Energy Export Restrictions in the WTO Between Resources Nationalism and Sustainable Development

This chapter aims at contributing to the trade and energy debate by focusing on the specific issue of export restrictions. It starts from the premise that a balanced and efficient regulation of export barriers in the energy sector would contribute to tackle emerging energy concerns such as energy security and the elimination of fossil fuel subsidies in light of the challenge of climate change mitigation. It assesses the adequacy of existing WTO rules on export restric­tions and accordingly identifies the main gaps and inconsistencies inherent in the current disciplines from an energy-specific perspective. Finally, it discusses the merits of an energy-specific approach to advance existing disciplines in the most deficient area of export duties based on the systematisation of the Russian ‘model’. Such approach could raise the overall level of commitments in the energy sector while still allowing for the systemic applicability of GATT environmental exceptions in a manner consistent with the principle of sus­tainable development recognised in the Preamble of the WTO Agreement.

The Garment Industry in Cambodia: Its Role in Poverty Reduction through Export-Oriented Development

Cambodia's export-oriented garment industry has contributed greatly to poverty reduction in the country through employment of the poor. This paper provides a statistical verification of this contribution based on firm-level data from 164 sampled companies collected in 2003. Its main conclusions confirm the substantial impact that employment in the garment industry has had on poverty reduction in Cambodia. Firstly, entry-level workers receive wages far above the poverty line. Secondly, females make up the predominant share of the main category jobs in the industry. Thirdly, barriers to employment and to promotions up to certain job categories are not high in terms of education and experience. Another important finding is that a typical sample firm exhibited high profitability, although there was wide variation in profitability among firms. This average of high profitability could be a good predictor of Cambodia's viability in the intensified competition since the phase out of the Multi-Fiber Arrangement (MFA) at the beginning of 2005. A point of note is that Cambodia's pattern of industrial development led by a labor-intensive industry is similar to that of neighboring countries in East Asia which earlier went through the initial stage of industrial development, except that Cambodia has lacked a strong government industrial promotion policy which characterized the earlier group.

Export processing zones and growth triangle development: The case of the BIMP-EAGA, Southeast Asia

Exorts processing zones (EPZs) and growth triangles have been two common Asian initiatives to increase wealth and regional competitiveness in the world economy. Since they are seldom analysed jointly, this paper investigates their mutuality in the development process. Taking the problematic case of the Brunei-Indonesia-Malaysia-Philippines East ASEAN Growth Area (BIMP-EAGA) triangle, we explore the role of EPZs in enhancing regional collaboration, competitiveness, and domestic linkages. Despite the triangle's weak economic complementarities, its processing zones are found capable of advancing development by furthering opportunities in regionalisation/localisation of production. Latterly, trade and investment liberalisation within ASEAN raises broad questions about the rationale of EPZs and growth triangles. Zone-triangle nexuses will require rethinking as, under different regulatory conditions, the zones compete more directly across ASEAN and also with global rivals. Copyright © 2005 John Wiley & Sons, Ltd.

Sustainable rural development through alternative economic networks: Redefining relations in the commodity chain for export vegetables in western Guatemala

The current research considers the capacity of a local organic food system for producer and consumer empowerment and sustainable development outcomes in western Guatemala. Many have argued that the forging of local agricultural networks linking farmers, consumers, and supporting institutions is an effective tool for challenging the negative economic, environmental, and sociopolitical impacts associated with industrial models of global food production. But does this work in the context of agrarian development in the developing world? Despite the fact that there is extensive literature concerning local food system formation in the global north, there remains a paucity of research covering how the principles of local food systems are being integrated into agricultural development projects in developing countries. My work critically examines claims to agricultural sustainability and actor empowerment in a local organic food system built around non-traditional agricultural crops in western Guatemala. Employing a mixed methods research design involving twenty months of participant observation, in-depth interviewing, surveying, and a self-administered questionnaire, the project evaluates the sustainability of this NGO-led development initiative and local food movement along several dimensions. Focusing on the unique economic and social networks of actors and institutions at each stage of the commodity chain, this research shows how the growth of an alternative food system continues to be shaped by context specific processes, politics, and structures of conventional food systems. Further, it shows how the specifics of context also produce new relationships of cooperation and power in the development process. Results indicate that structures surrounding agrarian development in the Guatemalan context give rise to a hybrid form of development that at the same time contests and reinforces conventional models of food production and consumption. Therefore, participation entails a host of compromises and tradeoffs that result in mixed successes and setbacks, as actors attempt to refashion conventional commodity chains through local food system formation.^

Domestic and export marketing of Auracaria timber

This article examines the need for a marketing approach to support the expansion of trade in Australian forest Products. Opportunities available for trade in hoop pine ( Araucaria cunninghamii), a Queensland species of timber, are examined. Markets within China and Japan are found to have substantial potential end product uses for the plantation timber.

Geometric and force relationships for the development of a scaled model hydraulic excavator

Hydraulic excavators in the mining industry are widely used owing to the large payload capabilities these machines can achieve. However, there are very few optimisation studies for producing efficient hydraulic excavator backets. An efficient bucket can avoid unnecessary weight; greatly influence the payload and optimise the efficiency of hydraulic mining excavators. This paper presents a framework for the development of a scaled hydraulic excavator by examining the geometry and force relationships. A small hydraulic excavator was purchased and fitted with a broom scaled to a factor. Geometric and force relationships of the model were derived to assist computer instrumentation to retrieve necessary variable input for bucket design.

Strategic technology management : case study development in innovative building products

National and international competition demands that Australian organisations become more competent at making the strategic technological decisions that impact their future in the international business economy. A new subject unit, Management of Technology is now offered in the popular Master of Project Management and Master of Business Administration programs at the Queensland University of Technology. This cross-disciplinary subject provides students with a theoretical foundation and practical tools to improve the efficiency and competitiveness of technically-oriented organisations. Applied case studies—shown to be the most appropriate mode of learning for mature-age students—form an integral component of the teaching program. In the first offerings of this subject during 1995 and 1996, American case studies were used. QUT has now supported the development of Australian case study packages for technology management through its Teaching and Learning Grants Scheme. The first case developed—Inland Oil Refiners’ Microstill Project—was completed in early 1996. A newly developed case—Automated Door Opening System for Wheelchair Access—is currently being completed. This case (comprising case study documentation and video presentation) tracks a cross-disciplinary product development driven by legislative and community pressures. It also reinforces the importance of personal relationships in the technology and business development that has taken this young Brisbane-based company from its embryonic beginnings on the Queensland Cultural Centre in 1994 to a national and export-focussed organisation in 1997. This paper reviews the need to develop Australian case material in Management of Technology, discusses the case study documentation and supporting video developed, and application of the case study approach in this teaching initiative in QUT’s Master of Project Management and Master of Business Administration programs.

China's foreign economic cooperation development : exporting Chinese construction services

Since the movement for economic reform started in China 20 years ago, the nation's GDP had grown on average from seven to nine per cent a year, making China's construction industry one of the largest in the world. This paper presents an overview of China's foreign economic cooperation development (FECD) in the context of exporting three major construction services namely; contracting, labour and design. The paper outlines the export market profile of Chinese contractors and discusses their current position in the international market. It then addresses challenges; they are facing in view of meeting the ambitious strategic targets set out by the Government for the FECD, which cover the export of construction services. Finally, the paper sheds some light on key exporting strategies currently adopted by Chinese contractors.

The development of Monte Carlo techniques for the verification of radiotherapy treatments

Introduction: Recent advances in the planning and delivery of radiotherapy treatments have resulted in improvements in the accuracy and precision with which therapeutic radiation can be administered. As the complexity of the treatments increases it becomes more difficult to predict the dose distribution in the patient accurately. Monte Carlo (MC) methods have the potential to improve the accuracy of the dose calculations and are increasingly being recognised as the ‘gold standard’ for predicting dose deposition in the patient [1]. This project has three main aims: 1. To develop tools that enable the transfer of treatment plan information from the treatment planning system (TPS) to a MC dose calculation engine. 2. To develop tools for comparing the 3D dose distributions calculated by the TPS and the MC dose engine. 3. To investigate the radiobiological significance of any errors between the TPS patient dose distribution and the MC dose distribution in terms of Tumour Control Probability (TCP) and Normal Tissue Complication Probabilities (NTCP). The work presented here addresses the first two aims. Methods: (1a) Plan Importing: A database of commissioned accelerator models (Elekta Precise and Varian 2100CD) has been developed for treatment simulations in the MC system (EGSnrc/BEAMnrc). Beam descriptions can be exported from the TPS using the widespread DICOM framework, and the resultant files are parsed with the assistance of a software library (PixelMed Java DICOM Toolkit). The information in these files (such as the monitor units, the jaw positions and gantry orientation) is used to construct a plan-specific accelerator model which allows an accurate simulation of the patient treatment field. (1b) Dose Simulation: The calculation of a dose distribution requires patient CT images which are prepared for the MC simulation using a tool (CTCREATE) packaged with the system. Beam simulation results are converted to absolute dose per- MU using calibration factors recorded during the commissioning process and treatment simulation. These distributions are combined according to the MU meter settings stored in the exported plan to produce an accurate description of the prescribed dose to the patient. (2) Dose Comparison: TPS dose calculations can be obtained using either a DICOM export or by direct retrieval of binary dose files from the file system. Dose difference, gamma evaluation and normalised dose difference algorithms [2] were employed for the comparison of the TPS dose distribution and the MC dose distribution. These implementations are spatial resolution independent and able to interpolate for comparisons. Results and Discussion: The tools successfully produced Monte Carlo input files for a variety of plans exported from the Eclipse (Varian Medical Systems) and Pinnacle (Philips Medical Systems) planning systems: ranging in complexity from a single uniform square field to a five-field step and shoot IMRT treatment. The simulation of collimated beams has been verified geometrically, and validation of dose distributions in a simple body phantom (QUASAR) will follow. The developed dose comparison algorithms have also been tested with controlled dose distribution changes. Conclusion: The capability of the developed code to independently process treatment plans has been demonstrated. A number of limitations exist: only static fields are currently supported (dynamic wedges and dynamic IMRT will require further development), and the process has not been tested for planning systems other than Eclipse and Pinnacle. The tools will be used to independently assess the accuracy of the current treatment planning system dose calculation algorithms for complex treatment deliveries such as IMRT in treatment sites where patient inhomogeneities are expected to be significant. Acknowledgements: Computational resources and services used in this work were provided by the HPC and Research Support Group, Queensland University of Technology, Brisbane, Australia. Pinnacle dose parsing made possible with the help of Paul Reich, North Coast Cancer Institute, North Coast, New South Wales.

Export readiness index : construction and analysis

The internationalisation process of firms has attracted much research interest since the 1970s. It is noted, however, that a significant research gap exists in studies with a primary focus on the pre-internationalisation behaviour of firms. This paper proposes the incorporation of a pre-internationalisation phase into the traditional Uppsala model of firm internationalisation to address the issue of export readiness. Through extensive literature review, the concepts fundamental to the ability of an Uppsala type firm to begin internationalisation through an export entry mode are identified: exposure to stimuli factors, attitudinal commitment of decision makers towards exporting, the firm’s resource capabilities, as well as the moderating effect of lateral rigidity. The concept of export readiness is operationalised in this study through the construction of an export readiness index (ERI) using exploratory and confirmatory factor analysis. The index is then applied to some representative cases and tested using logistic regression to establish its validity as a diagnostic tool. The proposed ERI presents not only a more practical approach towards analysing firms’ export readiness but has also major public policy implications as a possible tool for government export promotion agencies.

Internet marketing and export market growth in Chile

Previous studies show that the Internet positively influences firms’ export activities from developed markets. However, the literature is vague as to whether the Internet has an impact on the export performance of firms from emerging markets. This study tests a conceptual model that includes the effect of Internet marketing capabilities on export market growth in an emerging market. Drawing on a cross-national sample of 204 export firms from a Latin American country (Chile), findings indicate that Internet marketing capabilities positively influence the availability of export information, which in turn impacts the development of business network relationships and export market growth.

Development of a New Zealand database of plant virus and virus-like organisms.

The recent 8th Australasian plant virology workshop in Rotorua, New Zealand, discussed the development of a New Zealand database of plant virus and virus-like organisms. Key points of discussion included: (i) the purpose of such a database; (ii) who would benefit from the information in a database; (iii) the scope of a database and its associated collections; (iv) database information and format; and (v) potential funding of such a database. From the workshop and further research, we conclude that the preservation and verification of specimens within the collections and the development of a New Zealand database of plant virus and virus-like organisms is essential. Such a collection will help to fulfil statutory requirements in New Zealand and assist in fulfilling international obligations under the International Plant Protection Convention. Sustaining such a database will assist New Zealand virologists and statutory bodies to undertake scientifically sound research. Establishing reliable records and an interactive database will help to ensure accurate and timely diagnoses of diseases caused by plant viruses and virus-like organisms. Detection of new incursions and their diagnosis will be further enhanced by the use of such reference collections and their associated database. Connecting and associating this information to similar overseas databases would assist international collaborations and allow access to the latest taxonomic and diagnostic resources. Associated scientists working in the areas of plant breeding, export phytosanitary assurance and in the area of the conservation estate would also benefit from access to verified specimens of plant viruses and virus-like organisms. We conclude that funding of a New Zealand database of virus and virus-like organisms and its associated collections should be based partly on Crown funds, as it is a nationally significant biological resource.

Spiny lobster aquaculture development in eastern Indonesia, Vietnam and Australia

The project was successful across all objectives, making demonstrable progress in support of establishing tropical lobster farming in Indonesia. The industry remains most active in Lombok where lobster seed resources are most abundant, and impact has been greatest there. Nevertheless, project activities have established activity and interest in lobster farming in other provinces and particularly Aceh and, South and Southeast Sulawesi. The project met all of its 23 milestones with the exception of publishing a production manual, which has been held over until 2017. For several milestone activities, further research will be required to build on the outcomes generated and reach practical commercial outputs. The research was instigated to address the opportunity to establish a significant small-holder based industry in Indonesia that could alleviate poverty in coastal communities. The premise was that such an industry – lobster farming, had been established in Vietnam, with ACIAR involvement, and it could be replicated in Indonesia where the availability of necessary basic requirements had been confirmed through a previous ACIAR project focussed in Vietnam (FIS/2001/058). The broad aim was to assess, develop and expand the resources of naturally settling lobster seed (puerulus), and develop grow out of those seed to meet export market demand. This was to be achieved by adapting and transferring to Indonesia technology from Vietnam, where lobster farming had become a successful industry producing 1,500 tonnes of export quality lobsters valued at $A100 million.

Export subsidies and foreign capital inflows

The welfare effect of a foreign capital inflow in an economy which practises an export-oriented trade policy is examined. The latter takes the form of optimally designed export subsidies, minimizing the welfare costs of existing import tariffs. Under the practice of this policy, an inflow of foreign capital is shown to have anambiguous welfare effect. An empirically relevant condition for welfare improvement is derived and discussed.