Mortar added by tyre rubber residues: Characterisation in fresh and hardened state

Due to the progressive increase of vehicles, the number of used tires is globally one of the serious environmental problems faced now. Therefore, several researches have being developed for its reuse. The use of tires' rubber in the concrete is a possible form of its application, aiming at the recycling of this material and the improvement of certain properties, as tenacity, impact resistance, thermal and acoustic isolation. This article presents conclusions that several researchers obtained using the rubberized concrete. Thus there were researched several works enclosing the period of 1993 to 2003, presenting then the results of some characteristics of this concrete such as: physical properties in fresh and hardened state, mechanical properties and properties that remit the durability. The bibliographical revision has as objective to subsidize future researches that can contribute to improve the use of this concrete in civil construction.

Structural analyzes of the use of residues of tires in reinforced concrete

The search for an adequate destination to the tires without use is a problem for many countries. The use of tire rubber in concrete through the partial substitution of the small aggregate has for objective the withdrawal of this material of the environment besides serving as alternative material in places that present sand scarcity. However, to use this type of concrete in civil construction it's necessary to verify its structural behavior. The behavior of the adherence enters the bar of armor and the concrete surrounding it has decisive importance with relation to the load capacity of the structures of reinforced concrete. In this context, this work presents, argues and evaluates the results of the experimental studies for determination of the adherence tension according to pulling up assays pull-out normalized for CEB RC6 and also related in the ASTM C-234 in concrete with and without rubber residues. Armors of nominal diameter of 10,0; 12,5 and 16 mm had been used and concrete contend 10% of rubber fibres in substitution to the sand in volume.

Efeito de níveis de irrigação em substratos para a produção de mudas de ipê-roxo

The aim of this work was to evaluate the ipê-roxo (Tabebuia impetiginosa (Mart.) Standl). seedlings behavior in different substrates and irrigation levels and also study the use of urban waste compost in the substrates. The experiment was conducted in the agricultural engineering department at the Faculdade de Ciências Agrárias e Veterinárias - UNESP, Campus de Jaboticabal, SP. The experimental design used was the completely randomized with 30 treats and 2 replicates, in a 15× 2 factorial arrangement [15 substrates and 2 irrigation levels (100% and 150% of evapotranspiration)]. The substrates were composed by different material combinations: urban waste, Plantmax, tanned cattle manure, vermiculite and soil. For the study of the seedlings development, the following characteristics were evaluated: the seedlings height (H) and stem diameter (D). Evaluations (H and D) were made on 90, 105, 120, 135 and 150 days after sowing. The statistical analysis showed significant differences between the irrigation levels. According to the results, we can conclude that urban waste compost did not increase Blake development. For tested irrigation levels, the statistical analysis showed significant differences with better results for the 150% ET irrigation level compared to 100% ET.

Análise de econometria de dois sistemas naturais de tratamento de água residuária na suinocultura

The aim of this work was to develop a detailed econometric analysis to compare a constructed wetland system - combined model, and a waste stabilization pond system - facultative pond, as a function of six different sizes of finishing pig farms and two waste management systems - wet and dry. The constructed wetland system using dried waste management showed the best economic results. This finding is due to the low-cost implementation a year both per animal and per kilogram of meat. This system also required the smallest area for waste treatment. The use of stabilization pond with wet waste management system showed a lower implementation cost a year per animal and per kilogram of meat, but it required large areas. The econometric analysis of both systems of wastewater treatment revealed an economy of scale.

Ecoeficiencia y desarrollo de infraestructura urbana sostenible en Asia y América Latina: Residuos y reducción de gases de efecto invernadero: el caso de Chile

Incluye bibliografía

The Mexican maquila industry and the environment: an overview of the issues

Includes bibliography

Cooperación ambiental en el NAFTA y perspectivas para el DR-CAFTA

Incluye Bibliografía

Social and environmental indexes to determine the impacts of closed neighbourhoods in Brazil

São Paulo State, in Brazil, is getting increasingly crowded, like in other third world countries around the world, so should give great importance to city development. This work considered the phenomenon of closed neighbourhoods (CN) as an important factor to city planning, papers report many impacts of this model of neighbourhoods in other countries, but in Brazil its impacts are not yet well listed in the literature. The aim of this work was to determine indicators to achieve the social and environmental performances and verify their applicability on three different closed neighbourhoods in São Paulo state, Brazil. The indicators were condensed on indexes: water management, waste management, energy and emissions, legal compliance, environment and buildings, risk management, health and education and governance. The preliminary results indicated several social and environmental problems in all indexes. © 2013 WIT Press.

FT-IR analysis of acid black dye biodegradation using saccharomyces cerevisiae immobilized with treated sugarcane bagasse

Textile industries use large amounts of water in dyeing processes and a wide variety of synthetic dyes. A small concentration of these dyes in the environment can generate highly visible pollution and changes in aquatic ecosystems. Adsorption, biosorption, and biodegradation are the most advantageous dye removal processes. Biodegradation occurs when enzymes produced by certain microorganisms are capable of breaking down the dye molecule. To increase the efficiency of these processes, cell immobilization enables the reuse of the immobilized cells and offers a high degree of mechanical strength, allowing metabolic processes to take place under adverse conditions. The aim of the present study was to investigate the use of Saccharomyces cerevisiae immobilized in activated sugarcane bagasse for the degradation of Acid Black 48 dye in aqueous solutions. For such, sugarcane bagasse was treated with polyethyleneimine (PEI). Concentrations of a 1 % S. cerevisiae suspension were evaluated to determine cell immobilization rates. Once immobilization was established, biodegradation assays for 240 h with free and immobilized yeast in PEI-treated sugarcane bagasse were evaluated by Fourier transform infrared spectrophotometry. The results indicated a probable change in the dye molecule and the possible formation of new metabolites. Thus, S. cerevisiae immobilized in sugarcane bagasse is very attractive for biodegradation processes in the treatment of textile effluents. © 2013 Springer Science+Business Media Dordrecht.

Prospects for the use of municipal tree pruning wastes in particleboard production

The purpose of this study was to evaluate the physical and mechanical properties of particleboard made with pruning wastes from Ipê (Tabebuia serratifolia) and Chapéu-de-Sol (Terminalia catappa) trees. Particleboards were prepared with both wood species, using all the material produced by grinding the pruning wastes. The particleboards had dimensions of 45×45 cm, a thickness of approximately 11.5 mm and an average density of 664 kg/m3. A urea-formaldehyde adhesive was used in the proportion of 12% of the dry particle mass. The particleboards were pressed at a temperature of 130 C for 10 mins. The physical and mechanical properties analyzed were density, moisture content, thickness swelling, percentage of lignin and cellulose, modulus of resilience, modulus of elasticity and tensile strength parallel to the grain, accordingly to the standards NBR 14810 and CS 236-66 (1968). The particleboards were considered to be of medium density. The particle size significantly affected the static bending strength and tensile strength parallel to the grain. Ipê presented better results, demonstrating a potential for the production and use of particleboard made from this species. © The Author(s) 2013.

Avaliação da genotoxicidade e mutagenicidade das águas dos rios Jaguari, Atibaia e Piracicaba, na região de influência da refinaria de Paulínia - SP

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Framework for implementation of the outcomes of the World Summit on Sustainable Development (WSSD) in the small island developing states of the Caribbean subregion

Includes bibliography

Diagnóstico do gerenciamento dos resíduos da construção civil da região metropolitana de São Paulo

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Gerenciamento de resíduos sólidos em indústria de cerâmica: estudo de caso

Pós-graduação em Geociências e Meio Ambiente - IGCE

Diagnóstico da geração e disposição dos resíduos sólidos urbanos nos municípios da 7ª região administrativa do Estado de São Paulo

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)