Swath bathymetry using phase difference: Theoretical analysis of acoustical measurement precision

The phase difference principle is widely applied nowadays to sonar systems used for sea floor bathymetry, The apparent angle of a target point is obtained from the phase difference measured between two close receiving arrays. Here we study the influence of the phase difference estimation errors caused by the physical structure of the backscattered signals. It is shown that, under certain current conditions, beyond the commonly considered effects of additive external noise and baseline decorrelation, the processing may be affected by the shifting footprint effect: this is due to the fact that the two interferometer receivers get simultaneous echo contributions coming from slightly shifted seabed parts, which results in a degradation of the signal coherence and, hence, of the phase difference measurement. This geometrical effect is described analytically and checked with numerical simulations, both for square- and sine-shaped signal envelopes. Its relative influence depends on the geometrical configuration and receiver spacing; it may be prevalent in practical cases associated with bathymetric sonars. The cases of square and smooth signal envelopes are both considered. The measurements close to nadir, which are known to be especially difficult with interferometry systems, are addressed in particular.

Comments on hydrographic and topographic LIDAR acquisition and merging with multibeam sounding data acquired in the Olympic Coast National Marine Sanctuary

In April 2005, a SHOALS 1000T LIDAR system was used as an efficient alternative for safely acquiring data to describe the existing conditions of nearshore bathymetry and the intertidal zone over an approximately 40.7 km2 (11.8 nm2) portion of hazardous coastline within the Olympic Coast National Marine Sanctuary (OCNMS). Data were logged from 1,593 km (860 nm) of track lines in just over 21 hours of flight time. Several islands and offshore rocks were also surveyed, and over 24,000 geo-referenced digital still photos were captured to assist with data cleaning and QA/QC. The 1 kHz bathymetry laser obtained a maximum water depth of 22.2 meters. Floating kelp beds, breaking surf lines and turbid water were all challenges to the survey. Although sea state was favorable for this time of the year, recent heavy rainfall and a persistent low-lying layer of fog reduced acquisition productivity. The existence of a completed VDatum model covering this same geographic region permitted the LIDAR data to be vertically transformed and merged with existing shallow water multibeam data and referenced to the mean lower low water (MLLW) tidal datum. Analysis of a multibeam bathymetry-LIDAR difference surface containing over 44,000 samples indicated surface deviations from –24.3 to 8.48 meters, with a mean difference of –0.967 meters, and standard deviation of 1.762 meters. Errors in data cleaning and false detections due to interference from surf, kelp, and turbidity likely account for the larger surface separations, while the remaining general surface difference trend could partially be attributed to a more dense data set, and shoal-biased cleaning, binning and gridding associated with the multibeam data for maintaining conservative least depths important for charting dangers to navigation. (PDF contains 27 pages.)

Multibeam coupling in photorefractive SBN:Ce

Theoretical and experimental results are presented for simultaneous multibeam coupling in photorefractive SBN:Ce. Within a single crystal, multiple signals are amplified through a coupling process that employs a single pump. The coupling gain of each signal results from coupling both between the pump and the signal and between different signals. The amount of gain that each signal receives is dependent on the intensity of the incident signal; thus a competition for the gain exists among the various signals.

Formation of array microstructures on silicon by multibeam interfered ferntosecond laser pulses

We report on an optical interference method to fabricate array microstructures on the surface of silicon wafers by means of five-beam interference of femtosecond laser pulses. Optical microscope and scanning electron microscope observations revealed microstructures with micrometer-order were fabricated. The diffraction characteristics of the fabricated structures were evaluated. The present technique allows one-step realization of functional optoelectronic devices on silicon surface. (C) 2004 Elsevier B.V. All rights reserved.

Formation of arrayed holes on metal foil and metal film by multibeam interfering femtosecond laser beams

We report on an optical interference method to fabricate arrayed holes on metal nickel foil and aluminum film deposited on glass substrate by means of five-beam interference of femtosecond laser pulses. Optical microscope and scanning electron microscope observations revealed that arrayed holes of micrometre-order were fabricated on both metal foil and metal film. The present technique allows one-step, large-area, micrometric processing of metal materials for potential industrial applications.

A field guide for Agency staff operating the SIMRAD EY500 portable scientific echosounder. 2nd draft 3rd August 1999

This manual has been produced by members of the national acoustics group (NAG) and represents the first in a series of outputs designed to promote co-ordination and consistency in Agency hydroacoustic surveys. It is designed as a field guide for Agency staff operating the SIMRAD EY500 portable scientific echosounder. It should be simplistic enough for the newcomer to EY500 to be able to set up and run a mobile hydroacoustic survey with some knowledge of the supporting theory. It should act as guidance for standardisation of survey procedures providing a concise list of settings and recommendations that can be used as a quick reference guide in the field. This manual condenses 5 years of practical experience of surveying fish populations using Simrad hardware and software for surveying large rivers and still waters throughout England and Wales. This document should be used as a companion to the manufacturers instruction manual and not act as a substitute for it.

Measurements of total scattering spectra from bocaccio (Sebastes paucispinis)

Marine sportfishing in southern California is a huge industry with annual revenues totaling many billions of dollars. However, the stocks of lingcod and six rockfish species have been declared overfished by the Pacific Fisheries Management Council. As part of a multifaceted fisheries management plan, marine conservation areas, covering many million square nautical miles, have been mandated. To monitor the recovery of the rockfish stocks in these areas, scientists are faced with the following challenges: 1) multiple species of rockfish exist in these areas; 2) the species reside near or on the bottom at depths of 80 to 300 m; and 3) they are low in numerical density. To meet these challenges, multifrequency echosounders, multibeam sonar, and cameras mounted on remotely operated vehicles are frequently used (Reynolds et al., 2001). The accuracy and precision of these echosounder results are largely dependent upon the accuracy of the species classification and target strength estimation (MacLennan and Simmonds, 1992).

The use of multibeam sonar mapping techniques to refine population estimates of the endangered white abalone (Haliotis sorenseni)

Multibeam sonar mapping techniques provide detailed benthic habitat information that can be combined with the data on species-specific habitat preferences to provide highly accurate calculations of populations in a particular area. The amount of suitable habitat available for the endangered white abalone (Haliotis sorenseni) was quantified to aid in obtaining an accurate estimate of the number of remaining individuals at two offshore banks and one island site off the coast of southern California. Habitat was mapped by using multibeam sonar survey techniques and categorized by using rugosity and topographic position analysis. Abalone densities were evaluated by using a remotely operated vehicle and video transect methods. The total amount of suitable habitat at these three sites was far greater than that previously estimated. Therefore, although present estimates of white abalone densities are several orders of magnitude lower than historic estimates, the total population is likely larger than previously reported because of the additional amount of habitat surveyed in this study.

Integration of submersible transect data and high-resolution multibeam sonar imagery for a habitat-based groundfish assessment of Heceta Bank, Oregon

In the face of dramatic declines in groundfish populations and a lack of sufficient stock assessment information, a need has arisen for new methods of assessing groundfish populations. We describe the integration of seafloor transect data gathered by a manned submersible with high-resolution sonar imagery to produce a habitat-based stock assessment system for groundfish. The data sets used in this study were collected from Heceta Bank, Oregon, and were derived from 42 submersible dives (1988–90) and a multibeam sonar survey (1998). The submersible habitat survey investigated seafloor topography and groundfish abundance along 30-minute transects over six predetermined stations and found a statistical relationship between habitat variability and groundfish distribution and abundance. These transects were analyzed in a geographic information system (GIS) by using dynamic segmentation to display changes in habitat along the transects. We used the submersible data to extrapolate fish abundance within uniform habitat patches over broad areas of the bank by means of a habitat classification based on the sonar imagery. After applying a navigation correction to the submersible-based habitat segments, a good correlation with major boundaries on the backscatter and topographic boundaries on the imagery were apparent. Extrapolation of the extent of uniform habitats was made in the vicinity of the dive stations and a preliminary stock assessment of several species of demersal fish was calculated. Such a habitat-based approach will allow researchers to characterize marine communities over large areas of the seafloor.