Microbial community composition in sediments of the Hydrate Ridge (Cascadian Margin) collected during RV SONNE cruises SO143 (1999) and SO148-1 (2000)

Cold seep environments such as sediments above outcropping hydrate at Hydrate Ridge (Cascadia margin off Oregon) are characterized by methane venting, high sulfide fluxes caused by the anaerobic oxidation of methane, and the presence of chemosynthetic communities. This investigation deals with the diversity and distribution of sulfate-reducing bacteria, some of which are directly involved in the anaerobic oxidation of methane as syntrophic partners of the methanotrophic archaea. The composition and activity of the microbial communities at methane vented and nonvented sediments are compared by quantitative methods including total cell counts, fluorescence in situ hybridization (FISH). Bacteria involved in the degradation of particulate organic carbon (POC) are as active and diverse as at other productive margin sites of similar water depths. The availability of methane supports a two orders of magnitude higher microbial biomass (up to 9.6×10**10cells/cm**3). Sediment samples were obtained during RV SONNE cruises SO143-2 and SO148-1 at the crest of southern Hydrate Ridge at the Cascadia convergent margin off the coast of Oregon. Sediment cores of 20 - 40 cm length were obtained using a video-guided multiple corer from gas hydrate bearing sediments and from reference sites not enriched in methane in the surface sediments. Samples for total cell counts were obtained from 1 cm core slices, fixed with 2% formaldehyde and stored cold (4°C) and the quantification of aggregates was done via epifluorescence microscopy after staining the sediments with Acridine Orange Direct Counts (AODC) according to the method of Meyer- Reil (1983, doi:10.1007/BF00395813). Total cell counts were defined as the sum of single cells plus the aggregated cells in the syntrophic consortia. DAPI staining was used to measure ANME2/DSS aggregate sizes via epifluorescence microscopy of FISH-treated samples. For FISH, subsamples of sediment cores were sliced into 1 cm intervals and fixed for 2-3 h with 3% formaldehyde (final concentration), washed twice with 1×PBS (10 mM sodium phosphate; 130 mM NaCl), and finally stored in 1×PBS/EtOH (1:1) at -20°C.

Iron concentration and fluxes in the water column during POLARSTERN cruises in the Southern Ocean

In large parts of the Southern Ocean, primary production is limited due to shortage of iron (Fe). We measured vertical Fe profiles in the western Weddell Sea, Weddell-Scotia Confluence, and Antarctic Circumpolar Current (ACC), showing that Fe is derived from benthic Fe diffusion and sediment resuspension in areas characterized by high turbulence due to rugged bottom topography. Our data together with literature data reveal an exponential decrease of dissolved Fe (DFe) concentrations with increasing distance from the continental shelves of the Antarctic Peninsula and the western Weddell Sea. This decrease can be observed 3500 km eastward of the Antarctic Peninsula area, downstream the ACC. We estimated DFe summer fluxes into the upper mixed layer of the Atlantic sector of the Southern Ocean and found that horizontal advection dominates DFe supply, representing 54 ± 15% of the total flux, with significant vertical advection second most important at 29 ± 13%. Horizontal and vertical diffusion are weak with 1 ± 2% and 1 ± 1%, respectively. The atmospheric contribution is insignificant close to the Antarctic continent but increases to 15 ± 10% in the remotest waters (>1500 km offshore) of the ACC. Translating Southern Ocean carbon fixation by primary producers into biogenic Fe fixation shows a twofold excess of new DFe input close to the Antarctic continent and a one-third shortage in the open ocean. Fe recycling, with an estimated 'fe' ratio of 0.59, is the likely pathway to balance new DFe supply and Fe fixation.

Sediment and pore water chemistry and physical oceanography of samples obtained during Baltic Sea research cruises

Sediment samples from approximately 40 stations in the Western, middle and eastern Baltic Sea were investigated for manganese and iron content. In a series of interstitial water samples and numerous deep and surface water samples, the manganese content was likewise determined. A strong enrichment of these elements in the basin sediments was shown. In many instances, several percent manganese were present. As a maximum value, 13% was found in a 1 mm thick layer. Furthermore, a distinct decrease in manganese content with increasing sediment depth was shown in the upper 10 to 20 cm of the Sediment at almost all stations. Both phenomena may be explained by the release of manganese from the Sediment through diffusion. In the flat parts of the Baltic and those parts having good bottom water circulation, this diffusion progresses especially vigorously as a result of a steep gradient of the Mn++ concentration in the interstitial water-deep water interface. The manganese which hereby passes into the water overlying the bottom (manganese contents between 10 and 100 y Mn/l were determined in numerous deep water samples) is partly reprecipitated on the Sediment surface, and partly carried by currents into the deeper basins where it is finallv deposited. It is bound there as a manganese-rich mixed carbonate, the composition of which can be proved chemically and by x-ray methods. Iron is likewise of higher content in the basinal sediments, however, the extent of its enrichment is far less since it is less soluble than manganese under the reducing conditions in the sediments. The fine bands of manganese- and iron-rich layers in the basin sediments may likewise be explained as a result of diffusion.