Assessment of the ability to model proteins with leucine-rich repeats in light of the latest structural information

The three-dimensional structures of leucine-rich repeat (LRR) -containing proteins from five different families were previously predicted based on the crystal structure of the ribonuclease inhibitor. using an approach that combined homology-based modeling, structure-based sequence alignment of LRRs, and several rational assumptions. The structural models have been produced based on very limited sequence similarity, which, in general. cannot yield trustworthy predictions. Recently, the protein structures from three of these five families have been determined. In this report we estimate the quality of the modeling approach by comparing the models with the experimentally determined structures. The comparison suggests that the general architecture, curvature, interior/exterior orientations of side chains. and backbone conformation of the LRR structures can be predicted correctly. On the other hand. the analysis revealed that, in some cases. it is difficult to predict correctly the twist of the overall super-helical structure. Taking into consideration the conclusions from these comparisons, we identified a new family of bacterial LRR proteins and present its structural model. The reliability of the LRR protein modeling suggests that it would be informative to apply similar modeling approaches to other classes of solenoid proteins.

A model updating technique based on FRFs for damped structures

Model updating methods often neglect that in fact all physical structures are damped. Such simplification relies on the structural modelling approach, although it compromises the accuracy of the predictions of the structural dynamic behaviour. In the present work, the authors address the problem of finite element (FE) model updating based on measured frequency response functions (FRFs), considering damping. The proposed procedure is based upon the complex experimental data, which contains information related to the damped FE model parameters and presents the advantage of requiring no prior knowledge about the damping matrix structure or its content, only demanding the definition of the damping type. Numerical simulations are performed in order to establish the applicability of the proposed damped FE model updating technique and its results are discussed in terms of the correlation between the simulated experimental complex FRFs and the ones obtained from the updated FE model.

James W. Carey as critical theorist of the information age

This paper suggests that the thought of the North-American critical theorist James W. Carey provides a relevant perspective on communication and technology. Having as background American social pragmatism and progressive thinkers of the beginning of the 20th century (as Dewey, Mead, Cooley, and Park), Carey built a perspective that brought together the political economy of Harold A. Innis, the social criticism of David Riesman and Charles W. Mills and incorporated Marxist topics such as commodification and sociocultural domination. The main goal of this paper is to explore the connection established by Carey between modern technological communication and what he called the “transmissive model”, a model which not only reduces the symbolic process of communication to instrumentalization and to information delivery, but also politically converges with capitalism as well as power, control and expansionist goals. Conceiving communication as a process that creates symbolic and cultural systems, in which and through which social life takes place, Carey gives equal emphasis to the incorporation processes of communication.If symbolic forms and culture are ways of conditioning action, they are also influenced by technological and economic materializations of symbolic systems, and by other conditioning structures. In Carey’s view, communication is never a disembodied force; rather, it is a set of practices in which co-exist conceptions, techniques and social relations. These practices configure reality or, alternatively, can refute, transform and celebrate it. Exhibiting sensitiveness favourable to the historical understanding of communication, media and information technologies, one of the issues Carey explored most was the history of the telegraph as an harbinger of the Internet, of its problems and contradictions. For Carey, Internet was seen as the contemporary heir of the communications revolution triggered by the prototype of transmission technologies, namely the telegraph in the 19th century. In the telegraph Carey saw the prototype of many subsequent commercial empires based on science and technology, a pioneer model for complex business management; an example of conflict of interest for the control over patents; an inducer of changes both in language and in structures of knowledge; and a promoter of a futurist and utopian thought of information technologies. After a brief approach to Carey’s communication theory, this paper focuses on his seminal essay "Technology and ideology. The case of the telegraph", bearing in mind the prospect of the communication revolution introduced by Internet. We maintain that this essay has seminal relevance for critically studying the information society. Our reading of it highlights the reach, as well as the problems, of an approach which conceives the innovation of the telegraph as a metaphor for all innovations, announcing the modern stage of history and determining to this day the major lines of development in modern communication systems.

Integrating protein structural information

Dissertação apresentada para obtenção de Grau de Doutor em Bioquímica,Bioquímica Estrutural, pela Universidade Nova de Lisboa, Faculdade de Ciências e Tecnologia

Low-cost vibration sensors: tendencies and applications in condition monitoring of machines and structures

Trabalho Final de Mestrado para obtenção do grau de Mestre em Engenharia Mecânica

Geography of the Information Society

All every day activities take place in space. And it is upon this that all information and knowledge revolve. The latter are the key elements in the organisation of territories. Their creation, use and distribution should therefore occur in a balanced way throughout the whole territory in order to allow all individuals to participate in an egalitarian society, in which the flow of knowledge can take precedence over the flow of interests. The information society depends, to a large extent, on the technological capacity to disseminate information and, consequently, the knowledge throughout territory, thereby creating conditions which allow a more balanced development, from the both the social and economic points of view thus avoiding the existence of info-exclusion territories. Internet should therefore be considered more than a mere technology, given that its importance goes well beyond the frontiers of culture and society. It is already a part of daily life and of the new forms of thinking and transmitting information, thus making it a basic necessity essential, for a full socio-economic development. Its role as a platform of creation and distribution of content is regarded as an indispensable element for education in today’s society, since it makes information a much more easily acquired benefit.”…in the same way that the new technologies of generation and distribution of energy allowed factories and large companies to establish themselves as the organisational bases of industrial society, so the internet today constitutes the technological base of the organisational form that characterises the Information Era: the network” (CASTELLS, 2004:15). The changes taking place today in regional and urban structures are increasingly more evident due to a combination of factors such as faster means of transport, more efficient telecommunications and other cheaper and more advanced technologies of information and knowledge. Although their impact on society is obvious, society itself also has a strong influence on the evolution of these technologies. And although physical distance has lost much of the responsibility it had towards explaining particular phenomena of the economy and of society, other aspects such as telecommunications, new forms of mobility, the networks of innovation, the internet, cyberspace, etc., have become more important, and are the subject of study and profound analysis. The science of geographical information, allows, in a much more rigorous way, the analysis of problems thus integrating in a much more balanced way, the concepts of place, of space and of time. Among the traditional disciplines that have already found their place in this process of research and analysis, we can give special attention to a geography of new spaces, which, while not being a geography of ‘innovation’, nor of the ‘Internet’, nor even ‘virtual’, which can be defined as one of the ‘Information Society’, encompassing not only the technological aspects but also including a socio-economic approach. According to the last European statistical data, Portugal shows a deficit in terms of information and knowledge dissemination among its European partners. Some of the causes are very well identified - low levels of scholarship, weak investments on innovation and R&D (both private and public sector) - but others seem to be hidden behind socio-economical and technological factors. So, the justification of Portugal as the case study appeared naturally, on a difficult quest to find the major causes to territorial asymmetries. The substantial amount of data needed for this work was very difficult to obtain and for the islands of Madeira and Azores was insufficient, so only Continental Portugal was considered for this study. In an effort to understand the various aspects of the Geography of the Information Society and bearing in mind the increasing generalised use of information technologies together with the range of technologies available for the dissemination of information, it is important to: (i) Reflect on the geography of the new socio-technological spaces. (ii) Evaluate the potential for the dissemination of information and knowledge through the selection of variables that allow us to determine the dynamic of a given territory or region; (iii) Define a Geography of the Information Society in Continental Portugal.

PINPIN a-Si: H based structures for X-ray image detection using the laser scanning technique

Conventional film based X-ray imaging systems are being replaced by their digital equivalents. Different approaches are being followed by considering direct or indirect conversion, with the later technique dominating. The typical, indirect conversion, X-ray panel detector uses a phosphor for X-ray conversion coupled to a large area array of amorphous silicon based optical sensors and a couple of switching thin film transistors (TFT). The pixel information can then be readout by switching the correspondent line and column transistors, routing the signal to an external amplifier. In this work we follow an alternative approach, where the electrical switching performed by the TFT is replaced by optical scanning using a low power laser beam and a sensing/switching PINPIN structure, thus resulting in a simpler device. The optically active device is a PINPIN array, sharing both front and back electrical contacts, deposited over a glass substrate. During X-ray exposure, each sensing side photodiode collects photons generated by the scintillator screen (560 nm), charging its internal capacitance. Subsequently a laser beam (445 nm) scans the switching diodes (back side) retrieving the stored charge in a sequential way, reconstructing the image. In this paper we present recent work on the optoelectronic characterization of the PINPIN structure to be incorporated in the X-ray image sensor. The results from the optoelectronic characterization of the device and the dependence on scanning beam parameters are presented and discussed. Preliminary results of line scans are also presented. (C) 2014 Elsevier B.V. All rights reserved.

Life-cycle performance of structures: combining expert judgment and results of inspection

Life-Cycle Civil Engineering – Biondini & Frangopol

Earthquakes and robustness for timber structures

Workshop of COST Actions TU0601 and E55 September 21-22 2009, Ljubljana, Slovenia

Earth mortars constructive use on Neolithic domestic structures. Some case studies in Alentejo.

HMC08 - 1st Historical Mortars Conference: Characterization, Diagnosis, Conservation, Repair and Compatibility, LNEC, Lisbon, 24-26 September 2008

Semantic relations extraction from unstructured information for domain ontologies enrichment

Based in internet growth, through semantic web, together with communication speed improvement and fast development of storage device sizes, data and information volume rises considerably every day. Because of this, in the last few years there has been a growing interest in structures for formal representation with suitable characteristics, such as the possibility to organize data and information, as well as the reuse of its contents aimed for the generation of new knowledge. Controlled Vocabulary, specifically Ontologies, present themselves in the lead as one of such structures of representation with high potential. Not only allow for data representation, as well as the reuse of such data for knowledge extraction, coupled with its subsequent storage through not so complex formalisms. However, for the purpose of assuring that ontology knowledge is always up to date, they need maintenance. Ontology Learning is an area which studies the details of update and maintenance of ontologies. It is worth noting that relevant literature already presents first results on automatic maintenance of ontologies, but still in a very early stage. Human-based processes are still the current way to update and maintain an ontology, which turns this into a cumbersome task. The generation of new knowledge aimed for ontology growth can be done based in Data Mining techniques, which is an area that studies techniques for data processing, pattern discovery and knowledge extraction in IT systems. This work aims at proposing a novel semi-automatic method for knowledge extraction from unstructured data sources, using Data Mining techniques, namely through pattern discovery, focused in improving the precision of concept and its semantic relations present in an ontology. In order to verify the applicability of the proposed method, a proof of concept was developed, presenting its results, which were applied in building and construction sector.

A type system for value-dependent information flow analysis

Information systems are widespread and used by anyone with computing devices as well as corporations and governments. It is often the case that security leaks are introduced during the development of an application. Reasons for these security bugs are multiple but among them one can easily identify that it is very hard to define and enforce relevant security policies in modern software. This is because modern applications often rely on container sharing and multi-tenancy where, for instance, data can be stored in the same physical space but is logically mapped into different security compartments or data structures. In turn, these security compartments, to which data is classified into in security policies, can also be dynamic and depend on runtime data. In this thesis we introduce and develop the novel notion of dependent information flow types, and focus on the problem of ensuring data confidentiality in data-centric software. Dependent information flow types fit within the standard framework of dependent type theory, but, unlike usual dependent types, crucially allow the security level of a type, rather than just the structural data type itself, to depend on runtime values. Our dependent function and dependent sum information flow types provide a direct, natural and elegant way to express and enforce fine grained security policies on programs. Namely programs that manipulate structured data types in which the security level of a structure field may depend on values dynamically stored in other fields The main contribution of this work is an efficient analysis that allows programmers to verify, during the development phase, whether programs have information leaks, that is, it verifies whether programs protect the confidentiality of the information they manipulate. As such, we also implemented a prototype typechecker that can be found at http://ctp.di.fct.unl.pt/DIFTprototype/.

MixAR mobile prototype: visualizing virtually reconstructed ancient structures in situ

Archeology and related areas have a special interest on cultural heritage sites since they provide valuable information about past civilizations. However, the ancient buildings present in these sites are commonly found in an advanced state of degradation which difficult the professional/expert analysis. Virtual reconstructions of such buildings aim to provide a digital insight of how these historical places could have been in ancient times. Moreover, the visualization of such models has been explored by some Augmented Reality (AR) systems capable of providing support to experts. Their compelling and appealing environments have also been applied to promote the social and cultural participation of general public. The existing AR solutions regarding this thematic rarely explore the potential of realism, due to the following lacks: the exploration of mixed environments is usually only supported for indoors or outdoors, not both in the same system; the adaptation of the illumination conditions to the reconstructed structures is rarely addressed causing a decrease of credibility. MixAR [1] is a system concerned with those challenges, aiming to provide the visualization of virtual buildings augmented upon real ruins, allowing soft transitions among its interiors and exteriors and using relighting techniques for a faithful interior illumination, while the user freely moves in a given cultural heritage site, carrying a mobile unit. Regarding the focus of this paper, we intend to report the current state of MixAR mobile unit prototype, which allows visualizing virtual buildings – properly aligned with real-world structures – based on user's location, during outdoor navigation. In order to evaluate the prototype performance, a set of tests were made using virtual models with different complexities.

A integração de técnicas BIM (Building Information Modeling) no projeto e na construção de estruturas de madeira

Dissertação de mestrado integrado em Engenharia Civil

A multi–physics approach applied to masonry structures with non–hydraulic lime mortars

Tese de Doutoramento em Engenharia Civil (área de especialização em Engenharia de Estruturas).