Measurement of phase differences between the diffracted orders of deep relief gratings

Measurement of the phase difference between the 0th and the 1st transmitted diffraction orders of a symmetrical surface-relief grating recorded on a photoresist film is carried out by replacement of the grating in the same setup with which it was recorded. The measurement does not depend on lateral shifts of the replaced grating relative to the interference pattern, on environmental phase perturbations or on the wave-front quality of the interfering beams. The experimental data agree rather well with theoretical results calculated for sinusoidal profiled gratings. (C) 2003 Optical Society of America.

Assignment and frequency measurement of rotational transitions of (CD3OH)-C-13 by intracavity laser Stark spectroscopy

We present the results of an intracavity Stark spectroscopy experiment on the fundamental state of (CD3OH)-C-13. We use an optically pumped hybrid waveguide FIR laser, CH2F2 as active molecule, and (CD3OH)-C-13 as absorbent molecule. No Brewster window is needed to separate the lasing gas from the absorbing deuterated methanol. An absorption line is assigned as E(l) symmetry (n, K, J): (1,4,18) --> (1,5,18) and its frequency is measured as 63.08631 cm(-1) with a precision of a few parts in 10(7); two more absorptions are reported and a tentative assignment for one of them.

Acoustic measurement of the low-energy excitations in Nd2-xCexCuO4+delta

The complex dynamic Young's modulus of ceramic Nd2-xCexCuO4 with x = 0, 0.05 and 0.20 has been measured from 1.5 to 100 K at frequencies of 1 - 10 kHz. In the undoped sample the modulus starts decreasing below similar to 20 K, instead of approaching a constant value as in a normal solid. The modulus minimum has been interpreted in terms of paraelastic contribution from the relaxation of the Nd3+ 4f electrons between the levels of the ground state doublet, which is split by the interaction with the antiferromagnetically ordered Cu sublattice. The value of the splitting is found to be 0.34 meV, in excellent agreement with inelastic neutron scattering, infrared and specific heat experiments. With doping, the anomaly shifts to lower temperature and decreases in amplitude, consistently with a reduction of the local field from the Cu sublattice. (C) 2003 Elsevier B.V. Ltd. All rights reserved.

Contactless measurement of colossal magnetoresistance in La1-xSrxMnO3 using the infrared magnetorefractive effect

The magnetorefractive effect (MRE) has been used for the first time to study the magnetotransport properties of La1-xSrxMnO3 perovskite materials. A direct correlation between the MRE and colossal magnetoresistance was observed. Samples with x = 0-0.3 prepared using the homogeneous coprecipitation and the solid state reaction methods were studied, covering the range of insulating to metallic behaviour. The M RE probed both the magnetically induced modification of the scattering of Drude-like electrons and the magnetic dependence of a stretching vibration mode. (C) 2004 Elsevier B.V. All rights reserved.

Measurement of atmospheric formaldehyde using a drop collector and in-situ colorimetry

A sensitive and affordable approach is described for the in-situ measurement of ambient formaldehyde. Air is sampled around a 100 microliter aqueous drop containing 3-methyl-2-benzothiazoline hydrazone. After a desired period of sampling (typ. 5 min) and a waiting period of 10 min for the reaction to be completed, a second reagent (FeCl3) is added to the drop by means of a conjoined conduit. A blue product is formed and is read after an additional 10 min of reaction by a fiber-optic/light emitting diode based photodetector. A fresh drop is then formed and the process begins anew. As demonstrated here, the limit of detection is similar to 6.25 mu g m(-3) HCHO but can be significantly improved by using longer sampling times and a sampling rate higher than 100 mi min(-1) used in most of this work. This is the first example of a chromogenic drop sensor that utilizes sequential reagent addition.

Porosity measurement of solid pharmaceutical dosage forms by gamma-ray transmission

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Assessing the uncertainties of model estimates of primary productivity in the tropical Pacific Ocean

Depth-integrated primary productivity (PP) estimates obtained from satellite ocean color-based models (SatPPMs) and those generated from biogeochemical ocean general circulation models (BCGCMs) represent a key resource for biogeochemical and ecological studies at global as well as regional scales. Calibration and validation of these PP models are not straightforward, however, and comparative studies show large differences between model estimates. The goal of this paper is to compare PP estimates obtained from 30 different models (21 SatPPMs and 9 BOGCMs) to a tropical Pacific PP database consisting of similar to 1000 C-14 measurements spanning more than a decade (1983-1996). Primary findings include: skill varied significantly between models, but performance was not a function of model complexity or type (i.e. SatPPM vs. BOGCM); nearly all models underestimated the observed variance of PR specifically yielding too few low PP (< 0.2 g Cm-2 d(-1)) values; more than half of the total root-mean-squared model-data differences associated with the satellite-based PP models might be accounted for by uncertainties in the input variables and/or the PP data; and the tropical Pacific database captures a broad scale shift from low biomassnormalized productivity in the 1980s to higher biomass-normalized productivity in the 1990s, which was not successfully captured by any of the models. This latter result suggests that interdecadal and global changes will be a significant challenge for both SatPPMs and BOGCMs. Finally, average root-mean-squared differences between in situ PP data on the equator at 140 degrees W and PP estimates from the satellite-based productivity models were 58% lower than analogous values computed in a previous PP model comparison 6 years ago. The success of these types of comparison exercises is illustrated by the continual modification and improvement of the participating models and the resulting increase in model skill. (C) 2008 Elsevier BY. All rights reserved.

Measurement of low-derivative surface lenses by two-laser holography with Bi12TiO20 crystals

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Measurement of the differential cross section d sigma/dt in elastic p(p)over-bar scattering at root s=1.96 TeV

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

First measurement of π-e→π-eγ pion virtual compton scattering

Pion virtual compton scattering (VCS) via the reaction π-e→π-eγ was observed in the Fermilab E781 SELEX experiment. SELEX used a 600 GeV/c π- beam incident on target atomic electrons, detecting the incident π- and the final state π-, electron and γ. Theoretical predictions based on chiral perturbation theory are incorporated into a Monte Carlo simulation of the experiment and are compared to the data. The number of reconstructed events (=9) and their distribution with respect to the kinematic variables (for the kinematic region studied) are in reasonable accord with the predictions. The corresponding π- VCS experimental cross section is σ=38.8±13 nb, in agreement with the theoretical expectation of σ=34.7 nb.

Morphologic characterization and evaluation of the productivity of nine rootstocks of rose bush (rosa spp.)

In Brazil, garden and cut rose bushes are propagated through cuttings or grafting. The rootstocks used in most of the traditional areas of cultivation are not identified, being known just by the vulgar name. There is not any information in the literature on the morphologic characteristics, nor about the productivity of different cultivars on the rootstocks available in Brazil. The objective of this work was to characterize and determine productivity of nine rootstocks (Rosa multiflora 'Paulista'; R. multiflora 'Japones'; R. multiflora 'Iowa'; R. multiflora 'Kopmans'; R. indica 'Mayor'; R. indica x multiflora; R. sp. 'Natual Brier'; R. manetti and R. canina 'Inermis') grafted with 'Versilia' and 'Tineke' scions. Morphologic studies were undertaken to characterize branches of adult plants to determine shape and dimensions of the leaf; number of prickles/15 cm of stem; vigor of the stems; incidence of Diplocarpon rosae (blackspot) and coloration of the leaf. The productivity (number of commercial flowers/plant/month) was evaluated for 6 months (October, 2000 to March, 2001), in the city of Andradas, Minas Gerais State, located at 1251 meters above sea level. Since there was significant difference in just two months for both rootstocks, 'Tineke' and 'Versilia', no rootstocks could be considered inadequate. Nonetheless, in general, the rootstocks that showed a better performance with 'Tineke' were, R. multiflora 'Kopmans' and R. manetti and with 'Versilia', R. multiflora 'Kopmans' and Rosa sp. 'Natual Brier'.

Measurement of the pp(-)-> W gamma plus X cross section at root s=1.96 TeV and WW gamma anomalous coupling limits

The WWγ triple gauge boson coupling parameters are studied using pp̄rarr; νγ+X(=e,μ) events at s=1.96 TeV. The data were collected with the D0 detector from an integrated luminosity of 162pb-1 delivered by the Fermilab Tevatron Collider. The cross section times branching fraction for pp̄→W(γ)+X→ νγ+X with ETγ>8 GeV and ΔR γ> 0.7 is 14.8±1.6(stat)±1.0(syst) ±1.0(lum)pb. The one-dimensional 95% confidence level limits on anomalous couplings are -0.88<Δκγ<0.96 and -0. 20<λγ<0.20. © 2005 The American Physical Society.