A mixed culture trail of mud crab (Scylla serrata Forskal) with tilapia ( Oreocromis niloticus L.)

A ten-month study on mixed culture of mud crab Scylla serrata with tilapia (Oreochromis niloticus) was performed in brackish water earthen ponds using live tilapia fry as the only feed for crab. The monthly growth rate varied from 9.07-19.llg among four treatments. Treatment T 1, cw: 0.68cm (±0.72) and bw: 19.11 gm (±12.97) showed highest performance which was followed by T 3, cw: 0.62cm (±0.60) and bw: 13.42 gm (±10.51), T4, cw: 0.65cm (±0.64) and bw: 13.20 gm (±9.89) and T2, cw: 0.36cm (± 0.25) and bw: 9.07 gm (±8.05). Highest survivability of crabs was also recorded in T 1 (21.5%) which was followed by T 2 (15.65%), T4 (14.95%) and T 3 (14.15%). In terms of survivability, significant differences (p<0.05) were observed among the treatments whereas these were recorded as insignificant difference (p<0.05) in final weight, weight gain and production of crabs and tilapia. Mixed culture of mud crab with tilapia could make more rewarding than crab monoculture but the study suggests that only tilapia fry can not fulfill the feed requirement of crabs in respects of survivability, final body weight and weight gain. Besides, existed salinity level of 4-12 ppt during experimental period might be the another key factor for low survivability and weight gain.

Performance of genetically improved farmed tilapia (GIFT) under mono and mixed cui ture with silver barb (Barbodes gonionotus) in south-west Bangladesh

A participatory on-farm trial was carried out to evaluate the production performance of GIFT (genetically improved farmed tilapia) strain of Oreochmis sp., either alone or with silver barb (Barbodes gonionotus), in six rain-fed freshwater ponds of coastal area. There vvere two treatments; (i) GIFT alone at a stocking density of 24,700/ha (T1) and (ii) 1:1 combination of GIFT and silver barb (T1). Each of the treatments had three replications. A significantly (p

Species diversification in coastal aquaculture: production potentials of shrimp (Penaeus monodon) with mono and mixed sex tilapia

An experiment of 120 days of culture was conducted in brackishwater earthen ponds having an area of 0.2ha each. The hatchery produced shrimp (Penaeus monodon) post larvae were stocked in the 40m² fine meshed nylon net nursery enclosures were fed with commercial pellet feed. After two weeks of nursing, juveniles were allowed to spread in cultural pond by opening the fence. Fingerlings of three different strain of tilapia were stocked as shrimp and Strain-1 all male (monosex) (T1), shrimp and Strain-2 all male (T2), shrimp and Strain-3 mixed sex population (T3) @ 20.000/ha and 10.000/ha, respectively and shrimp only (monoculture) (T4) @ 20.000/ha. The shrimp and fish were fed with farm made feed consisting of a mixture of fishmeal 29%, MOC 15%, rice bran 30%, soybean meal 16%, wheat flour 9% and vitamin premix 0.1%. The average final weight of shrimp was 24.9±1.13g, 23.41±3.26g and 26.67±1.89g that stocked with tilapia in treatments T1, T2, and T3 respectively. The final average weight of shrimp in monoculture (T4) was 27.41±0.76g, apparently higher but insignificant in treatments. The survival of shrimp was 42.17%, 32.38%, 39.45% and 61.98% in treatments T1 T2, T3 and T4 respectively. The production of shrimp in concurrent culture was 193.67, 154.26 and 210.41kg/ha in T1, T2 and T3, respectively, while in monoculture (T4) was 339.77 kg/ha. The growth and survival of tilapia among the treatments was insignificant. The growth of monosex tilapia ranged 225.29 and 291.31g and survival 62.77 and 72.20% in T1 and T2, respectively, in mixed sex was 193.0g and 83.20% (T3). The production of tilapia monosex strains was 1676.69kg/ha (Strain-2 all male) and 1668.98 kg/ha (Strain-1 all male) while that of Strain-3 mixed sex population was 1622.92 kg/ha.

Structural tunability and switchable exciton emission in inorganic-organic hybrids with mixed halides

Room-temperature tunable excitonic photoluminescence is demonstrated in alloy-tuned layered Inorganic-Organic (IO) hybrids, (C12H 25NH3)2PbI4(1-y)Br4y (y = 0 to 1). These perovskite IO hybrids adopt structures with alternating stacks of low-dimensional inorganic and organic layers, considered to be naturally self-assembled multiple quantum wells. These systems resemble stacked monolayer 2D semiconductors since no interlayer coupling exists. Thin films of IO hybrids exhibit sharp and strong photoluminescence (PL) at room-temperature due to stable excitons formed within the low-dimensional inorganic layers. Systematic variation in the observed exciton PL from 510 nm to 350 nm as the alloy composition is changed, is attributed to the structural readjustment of crystal packing upon increase of the Br content in the Pb-I inorganic network. The energy separation between exciton absorption and PL is attributed to the modified exciton density of states and diffusion of excitons from relatively higher energy states corresponding to bromine rich sites towards the lower energy iodine sites. Apart from compositional fluctuations, these excitons show remarkable reversible flips at temperature-induced phase transitions. All the results are successfully correlated with thermal and structural studies. Such structural engineering flexibility in these hybrids allows selective tuning of desirable exciton properties within suitable operating temperature ranges. Such wide-range PL tunability and reversible exciton switching in these novel IO hybrids paves the way to potential applications in new generation of optoelectronic devices. © 2013 AIP Publishing LLC.

Peculiarity of constant photocurrent method for silicon films with mixed amorphous-nanocrystalline structure

The results of conductivity, photoconductivity and constant photocurrent method absorption measurements by DC and AC methods in hydrogenated silicon films with mixed amorphous-nanocrystalline structure are presented. A series of diphasic silicon films was deposited by very high frequency plasma enhanced chemical vapor deposition technique, using different hydrogen dilution ratios of silane. The increase of hydrogen dilution ratio results in five orders of magnitude increase of conductivity and a sharp increase of grain volume fraction. The comparison of the absorption spectra obtained by DC and AC methods showed that they are similar for silicon films with the predominantly amorphous structure and films with high grain volume fraction. However we found a dramatic discrepancy between the absorption spectra obtained by DC and AC constant photocurrent methods in silicon films deposited in the regime of the structure transition from amorphous to nanocrystalline state. AC constant photocurrent method gives higher absorption coefficient than DC constant photocurrent method in the photon energy range of 1.2-1.7 eV. This result indicates the possibility of crystalline grains contribution to absorption spectra measured by AC constant photocurrent method in silicon films with intermediate crystalline grain volume fraction. (c) 2008 Published by Elsevier B.V.

A 1,000 Frames/s Programmable Vision Chip with Variable Resolution and Row-Pixel-Mixed Parallel Image Processors

A programmable vision chip with variable resolution and row-pixel-mixed parallel image processors is presented. The chip consists of a CMOS sensor array, with row-parallel 6-bit Algorithmic ADCs, row-parallel gray-scale image processors, pixel-parallel SIMD Processing Element (PE) array, and instruction controller. The resolution of the image in the chip is variable: high resolution for a focused area and low resolution for general view. It implements gray-scale and binary mathematical morphology algorithms in series to carry out low-level and mid-level image processing and sends out features of the image for various applications. It can perform image processing at over 1,000 frames/s (fps). A prototype chip with 64 x 64 pixels resolution and 6-bit gray-scale image is fabricated in 0.18 mu m Standard CMOS process. The area size of chip is 1.5 mm x 3.5 mm. Each pixel size is 9.5 mu m x 9.5 mu m and each processing element size is 23 mu m x 29 mu m. The experiment results demonstrate that the chip can perform low-level and mid-level image processing and it can be applied in the real-time vision applications, such as high speed target tracking.

Synthesis of composite AIN powder mixed with sintering additives by the Lanxide method

Composite AlN powder, mixed with the sintering additive Y2O3, was synthesized by the direct nitridation of molten Al-Mg-Y alloys. The character of products was determined by means of electron microscopy, X-ray diffraction, granularmetric analysis and chemical composition analysis etc. The results show that the nitridation rate of the raw alloys is higher, and the nitridation products axe porous enough to be easily crushed. Composite AlN powder, obtained by the Lanxide method, has excellent characters such as high purity, especially low oxygen content, and narrow well-distributed grain size and so on.

Improved performance in organic light emitting diodes with a mixed electron donor-acceptor film involved in hole injection

Organic light emitting diodes using a mixed layer of electron acceptor 3, 4, 9, 10 perylenetetracarboxylic dianhydride and electron donor copper phthalocyanine (PTCDA:CuPc) on indium tin oxide (ITO) anodes were fabricated. The device properties were found to be strongly dependent on the thickness of the PTCDA:CuPc film: both the power efficiency and the driving voltage of the device were optimized with a thickness of PTCDA:CuPc ranging from 10 to 20 nm. As compared to the conventional ITO/CuPc hole injection structure, the ITO/PTCDA:CuPc hole injection structure could remarkably enhance both the luminance and the power efficiencies of devices. A mechanism of static-induced, very efficient hole-electron pairs generation in mixed PTCDA:CuPc films was proposed to explain the experimental phenomena. The structural and optical properties of PTCDA:CuPc film were examined as well. (c) 2007 American Institute of Physics.

Separation of peptides on mixed mode of reversed-phase and ion-exchange capillary electrochromatography with a monolithic column

The mixed mode of reversed phase (RP) and strong canon-exchange (SCX) capillary electrochromatography (CEC) based on a monolithic capillary column has been developed. The capillary monolithic column was prepared by in situ copolymerization of 2-(sulfooxy)ethyl methacrylate (SEMA) and ethylene dimethacrylate (EDMA) in the presence of porogens. The sulfate group provided by the monomer SEMA on the monolithic bed is used for the generation of the electroosmotic flow (EOF) from the anode to the cathode, but at the same time serves as a SCX stationary phase. A mixed-mode (RP/SCX) mechanism for separation of peptides was observed in the monolithic column, comprising hydrophobic and electrostatic interaction as well as electrophoretic migration at a low pH value of mobile phase. A column efficiency of more than 280000 plates/m for the unretained compound has been obtained on the prepared monoliths. The relative standard deviations observed for to and retention factors of peptides were about 0.32% and less than 0.71% for ten consecutive runs, respectively. Effects of mobile phase compositions on the EOF of the monolithic column and on the separation of peptides were investigated. The selectivity on separation of peptides in the monolithic capillary column could be easily manipulated by varying the mobile phase composition.

Rare-earth-metal mixed hydride/aryloxide complexes bearing mono(cyclopentadienyl) ligands. Synthesis, CO2 fixation, and catalysis on copolymerization of CO2 with cyclohexene oxide

Hydrogenolysis of mono(cyclopentadienyl)-ligated rare-earth-metal bis(alkyl) complexes Cp'Ln-(CH2SiMe3)2(THF) (Ln = Y (1a), Dy (1b), Lu (1c); Cp' = C5Me4SiMe3) with PhSiH3 afforded the mixed hydride/alkyl complexes [Cp'Ln(mu-H)(CH2SiMe3)(THF)](2) (Ln = Y (2a), Dy (2b), Lu (2c)). The overall structure of complexes 2a-c is a C-2-symmetric dimer containing a planar symmetric Ln(2)H(2) core at the center of the molecule. Deprotonation of ArOH (Ar = C6H2-Bu-t(2)-2,6-Me-4) by the metal alkyl group of 2a-c led to formation of the mixed hydride/aryloxide derivatives [Cp'Ln(mu-H)(OAr)](2) (Ln = Y (3a), Dy (3b), Lu (3c)), which adopt the dimeric structure through hydride bridges with trans-accommodated terminal aryloxide groups.