967 resultados para Liberação de promessas
Resumo:
Due to an increasing interest, a vast number of biodegradable polymers have been obtained recently. Polymers naturally produced, such as cellulose, starch, chitosan and alginate, represent biodegradable materials, with low toxicity and low cost. Among polysaccharides, chitosan has been of great interest of the industrial and academic research, due to its special qualities of biodegradability and biocompatibility and, on the other hand, to the versatility of its use in several physical forms and products. A significant growth in the development of new dosage forms capable to deliver the drug in a controlled and targeted way has been observed in these last years. Such pharmaceutical forms search, mainly, the reduction of the dose administered and of the administration frequency, the reduction of adverse side effects and, consequently, a better patient compliance. The present paper describes the use of chitosan in pharmaceutical products, especially in drug controlled delivery systems.
Resumo:
Purpose: To evaluate the quantity of Mitomycin C discharged from different materials with the same size, potentially used in the application of this medicine accessible in the surgery center of an Universitarian Hospital. Material and Method: It was studied 20 fragments with 5 to 5mm, from each 5 materials: Lyostypt, Weck sponge, absorbable cloth which is used to clean, cotton plate and of cotton swab concerning the saturation capacity and the quantity of mitomicyn discharged. In the first stage, it was studied the saturation capacity from each material. In the second stage, it was applied 0,1 ml solution of Mitomicyn C (0,5 mg/ml) and it was measured the biggest discharge halo in the filter paper and the discharged quantity (the difference between the weight before and after the medicine discharge). Results: The absorveble capacity from each material varied from 0,144 ml (absorbable cloth) to 0,216 ml Weck sponge. The discharge of Mitomicyn C was varied too, the biggest was the cotton plate and absorbable cloth. The Weck sponge and the cotton (of cotton swab) discharges the same quantity. Conclusion: The different materials discharged different quantities of Mitomicyn C. This can explain the different results of the trabeculectomy with Mitomicyn C. The surveys must inform not only the material used to apply the mitomycin C but the volume used too. Because the same values of mitomycin C liberation, cotton may substitute Weck sponje in trabeculectomy.
Resumo:
Depending on formula composition, microemulsions may be used as a vehicle for drug administration. In this work the main applicable parameters used in the development of pharmaceutical microemulsions (ME) are analyzed. The conceptual description of the system, theoretical parameters related to formation of internal phases and some aspects of ME stability are described. The pseudo ternary phase diagram is used to characterize ME boundaries and to describe different structures in several regions of the diagram. Some applications of ME as drug delivery systems for different administration routes are also analyzed. ME offer advantages as drug delivery systems, because they favor drug absorption, being in most cases faster and more efficient than other methods in delivering the same amount of drug.
Resumo:
The immunological response includes wide contexts involving several cells, and the macrophage is crucial in the cellular immune response. Several stimuli to macrophage membrane may induce the liberation of H2O2, contributing to antibacterial and cytotoxicical actions. Nowadays, there is a tendency to study natural products to verify their capacity of acting in the immune system. This study evaluated the citotoxicity of the bulk extract and the hexanic and acetic fractions extracted from Styrax camporum Pohl (Styracaceae) and the production of H2O2, on murine peritonal macrophages cultures exposed to fractions extracted from this plant. The results showed that the fraction HX 2 mg/ml produced the liberation of H 2O2 in high concentrations and to 4 mg/ml was observed high citotoxicity. The fractions AC did not produce the liberation of H 2O2 and EB was produced in low levels. We conclude that this HX is a potent stimulator of macrophage.
Resumo:
The text highlights the state of research related with the application of liposomes in the control of drug delivery and drug target to infectious diseases. Liposomes have several pharmaceutical applications and this manuscript is primarily focused on the potential of this colloidal system as an antibiotic carrier system and of administration through several accesses via to organism. Numerous case studies in which liposomes have successfully been used to improve pharmacological drug effect are presented. Mechanisms involved in drug delivery, application possibilities, research and development and efforts to reach these objectives are discussed. © Copyright Moreira Jr. Editora. Todos os direitos reservados.
Resumo:
Liposomes (LP) are colloidal systems with ability to compartmentalize therapeutic molecules in order to improve biological activity, decreases the potential toxicity, and to obtain prolonged effect. In this work it was discussed the role of the various liposomes types to encapsulate drug molecules able to provoke some immunological response (drugs, antigens and DNA). The effect of the liposomes and the parameters about the formation of the structures are also analyzed. Detailed literature review shows that, depending on the molecules polarity and the superficial charge of the liposome structures, the system may be efficiently used to optimize the therapeutic effects by means of the release control or through a drug delivery mechanism.
Resumo:
The objective of this study was to evaluate the LH surge after last hormonal injection of synchronization of ovulation protocols in buffalo. Fifteen multiparous buffaloes received 25 mg of Lecirelin in Day 0, and 150 mg of D-Cloprostenol on Day 7. On Day 8, estradiol benzoate was injected in Group 1 (0.5 mg, n = 5) and Group 2 (1.0 mg, n = 5). On Day 9, five buffaloes received 25 mg of Lecirelin (Control). Blood samples were collected for measure the LH concentrations on Day 7 and then every 3 hours until 72 hours after the PGF 2a injection. For evaluation of LH surge were compared the interval between PGF 2a injection to LH surge, duration, amplitude and area under the LH peak. The LH surge occurred 51.0 + 0.0 hours, 47.3 + 2.7 hours and 47.0 + 3.8 hours after PGF 2a injection for Control, Group 1 and Group 2, respectively (P > 0.05). The duration of LH peak in Control (7.8 + 1.5 hours) was shorter than Groups 1 and 2 (10.5 + 1.5 hours vs. 10.8 + 2.4 hours, respectively; P < 0.05). The amplitudes of LH peak were 4.5 + 0.4 ng/mL, 4.0 + 0.4 ng/mL and 4.3 + 0.8 ng/mL for Control, Group 1 and Group 2, respectively (P > 0.05). The area under LH peak for Control (4.8 ± 0.7) was smaller than the areas of the Groups 1 and 2 (8.8 ± 2.5 vs. 8.7 2.2, respectively; P < 0.05). In summary, the estradiol benzoate injection provided higher duration and area of LH peak than GnRH injection in Ovsynch protocol in buffalo.
Resumo:
Type-1 diabetes patients suffer from frequent episodes of acidosis caused by an increased fatty acid metabolism and consequently increased plasma level of acetoacetate (AcAc) and β-hydroxybutyrate (β-HOB). This article describes a study of the effects of pathological concentrations of AcAc and β-HOB on lipoperoxidation, cell viability and the release of the CXCL8 (IL-8) cytokine by activated neutrophils. Neutrophils from healthy donors were isolated by density gradient (Histopaque® 1077/1119) and incubated with the ketone bodies. Lipoperoxidation was determined as thiobarbituric acid reactive substances (TBARS). The cell viability was evaluated by the release of intracellular lactate dehydrogenase. The release of CXCL8 was measured by ELISA in a 24-h culture of opsonized zymosan-stimulated neutrophils. AcAc, but not β-HOB, provoked a dose-dependent increase in the neutrophil membrane lipoperoxidation (p<0.05; r =0.9915). In the cytotoxicity assay, a dose-dependent release of LDH was observed when the neutrophils were incubated with AcAc in concentrations up to 40 mM (p<0.05). β-HOB was devoid of effect. The release of CXCL8 was inhibited by AcAc and β-HOB in a dose-dependent manner. In conclusion, these results suggest that the accumulation of ketone bodies in diabetic patients could be involved in their usually increased susceptibility to infection.
Resumo:
For the production of quality seedlings, depending on the physical characteristics of each substrate, more rational nutritional managements, from the of economic-environmental point of view, should be sought. This study aimed to evaluate the development and quality of Eucalyptus grandis × E. urophylla seedlings in terms of substrates and doses of controlledrelease Osmocote® fertilizer. The experiment was conducted with a completely randomized, factorial design, using as substrates: vermiculite+carbonized rice chaff+coconut fiber (1:1:1); vermiculite+coconut fiber (1:1) and vermiculite+coconut fiber (2:1) and doses of 2, 4, 6 and 8kg·m -3 of substrate. The substrates with higher water holding capacity allow seedlings to reach their maximum development in most parameters using lower doses of controlled-release fertilizer. We recommend the application of the controlled-release fertilizer at a dose of 6.0kg·m-3 in vermiculite+carbonized rice chaff+coconut fiber (1:1:1) and vermiculite+coconut fiber (2:1) substrates, and in substrate vermiculite+coconut fiber (1:1) at a dose of 7.0kg·m-3. In each substrate there is a dose range that promotes a greater formation of suitable root systems for planting in the field, which consequently results in seedlings with greater morphological development at nursery.
Resumo:
Objective: To evaluate fluoride ion release from two anhydrous glass ionomer cements (GICs) and two resin-modified GICs (RMGICs) before and after recharge with 2% neutral sodium fluoride for 4 min and after surface protection of the Maxxion R GIC with an adhesive system, a cavity varnish and a colorless nail polish. Method: A stainless steel 2x6 mm matrix was used for fabricating 5 specimens of each material, which were immersed in 5 mL of deionized water, renewed every 24 h. Measurements with a potentiometer were performed on days 1, 2, 9 and 17, in the 1st and 2nd phases, and the specimens were buffered with a TISAB III solution. In the 2nd phase, the specimens were subjected to recharge and immersed again in 5 mL of deionized water. In the 3rd phase, the GIC surfaces were protected and readings were made at 5 min, 24 h, 48 h and 72 h. Tukey's post-hoc and Student's t tests were used for statistical analyses (p<0.05). Results: There was statistically significant difference in the comparison between the 1st and 2nd phases for all materials, except at day 2 for Vidrion R and VitroFil LC. In the 3rd phase, it was observed that for all materials, comparison of the first 5 min with the other times revealed statistically significant differences among the means of fluoride ion release. In the comparison with the other times, both the varnish and the colorless nail polish presented statistically significant difference between 24 and 48 h as well as between 24 and 72 h. Conclusion: The anhydrous GICs were more effective in fluoride ion release and recharge compared with the RMGICs. Maxxion R presented a homogeneous and statistically significant behavior in both phases. All materials for surface protection were efficient and the colorless nail polish had the best behavior.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
Pós-graduação em Agronomia (Agricultura) - FCA
Resumo:
Pós-graduação em Pesquisa e Desenvolvimento (Biotecnologia Médica) - FMB
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)