Effect of heated solutions on decay control and residues of imazalil in lemons

Freshly harvested lemons [(Citrus limon (L.) Burm)] were dipped 3 min in water with and without imazalil (IMZ) at 50, 100, and 200 ppm at 50 degrees C and at 1000 ppm IMZ at 20 degrees C. Following treatments fruit were kept at 9 degrees C and 90%-95% relative humidity (RH) for 13 weeks and an additional week at 21 degrees C and ca. 75% RH, to simulate a marketing period (SMP). No decay control was observed with fruit dipped in water at 50 degrees C. In contrast, IMZ treatments provided 90%-96% control of Penicillium rots during cold storage and SMP. Fungi other than Penicillium spp. were also found in all samples as differences among treatments were negligible. IMZ treatment caused some external damage to the fruit (peel browning), and the percentage of damaged fruit was related to the amount of active ingredient (AI) present in it. Dipping in 200 or 1000 ppm IMZ promoted off-flavor development after 10 weeks of storage, and fruit were judged to be unacceptable for consumption after 13 weeks of cold storage. After 1000 ppm IMZ dipping at 20 degrees C, residue concentration in fruit was 8.20 ppm; this value doubled that found in a previous investigation on lemons treated with comparable IMZ levels. Residue concentrations in fruit after treatment at 50 degrees C was strictly related to the amount of fungicide employed. After 13 weeks Al residues in fruit decreased to average ca. 35% of the initial values. During the 1 week SMP, residue levels decreased by a further ca. 25%. It was concluded that it is possible to achieve significant control of decay in lemons during longterm storage by dipping fruit in 50 ppm IMZ mixtures at 50 degrees C. Such treatment should be advised to remarkably reduce potential pollution in the environment due to packinghouse wastewater disposal.

High-speed cavity preparation techniques with different water flows

Statement of problem. Cavity and tooth preparations generate heat because the use of rotary cutting instruments on dental tissues creates friction. Dental pulps cannot survive temperature increases greater than 5.5degreesC.Purpose. This study evaluated the efficiency of 3 different water flows for 2 different tooth preparation techniques to determine which are safe for use.Material and methods. Thermocouples were placed in the pulpal chambers of 30 bovine teeth, and 1 of 2 tooth preparation techniques was used: a low-load intermittent tooth preparation technique or a high-load tooth preparation technique without intervals. Water flows of 0, 30, and 45 mL/min were associated with each technique, for a total of 6 different groups. The results were analyzed with a 2-factor analysis of variance (P<.05).Results. Temperature increases with the high-load technique were 16.40&DEG;C without cooling (group 1), 11.68&DEG;C with 30 mL/min air-water spray cooling (group III), and 9.96&DEG;C with 45 mL/min cooling (group V). With the low-load tooth preparation technique, a 9.54&DEG;C increase resulted with no cooling (group II), a 1.56&DEG;C increase with 30 mL/min air-water spray cooling (group TV), and a 0.04&DEG;C decrease with 45 mL/min cooling (group VI). The low-load technique was associated with more ideal temperature changes.Conclusion. The results of this study confirm the necessity of using a low-load technique and water coolants during cavity and tooth preparation procedures.

Anatomy of the oral cavity of hylid larvae from the genera Aplastodiscus, Bokermannohyla, and Hypsiboas (Amphibia, anura): Description and systematic implications

Internal larval oral anatomy was used to explore morphological diversity and its contribution to the systematics of the genera Aplastodiscus, Bokerinannohyla, and Hypsiboas, belonging to the tribe Cophomantini. Internal oral morphology was examined for tadpoles of 12 species. All species have a large pair of infralabial papillae on the buccal floor and other papillae on the prelingual region. In Aplastodiscus and Bokerinannohyla, the large infralabial papillae have digitiform secondary projections. The number and arrangement of the buccal floor papillae varies among species, but they are more numerous in Aplastodiscus and Bokerinannohyla. The arrangement of the postnarial papillae is variable, but in Aplastodiscus and Bokerinannohyla, they show a definite, inverted V-shape pattern. The lateral ridge papillae are more complex in larvae of Bokertnannohyla with long digitiform secondary projections. Tadpoles of only Aplastodiscus albofrenatus, Aplastodiscus eugenioi, and Bokerinannohyla luctuosa have papillae on the buccal roof arena and larvae of all species have lateral roof papillae except Hypsiboas albomarginatus and Hypsiboas cinerascens. Larvae of Aplastodiscus, Bokermannohyla, and Hypsiboas presumably share the presence of vacuities anterior to the internal nares; although this character state is clearly synapomorphic within hylids, it is still uncertain whether it is exclusive of these three genera or whether it is present in the other genera of the tribe Cophomantini (Hyloscirtus and Myersiohyla). The inclusion of internal oral anatomy characters, such as the narial vacuities, in systematic studies is certainly valuable because it will provide additional information toward the understanding of phylogenetic relationships.

Mummified papyraceous fetuses in the abdominal cavity of an elderly female dog with pyometra

This paper reports on a rare case of fetal papyraceous mummification after asymptomatic uterine rupture in an elderly female dog with pyometra. The patient had a history of mating six months before the examination but no apparent signs of gestation or parturition. Exploratory laparotomy was used to identify a rupture of the left uterine horn and the presence of cystic endometrial hyperplasia and pyometra. Two mummified papyraceous fetuses were observed in the abdominal cavity and had adhered to the spleen, pancreas, intestine and omentum. Ovariehysterectomy and corrective surgery were performed. The patient had remained healthy after uterine rupture until a new estrous cycle and the development of pyometra. Bitches that are 10 years old or more are predisposed to implantation failure, pregnancy or parturition problems and they should not be breed to avoid complications.

Trajectory of Water- and Fat-Soluble Dyes in the Grass-Cutting ant Atta capiguara (Hymenoptera, Formicidae): Evaluation of Infrabuccal Cavity, Post-Pharyngeal Glands and Gaster

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Contribution of the study of the styloid prominence in the posterior tympanic cavity

70 human temporal bones were analyzed with the aid of an otologic microscope. The styloid prominence was found to be extremely variable in shape, location and occurrence. Depending on the degree of development, the prominence establishes important relationships with the sinus tympani, with the fossula of the cochlear fenestra, and with the suprapyramidal recess. Serial sections were used to study the relationship of the styloid process with the facial nerve inside the bony mass of the mastoid portion of the temporal bone.

Effects of a temperature dependent viscosity in surface nonlinear waves propagating in a shallow fluid heated from below

The effects of a temperature dependent viscosity in surface nonlinear waves propagating in a shallow fluid heated from below are investigated. It is shown that the (2+1)-dimensional Burgers equation may appear as the equation governing the upper free surface perturbations of a Bénard system, even when the viscosity is assumed to depend on temperature. The critical Rayleigh number for the appearance of waves governed by the Kadomtsev-Petviashvili equation, however, will be smaller than R=30, which is the critical number obtained for a constant viscosity. © 1992.

Numerical and experimental analysis of natural convection in a cavity with flush mounted heat sources on a side wall

This work considers a problem of interest in several technological applications such as the thermal control of electronic equipment. It is also important to study the heat transfer performance of these components under off-normal conditions, such as during failure of cooling fans. The effect of natural convection on the flow and heat transfer in a cavity with two flush mounted heat sources on the left vertical wall, simulating electronic components, is studied numerically and experimentally. The influence of the power distribution, spacing between the heat sources and cavity aspect ratio have been investigated. An analysis of the average Nusselt number of the two heat sources was performed to investigate the behavior of the heat transfer coefficients. The results obtained numerically and experimentally, after an error analysis, showed a good agreement.

Simultaneous determination of As, Cu, Mn, Sb, and Se in drinking water by GFAAS with transversely heated graphite atomizer and longitudinal zeeman-effect background correction

A method has been developed for the direct and simultaneous determination of As, Cu, Mn, Sb, and Se in drinking water by electrothermal atomic absorption spectrometry (ETAAS) using a transversely heated graphite tube atomizer (THGA) with longitudinal Zeeman-effect background correction. The thermal behavior of analytes during the pyrolysis and atomization stages was investigated in 0.028 mol L-1 HNO3, 0.14 mol L-1 HNO3 and 1 + 1 (v/v) diluted water using mixtures of Pd(NO3)2 + Mg(NO3)2 as the chemical modifier. With 5 μg Pd + 3 μg Mg as the modifier, the pyrolysis and atomization temperatures of the heating program of the atomizer were fixed at 1400°C and 2100°C, respectively, and 20 μL of the water sample (sample + 0.28 mol L-1 HNO3, 1 + 1, v/v), dispensed into the graphite tube, analytical curves were established ranging from 5.00 -50.0 μg L-1 for As, Sb, Se; 10.0 - 100 μg L-1 for Cu; and 20.0 - 200 μg L-1 for Mn. The characteristic masses were around 39 pg As, 17 pg Cu, 60 pg Mn, 43 pg Sb, and 45 pg Se, and the lifetime of the tube was around 500 firings. The limits of detection (LOD) based on integrated absorbance (0.7 μg L-1 As, 0.2 μg L-1 Cu, 0.6 μg L-1 Mn, 0.3 μg L-1 Sb, 0.9 μg L-1 Se) exceeded the requirements of the Brazilian Food Regulations (decree # 310-ANVS from the Health Department), which established the maximum permissible level for As, Cu, Mn, Sb, and Se at 50 μg L-1, 1000 μg L-1, 2000 μg L-1, 5 μg L-1, and 50 μg L-1, respectively. The relative standard deviations (n = 12) were typically < 5.3% for As, < 0.5% for Cu, < 2.1% for Mn, < 11.7% for Sb, and < 9.2% for Se. The recoveries of As, Cu, Mn, Sb, and Se added to the mineral water samples varied from 102-111%, 91-107%, 92-109%, 89-97%, and 101-109%, respectively. Accuracy for the determination of As, Cu, Mn, Sb, and Se was checked using standard reference materials NIST SRM 1640 - Trace Elements in Natural Water, NIST SRM 1643d - Trace Elements in Water, and 10 mineral water samples. A paired t-test showed that the results were in agreement with the certified values of the standard reference materials at the 95% confidence level.

Gelatinous polyethylene in the treatment of the anophthalmic cavity

PURPOSE: Gelatinous polyethylene (GP) has been used as an orbital implant to evaluate volume maintenance and tissue reaction in the anophthalmic socket in a rabbit model. METHODS: Twenty-eight Norfolk white rabbits underwent unilateral evisceration with placement of 2ml GP (GP group - 16 animals) or 2ml 0.9% sodium chloride solution (Control group - 12 animals). Animal behavior, postoperative tissue response and socket conditions were evaluated. The animals were sacrificed at 7, 15, 30 and 60 days after the surgery and the bulbs were enucleated; volume maintenance and histopathological evaluation were done in the enucleated bulbs. The results were submitted to statistical analysis. RESULTS: All animals showed normal behavior. The orbital volume maintenance was better in the GP group. Histopathology in the GP animals showed mild tissue inflammation throughout the evaluation period and a thin pseudocapsule formation surrounding the orbital implant material. CONCLUSION: The clinical findings, good orbital volume maintenance and mild inflammatory tissue response make GP a good choice to replace the lack of volume in anophthalmic socket reconstruction.

Prevalence of yeasts in the oral cavity of children treated with inhaled corticosteroids

The aim of this study was to observe the prevalence of Candida spp. in the oral cavity of children undergoing treatment with inhaled corticosteroids. Thirty children treated with inhaled corticosteroids and thirty control children were studied. Saliva samples were collected through oral rinses with phosphate buffered saline (PBS). The samples were plated on Sabouraud's dextrose agar and incubated at 37 degrees C for 48 h. After this period, the number of colony-forming units per ml (cfu/ml) of saliva was calculated. The isolates were identified by phenotypic characterization. Candida spp. was isolated from 43.33% of the samples of children treated with corticosteroids, with a mean of 780 cfu/ml of saliva, and from 30% of the samples of the control group, with a mean of 560 cfu/ml of saliva. No significant statistical difference was observed between the groups. C. albicans was the prevalent species in both groups, followed by C. guilliermondii, C. parapsilosis and C. stellatoidea. Furthermore, Rhodotorula rubra and C. lusitaniae were also isolated from the treated group. We concluded that there was no significant increase in the prevalence and number of Candida spp. in the oral cavity of children treated with inhaled corticosteroids.