881 resultados para PROTECTIVE COATINGS
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Ti-6Al-4V alloy is one of the most frequently used Ti alloys with diverse applications in aerospace and biomedical areas due to its favorable mechanical properties, corrosion resistance and biocompatibility. Meanwhile, its surface can stiffer intense corrosion caused by wear processes due to its poor tribological properties. Thus in the present study, PIII processing of Ti-6Al-4V alloy was carried out to evaluate its corrosion resistance in 3.5% NaCl solution. Two different sets of Ti-6Al-4V samples were PIII treated, varying the plasma gases and the treatment time. The corrosion behavior is correlated with the surface morphology, and the nitrogen content. SEM micrographs of the untreated sample reveal a typical two-phase structure. PIII processing promotes surface sputtering and the surface morphology is completely different for samples treated with N-2/H-2 mixture and N-2 only. The highest penetration of nitrogen (similar to 88 nm), corresponding to 33% of N-2 was obtained for the sample treated with N-2/H-2 mixture for 1:30 h. The corrosion behavior of the samples was investigated by a potentiodynamic polarization method. A large passive region of the polarization curves (similar to 1.5 V), associated with the formation of a protective film, was observed for all samples. The passive current density (similar to 3 x 10(-6) A cm(-2)) of the PIII-treated Ti-6Al-4V samples is about 10 times higher than for the untreated sample. This current value is still rather low and maintains good corrosion resistance. The anodic branches of the polarization curves for all treated Ti-6Al-4V samples demonstrate also that the oxide films break down at approximately 1.6 V, forming an active region. Although the sample treated by N-2/H-2 mixture for 1.30 It has thicker nitrogen enriched layer, better corrosion resistance is obtained for the PIII process performed with N, gas only. (c) 2007 Elsevier B.V. All rights reserved.
Resumo:
Electrochemical corrosion measurements of AISI H13 steel treated by Pill process in 3.5% (wt) NaCl solution were investigated. So far the corrosion behavior of AISI H 13 steel by Pill has not been studied. The electrochemical results are correlated with the surface morphology, nitrogen content and hardness of the nitride layer. Ion implantation of nitrogen into H 13 steel was carried out by Pill technique. SEM examination revealed a generalized corrosion and porosity over all analyzed sample surfaces. Penetration of nitrogen reaching more than 20 gm was achieved at 450 degrees C and hardness as high as 1340 HV (factor of 2.7 enhancement over standard tempered and annealed H 13) was reached by a high power, 9 h Pill treatment. The corrosion behavior of the samples was studied by potentiodynamic polarization method. The noblest corrosion behavior was observed for the samples treated by PIII at 450 degrees C, during 9 h. Anodic branches of polarization curves of PIII processed samples show a passive region associated with the formation of a protective film. The passive region current density of PIII treated H13 samples (3.5 x 10(-6) A/cm(2)) is about 270 times lower than the one of untreated specimens, which demonstrates the higher corrosion resistance for the Pill treated H 13 samples. (c) 2007 Elsevier B.V. All rights reserved.
Resumo:
It is known that chromium electroplating is related to the reduction in the fatigue strength of base metal. However, chromium results in protection against wear and corrosion combined with chemical resistance and good lubricity. Environmental requirements are an important point to be considered in the search for possible alternatives to hard chrome plating. Aircraft landing gear manufactures are considering WC thermal spray coating applied by the high-velocity oxygen-fuel (HVOF) process an alternative candidate, which shows performance at least comparable to results, obtained for hard chrome plating. The aim of this study is to compare the influence of WC-17Co and WC-10Co-4Cr coatings applied by HVOF process and hard chromium electroplating on the fatigue strength of AISI 4340 steel, with and without shot peening. S-N curves were obtained in axial fatigue test for base material, chromium plated and tungsten carbide coated specimens. Tungsten carbide thermal spray coating results in higher fatigue strength when compared to hard chromium electroplated. Shot peening prior to thermal spraying showed to be an excellent alternative to increase fatigue strength of AISI 4340 steel. Experimental data showed higher axial fatigue and corrosion resistance in salt fog exposure for samples WC-10Co-4Cr HVOF coated when compared with WC-17Co. Fracture surface analysis by scanning electron microscopy (SEM) indicated the existence of a uniform coverage of nearly all substrates. (C) 2004 Elsevier B.V. All rights reserved.
Resumo:
Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)
Resumo:
The optimized allocation of protective devices in strategic points of the circuit improves the quality of the energy supply and the system reliability index. This paper presents a nonlinear integer programming (NLIP) model with binary variables, to deal with the problem of protective device allocation in the main feeder and all branches of an overhead distribution circuit, to improve the reliability index and to provide customers with service of high quality and reliability. The constraints considered in the problem take into account technical and economical limitations, such as coordination problems of serial protective devices, available equipment, the importance of the feeder and the circuit topology. The use of genetic algorithms (GAs) is proposed to solve this problem, using a binary representation that does (1) or does not (0) show allocation of protective devices (reclosers, sectionalizers and fuses) in predefined points of the circuit. Results are presented for a real circuit (134 busses), with the possibility of protective device allocation in 29 points. Also the ability of the algorithm in finding good solutions while improving significantly the indicators of reliability is shown. (C) 2003 Elsevier B.V. All rights reserved.
Resumo:
Optimised placement of control and protective devices in distribution networks allows for a better operation and improvement of the reliability indices of the system. Control devices (used to reconfigure the feeders) are placed in distribution networks to obtain an optimal operation strategy to facilitate power supply restoration in the case of a contingency. Protective devices (used to isolate faults) are placed in distribution systems to improve the reliability and continuity of the power supply, significantly reducing the impacts that a fault can have in terms of customer outages, and the time needed for fault location and system restoration. This paper presents a novel technique to optimally place both control and protective devices in the same optimisation process on radial distribution feeders. The problem is modelled through mixed integer non-linear programming (MINLP) with real and binary variables. The reactive tabu search algorithm (RTS) is proposed to solve this problem. Results and optimised strategies for placing control and protective devices considering a practical feeder are presented. (c) 2007 Elsevier B.V. All rights reserved.
Resumo:
In patients with acute respiratory distress syndrome, positive end-expiratory pressure is associated with alveolar recruitment and lung hyperinflation despite the administration of a low tidal volume. The best positive end-expiratory pressure should correspond to the best compromise between recruitment and distension, a condition that coincides with the best respiratory elastance.
Resumo:
This study was designed to evaluate the toxicogenetic or protective effect of cooked and dehydrated black beans (Phaseolus vulgaris L.) in bone marrow and peripheral blood cells of exposed mice. The frequency of micronuclei detected using the bone marrow erythrocyte micronucleus test and level of DNA lesions detected by the comet assay were chosen as end-points reflecting mutagenic and genotoxic damage, respectively. Initially, Swiss male mice were fed with a 20% black bean diet in order to detect mutagenic and genotoxic activity. However, no increase in the frequency of bone marrow micronucleated polychromatic erythrocytes (MN PCEs) or DNA lesion in leukocytes was observed. In contrast, received diets containing 1, 10 or 20% of black beans, a clear, but not dose-dependent reduction in the frequency of MN PCEs were observed in animals simultaneously treated with cyclophosphamide, an indirect acting mutagen. Similar results were observed in leukocytes by the comet assay. Commercial anthocyanin was also tested in an attempt to identify the bean components responsible for this protective effect. However, instead of being protective, the flavonoid, at the highest dose administered (50 mg/kg bw), induced primary DNA lesion, as detected by the comet assay. These data indicate the importance of food components in preventing genetic damage induced by chemical mutagens, and also reinforce the role of toxicogenetic techniques in protecting human health. (C) 2003 Elsevier Ltd. All rights reserved.
Resumo:
Propolis is a honeybee product with several biological and therapeutical properties. Its effect on the process of colon carcinogenesis and DNA damage were evaluated in the male Wistar rats using the aberrant crypt foci (ACF) assay and the comet assay, respectively. For both tests, animals were treated with the colon carcinogen 1,2 dimethylhydrazine (DMH, 40 mg/kg, s.c.) for 2 weeks (two injections/week) in order to induce both DNA damage and ACF. The animals were divided into groups that received propolis (ethanolic extract) at three different doses (10, 30, and 90 mg/kg b.w., by gavage), either simultaneously or after DMH treatment. For the comet assay, peripheral blood samples were collected 4 h after the last DMH treatment. All animals were sacrificed at the 5th week for evaluation of ACF. The results show that only the intermediate dose (30 mg/kg) of propolis, administered after DMH initiation, is significantly associated to a smaller number of aberrant crypts in the distal colon. No effect on DNA damage in peripheral blood cells, however, was verified by the comet assay. These data suggest that propolis has a protective influence on the process of colon carcinogenesis, suppressing the development of preneoplastic lesions, and probably exerts no protection against the initiation of carcinogenesis.
Resumo:
Ginkgo biloba (EGb) has been proposed as a promising candidate for cancer chemoprevention and has shown protective effects on the liver against chemically induced oxidative injury and fibrosis. The potential beneficial effects of EGb were investigated in two rat liver carcinogenesis bioassays induced by diethylnitrosamine (DEN). In a short-term study for anti-initiating screening, male Wistar rats were fed a basal diet or supplemented diet with 500 or 1000 ppm EGb and initiated 14 days later with a single dose of DEN (100 mg/kg i.p.). The respective groups were killed 24 h or 2 weeks after DEN-initiation. Liver samples were collected for the analysis of proliferating cell nuclear antigen (PCNA), transforming growth factor alpha (TGF-alpha), p53, apoptosis and induction of single hepatocytes and minifoci positive for the enzyme glutathione S-transferase P-form (GST-P). In a medium-term study for anti-promoting screening, the animals received a single dose of DEN (200 mg/kg i.p.) and, 2 weeks later, were fed a basal diet or supplemented diet with 500 or 1000 ppm EGb for 6 weeks. All animals underwent 70% partial hepatectomy (PH) at week 3 and killed at week 8. Liver samples were colleted to analyze development of preneoplastic foci of altered hepatocytes (FAH) expressing GST-P. In the short-term study, pretreatment of rats with 1000 ppm EGb significantly reduced the rates of cell proliferation, apoptosis and p53, TGF-a immunoreactivity and the number of GST-P-positive hepatocytes. In the medium-term study, EGb treatment during the post-initiation stage failed to reduce the development of DEN-induced GST-P-positive foci. Thus, EGb presented inhibitory actions during initiation but not promotion of rat liver carcinogenesis induced by DEN. (C) 2008 Elsevier B.V. All rights reserved.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
O presente trabalho teve como objetivo verificar os efeitos do Baypamun®HK sobre a sobrevida de camundongos albinos, experimentalmente infectados com Toxoplasma gondii amostra RH, submetidos ou não ao tratamento com sulfadiazina-pirimetamina, bem como sobre a formação e número de cistos cerebrais. Quatro grupos de 20 camundongos foram inoculados com 10(5) taquizoítos, via subcutânea, e submetidos a diferentes tratamentos. Os testes sorológicos foram realizados pela técnica de imunofluorescência indireta, e, dos animais que sucumbiram, amostras de cérebro, pulmão e fígado foram retiradas para exame citológico e de cérebros para a pesquisa de cistos. Ao final de 60 dias todos os sobreviventes foram sacrificados. Isoladamente o Baypamun®HK não apresentou uma ação protetora contra a infecção pelo T. gondii, mas sua associação com o tratamento específico pela sulfadiazina-pirimetamina promoveu maior sobrevida dos animais e uma resposta de anticorpos mais intensa e duradoura.
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)
Resumo:
Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)