聚氧化乙烯(PEO)/聚双酚A羟基醚(PBHE)共混体系的非等温结晶动力学

本文联系Avrami方程和Ozawa方程,得出一个适合于非等温结晶动力学过程的新的基本方程,由这个方程可获得描述非等温结晶动力学过程的某些参数,并用DSC方法,对PEO/PBHE共混体系的非等温结晶动力学进行了研究,对实验结果进行了讨论.

PEO/PVP共混体系结晶行为

本文用WAXD、PLM、DSC方法研究了聚氧化乙烯(PEO)/聚乙烯基吡咯烷酮(PVP)共混体系的结晶行为,探索了两组分聚合物间相互作用及体系结晶度与非晶组分含量的关系。DSC研究表明PEO/PVP共混体系具有两个玻璃化转变温度,分别是纯组分的T_g,无相容性。应用Avrami和LH方程对其动力学参数进行了研究。偏光显微镜观察了共混物结构形态。

微量PEO-PS-PEO/PEO共混体系结晶过程中共聚物胶束的成核作用

本工作将Leibler等近期关于含非晶两嵌段共聚物“稀固体溶液”的胶束理论推广并应用到含结晶三嵌段共聚物的“稀固体溶液”.对微量聚氧化乙烯-聚苯乙烯-聚氧化乙烯三嵌段共聚物/聚氧化乙烯均聚物共混体系的结晶行为进行了研究.结果表明,共聚物胶束在共混体系的结晶过程中可以起到成核剂的作用.这对改善结晶均聚物的性能具有一定的应用价值.

THE IMPEDANCE STUDY OF MODIFIED PEO POLYMER ELECTROLYTE

The ultra-thin modified PEO (polyethylene oxide)-LiClO4 polymer electrolyte film (50-mu-m) was obtained by solution-casting technique. Impedance spectra were taken on the cells consisting of above PEO film electrolyte and ion-blocking or nonblocking electrodes. The ambient conductivity as high as 1.33 X 10(-4)S cm-1 could be achieved for PEO electrolyte modified by the crosslinking. It was shown that the resistance at the interface between solid polymer electrolyte and lithium electrode is growing with increasing the storage time. At high temperature, as 96-degrees-C, the ionic transport is clearly controlled by diffusion.

WATER-SOLUBLE AND AMPHIPHILIC POLYMERS .6. A STUDY ON THE SURFACE-COMPOSITION OF CAST FILMS OF PST/PMAA AND PEO-PST-PEO BLOCK POLYMERS BY XPS

Thin films of PSt/PMAA and PEO-PSt-PEO block polymers were deposited on a polystyrene substrate by solution adsorption (with or without solvent treatment), and the film surfaces were characterized by means of XPS. Direct solvent - casting of PEO-PSt-PEO from benzene solutions resulted in PSt-rich surfaces, whereas PMAA richer surfaces were obtained for PSt/PMAA films cast from DMF solutions. Moreover, solvent treatment after casting had profound effect on the film surface composition. Treatment with water markedly increased the surface concentration of polar PEO segments. In the case of PSt-PMAA block polymers, the PSt content on the surface increased in the order of water < ethanol < cyclohexane < petroleum ether, the last-named giving films with almost pure PSt surface. It is well worth noticing that the bulk composition had little to do with the surface composition for both PSt/PMAA and PEO-PSt-PEO block polymers within the composition range investigated when subsequent solvent treatment was applied.

PMMA-PEO共混体系的辐射交联

聚甲基丙烯酸甲酯(PMMA)是典型的辐射裂解型聚合物。经辐照后,PMMA主链发生无规断裂。在聚合物共混体系中,PMMA是否能发生交联,这是辐射化学中一个非常重要的研究课题之一,也是一项探索性工作。 PMMA-PEO共混体系是可以分子水平共溶的体系。本文试图将共混体系的相容性与共混体系中的裂解型聚合物的辐射效应联系起来,讨论PMMA-PEO共混体系的辐射交联。

PEO/PBHE共混体系X射线散射研究

在聚环氧乙烷(PEO)/聚双酚A羟基醚(PBHE)共混体系中PEO是一个强质子受体,而PBHE是一个强质子给体,两者极易形成氢键,十分有利于形成互容对。笔者研究了PEO/PBHE共混体系的相容性,等温及非等温结晶动力学,本文根据Vonk提出的一维电子密度相关函数,分析了PEO/PBHE的SAXS现象,求得了共混体系的结晶度,片晶层厚度,过渡层厚度及长周期等结构参数。

PEO/PVAc共混体系辐射交联反应中溶胶分数与辐照剂量间的关系

交联度对由聚合物共混物辐射交联而制备出的材料的性能影响很大,研究共混体系的辐射交联度和交联行为是十分重要的。通常,用溶胶分数与辐照剂量间的关系表征聚合物的交联度和交联行为。文献[2]发现线性聚合物的溶胶分数与辐照剂量间的关系与高分子链结构参数有关。本文试图考察共混体系的辐射交联行为是否也与高分子链结构有关,并将线性聚合物的关系式(1)推广应用到PEO/PVAc共混体系中。目前,有关这方面的研究工作还未曾见文献详细报道。

交联共聚物(ER-PEO)及其与NaSCN络合物的结构研究

环氧树脂(ER)与聚环氧乙烷(PEO)的共混物经水/乙醇萃取后的剩余物为交联ER-PEO非晶共聚物。萃取分析表明,ER/PEO中约有50wt·％的PEO与ER形成ER-PEO交联共聚物。ER/PEO与NaSCN络合后,由于Na~+的配位络合作用,使结晶能力进一步降低。

Fractionated crystallization and fractionated melting of confined PEO microdomains in PB-b-PEO and PE-b-PEO diblock copolymers

The confined crystallization of poly(ethylene oxide) (PEO) in predominantly spherical microdomains formed by several diblock copolymers was studied and compared. Two polybutadiene-b-poly(ethylene oxide) diblock copolymers were prepared by sequential anionic polymerization (with approximately 90 and 80 wt % polybutadiene (PB)). These were compared to equivalent samples after catalytic hydrogenation that produced double crystalline polyethylene-b-poly(ethylene oxide) diblock copolymers. Both systems are segregated into microdomains as indicated by small-angle X-ray scattering (SAXS) experiments performed in the melt and at lower temperatures. However, the PB-b-PEO systems exhibited a higher degree of order in the melt. A predominantly spherical morphology of PEO in a PB or a PE matrix was observed by both SAXS and transmission electron microscopy, although a possibly mixed morphology (spheres and cylinders) was formed when the PEO composition was close to the cylinder-sphere domain transitional composition as indicated by SAXS. Differential scanning calorimetry experiments showed that a fractionated crystallization process for the PEO occurred in all samples, indicating that the PE cannot nucleate PEO in these diblock copolymers. A novel result was the observation of a subsequent fractionated melting that reflected the crystallization process. Sequential isothermal crystallization experiments allowed us to thermally separate at least three different crystallization and melting peaks for the PEO microdomains. The lowest melting point fraction was the most important in terms of quantity and corresponded to the crystallization of isolated PEO spheres (or cylinders) that were either superficially or homogeneously nucleated. This was confirmed by Avrami index values of approximately 1. The isothermal crystallization results indicate that the PE matrix restricts the crystallization of the covalently bonded PEO to a higher degree compared to PB.

Structural analysis of PEO-PBO copolymer monolayers at the air-water interface

X-ray reflectivity (XR) and grazing incidence X-ray diffraction (GIXD) have been used to examine an oxyethylene-b-oxybutylene (E23B8) copolymer film at the air-water interface. The XR data were fitted using both a one- and a two-layer model that outputted the film thickness, roughness, and electron density. The best fit to the experimental data was obtained using a two-layer model (representing the oxyethylene and oxybutylene blocks, respectively), which showed a rapid thickening of the copolymer film at pressures above 7 mN/m. The large roughness values found indicate a significant degree of intermixing between the blocks and back up the GIXD data, which showed no long range lateral ordering within the layer. It was found from the electron density model results that there is a large film densification at 7 mN/m, possibly suggesting conformational changes within the film, even though no such change occurs on the pressure-area isotherm at the same surface pressure.

Self-assembly of telechelic tyrosine end-capped PEO and poly(alanine) polymers in aqueous solution

The self-assembly in aqueous solution of three novel telechelic conjugates comprising a central hydrophilic polymer and short (trimeric or pentameric) tyrosine end-caps has been investigated. Two of the conjugates have a central poly(oxyethylene) (polyethylene oxide, PEO) central block with different molar masses. The other conjugate has a central poly(l-alanine) (PAla) sequence in a purely amino-acid based conjugate. All three conjugates self-assemble into β-sheet based fibrillar structures, although the fibrillar morphology revealed by cryogenic-TEM is distinct for the three polymers—in particular the Tyr5-PEO6k-Tyr5 forms a population of short straight fibrils in contrast to the more diffuse fibril aggregates observed for Tyr5-PEO2k-Tyr5 and Tyr3-PAla-Tyr3. Hydrogel formation was not observed for these samples (in contrast to prior work on related systems) up to quite high concentrations, showing that it is possible to prepare solutions of peptide–polymer-peptide conjugates with hydrophobic end-caps without conformational constraints associated with hydrogelation. The Tyr5-PEO6k-Tyr5 shows significant PEO crystallization upon drying in contrast to the Tyr5-PEO2k-Tyr5 conjugate. Our findings point to the remarkable ability of short hydrophobic peptide end groups to modulate the self-assembly properties of polymers in solution in model peptide-capped “associative polymers”. Retention of fluidity at high conjugate concentration may be valuable in potential future applications of these conjugates as bioresponsive or biocompatible materials, for example exploiting the enzyme-responsiveness of the tyrosine end-groups

Rádio peão: estudo dos mecanismos, tipologia e os efeitos dos rumores nas organizações

Esta dissertação tem como tema o estudo da rádio peão, equivalente brasileiro da grapevine americana e dos rumores e boatos que circulam nas organizações. O trabalho contém a revisão da teoria existente sobre o assunto, abrangendo seus principais mecanismos de . surgimento e transformação, a tipologia, e classificação dos rumores, segundo seus aspectos sociais e psicológicos. Também analisa as diversas metodologias de pesquisa do assunto. Ao final são feitas algumas recomendações para as empresas e sugeridos alguns temas para aprofundamento futuro do assunto.

O peão e o acidente de trabalho na construção civil do Rio de Janeiro: elementos para uma avaliação do papel da educação nas classes trabalhadoras

This dissertation seeks to identify specifications bu which the Subsection cf Buildings c f the Civil Construction os Rio de Janeiro could be improved. It attempt to determine the factors that make construction workers both victims of accidents, as well as the cause of these accidents. It a150 seeks t o identify the means af the capitalist way that as the producer specific kind af society, creates this type af invisible of a worker. Further more, to verify the violent ar disguised ways, that lead the worker to have a guilty consclence relative to himself and to the other workers , and maklng him feel responsible even for accident - related deaths on the job. A revolting factor is that malnutrition and endemic hunger, are in large part responsible for accidents at work in the capitalist production system, ln which production relations are still primitive. Therefore, the accidents at work are a product of society, especially caused by conditions in the construction sector . This fac 19 often masked, and responsibility is put on the worker ln 77,5~ of work related accident . Under these specific working conditions the cumulative overtime hours of work and tasks make the rythm and working hours extreme and overburdensome. The large and modern firms subcantract to smoller construc~i ns firms who have more dangeraus working condictions which result in more frequent and mayor accidents. These are not computed in the statistics of the large firms and the workers of the subcontractors do not appear on the builging construction lists, and are therefore a non - existent entities. Even opressed, the workers still continue to work under these conditions mak1ng there resistence a form af struggle. The Education that intends to be transformed in to an instrument of the workers struggle, should stimulated the participation in the daily educational and political practices and try to reconstructed what the dominant knowledge has fragmented: the ptoduction of existence as an integrated whole.