Produção e aplicação de adubo orgânico, proveniente da compostagem de resíduos da FCT/UNESP

This work presents the objective of producing organic fertilizer from the waste generated at FCT/UNESP and its use in the growing sunflower. For this, there were collected wastes of pruning/weeding and organic waste from the canteen. It were made two types of treatments, one conventional and the other mechanized, using three mass ratios: ratio 1 (30% wastes of pruning/weeding (RP) + 70% organic waste (RC)), ratio 2 (50% RP + 50% RC) and ratio 3 (70% RP + 30% RC). The conventional system was done windrow with turning manual and the mechanized system was developed in reactors by injecting compressed air. The compounds produced were analyzed in terms of pH, organic matter, organic carbon, mineral residue, nitrogen, phosphorus and potassium, which could be compared to the values stipulated by the Instrução Normativa n° 25 de 23/07/2009 do Ministério da Agricultura, Pecuária e Abastecimento. The compounds produced were used on growing sunflowers in 14 different conditions for the systems manual and mechanized, totaling 26 treatments with the following proportions... (Complete abstract click electronic access below)

Análise das emissões de gases do efeito estufa na produção do milho através da fertilização por resíduos de biocombustível. Estudo de caso : Dedelow - Brandemburgo - Alemanha

The focus of this research study were gas exchange between soil and atmosphere of nitrous oxide (N2O) between different fertilization treatments Corn The research, conducted in the experimental field Dedelow - Brandenburg / Germany, analyzed three different fertilization treatments, aiming to quantify GHE emissions, to identify the influence of the residue of biogas in the release of these gases process in agricultural soils in search for a solution fertilization less harmful to the environment and the greenhouse effect , based on the comparison of three treatments: organic fertilization, mineral fertilization and no fertilization. It was found through the analysis of the measurements that the first was the one which issued N2O, showing that even though coming from the residue of biogas , when returned to the soil, it becomes harmful to the environment and global warming . The cultivation of energy crops can lower or raise the emissions of greenhouse gases, so it is necessary for further research on this question not only in Germany , where such research is in continuity, but also in Brazil, a pioneer in the introduction to his energy matrix of a biofuel produced from cane sugar

Influência da adubação em cana-de-açúcar sobre as bactérias solubilizadoras de fósforo

Pós-graduação em Microbiologia Agropecuária - FCAV

Resposta da soqueira da cana-de-açúcar à aplicação de nitrogênio na ausência e na presença de silício

Pós-graduação em Agronomia (Ciência do Solo) - FCAV

Imobilização de fosfatos em microesferas poliméricas contendo biochar: preparação, caracterização e liberação lenta em sistemas aquosos

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Fontes e manejo de nitrogênio na cultura da batata em solos arenosos

Pós-graduação em Agronomia (Agricultura) - FCA

Alteração da fertilidade do solo como indicador do processo de antropização e presença de atividades não agrícolas no assentamento rural Horto Aimorés, municípios de Bauru e Pederneiras/SP =: Change of soil fertility as an indicator of the anthropization process and presence of non agricultural activities at the rural settlement Horto Aimorés, cities of Bauru and Pederneiras/ SP

Pós-graduação em Geografia - FCT

Recuperação de pastagem com estilosantes Campo Grande e adubação Fosfatada

Pós-graduação em Ciência e Tecnologia Animal - FEIS

Aplicação mecanizada de N-P-K individualizada na cultura da cana-de-açúcar

Pós-graduação em Agronomia (Produção Vegetal) - FCAV

Efeito da fertilização e da disponibilidade hídrica na produtividade florestal e na eficiência do uso da luz de povoamentos clonais de eucalyptus spp. em Bocaiúva,MG

Pós-graduação em Ciência Florestal - FCA

Desenvolvimento de hidrogéis nanoestruturados baseados em polissacarídeo e zeólita para aplicação em sistemas de liberação controlada

Pós-graduação em Ciência dos Materiais - FEIS

Síntese e caracterização de nanocompósitos constituídos por nanoargila e hidrogel para uso agrícola

Pós-graduação em Ciência dos Materiais - FEIS

Análise das principais variáveis na flotação industrial do complexo de mineração de Tapira - MG

Faced with an agribusiness expansion scenario and the increase in fertilizer consumption due to the exponential growth of the population, it is necessary to make better use of existing reserves, by obtaining products of better quality and in adequate quantities to meet demand national. In Tapira Mining Complex, Vale Fertilizantes, the phosphate concentrate is produced with content of 35.0% P2O5 from ore with content of about 8.0% P2O5, which are intended to supply Complex Industrial Uberaba and Araxá Minero Chemical Complex for the production of fertilizers. The industrial flotation step responsible for the recovery of P2O5 and hence the viability of the business is divided into the crumbly, grainy and ultrathin circuits, and, friable and granular concentrate comprise the conventional concentrated. Today only 14.7% of the mass which feeds the mill product becomes, the remainder being considered losses in the process, and the larger mass losses are located in the waste of flotation, representing 42.3%. From 2012 to 2014, the daily global mass recovery processing plants varied from 12.4 to 15.9% while the daily metallurgical recovery of P2O5 from 48.7 to 82.4%. By the degree of variability, it appears that the plant operated under different conditions. Seen this, this study aimed to analyze the influence of operational and process variables in P2O5 mass and metallurgical recoveries of industrial flotation circuits of grainy, crumbly and ultrathin. And besides was made an analysis of the effect of ore variables, as degrees, hardnesse and the ore front 02 percentage, in global recoveries of processing plant and the effect of dosages of reagents in the recoveries obtained from the bench flotation using the experimental design methodology. All work was performed using the historical database of Vale Fertilizantes of Tapira-MG, where all independent variables were dimensionless as the experimental range used. To make the statistical analysis it used the response surface technique and the values of the independent variables that maximize recoveries were found by canonical analysis. In the study of industrial flotation circuit crispy were obtained from 41.3% mass recovery and 91.3% metallurgical recovery P2O5, good values for the circuit, and the highest recoveries occur for solids concentration of the new flotation power between 45 and 50%, which values are assigned to the residence time of the pulp in cells and industrial flotation columns. The greater the number of ore heaps resumed on the higher the mass recovery, but in this scenario flotation becomes unstable because there is enormous weight variation in the feed. Higher recoveries are obtained for mass depressant dosage exceeding 120 g / t for synthetic collector dosage of 11.6%. In the study of industrial flotation circuit of the granulate were obtained 28.3% to 79.4% mass recovery and metallurgical recovery of P2O5 being considered good values for the circuit. Higher recoveries are obtained when the front ore 02 percentage is above 90%, because the ore of this front have more clear apatite. Likewise recoveries increase when the level of pulp rougher step is highest due to the high mass of circulating step receives loads. In the analysis of industrial flotation circuit of the ultrafine were obtained 23.95% of mass recovery, and the same is maximized to depressant dosage and the top collector 420 and 300 g / t, respectively. The analysis of the influence of variables ore, it was observed that higher recoveries are obtained for ores with P2O5 content above 8.0%, Fe2O3 content in the order of 28% forward and 02 of ore percentage of 83%. Hard ore percentage has strong influence on recoveries due to mass division in the circuit that is linked to this variable. However, the hard ore percentage that maximizes recoveries was very close to the design capacity of the processing plant, which is 20%. Finally, the study of the bench flotation, has noted that in friable and granular circuits the highest recoveries are achieved for a collector dosage exceeding 250 g / t and the simultaneous increase of collector dosage and synthetic collector percentage contributes to the increase recovery in the flotation, but this scenario is suitable to produce a concentrate poorer in terms of P2O5 content, showing that higher recovery is not always the ideal scenario. Thus, the results show the values of variables that provide higher recoveries in the flotation and hence lower losses in the waste.

Adubação de sistemas: antecipação de adubação nitrogenada para a cultura do milho em integração lavoura-pecuária

Traditionally in no-tillage systems, fertilization is done to the catch crop. In general nutrient cycling in crop systems has not been treated as an important tool in the process of nutrient supplying for plants. The type and the condition in which vegetable residuesis decomposed can affect the efficiency of nutrient cycling.This study assessed the effect of anticipated nitrogen fertilization in crop-livestock systems on cultivated cornproduction, rate ofnutrient release from plant residue, and theN-minerallevels of soil. The study was carried out in the city Abelardo Luz (SC) in a Clayey Oxisol. The experimental design was a randomized block design with three replications. The treatments were arranged in a 2 x 2 factorial arrangement. The first factor was N Fertilization Time: in the N-Pasture level, nitrogen (200 kg ha-1 N) and N-Grains level, no nitrogen was applied. The second factor was the Grazing Height, characterized by two sward heights of oat at 15 cm (Low Height Pasture) and at 30 cm (High Height Pasture). Corn hybrid ‘Máximus’ was sowed in 10thOctober, 31 days after the removal of animals. In the twelve resulting plots from the combination of treatments on pasture phase (N Fertilization Time x Grazing Height) rates of N-fertilizer (0, 100, 200 e 300 Kg ha-1 of N) as urea were allocated in the split plot.We conclude that anticipated N fertilization of winter cover crop pasture to provide high-quality forage and carry-over N to the subsequent corn crop and may eventually replace side drees nitrogen fertilization on corn and can improve overall N fertilizer efficiency use in integrated crop-livestock systems.The rate of K release from plant residues is very fast, releasing large quantities in the first days after plant desiccation.Despite of considerably high nitrogen dose used in both the pasture and at the grain crop it was not observed nitrate leaching risks during the study period.

Fontes e períodos de contato de fertilizantes e germinação de sementes de Brachiaria brizantha

A mistura de sementes forrageiras com fertilizantes pode viabilizar o cultivo consorciado, por diminuir a competição com a cultura produtora de grãos. No entanto, se realizada muito antes da semeadura, pode prejudicar a emergência e o estabelecimento das forrageiras. Realizou-se trabalho em condições de laboratório e casa de vegetação, em Botucatu (SP), com o objetivo de avaliar a germinação de sementes de Brachiaria brizantha em razão do tempo de mistura com fertilizantes químicos. O delineamento experimental empregado foi o inteiramente casualizado, com quatro repetições. Os tratamentos constaram de um fatorial 6 x 8, constituído de diferentes períodos de contato das sementes de Brachiaria brizantha cultivar Marandu (0, 6, 12, 24, 48 e 96 h) com os fertilizantes uréia, sulfato de amônio, cloreto de potássio, sulfato de potássio, superfosfato simples, superfosfato triplo e formulado N-P-K (8-28-16) nas formas de mistura de grânulos e farelado. Não houve relação entre os testes de germinação em laboratório e a emergência a campo. No solo, a emergência das plântulas de Brachiaria brizantha não é afetada se realizada a mistura com fertilizantes minerais fosfatados, cloreto de potássio e formulado farelado até 96 h antes da semeadura.