911 resultados para IRRADIATED GROUND-BEEF
Resumo:
Objectives: the aim of this study was to evaluate in vitro, by scanning electron microscopy (SEM), the adhesion of blood components on root surfaces irradiated with Er:YAG (2.94 mu m) and GaAlAs Diode (808 nm) lasers and the effects on the morphology of irradiated root surfaces.Methods: One hundred samples of human teeth were obtained. They were previously planed and scaled with manual instruments and divided into five groups of 20 samples each: G1 (control group) - absence of treatment; G2 - Er:YAG laser (7.6 J/cm(2)); G3 - Er:YAG laser (12.9 J/cm(2)); G4 - Diode laser (90 J/cm(2)) and G5 - Diode laser (108 J/cm(2)). After these treatments, 10 samples of each group received a blood tissue but the remaining 10 did not. After laboratory treatments, the samples were obtained by SEM, the photomicrographs were analysed by the score of adhesion of blood components and the results were statistically analysed (Kruskall-Wallis and Mann-Whitney test).Results: In relation to the adhesion of blood components, the study showed no significant differences between the control group and the groups treated with Er:YAG laser (p = 0.9633 and 0.6229). Diode laser radiation was less effective than control group and Er:YAG laser radiation (p < 0.01).Conclusion: None of the proposed treatments increased the adhesion of blood components in a significant way when compared to the control group. Although the Er:YAG laser did not interfere in the adhesion of blood components, it caused more changes on the root surface, whereas the Diode laser inhibited the adhesion.
Resumo:
Low-level laser therapy (LLLT) accelerates tissue repair. Mast cells induce the proliferation of fibroblasts and the development of local fibrosis. The objective of this study was to quantify fibrosis rate and mast cells in connective tissue after endodontic sealer zinc oxide and eugenol (ZOE) was implanted and submitted to LLLT, immediately after implant and again 24 h later. Sixty mice were distributed into three groups: GI, GII, and GIII (n = 20). In GI, the tubes filled with Endofill were implanted in the animals and were not irradiated with LLLT. In GII, the tubes containing Endofill were implanted in the animals and then irradiated with red LLLT (InGaAIP) 685-nm wavelength, D=72 J/Cm(2), E = 2 J, T=58 s, P=35 mW, and in GIII, the tubes with Endofill were implanted and irradiated with infrared LLLT (AsGaAl) 830-nm wavelength, D=70 J/Cm(2), E = 2 J, T=40 s, P=50 mW. After 7 days and 30 days, the animals were killed. A series of 6-mu m-thick sections were obtained and stained with Toluidine Blue and Picrosirius and analyzed under a standard light microscope using a polarized light filter for the quantification of fibrosis. The statistics were qualitative and quantitative with a significance of 5%. The irradiation with LLLT did not offer improvement in the fibrosis rate, however, it provided a significant decrease in the concentration of independent mast cells for the period studied.
Resumo:
The objective this study was to evaluate in vitro the bond strength of two etch-and-rise and one self-etching adhesive system after dentin irradiation with Er:YAG (erbium: yttrium aluminum garnet) laser using microtensile test. The results revealed that the groups treated with laser Er:YAG presented less tensile bond strength, independently to the adhesive system used. The prompt L-pop adhesive presented less microtensile bond strength compared to the other adhesives evaluated. There was no difference between single bond and excite groups. The adhesive failures were predominant in all the experimental groups. The Er:YAG laser influenced negatively bond strength values of adhesive systems tested in dental substrate.
Resumo:
The purpose of this in vitro study was to verify through micro tensile bond test the bond strength of an adhesive system irradiated with Nd:YAG laser in dentine previously treated with Er:YAG laser. Twenty caries free extracted human third molars were used. The teeth were divided in four experimental groups (n = 5): (G1) control group; (G2) irradiation of the adhesive system with the Nd:YAG laser; (G3) dentin treatment with Er:YAG laser; (G4) dentin treatment with Er:YAG laser followed by the irradiation of the adhesive system with Nd:YAG laser. The Er:YAG laser fluency parameter for the dentin treatment was of 60 J/cm(2). ne adhesive system was irradiated with the Nd:YAG laser with fluency of 100 J/cm(2). Dental restorations were performed with Adper Single Bond 2/Z250. One tooth from each group was prepared for the evaluation of the adhesive interface under SEM and bond failure tests were also performed and evaluated. The statistical analysis showed statistical significant difference between the groups G1 and G3, G1 and G4, G2 and G3, and G2 and G4; and similarity between the groups G1 and G2, and G3 and G4. The adhesive failures were predominant in all the experimental groups. The SEM analysis showed an adhesive interface with features confirming the results of the mechanical tests. The Nd:YAG laser on the adhesive system did not influence the bond strength in dentin treated or not with the Er:YAG laser.
Resumo:
The present work evaluated low-cost protocols for timed artificial insemination (TAI) in beef cattle. In Experiment 1, cycling nonlactating Nelore cows (Bos indicus, n=98) were assigned to the following groups: GnRH-PGF (GP) and GnRH-PGF-GnRH (GPG), whereas cycling (n=328, Experiment 2) or anestrus (n = 225, Experiment 3) lactating (L) cows were divided into 3 groups: GP-L, GPG-L and GnRH-PCF-Estradiol benzoate (GPE-L). In Experiment 4, lactating cows (n=201) were separated into 3 groups: GP-L, GPE-L and G 1/2PE-L. Animals from Experiment 1, 3 and 4 were treated (Day 0), at random stages of the estrous cycle, with 8 mug of buserelin acetate (GnRH agonist) intramuscularly (im), whereas in Experiment 2 half of the cows received 8 and the other half 12 mug of GnRH (im). Seven days later (D 7) all animals were treated with 25 mg of dinoprost trometamine (PGF2 alpha, im) except those cows from the G 1/2PE-L group which received only 1/2 dose of PGF2 alpha (12.5 mg) via intravulvo-submucosa (ivsm). Alter PGF2 alpha injection the animals from the control groups (GP and GP-L) were observed twice daily to detect estrus and Al was performed 12 h afterwards. The cows from the other groups received a second GnRH injection (D 8 in GPG-L and d9 in GPG groups) or one injection of estradiol benzoate (EB, 1.0 mg, D 8 in GPE-L group). All cows from GPG and GPG-L or GPE-L groups were AI 20 to 24 or 30 to 34 h, respectively, after the last hormonal injection. Pregnancy was determined by ultrasonography or rectal palpation 30 to 50 days after AI. In the control groups (GP and GP-L) percentage of animals detected in heat (44.5 to 70.3%) and pregnancy rate (20 to 42%) varied according to the number of animals with corpus luteum (CL) at the beginning of treatment. The administration of a second dose of GnRH either 24 (Experiment 2) or 48 h (Experiment 1) after PGF2 alpha resulted in 47.7 and 44.9% pregnancy rates, respectively, after TAI in cycling animals. However, in anestrus cows the GPG treatment induced a much lower pregnancy rate (14.9%) after TAI. The replacement of the second dose of GnRH by EB (GPE-L) resulted in a pregnancy rate (43.3%) comparable to that obtained after GnRH treatment (GPG-L, 47.7%, Experiment 2). Furthermore, the use of 1/2 dose of PGF2 alpha (12.5 mg ivms, Experiment 4) resulted in pregnancy rate (43.5%) similar to that observed with the full dose (im). Both protocols GPG and GPE were effective in synchronizing ovulation in cycling Nelore cows and allowed approximately a 45% pregnancy rate after TAI. Additionally, the GPE treatment is a promising alternative to the use of GPG in timed Al of beef cattle, due to the low cost of EB when compared to GnRH agonists. (C) 2001 by Elsevier B.V.
Resumo:
The objective of this study was to evaluate protocols for synchronizing ovulation in beef cattle. In Experiment 1, Nelore cows (Bos indicus) at random stages of the estrous cycle were assigned to 1 of the following treatments: Group GP controls (nonlactating, n=7) received GnRH agonist (Day 0) and PGF2 alpha (Day 7); while Groups GPG (nonlactating, n=8) and GPG-L (lactating, n=9) cows were given GnRH (Day 0), PGF2a (Day 7) and GnRH again (Day 8, 30 h after PGF2 alpha). A new follicular wave was observed 1.79+/-0.34 d after GnRH in 19/24 cows. After PGF2a, ovulation occurred in 19/24 cows (6/7 GP, 6/8 GPG, 7/9 GPG-L). Most cows (83.3%) exhibited a dominant follicle just before PGF2a, and 17/19 ovulatory follicles were from a new follicular wave. There was a more precise synchrony of ovulation (within 12 h) in cows that received a second dose of GnRH (GPG and GPG-L) than controls (GP, ovulation within 48 h; P<0.01). In Experiment 2, lactating Nelore cows with a visible corpus luteum (CL) by ultrasonography were allocated to 2 treatments: Group GPE (n=10) received GnRH agonist (Day 0), PGF2a (Day 7) and estradiol benzoate (EB; Day 8, 24 h after PGF2 alpha); while Group EPE (n=11), received EB (Day 0), PGF2a (Day 9) and EB (Day 10, 24 h after PGF2a). Emergence of a new follicular wave was observed 1.6+/-0.31 d after GnRH (Group GPE). After EB injection (Day 8) ovulation was observed at 45.38+/-2.03 h in 7/10 cows within 12 h. In Group EPE the emergence of a new follicular wave was observed later (4.36+/-0.31 d) than in Group GEP (1.6+/-0.31 d; P<0.001). After the second EB injection (Day 10) ovulation was observed at 44.16+/-2.21 h within 12 (7/11 cows) or 18 h (8/11 cows). All 3 treatments were effective in synchronizing ovulation in beef cows. However, GPE and, particularly EPE treatments offer a promising alternative to the GPG protocol in timed artificial insemination of beef cattle, due to the low cost of EB compared with GnRH agonists. (C) 2000 by Elsevier B.V.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
This study evaluated the resistance to demineralization and fluoride incorporation of enamel irradiated with Er:YAG. A total of 110 bovine teeth were selected and divided into eight groups: unlased, 37% phosphoric acid, and samples irradiated with the Er:YAG laser at several fluences (31.84 J/cm(2), 25.47 J/cm(2), 19.10 J/cm(2), 2.08 J/cm(2), 1.8 J/cm(2), and 0.9 J/cm(2)). The application of acidulated phosphate fluoride was performed after treatments. All samples were immersed in 2 ml of 2.0 M acetic-acetate acid solution at pH 4.5 for 8 h, and fluoride, calcium, and phosphorus ions dissolved were analyzed by atomic absorption spectrometry and spectrophotometry. The phosphoric acid and 31.84 J/cm(2) groups presented the lowest dissolution of calcium and phosphorus ions. Higher fluoride incorporation was observed on 1.8 J/cm(2) and 0.9 J/cm(2) groups. Based on these results, Er:YAG laser was able to decrease acid dissolution and increase fluoride uptake and can be a promissory alternative for preventive dentistry.
Resumo:
Jerked beef - JB - é um produto cárneo curado, salgado e seco ao sol, derivado de um típico produto cárneo brasileiro - o charque. Ambos carecem de estudos que orientem seu aprimoramento. Staphylococcus spp. têm sido reportado como o gênero predominante na microbiota do produto, o que evidencia o risco de desenvolvimento de linhagens enterotoxigênicas de S. aureus. Foram empregadas duas linhagens inócuas de estafilococos na elaboração de JB, a fim de avaliar sua influência sobre o desenvolvimento de S. aureus por mecanismo competitivo ou pela produção de bacteriocinas. Os resultados demonstraram que ambas inibiram o desenvolvimento do patógeno tanto in vitro como durante o processamento do produto. Não se observou produção de compostos inibitórios pelas linhagens iniciadoras, ficando a explicação para a inibição observada restrita ao mecanismo competitivo. Este trabalho permitiu demonstrar a possibilidade de aumentar a segurança e padronização de JB pelo emprego de culturas bacterianas selecionadas.
Resumo:
The ground state masses and binding energies of the nucleon, lambda0, lambdac+ , lambdab0 are studied within a constituent quark QCD-inspired light-front model. The light-front Faddeev equations for the Qqq composite spin 1/2 baryons, are derived and solved numerically. The experimental data for the masses are qualitatively described by a flavor independent effective interaction.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)