Design and optimization of na ultra wideband and compact microwave antenna for radiometric monitoring of brain temperature

We present the modeling efforts on antenna design and frequency selection to monitor brain temperature during prolonged surgery using noninvasive microwave radiometry. A tapered log-spiral antenna design is chosen for its wideband characteristics that allow higher power collection from deep brain. Parametric analysis with the software HFSS is used to optimize antenna performance for deep brain temperature sensing. Radiometric antenna efficiency (eta) is evaluated in terms of the ratio of power collected from brain to total power received by the antenna. Anatomical information extracted from several adult computed tomography scans is used to establish design parameters for constructing an accurate layered 3-D tissue phantom. This head phantom includes separate brain and scalp regions, with tissue equivalent liquids circulating at independent temperatures on either side of an intact skull. The optimized frequency band is 1.1-1.6 GHz producing an average antenna efficiency of 50.3% from a two turn log-spiral antenna. The entire sensor package is contained in a lightweight and low-profile 2.8 cm diameter by 1.5 cm high assembly that can be held in place over the skin with an electromagnetic interference shielding adhesive patch. The calculated radiometric equivalent brain temperature tracks within 0.4 degrees C of the measured brain phantom temperature when the brain phantom is lowered 10. C and then returned to the original temperature (37 degrees C) over a 4.6-h experiment. The numerical and experimental results demonstrate that the optimized 2.5-cm log-spiral antenna is well suited for the noninvasive radiometric sensing of deep brain temperature.

Compact, frequency reconfigurable, printed monopole antenna

This paper proposes a possible implementation of a compact printed monopole antenna, useful to operate in UMTS and WLAN bands. In order to accomplish that, a miniaturization technique based on the application of chip inductors is used in conjunction with frequency reconfiguration capability. The chip inductors change the impedance response of the monopole, allowing to reduce the resonant frequency. In order to be able to operate the antenna in these two different frequencies, an antenna reconfiguration technique based on PIN diodes is applied. This procedure allows the change of the active form of the antenna leading to a shift in the resonant frequency. The prototype measurements show good agreement with the simulation results.

Compact ion-source based on superionic rubidium silver iodide (RbAg4I5) solid electrolyte

Dissertação para obtenção do Grau de Mestre em Engenharia Física

Design of multidimensional compact constellations with high power efficiency

Dissertação apresentada para obtenção do Grau de Mestre em Engenharia Electrotécnica e de Computadores, pela Universidade Nova de Lisboa, Faculdade de Ciências e Tecnologia

Compact simulated countercurrent chromatography for downstream processing of (bio)pharmaceuticals

Dissertação para obtenção do Grau de Doutor em Engenharia Química e Bioquímica

Schottky principal G-bundles over compact Riemann surfaces

Fundação para a Ciência e a Tecnologia (FCT)- PhD grant SFRH/BD/37151/2007; projects PTDC/MAT/099275/2008; PTDC/MAT/119689/2010; PTDC/MAT/120411/2010; PTDC/MAT-GEO/0675/2012

Descriptive study of HTLV infection in a population of pregnant women from the state of Pará, Northern Brazil

INTRODUCTION: In Brazil, studies have shown that HTLV seroprevalence among pregnant women varies from 0 to 1.8%. However, this seroprevalence was unknown in the State of Pará, Brazil. The present study describes, for the first time, the HTLV seroprevalence among pregnant women from the State of Pará, Northern Brazil. METHODS: 13,382 pregnant women were submitted to HTLV screening during prenatal care, and those with non-seronegative results to anti-HTLV were submitted to Western blot (WB) test to confirm and separate HTLV-1 and HTLV-2 carriers. RESULTS: HTLV seroprevalence in the population of pregnant women was 0.3%, and HTLV-1 was identified in 95.3% of patients. The demographic profile of HTLV carriers was as follows: women with age between 20 and 40 years old (78.4%); residing in the metropolitan region of Belém, Pará (67.6%); and with educational level of high school (56.8%). Other variables related to infection were as follows: beginning of sexual intercourse between the age of 12 and 18 years old (64.9%) and have being breastfed for more than 6 months (51.4%). Most of the women studied had at least two previous pregnancies (35.1%) and no abortion (70.3%). Coinfections (syphilis and HIV) were found in 10.8% (4/37) of these pregnant women. CONCLUSIONS: Seroprevalence of HTLV infection in pregnant women assisted in basic health units from the State of Pará, Northern Brazil, was 0.3% similar to those described in other Brazilian studies. The variables related to infection were important indicators in identifying pregnant women with a higher tendency to HTLV seropositivity, being a strategy for disease control and prevention, avoiding vertical transmission.

Optimal design and operation of compact simulated moving bed processes for enantioseparations

Simulated moving bed (SMB) chromatography is attracting more and more attention since it is a powerful technique for complex separation tasks. Nowadays, more than 60% of preparative SMB units are installed in the pharmaceutical and in the food in- dustry [SDI, Preparative and Process Liquid Chromatography: The Future of Process Separations, International Strategic Directions, Los Angeles, USA, 2002. http://www. strategicdirections.com]. Chromatography is the method of choice in these ¯elds, be- cause often pharmaceuticals and ¯ne-chemicals have physico-chemical properties which di®er little from those of the by-products, and they may be thermally instable. In these cases, standard separation techniques as distillation and extraction are not applicable. The noteworthiness of preparative chromatography, particulary SMB process, as a sep- aration and puri¯cation process in the above mentioned industries has been increasing, due to its °exibility, energy e±ciency and higher product purity performance. Consequently, a new SMB paradigm is requested by the large number of potential small- scale applications of the SMB technology, which exploits the °exibility and versatility of the technology. In this new SMB paradigm, a number of possibilities for improving SMB performance through variation of parameters during a switching interval, are pushing the trend toward the use of units with smaller number of columns because less stationary phase is used and the setup is more economical. This is especially important for the phar- maceutical industry, where SMBs are seen as multipurpose units that can be applied to di®erent separations in all stages of the drug-development cycle. In order to reduce the experimental e®ort and accordingly the coast associated with the development of separation processes, simulation models are intensively used. One impor- tant aspect in this context refers to the determination of the adsorption isotherms in SMB chromatography, where separations are usually carried out under strongly nonlinear conditions in order to achieve higher productivities. The accurate determination of the competitive adsorption equilibrium of the enantiomeric species is thus of fundamental importance to allow computer-assisted optimization or process scale-up. Two major SMB operating problems are apparent at production scale: the assessment of product quality and the maintenance of long-term stable and controlled operation. Constraints regarding product purity, dictated by pharmaceutical and food regulatory organizations, have drastically increased the demand for product quality control. The strict imposed regulations are increasing the need for developing optically pure drugs.(...)

Compact saloplastic membranes of natural polysaccharides for soft tissue engineering

The regeneration of soft biological tissues requires new substitutes that exhibit mechanical properties similar to the native tissue. Herein, thin saloplastic membranes with tunable physical properties are prepared by complexation of chitosan and alginate solutions containing different concentrations of sodium chloride. Polyelectrolyte complexes (PECs) are transferred to flat Petri dishes for compaction into membrane shapes by sedimentation and solvent evaporation. All membranes are resistant to degradation by lysozyme and are stable in solutions with pH values between 1 and 13. Immersing the different membranes in new doping solutions of increasing salt concentrations triggers the typical saloplastic behavior, with a high water absorption and decrease of the rigidity and ultimate tensile strength. The range of such variations is tuned by the sodium chloride amount used in the synthesis: high salt concentrations increase water uptake and tensile moduli, while decreasing the ultimate strength. Cellular assays demonstrate high proliferation rates and viability of L929 fibroblasts seeded onto the most rigid membranes. The results validate the use of saloplastic membranes as soft tissue substitutes for future biomedical applications.

Desarrollo de tableros aglomerados compactos de cáscara de maní. Peanuts husks compact board development

El presente proyecto de investigación solicitado es continuacion de una línea de trabajo con insumos de desecho agroindustrial regional en la provincia de Cordoba. Prevé aportes que contribuyan a la sustentabilidad económica y social, y ambiental. Se trata de aportar valor agregado a importantes cantidades residuales de cascaras de mani. Además promueve la produccion de materiales y componentes de construcción de viviendas saludables y accesibles para sectores con necesidades sociohabitacionales.El deshecho de cáscara de maní constituye hoy en la provincia de Córdoba, un recurso sobre abundante no aprovechado en la escala en que se dispone. Existen desarrollos para su aprovechamiento - camadas de aves, alimento de ganado, carbon activado- , que no alcanzan a consumir las enormes cantidades de cascaras que se disponen hoy: alrededor de 250 000 Tn/ año. (La produccion anual de mani en caja en la provincia de Cordoba es estimada en 700.000 Tn/año)A partir de los resultados ya obtenidos con paneles livianos termoaislantes, utilizados en cielorrasos y tabiques divisorios, el nuevo trabajo de investigación y desarrollo se propone avanzar sobre las condiciones de produccion de tableros compactos, similares a los producidos comercialmente con residuos de la industria de la madera. Se estudiaran y experimentaran las propiedades de uso de resinas poliester, ureaformaldehido y fenolformaldehido, bajo condiciones de alta presion y temperatura. En la primera etapa (1º año) buscamos obtener nuevos materiales en escala de probetas.En una etapa siguiente (2º año), los nuevos materiales obtenidos serán aplicados al diseño de componentes de vivienda. Se estudiarán las posibilidades alternativas de empleo en relación a los parámetros de evaluación : peso, resistencia mecánica, aislación térmica, resistencia a la humedad, y al envejecimiento acelerado.En la última etapa (3º año) los resultados obtenidos serán aplicados en modelos de escala real y/o prototipos demostrativos para evaluar su puesta en servicio.