Carp seed production during drought year 1987 under controlled hatchery system

The introduction of the controlled hatchery system "Model CIFE D-81" resulted in a production of 60 lakhs Indian major carp seed in the drought area of eastern Uttar Pradesh. The hatchery system provided optimum temperature, dissolved oxygen and pH for breeding and hatching and also removed the metabolites generated. The technology is simple and the success of the program attracts pisciculturists.

Fish seed production under controlled hatchery system: a cottage industry

The fish seed production in recent times has emerged as a cottage industry, with the development of controlled hatchery system. Two units of six buckets of vertical hatchery system i.e. Modern Carp Hatchery CIFE D-81 were installed in a private fish farm. 130.25 lakh spawn of Indian Major Carp (Cyprinidae) was produced during the 1988 season, with an average survival rate of 70%. The results support the viability of technology especially for the economically weaker section.

Growth and production performance of red tilapia and Nile tilapia (Oreochromis niloticus Lin.) under low-input culture system

Comparative production potential of red tilapia (a mutant hybrid of Oreochromis mossambicus) and Nile tilapia (Oreochromis niloticus) under low-input aquaculture was studied in six ponds of 360 m² each with an average water depth of 90 cm. Three ponds were stocked with fingerlings of O. niloticus (average weight 11.4±3.48 g) while three other ponds were stocked with red tilapia (average weight 10.72±2.5 g) at a density of 20,000 fingerlings/ha. Supplementary feed consisting of rice bran was given daily at 4-6% of standing biomass. Ponds were fertilized at fortnightly intervals with cattle manure 750 kg/ ha. After six months of rearing, gross fish productions of 3,218 and 3,017 kg/ha were obtained from O. niloticus and red tilapia ponds, respectively. Of this, table size fish (>80 g in size) production amounted to 2,366 and 2,823 kg/ha from O. niloticus and red tilapia culture, respectively. Analysis of cost and benefits showed higher benefit from red tilapia culture.

Observation on the production performance of Penaeus monodon with Liza parsia under different cropping system

Study was conducted in six ponds each with an area of 0.1 ha in the pond complex of Brackishwater Station, Paikgacha, Khulna from February to October '96, to find out the variation of production rate in two culture system viz., single and double crop of P. monodon with L. parsia. In treatment T1 wild fry of P. monodon (0.006g) and L. parsia (0.20g) collected from nearby river were stocked at a rate of 40,000 and 10,000/ha, respectively, for a culture period of 120 days. In treatment T2, the rate was 20,000/ha for bagda fry in 1st and 2nd crop each and 10,000 for parsia fry/ha for an extended period of 225 days. The highest survivability and growth of P. monodon and L. parsia were 57.08% (1st crop of T2) and 75.26% (T2), and 27.08g (1st crop of T2) and 47.78g (T2), respectively with a significant variations (P>0.05) with other treatment. The net profit (Tk. 93,134) and cost benefit ratio of 1:1.76 were also found higher in T2.

A record production from an integrated farming system utilising sewage enriched water

The results of experiments conducted on a pond dyke (655m²) in the Wastewater Aquaculture Division of the Central Institute of Freshwater Aquaculture, Rahara, during 1992-93 for maximising production through optimum utilisation of resources are communicated. Round the year intensive cultivation of okra (Abelmoschus esculentus), amaranth (Amaranthus gangeticus and A. viridus), water-bind weed (Ipomea aquatica), Indian spinach (Basella rubra), radish (Raphanus sativum), amaranth (Amaranthus viridis), cauliflower (Brassica oleracia var. votrytis), cabbage (Brassica oleracia var. capitota) and papaya (Carica papaya) was undertaken using the treated sewage water from fish ponds for irrigation. The pond dyke yielded 5,626.5 kg vegetable which worked out to 85.9 tons per ha per year. Multiple cropping with these vegetables excluding papaya on a 460 m² dyke recorded a production of 4,926.5 kg at the rate of 107.1t per ha/yr. An improved yearly net return of about 35% over investment could be achieved through the selection of highly productive and pest resistant vegetable crops of longer duration for integration into the system. Introduction of this type of integrated farming would enhance the overall productivity and returns from farming.

Semi-intensive shrimp farming system of Kerala, India: a production function analysis

An analysis of the factor-product relationship in the semi-intensive shrimp farming system of Kerala, farm basis and hectare basis, we are attempted and the results reported in this paper. The Cobb-Douglas model, in which the physical relationship between input and output is estimated, and the marginal analysis then employed to evaluate the producer behaviour, was used for the analysis. The study was based on empirical data collected during November 1994 to May 1996, covering three seasons, from 21 farms spread over Alappuzha, Ernakulam and Kasaragod districts of the state. The sample covered a total area of 61.06 ha. Of the 11 explanatory variables considered in the model, the size of the farm, casual labour and chemical fertilizers were found statistically significant. It was also observed that the factors such as age of pond, experience of the farmer, feed, miscellaneous costs, number of seed stocked and skilled labour contributed positively to the output. The estimated industry production function exhibited unitary economies of scale. The estimated mean output was 3937 kg/ha. The test of multi-co-linearity showed that there is no problem of dominant variable. On the basis of the marginal product and the given input-output prices, the optimum amounts of seed, feed and casual labour were estimated. They were about 97139 seed, 959 kg of feed and 585 man-days of casual labour per farm. This indicated the need for reducing the stocking density and amount of feed from the present levels, in order to maximise profit. Based on the finding of the study, suggestions for improving the industry production function are proposed.

Survival, growth and production of Penaeus monodon at different stocking densities in earthen ponds with flow-through system and supplementary feeding

The survival, growth and production of Penaeus monodon in earthen ponds were observed. A significant effect of stocking density on the survival rate of prawns was observed. The final average weight obtained varied inversly with the stocking density and the production varied directly with stocking density and survival rates. The maintenance of a clear water environment is recommended as a preventive measure against Vorticella attack.

Introducing tilapia (GIFT) with shrimp (Penaues monodon) in brackishwater rice-shrimp system: impact on water quality and production

Mixed rearing of tilapia (Genetically Improved Farmed Tilapia, GIFT) with shrimp (Penaeus monodon) in brackishwater rice-shrimp system was assessed for its impact on dry season's shrimp production. The experiment was conducted in pre-selected farmer's field located at Paikgacha Upazila of Khulna district and designed with three different densities (treatment) of GIFT, viz, 0.3, 0.4 and 0.5/m² with a constant stocking density of shrimp at 3/m². Each treatment had three replications. There had a set of control treatment where GIFT was not stocked. Results of the experiment revealed that tilapia did not exert any significant effect (p>0.05) on the water quality variables, even on survival rate of shrimp (p>0.05) under farm level condition in rice-shrimp rotational system, but a density dependent negative effect (P<0.05) on the growth of shrimp led apparently lower production rate of shrimp. Though tilapia provided the major augment of total production (p<0.05) in the respective treatments than in monoculture of shrimp, but not that of the economic return. However, economic loss due to sudden shrimp crop failure might be partially minimized by the tilapia crop.

The production of radionuclides for nuclear medicine from a compact, low-energy accelerator system.

The field of nuclear medicine is reliant on radionuclides for medical imaging procedures and radioimmunotherapy (RIT). The recent shut-downs of key radionuclide producers have highlighted the fragility of the current radionuclide supply network, however. To ensure that nuclear medicine can continue to grow, adding new diagnostic and therapy options to healthcare, novel and reliable production methods are required. Siemens are developing a low-energy, high-current - up to 10MeV and 1mA respectively - accelerator. The capability of this low-cost, compact system for radionuclide production, for use in nuclear medicine procedures, has been considered.

Production cross sections of superheavy nuclei based on dinuclear system model

The barrier distribution function method is introduced in the dinuclear system model in the calculation of the transmission probability, which is the first stage in the synthesis of superheavy nuclei. Dynamical deformation and averaging collision orientations are considered in the calculation of the fusion probability by solving master equation numerically. Survival probability with respect to xn evaporation channel (x = 1-5) in the de-excitation process of the thermal compound nucleus is calculated, in which the level density of the Fermi-gas model is used. Production cross sections of a series of superheavy nuclei formed in the reactions taken magic and deformed nuclei as target in Ca-48 induced reactions are studied systematically. The calculated results are in good agreement with available experimental data. Isotopic dependence of the production cross sections in the reactions Ca-48 + Pu is analyzed.

Center of mass energy and system-size dependence of photon production at forward rapidity at RHIC

We present the multiplicity and pseudorapidity distributions of photons produced in Au + Au and Cu + Cu collisions at root(NN)-N-s = 62.4 and 200 GeV. The photons are measured in the region -3.7 < eta < -2.3 using the photon Multiplicity detector in the STAR experiment at RHIC. The number of photons produced per average number of participating nucleon pairs increases with the beam energy and is independent of (lie collision centrality. For collisions with similar average numbers of participating nucleons the photon multiplicities are observed to be similar for An + Au and Cu + Cu collisions at a given beam energy. The ratios of the number of charged particles to photons in the measured pseudorapidity range are found to be 1.4 +/- 0.1 and 1.2 +/- 0.1 for root(NN)-N-s = 62.4 and 200 GeV, respectively. The energy dependence of this ratio could reflect varying contributions from baryons to charged particles, while mesons are the dominant contributors to photon production in the given kinematic region. The photon pseudorapidity distributions normalized by average number of participating nucleon pairs, when plotted as a function of eta-Y-beam, are found to follow a longitudinal scaling independent of centrality and colliding ion species at both beam energies. (C) 2009 Elsevier B.V. All rights reserved.

An information system to exploit the use of metadata within film and television production

The article focuses on an information system to exploit the use of metadata within film and television production. It is noted that the television and film industries are used to working on big projects. This involves the use of actual film, video tape, and P.E.R.T charts for project planning. Scripts are in most instances revised. It is essential to attach information on these in order to manage, track and retrieve them. The use of metadata eases the operations involved in these industries.

An information system to exploit the use of metadata within film and television production

The television and film industries are used to working on large projects. These projects use media and documents of various types, ranging from actual film and videotape to items such as PERT charts for project planning. Some items, such as scripts, evolve over a period and go through many versions. It is often necessary to attach information to these “objects” in order to manage, track, and retrieve them. On large productions there may be hundreds of personnel who need access to this material and who in their turn generate new items which form some part of the final production. The requirements for this industry in terms of an information system may be generalized and a distributed software architecture built, primarily using the internet, to serve the needs of these projects. This architecture must enable potentially very large collections of objects to be managed in a secure environment with distributed responsibilities held by many working on the production. Copyright © 2005 by the Society of Motion Picture and Television Engineers, Inc.