Efeito do extrato aquoso de Allium sativum L. sobre parâmetros bioquímicos de ratas com diabete induzido por Streptozotocin

Many plants, even without scientific confirmation, are used in Brazil as hypoglycemic. The objective of the present work was to study the influence of the Allium sativum treatment, plant known popularly as garlic, on characteristic biochemical parameters in streptozotocin-induced diabetic rats. Female Wistar rats were injected with 40 mg kg-1 streptozotocin (STZ). Oral administration of an aqueous extract of A. sativum was given to the diabetic animals in 2 doses: 200 and 400 mg kg-1 (n=6 animals/group). Diabetic rats given distilled water constituted the control group. After 28 days of treatment, the female rats were anesthetized and died by decapitation for collection of the blood for biochemical determinations and retreat of liver samples for hepatic glycogen dosage. The treatment with Allium sativum in the doses of 200 and 400 mg kg-1 alter no concentrations of total proteins, hepatic glycogen, triglycerides and VLDL, but it promoted reduction in the total cholesterol rate (control=280.5 ± 30.9; 200 mg kg-1 A. sativum =169.9 ± 19.5 and 400 mg kg-1 A. sativum =148.4 ± 26.6 mg dL-1) and LDL (control=128.8± 25.3; 200 mg kg-1 A. sativum = 41.4 ± 16.2 and 400 mg kg-1 A. sativum=42.0 ± 26.0 mg dL-1). The extract presented beneficial effect because it decreased 13.0% of glycemia in the highest dose. Therefore, the of garlic extract reduced the HDL concentration in two tested doses (control= 81.4 ± 30.2; 200 mg kg-1 A. sativum=49.6 ± 14.3 and 400 mg kg-1 A. sativum=41.7 ± 16.1 mg dL -1), presenting impaired effect. Thus, the garlic extract showed efficiency in the analyzed experimental conditions, and it could be used as complementary therapy to diabetic patients.

Heterogeneous photocatalytic treatment of organic dyes in air and aqueous media

This review focuses on the heterogeneous photocatalytic treatment of organic dyes in air and water. Representative studies spanning approximately three decades are included in this review. These studies have mostly used titanium dioxide (TiO2) as the inorganic semiconductor photocatalyst of choice for decolorizing and decomposing the organic dye to mineralized products. Other semiconductors such as ZnO, CdS, WO3, and Fe2O3 have also been used, albeit to a much smaller extent. The topics covered include historical aspects, dark adsorption of the dye on the semiconductor surface and its role in the subsequent photoreaction, semiconductor preparation details, photoreactor configurations, photooxidation kinetics/mechanisms and comparison with other Advanced Oxidation Processes (e.g., UV/H2O2, ozonation, UV/O3, Fenton and photo-Fenton reactions), visible light-induced dye decomposition by sensitization mechanism, reaction intermediates and toxicity issues, and real-world process scenarios. © 2008 Elsevier B.V. All rights reserved.

Wireless sensor networks Zigbee applied on sewage treatment station

The good efficiency in a sewage treatment plant (WWTP) is a great importance to the environment. The management of electromechanical equipment installed in these stations is a major challenge due to the fact that they are installed on areas of difficult access and maintenance unhealthy and making the time for the correction of any faults is extended. This paper proposes the development of a Wireless Sensor Network (WSN), in order to monitor electromechanical equipment, allowing the Concessionaire a predictive control in real time. The design of a wireless sensors network for monitoring equipment requires not only the development and assembly of the sensor modules, but must also include the development of software for managing the data collected. Thus, this work includes a Zigbee WSN, small, adapted for monitoring of electromechanical equipment and environmental conditions of a WWTP, type stabilization pond, installed in an area of approximately 0.15 km 2 and the average flow of 320 liters of treatment per second. The experimental results show that this monitoring system can perform with the collection of parameters of performance and quality assessment at the station.

Chlorine disinfection of dye wastewater: Implications for a commercial azo dye mixture

Azo dyes, the most widely used family of synthetic dyes, are often employed as colorants in areas such as textiles, plastics, foods/drugs/cosmetics, and electronics. Following their use in industrial applications, azo dyes have been found in effluents and various receiving waters. Chemical treatment of effluents containing azo dyes includes disinfection using chlorine, which can generate compounds of varying eco/genotoxicity. Among the widely known commercial azo dyes for synthetic fibers is C.I. Disperse Red 1. While this dye is known to exist as a complex mixture, reports of eco/genotoxicity involve the purified form. Bearing in mind the potential for adverse synergistic effects arising from exposures to chemical mixtures, the aim of the present study was to characterize the components of commercial Disperse Red 1 and its chlorine-mediated decoloration products and to evaluate their ecotoxicity and mutagenicity. In conducting the present study, Disperse Red 1 was treated with chlorine gas, and the solution obtained was analyzed with the aid of LC-ESI-MS/MS to identify the components present, and then evaluated for ecotoxicity and mutagenicity, using Daphnia similis and Salmonella/microsome assays, respectively. The results of this study indicated that chlorination of Disperse Red 1 produced four chlorinated aromatic compounds as the main products and that the degradation products were more ecotoxic than the parent dye. These results suggest that a disinfection process using chlorine should be avoided for effluents containing hydrophobic azo dyes such commercial Disperse Red 1. © 2012 Elsevier B.V..

Electrochemical oxidation of wastewater containing aromatic amines using a flow electrolytic reactor

Aromatic amines are environmental pollutants and represent one of the most important classes of industrial and natural chemicals. Some types of complex effluents containing these chemical species, mainly those originated from chemicals plants are not fully efficiently treated by conventional processes. In this work, the use of electrochemical technology through an electrolytic pilot scale flow reactor is considered for treatment of wastewater of a chemical industry manufacturer of antioxidant and anti-ozonant substances used in rubber. Experimental results showed that was possible to remove between 65% and 95% of apparent colour and chemical oxygen demand removal between 30 and 90% in 60 min of treatment, with energy consumption rate from 26 kWh m-3 to 31 kWh m-3. Absorbance, total organic carbon and toxicity analyses resulted in no formation of toxic by-products. The results suggest that the presented electrochemical process is a suitable method for treating this type of wastewater, mainly when pre-treated by aeration. Copyright © 2013 Inderscience Enterprises Ltd.

Seven years of external control of fluoride levels in the public water supply in Bauru, São Paulo, Brazil

luoridation of the public water supplies is recognized as among the top ten public health achievements of the twentieth century. However, the positive aspects of this measure depend on the maintenance of fluoride concentrations within adequate levels. Objective: To report the results of seven years of external control of the fluoride (F) concentrations in the public water supply in Bauru, SP, Brazil in an attempt to verify, on the basis of risk/ benefit balance, whether the levels are appropriate. Material and Methods: From March 2004 to February 2011, 60 samples were collected every month from the 19 supply sectors of the city, totaling 4,641 samples. F concentrations in water samples were determined in duplicate, using an ion-speciflc electrode (Orion 9609) coupled to a potentiometer after buffering with TISAB II. After the analysis, the samples were classified according to the best risk-benefit adjustment. Results: Means (±standard deviation) of F concentrations ranged between 0.73±0.06 and 0.81±0.10 mg/L for the different sectors during the seven years. The individual values ranged between 0.03 and 2.63 mg/L. The percentages of the samples considered low risk for dental fluorosis development and of maximum benefit for dental caries prevention (0.55-0.84 mg F/L) in the first, second, third, fourth, fifth, sixth, and seventh years of the study were 82.0, 58.5, 37.4, 61.0, 89.9, 77.3, and 72.4%, respectively, and 69.0% for the entire period. Conclusions: Fluctuations of F levels were found in the public water supply in Bauru during the seven years of evaluation. These results suggest that external monitoring of water fluoridation by an independent assessor should be implemented in cities where there is adjusted fluoridation. This measure should be continued in order to verify that fluoride levels are suitable and, if not, to provide support for the appropriate adjustments.

A photoelectrocatalytic process that disinfects water contaminated with Mycobacterium kansasii and Mycobacterium avium

Nontuberculous mycobacteria are resistant to conventional water treatment; indeed, they have been recovered from a wide variety of environmental sources. Here, we applied the photoelectrocatalytic technique using a Ti/TiO2-Ag photoanode to inactivate mycobacteria. For a mycobacteria population of 5 × 108 CFU mL-1, we achieved 99.9 and 99.8% inactivation of Mycobacterium kansasii and Mycobacterium avium with rate constant of 6.2 × 10-3 and 4.2 × 10-3 min-1, respectively, after 240 min. We compared the proposed method with the photolytic and photocatalytic methods. Using a mycobacteria population of 7.5 × 104 CFU mL-1, the proposed Ti/TiO2-Ag photoanode elicited total mycobacteria inactivation within 3 min of treatment; the presence of Ag nanoparticles in the electrode provided 1.5 larger degradation rate constant as compared with the Ti/TiO2 anode (1.75 × 10-2 for M. kansassi and 1.98 × 10-2 for M. avium). We monitored the degradation of the metabolites released during cellular lysis by TOC removal, sugar release, chromatography, and mass spectrometry measurements; photoelectrocatalysis and Ti/TiO2-Ag photoanodes furnished the best results. © 2013 Elsevier Ltd. All rights reserved.

Adubação mineral, esterco de curral e lodo de esgoto no desenvolvimento inicial do cafeeiro

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Avaliação do potencial citotóxico, genotóxico e mutagênico de esgoto por meio dos sistemas-teste Allium cepa e Tradescantia pallida

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Efeito de diferentes águas e fertilizantes foliares em caldas acaricidas no controle do ácaro Brevipalpus phoenicis (Geijskes, 1939) (Acari: Tenuipalpidae) em citros

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Avaliação do método respirométrico pelo acompanhamento e controle de processo de compostagem de lodo de esgoto

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Parâmetros químicos da solução de um solo fertilizado com lodo de esgoto em bananeiras irrigadas

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Desempenho de reator anaeróbio de fluxo ascendente alimentado com lodo de estação de tratamento de água e esgoto sanitário

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Caracterização e biodegradação de lodo de estações de tratamento de água para descarte em aterro sanitário

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Biodigestão anaeróbia da cama de frango associada ou não ao biofertilizante obtido com dejetos de suínos: produção de biogás e qualidade do biofertilizante

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)