Monolithically integrated laser diode and electroabsorption modulator with dual-waveguide spot-size converter input and output

We have demonstrated a 1.60 mu m ridge-structure laser diode and electroabsorption modulator monolithically integrated with buried-ridge-structure dual-waveguide spot-size converters at the input and output ports for low-loss coupling to a cleaved single-mode optical fibre by means of selective area growth and asymmetric twin waveguide technologies. The devices emit in single transverse and quasi-single longitudinal modes with a side mode suppression ratio of 25.6 dB. These devices exhibit 3 dB modulation bandwidth of 15.0 GHz and modulator extinction ratios of 14.0 dB dc. The output beam divergence angles of the spot-size converter in the horizontal and vertical directions are as small as 7.3 degrees x 10.6 degrees, respectively, resulting in 3.0 dB coupling loss with a cleaved single-mode optical fibre.

Analysis of output coupling efficiencies for directional emission triangle and square microlasers

Output coupling efficiencies are analyzed for triangular and square microlasers connected with an output waveguide by FDTD simulation. The results show that square resonator with an output waveguide connected to the midpoint of one side can have high output coupling efficiency and a good mode selection.

Experimental and theoretical analysis of nondegenerate ultrabroadband chirped pulse optical parametric amplification

Experimental investigations of nondegenerate ultrabroadband chirped pulse optical parametric amplification have been carried out. The general mathematical expressions for evaluating parametric bandwidth, gain and gain bandwidth for arbitrary three-wave mixing parametric amplifiers are presented. In our experiments, a type-I noncollinear phase-matched optical parametric amplifier based on lithium triborate, which was pumped by a 5-ns second harmonic pulses from a Q-switched Nd:YAG operating at 10 Hz, seeded by a 14-fs Ti:sapphire laser at 800 nm, was presented. The 0.85 nJ energy of input chirped signal pulse with 57-FWHM has been amplified to 3.1 muJ at pump intensity 3 GW/cm(2), the corresponding parametric gain reached 3.6 x 10(3), the 53 nm-FWHM gain spectrum bandwidth of output signal has been obtained. The large gain and broad gain bandwidth, which have been confirmed experimentally, provide great potentials to amplify efficiently the broad bandwidth femtosecond light pulses to generate new extremes in power, intensity, and pulse duration using optical parametric chirped pulse amplifiers pumped by powerful nanosecond systems.

THE MATRIX ANALYSIS FOR AN OPTICAL FREE-SPACE SWITCHING NETWORK AND AN OPTICAL CROSSOVER NETWORK WITH 4-FUNCTION INTERCHANGE NODES

A matrix analysis for free-space switching networks, such as perfect shuffle-exchange omega, crossover and Banyan is presented. On the basis of matrix analysis, the equivalence of these three switching networks and the route selection between input and output ports are simply explained. Furthermore, an optical crossover switching network, where MQW SEED arrays are used as electrically addressed four-function interchange nodes, is described and the optical crossover interconnection of 64 x 64, and high-speed four-function, interchange nodes is demonstrated in the experiment.

Analysis of directional emission in square resonator lasers with an output waveguide

Square microcavity laser with an output waveguide is proposed and analyzed by the finite-difference time-domain (FDTD) technique. For a square resonator with refractive index of 3.2, side length of 4 microns, and output waveguide of 0.4-micron width, we have got the quality factors (Q factors) of 6.7×10~2 and 7.3×10~3 for the fundamental and first-order transverse magnetic (TM) mode near the wavelength of 1.5 microns, respectively. The simulated intensity distribution for the first-order TM mode shows that the coupling efficiency in the waveguide reaches 53%. The numerical simulation shows that the first-order transverse modes have fairly high Q factor and high coupling efficiency to the output waveguide. Therefore the square resonator with an output waveguide is a promising candidate to realize single-mode directional emission microcavity lasers.

AND Logic Gates Based on Small Molecules with Chemical Inputs and Luminescence Output

AND logic gate behaviour can be recognized in chemical-responsive luminescence phenomena concerning small molecules. Though initial developments concerned separate and distinguishable chemical species as inputs, consideration of other types of input sets allows substantial expansion of the sub-field. Dissection of these molecular devices into modules, where possible, enables analysis of their logic behaviour according to supramolecular photochemical mechanisms.

Portfolio of Compositions investigating ensemble improvisation, distributed and real-time scoring, and multi-nodal input and output

This output is a collection of compositions which explore issues of ensemble improvisation, ensemble management and orchestration, real-time and distributed scoring, multi-nodal inputs and outputs, and animated and graphic notation. Compositions include: Activities I; tutti, duet, trio, solo, quartet; Lewitt Notations I; Webwork I; and Sometimes I feel the space between people (voices) in terms of tempos. These compositions are presented in computer animated scores which are synchronized through the network and subject to real-time modification and control. They can be performed by ensembles distributed over large physical spaces connected by the network. The scores for these compositions include software which displays the animations to the performers, software to structure and disseminate score events, and triggering software that allows the control of a performance to be distributed. Scores can also include live electronics which are coordinated with graphic events.

Preliminary analysis of organic Rankine cycles to improve vehicle efficiency

This paper presents the background rationale and key findings for a model-based study of supercritical waste heat recovery organic Rankine cycles. The paper’s objective is to cover the necessary groundwork to facilitate the future operation of a thermodynamic organic Rankine cycle model under realistic thermodynamic boundary conditions for performance optimisation of organic Rankine cycles. This involves determining the type of power cycle for organic Rankine cycles, the circuit configuration and suitable boundary conditions. The study focuses on multiple heat sources from vehicles but the findings are generally applicable, with careful consideration, to any waste heat recovery system. This paper introduces waste heat recovery and discusses the general merits of organic fluids versus water and supercritical operation versus subcritical operation from a theoretical perspective and, where possible, from a practical perspective. The benefits of regeneration are investigated from an efficiency perspective for selected subcritical and supercritical conditions. A simulation model is described with an introduction to some general Rankine cycle boundary conditions. The paper describes the analysis of real hybrid vehicle data from several driving cycles and its manipulation to represent the thermal inertia for model heat input boundary conditions. Basic theory suggests that selecting the operating pressures and temperatures to maximise the Rankine cycle performance is relatively straightforward. However, it was found that this may not be the case for an organic Rankine cycle operating in a vehicle. When operating in a driving cycle, the available heat and its quality can vary with the power output and between heat sources. For example, the available coolant heat does not vary much with the load, whereas the quantity and quality of the exhaust heat varies considerably. The key objective for operation in the vehicle is optimum utilisation of the available heat by delivering the maximum work out. The fluid selection process and the presentation and analysis of the final results of the simulation work on organic Rankine cycles are the subjects of two future publications.

Efficiency assessment of electricity power generation on Ireland’s Single Electricity Market by Data Envelopment Analysis

The efficiency of generation plants is an important measure for evaluating the operating performance. The objective of this paper is to evaluate electricity power generation by conducting an All-Island-Generator-Efficiency-Study (AIGES) for the Republic of Ireland and Northern Ireland by utilising a Data Envelopment Analysis (DEA) approach. An operational performance efficiency index is defined and pursued for the year 2008. The economic activities of electricity generation units/plants examined in this paper are characterized by numerous input and output indicators. Constant returns to scale (CRS) and variable returns to scale (VRS) type DEA models are employed in the analysis. Also a slacks based analysis indicates the level of inefficiency for each variable examined. The findings from this study provide a general ranking and evaluation but also facilitate various interesting efficiency comparisons between generators by fuel type.

Avaliação de desempenho dos municípios portugueses pelo método data envelopment analysis

Dissertação de mest., Economia Regional e Desenvolvimento Local, Faculdade de Economia, Univ. do Algarve, 2011

O uso do data envelopment analysis para avaliação e melhoria de desempenho no setor bancário: estudo de caso

O presente estudo aborda o uso do Data Envelopment Analysis (DEA) para avaliar e melhorar o desempenho no setor bancário. Consiste num estudo de caso aplicado a um dos maiores bancos portugueses. O seu objetivo, é avaliar a eficiência relativa das 333 agências bancárias que formam um dos dois departamentos comerciais do banco. Pretende-se identificar boas práticas e verificar a sua aplicabilidade nas unidades menos eficientes por forma a contribuir para a melhoria do desempenho global da instituição. Ao mesmo tempo, comparam-se os resultados de eficiência obtidos com o desempenho das unidades de negócio no cumprimento dos seus objetivos comerciais. Procura-se, assim, analisar a eventual existência de correlação entre eficiência e eficácia, ou seja, se as agências bancárias mais eficientes são também as mais eficazes. Para o efeito, é construído um modelo DEA que, considera em simultâneo, vários inputs e outputs. No modelo, as variáveis de input agregam os custos das unidades de negócio e as variáveis de output, os seus principais proveitos e alguns dos aspetos estratégicos que o banco pretende maximizar. Os resultados obtidos, identificam não só as agências bancárias menos eficientes, como assinalam aquelas que sendo semelhantes e eficientes, lhes podem servir de referência para a melhoria do seu desempenho. Tendo em conta, o caráter formativo que se pretende para o estudo, e de modo a facilitar a aceitação pelos decisores, procura-se verificar a exequibilidade das propostas apresentadas. O documento conclui pela existência, nas unidades de negócio analisadas, de uma correlação positiva fraca entre eficiência e eficácia, ainda assim estatisticamente significante. Por último, assinala a importância da metodologia DEA, enquanto medida de complementaridade de outras técnicas de controlo de gestão, em particular nas organizações que adotam a gestão por objetivos.

An extensible complex fast Fourier transform processor chip for real-time spectrum analysis and measurement

This paper describes in detail the design of a CMOS custom fast Fourier transform (FFT) processor for computing a 256-point complex FFT. The FFT is well-suited for real-time spectrum analysis in instrumentation and measurement applications. The FFT butterfly processor reported here consists of one parallel-parallel multiplier and two adders. It is capable of computing one butterfly computation every 100 ns thus it can compute a 256-point complex FFT in 102.4 μs excluding data input and output processes.

An integrated 256-point complex FFT processor for real-time spectrum analysis and measurement

This paper describes in detail the design of a custom CMOS Fast Fourier Transform (FFT) processor for computing 256-point complex FFT. The FFT is well suited for real-time spectrum analysis in instrumentation and measurement applications. The FFT butterfly processor consists of one parallel-parallel multiplier and two adders. It is capable of computing one butterfly computation every 100 ns thus it can compute 256-complex point FFT in 25.6 μs excluding data input and output processes.