Physical properties and minerals of Leg 65 Holes basalts

Velocities and densities of submarine basalts obtained during Leg 65 are distinguished by their relatively high values (about 6.3 km/s and 2.9 g/cm/**3, respectively). This is consistent with their low degree of alteration. The range of velocities covered by these samples correlates well with porosity, and a comparison with in situ velocities from refraction data suggests maximum porosities ih the upper 100 meters of the crust of about 10%.

Mineralogy and inorganic geochemistry of sediments at DSDP Leg 65 Holes

During Leg 65, 15 holes were drilled at four sites located on young crust in the mouth of the Gulf of California. Quaternary to upper Pliocene hemipelagic sediments above and interlayered within the young basaltic basement were cored. The influence of hot lava, high temperature gradients, and hydrothermal activity on the mineralogy and geochemistry of the terrigenous sediments near contacts with basalts might therefore be expected. The purpose of the present study was to determine the mineralogy and inorganic geochemistry of these sediments and to analyze the nature and extent of low temperature alteration. To this end we studied the mineralogy and inorganic geochemistry of 75 sediment samples, including those immediately overlying uppermost basalts and those from layers alternating with basalts within the basement. We separated three size fractions - <2 µm (clay), 2-20 µm (intermediate), and >20 µm (coarse) - and applied the following mineralogical determinations: x-ray diffraction (XRD), infrared spectroscopy, transmission and scanning electron microscopy, and optical microscopy (for coarse fractions, using thin sections and smear slides). We calculated the percentages of clay minerals using Biscaye's (1964) method, and used routine wet chemical analyses to determine bulk composition and quantitative spectral analyses for trace elements.

Metamorphic processes in sediments at DSDP Leg 65 Holes

Sites 482, 483, and 485 were drilled during Leg 65 on young oceanic crust south of the Tamayo Transform Fault. The Leg 65 drilling program was part of a multinational effort to study the East Pacific Rise (EPR) and complements sea bottom surveys conducted both in this area (Lewis, 1979; Cyamex Scientific Team and Pastouret, 1981) and farther south at 21 °N (Larson, 1971; Normark, 1976; Cyamex Scientific Team; Rise Project Group, 1980). These studies, which included deep-tow, Angus and submersible surveys, were recently complemented by sea-beam surveys conducted by the Jean Charcot on the Tamayo Fracture Zone and farther south along the EPR. They have led to a better understanding of the magmatic, tectonic, and sedimentary processes occurring on the East Pacific Rise between the Tamayo and Rivera fracture zones. The purpose of this chapter is to describe the metamorphic processes affecting Pliocene through Quaternary sediments found in contact, or inter layered, with basaltic units drilled during Leg 65 at the mouth of the Gulf of California.

Atterberg limits of sediments from DSDP Leg 65 Holes

Atterberg limits have been determined for 32 unconsolidated sediment samples, ranging in composition from silty clay to sandy silt and recovered from four sites drilled at the mouth of the Gulf of California during DSDP Leg 65. The liquid limit of the samples ranged from 41.5% to 157.5%, and the plastic limit from 32.8% to 65.1%. The plasticity index ranged from 5.9% to 102.0%. In some samples, the water content was less than the liquid limit. The liquidity index averaged 76% while the flow and toughness indices averaged 35% and 2.18%, respectively. On the basis of these limits, the sediments analyzed can be classified as inorganic clays of high plasticity, organic clays of moderate to high plasticity, and diatomaceous sands, silts, and silty clays of low plasticity.