate Daniel Bernoulli?s view that risk aversion is the dominant attitude,But, contrary to the Bernoulli-inspired canonical expected utility theory, we do find frequent risk attraction for small amounts of money at stake.In any event, we attempt neither to test expected utility versus nonexpected utility theories, nor to contribute to the important literature that estimates value and weighting functions. The question that we ask is more basic, namely: do people display risk aversion when facing large losses, or large gains? And, at the risk of oversimplifying, our answer is yes.

Loss of Prestress, Camber, and Deflection of Non-Composite and Composite Structures Using Different Weight Concretes, HR-137, 1970

General equations are presented for predicting loss of prestress and camber of both composite and non- composite prestressed concrete structures. Continuous time functins of all parameters needed to solve the equations are given, and sample results included. Computed prestress loss and camber are compared with experimental data for normal weight and lightweight concrete. Methods are also presented for predicting the effect of non-prestressed tension steel in reducing time-dependent loss of prestress and camber, and for the determination of short-time deflections of uncracked and cracked prestressed members. Comparisons with experimental results are indicated for these partially prestressed methods.

Reduced microwave losses of YBa2Cu3O7_thin films on electro-optic LiNbO3 crystals

We report on the growth of epitaxial YBa2Cu3O7 thin films on X-cut LiNbO3 single crystals. The use of double CeO2/YSZ buffer layers allows a single in-plane orientation of YBa2Cu3O7, and results in superior superconducting properties. In particular, surface resistance Rs values of 1.4 m¿ have been measured at 8 GHz and 65 K. The attainment of such low values of Rs constitutes a key step toward the incorporation of high Tc materials as electrodes in photonic and acoustic devices.

Electrical pump & probe and injected carrier losses quantification in Er doped Si slot waveguides

Electrically driven Er3+ doped Si slot waveguides emitting at 1530 nm are demonstrated. Two different Er3+ doped active layers were fabricated in the slot region: a pure SiO2 and a Si-rich oxide. Pulsed polarization driving of the waveguides was used to characterize the time response of the electroluminescence (EL) and of the signal probe transmission in 1 mm long waveguides. Injected carrier absorption losses modulate the EL signal and, since the carrier lifetime is much smaller than that of Er3+ ions, a sharp EL peak was observed when the polarization was switched off. A time-resolved electrical pump & probe measurement in combination with lock-in amplifier techniques allowed to quantify the injected carrier absorption losses. We found an extinction ratio of 6 dB, passive propagation losses of about 4 dB/mm, and a spectral bandwidth > 25 nm at an effective d.c. power consumption of 120 μW. All these performances suggest the usage of these devices as electro-optical modulators.

Assessing trends in insured losses from floods in Spain 1971-2008

Economic impacts from floods have been increasing over recent decades, a fact often attributed to a changing climate. On the other hand, there is now a significant body of scientific scholarship all pointing towards increasing concentrations and values of assets as the principle cause of the increasing cost of natural disasters. This holds true for a variety of perils and across different jurisdictions. With this in mind, this paper examines the time history of insured losses from floods in Spain between 1971 and 2008. It as- sesses whether any discernible residual signal remains after adjusting the data for the increase in the number and value of insured assets over this period of time. Data on insured losses from floods were sourced from Consorcio de Com- pensacíon de Seguros (CCS). Although a public institution, CCS compensates homeowners for the damage produced by floods, and thus plays a role similar to that of a private insurance company. Insured losses were adjusted using two proxy measures: first, changes in the total amount of annual surcharges (premiums) paid by customers to CCS, and secondly, changes in the total value of dwellings per year. The adjusted data reveals no significant trend over the period 1971-2008 and serves again to confirm that at this juncture, societal in- fluences remain the prime factors driving insured and economic losses from natural disasters.

Stochasticity in economic losses increases the value of reputation in indirect reciprocity.

Recent theory predicts harsh and stochastic conditions to generally promote the evolution of cooperation. Here, we test experimentally whether stochasticity in economic losses also affects the value of reputation in indirect reciprocity, a type of cooperation that is very typical for humans. We used a repeated helping game with observers. One subject (the "Unlucky") lost some money, another one (the "Passer-by") could reduce this loss by accepting a cost to herself, thereby building up a reputation that could be used by others in later interactions. The losses were either stable or stochastic, but the average loss over time and the average efficiency gains of helping were kept constant in both treatments. We found that players with a reputation of being generous were generally more likely to receive help by others, such that investing into a good reputation generated long-term benefits that compensated for the immediate costs of helping. Helping frequencies were similar in both treatments, but players with a reputation to be selfish lost more resources under stochastic conditions. Hence, returns on investment were steeper when losses varied than when they did not. We conclude that this type of stochasticity increases the value of reputation in indirect reciprocity.

Bernoulli correction to viscous losses: Radial flow between two parallel discs

For a massless fluid (density = 0), the steady flow along a duct is governed exclusively by viscous losses. In this paper, we show that the velocity profile obtained in this limit can be used to calculate the pressure drop up to the first order in density. This method has been applied to the particular case of a duct, defined by two plane-parallel discs. For this case, the first-order approximation results in a simple analytical solution which has been favorably checked against numerical simulations. Finally, an experiment has been carried out with water flowing between the discs. The experimental results show good agreement with the approximate solution