Sulfamethoxazole and ciprofloxacin removal using a horizontal-flow anaerobic immobilized biomass reactor

The antibiotics sulfamethoxazole (SMTX) and ciprofloxacin (CIP) are commonly used in human and veterinary medicine, which explains their occurrence in wastewater. Anaerobic reactors are low-cost, simple and suitable technology to wastewater treatment, but there is a lack of studies related to the removal efficiency of antibiotics. To overcome this knowledge gap, the objective of this study was to evaluate the removal kinetics of SMTX and CIP using a horizontal-flow anaerobic immobilized biomass reactor. Two different concentrations were evaluated, for SMTX 20 and 40 μg L(-1); for CIP 2.0 and 5.0 μg L(-1). The affluent and effluent analysis was carried out in liquid chromatography/tandem mass spectrometry (LC-MS/MS) with the sample preparation procedure using an off-line solid-phase extraction. This method was developed, validated and successfully applied for monitoring the affluent and effluent samples. The removal efficiency found for both antibiotics at the two concentrations studied was 97%. Chemical oxygen demand (COD) exhibited kinetic constants that were different from that observed for the antibiotics, indicating the absence of co-metabolism. Also, though the antibiotic concentration was increased, there was no inhibitory effect in the removal of COD and antibiotics.

Moisture content and its influence on the roughness and noise emission during wood machining

Numerous factors influencing the surface quality of wood after machining, among them we highlight the machining parameters and the properties of the wood. In the analysis of the influence of these factors on machining and in determining the quality measurement systems are used to obtain surface characteristics, these systems are divided into methods of contact and non-contact. The method for mechanical contact performed with the aid of the surface roughness tester is the most valued in the measurement of roughness of wood, however, aiming at a greater agility in these measurements, there is a need to seek alternatives for evaluation of surface quality, and one of these options is to use the forms of indirect measurements of this quality, as for example, the use of noise emission during the machining process. With this, the aim was to analyze the influence of the moisture content of the wood, at different levels, on surface quality of the species Pinus elliottii, determined by the method of mechanical probing move and relate this roughness with the sound emission issued for each class of humidity, during machining. The planning of experiments and statistical analyses were performed with the help of Taguchi method. The specimens were conditioned in greenhouses climatizadoras automatics for obtaining three classes of humidity. Machining tests of wooden pieces were performed on a machining center specific for this type of material. The roughness values were measured by a roughness verifier and the noise emission values were measured by for a measurer sound pressure level. Statistically significant differences were observed, the significance level of 10 %, on roughness and noise emission between the three levels of moisture. It was observed that with the increase in the moisture content occurred an increase of roughness and a reduction in noise emission. Monitoring of surface quality through noise level is an interesting alternative to the method of mechanical contact.

Debris and smear removal in flattened root canals after use of different irrigant agitation protocols

Scanning electron microscopy (SEM) can be used to analyze the presence of debris and smear layer on the internal walls of root canal. This study evaluated the debris and smear removal in flattened root canals using SEM after use of different irrigant agitation protocols. Fifty mandibular incisors were distributed into five groups (n = 10) according to the irrigant agitation protocol used during chemomechanical preparation: conventional syringe irrigation with NaviTip needle (no activation), active scrubbing of irrigant with brush-covered NaviTip FX needle, manual dynamic irrigation, continuous passive ultrasonic irrigation, and apical negative pressure irrigation (EndoVac system). Canals were irrigated with 5 mL of 2.5% NaOCl at each change of instrument and received a final flush with 17% EDTA for 1 min. After instrumentation, the roots were split longitudinally and SEM micrographs at x 100 and x 1,000 were taken to evaluate the amount of debris and smear layer, respectively, in each third. Data were analyzed by KruskalWallis and Dunn's post-hoc tests (a = 5%). Manual dynamic activation left significantly (p < 0.05) more debris inside the canals than the other protocols, while ultrasonic irrigation and EndoVac were the most effective (p < 0.05) for debris removal. Regarding the removal of smear layer, there was no statistically significant difference (p > 0.05) either among the irrigant agitation protocols or between the protocolcanal third interactions. Although none of the irrigant agitation protocols completely removed debris and smear layer from flattened root canals, the machine-assisted agitation systems (ultrasound and EndoVac) removed more debris than the manual techniques. Microsc. Res. Tech. 75:781790, 2012. (C) 2011 Wiley Periodicals, Inc.

Disentangling factors controlling fruit and seed removal by rodents in temperate forests

Fleshy fruits fall on to the ground together with cleaned seeds previously ingested by primary dispersers, offering a wide range of fruits and seeds to the ground foragers. Although nutritional properties strongly differ between fruits and seeds, this different seed presentation (cleaned seeds versus seeds within the pulp) has not been addressed in seed removal studies. This study reports on the removal of fruits versus their seeds in five fleshy-fruited species in a temperate forest. We found that rodents removed most of the seeds and partially consumed most of the fruits, preferring seeds to fruits. Rodents bit the fruits to extract the seeds, leaving most of the pulp. We found a preference ranking for the seeds (Sorbus aucuparia>Ilex aquifolium>Sorbus aria>Rosa canina>Crataegus monogyna) but no preferences were found for the fruits, probably due to their similarities in pulp constituents. Seed and fruit choice were affected by chemical and physical properties and not by their size. The presence of alternative and preferred seeds (nuts) delayed the encounter of the fruits and seeds and diminished their removal rates. We found that higher rodent abundance is not necessarily associated with higher removal rates of fleshy fruits. Rodent abundance, fruit size and seed size are minor factors in the removal of fleshy fruits and their seeds. This study underlines that scatter-hoarding rodents are important removers of fleshy fruits and their seeds, producing a differential seed removal depending on the seed presentation (with or without pulp), the nutritional properties of the seeds (but not of the fruits) and the presence of alternative food

A clustering technique for partial discharge and noise sources identification in power cables by means of waveform parameters

On-line partial discharge (PD) measurements have become a common technique for assessing the insulation condition of installed high voltage (HV) insulated cables. When on-line tests are performed in noisy environments, or when more than one source of pulse-shaped signals are present in a cable system, it is difficult to perform accurate diagnoses. In these cases, an adequate selection of the non-conventional measuring technique and the implementation of effective signal processing tools are essential for a correct evaluation of the insulation degradation. Once a specific noise rejection filter is applied, many signals can be identified as potential PD pulses, therefore, a classification tool to discriminate the PD sources involved is required. This paper proposes an efficient method for the classification of PD signals and pulse-type noise interferences measured in power cables with HFCT sensors. By using a signal feature generation algorithm, representative parameters associated to the waveform of each pulse acquired are calculated so that they can be separated in different clusters. The efficiency of the clustering technique proposed is demonstrated through an example with three different PD sources and several pulse-shaped interferences measured simultaneously in a cable system with a high frequency current transformer (HFCT).

The three sludge system for nitrogen and phosphorus removal /

"Presented at the 44th Annual Conference of the Water Pollution Control Federation, San Francisco, California (October, 1971)"--P. 1.

“How Do You ‘Do’ Bokeh?” The Aesthetics of How-to Videos about Background Blur and Eroticized Women

Producers of online instructional videos about bokeh emphasize disks of light and out-of-focus backgrounds. They demonstrate how camera lenses and technical features can render bokeh, or unfocused areas. Photographic and video bokeh ordinarily appears away from the center of attention. The bokeh genre, in opposition to typical photography and video practices, foregrounds the peripheral and proposes aesthetics and ways of looking by seeing and not seeing objects. However, producers of online instructional videos about bokeh sometimes couple their sensual aestheticization of backgrounds to their stated attempts to satisfy viewers’ investments in filling foregrounds with images of objectified women. These producers emphasize unconventional aesthetics as a means of establishing their creative and technical expertise and obscuring their reproduction of traditional conceptions of women as viewable and controllable. Close textual analysis, literature on photography and transparency, and feminist considerations of representation allow me to consider the aesthetics and functions of this how-to form.

Organizational, DS, GS, and depot maintenance manual : Hewlett-Packard noise figure meter model 342A and noise source model 349A.

"September 1967."

Report on the problem of street cleaning and snow removal in the city of Minneapolis, Minnesota.

Mode of access: Internet.

Compilation of statutes relating to soil conservation, marketing quotas and allotments, soil bank, Commodity Credit Corporation, price support, export and surplus removal, crop insurance, sugar payments and quotas, marketing agreements and orders, and related statutes.

Issued Jan. l, 1953- as U.S. Dept. of Agriculture. Agriculture handbook, no. 49, 79, 113, 192, 242, 281, 317, etc.

A novel wastewater treatment process: Simultaneous nitrification, denitrification and phosphorus removal

Simultaneous nitrification and denitrification (SND) via the nitrite pathway and anaerobic-anoxic enhanced biological phosphorus removal (EBPR) are two processes that can significantly reduce the COD demand for nitrogen and phosphorus removal. The combination of these two processes has the potential of achieving simultaneous nitrogen and phosphorus removal with a minimal requirement for COD. A lab-scale sequencing batch reactor (SBR) was operated in alternating anaerobic-aerobic mode with a low dissolved oxygen concentration (DO, 0.5 mg/L) during the aerobic period, and was demonstrated to accomplish nitrification, denitrification and phosphorus removal. Under anaerobic conditions, COD was taken up and converted to polyhydroxyalkanoates (PHA), accompanied with phosphorus release. In the subsequent aerobic stage, PHA was oxidized and phosphorus was taken up to less than 0.5 mg/L at the end of the cycle. Ammonia was also oxidised during the aerobic period, but without accumulation of nitrite or nitrate in the system, indicating the occurrence of simultaneous nitrification and denitrification. However, off-gas analysis found that the final denitrification product was mainly nitrous oxide (N2O) not N-2. Further experimental results demonstrated that nitrogen removal was via nitrite, not nitrate. These experiments also showed that denitrifying glycogen.-accumulating organisms rather than denitrifying polyphosphate-accumulating organisms were responsible for the denitrification activity.