993 resultados para 442
Resumo:
We present a simple mathematical model of a wind turbine supporting tower. Here, the wind excitation is considered to be a non-ideal power source. In such a consideration, there is interaction between the energy supply and the motion of the supporting structure. If power is not enough, the rotation of the generator may get stuck at a resonance frequency of the structure. This is a manifestation of the so-called Sommerfeld Effect. In this model, at first, only two degrees of freedom are considered, the horizontal motion of the upper tip of the tower, in the transverse direction to the wind, and the generator rotation. Next, we add another degree of freedom, the motion of a free rolling mass inside a chamber. Its impact with the walls of the chamber provides control of both the amplitude of the tower vibration and the width of the band of frequencies in which the Sommerfeld effect occur. Some numerical simulations are performed using the equations of motion of the models obtained via a Lagrangian approach.
Resumo:
Purpose: This study assessed the shear bond strength of 4 hard chairside reline resins (Kooliner, Tokuso Rebase Fast, Duraliner II, Ufi Gel Hard) to a rapid polymerizing denture base resin (QC-20) processed using 2 polymerization cycles (A or B), before and after thermal cycling. Materials and Methods: Cylinders (3.5 mm x 5.0 mm) of the reline resins were bonded to cylinders of QC-20 polymerized using cycle A (boiling water-20 minutes) or B (boiling water; remove heat-20 minutes; boiling water-20 minutes). For each reline resin/polymerization cycle combination, 10 specimens (groups CAt e CBt) were thermally cycled (5 and 55°C; dwell time 30 seconds; 2,000 cycles); the other 10 were tested without thermal cycling (groups CAwt ad CBwt). Shear bond tests (0.5 mm/min) were performed on the specimens and the failure mode was assessed. Data were analyzed by 3-way ANOVA and Newman-Keuls post-hoc test (α=.05). Results: QC-20 resin demonstrated the lowest bond strengths among the reline materials (P<.05) and mainly failed cohesively. Overall, the bond strength of the hard chairside reline resins were similar (10.09±1.40 to 15.17±1.73 MPa) and most of the failures were adhesive/cohesive (mixed mode). However, Ufi Gel Hard bonded to QC-20 polymerized using cycle A and not thermally cycled showed the highest bond strength (P<.001). When Tokuso Rebase Fast and Duraliner II were bonded to QC-20 resin polymerized using cycle A, the bond strength was increased (P=.043) after thermal cycling. Conclusions: QC-20 displayed the lowest bond strength values in all groups. In general, the bond strengths of the hard chairside reline resins were comparable and not affected by polymerization cycle of QC-20 resin and thermal cycling.
Resumo:
Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)
Resumo:
This paper aimed to determine the flow rate of drippers, their flow rate-pressure curve, their equation, their flow rate variation coefficient (VCq), as well as to evaluate the uniformity of water application of the Netafim drip pipe, Tiran 17 model, used for irrigation with domestic wastewater from treated household drain. After 1000 working hours, the blockage of some drippers decreased the uniformity of water application from 98% to lower than 60% and increased the flow variation coefficient to values higher than 0.29.
Resumo:
Incluye bibliografía
Resumo:
Incluye bibliografía
Resumo:
Incluye bibliografía
Resumo:
Objectives: The present study used strain gauge analysis to perform an in vitro evaluation of the effect of axial loading on 3 elements of implant-supported partial fixed prostheses, varying the type of prosthetic cylinder and the loading points. Material and methods: Three internal hexagon implants were linearly embedded in a polyurethane block. Microunit abutments were connected to the implants applying a torque of 20 Ncm, and prefabricated Co-Cr cylinders and plastic prosthetic cylinders were screwed onto the abutments, which received standard patterns cast in Co-Cr alloy (n = 5). Four strain gauges (SG) were bonded onto the surface of the block tangentially to the implants, SG 01 mesially to implant 1, SG 02 and SG 03 mesially and distally to implant 2, respectively, and SG 04 distally to implant 3. Each metallic structure was screwed onto the abutments with a 10 Ncm torque and an axial load of 30 kg was applied at five predetermined points (A, B, C, D, E). The data obtained from the strain gauge analyses were analyzed statistically by RM ANOVA and Tukey's test, with a level of significance of p<0.05. Results: There was a significant difference for the loading point (p=0.0001), with point B generating the smallest microdeformation (239.49 με) and point D the highest (442.77 με). No significant difference was found for the cylinder type (p=0.748). Conclusions: It was concluded that the type of cylinder did not affect in the magnitude of microdeformation, but the axial loading location influenced this magnitude.
Resumo:
Incluye Bibliografía
Alterations in levels of NPK, electrical conductivity and pH of substrate, in cultivation of peppers
Resumo:
The objective of this work was to evaluate the chemical alterations of the substrate in the cultivation of pepper in coconut husk fiber, in a protected environment. Initially, 160 pepper plants ('Eppo') were divided into four blocks, where two pots per block were analyzed every 21 days after transplanting. The cultivation of pepper was carried out in plastic pots of 13 L, containing coconut husk fiber, and placed in double rows with a spacing of 0.5×0.8 m between single rows and 1.10 m between double rows. After removal of the plants from the pots, individual samples of substrate (approximately 1 L) were collected from each pot and dried at ambient temperature. Electrical conductivity (EC), pH, and levels of NH4 +-N, NO3 -, P and K were determined for all periods of the cultivation. These analyses were performed using the method of extraction 1:1.5 v/v. For the conditions which the experiment was conducted, there was an increase in substrate EC, as well as in the levels of nitrogen, phosphorus and potassium.
Resumo:
Visceral leishmaniasis in dogs is described as a chronic disease whose main symptoms are progressive weigth loss, cachexy and dermatologic lesions. Recently, the disease has been associated to neurologic disorders. A total of 40 dogs with visceral leishmaniasis were divided into two groups. The first composed of dogs without neurological signs (n=30) and the second by dogs with neurological disorders (n=10). Brain samples were collected, stored in 10% buffered formalin and subjected to immunohistochemical examination for amastigotes forms of Leishmania (Leishmania) infantum chagasi, CD3+, CD4+ and CD8+ T lymphocytes and macrophages. Imunnohistochemistry evaluation revealed no amastigote forms of the parasite. CD3+ T lymphocytes were present in 24/30 (80%) dogs without neurological signs and in all dogs from the second group (p=0.0011). CD4+ and CD8+ were rarely observed, with CD4+ immunostaining in 10/40 (25%) dogs, from which half of them had neurological disease (p=0.0090). The presence of CD8+ was detected only in 4/10 (40%) dogs from neurological group (p=0.0021). Macrophages were detected in 38/40 (95%) dogs, without significant differences between groups (p=0.7664).
Resumo:
Cardiac or ventricular remodeling is characterized by molecular, cellular, and interstitial alterations that lead to changes in heart size, mass, geometry and function in response to a given insult. Currently, tobacco smoke exposure is recognized as one of these insults. Indeed, tobacco smoke exposure induces the enlargement of the left-sided cardiac chambers, myocardial hypertrophy, and ventricular dysfunction. Potential mechanisms for these alterations include hemodynamic and neurohormonal changes, oxidative stress, inflammation, nitric oxide bioavailability, matrix metalloproteinases and mitogen-activated protein kinase activation. This review will focus on the concepts, relevance, and potential mechanisms of cardiac remodeling induced by tobacco smoke. © 2012 Bentham Science Publishers.
Resumo:
Azo dyes, the most widely used family of synthetic dyes, are often employed as colorants in areas such as textiles, plastics, foods/drugs/cosmetics, and electronics. Following their use in industrial applications, azo dyes have been found in effluents and various receiving waters. Chemical treatment of effluents containing azo dyes includes disinfection using chlorine, which can generate compounds of varying eco/genotoxicity. Among the widely known commercial azo dyes for synthetic fibers is C.I. Disperse Red 1. While this dye is known to exist as a complex mixture, reports of eco/genotoxicity involve the purified form. Bearing in mind the potential for adverse synergistic effects arising from exposures to chemical mixtures, the aim of the present study was to characterize the components of commercial Disperse Red 1 and its chlorine-mediated decoloration products and to evaluate their ecotoxicity and mutagenicity. In conducting the present study, Disperse Red 1 was treated with chlorine gas, and the solution obtained was analyzed with the aid of LC-ESI-MS/MS to identify the components present, and then evaluated for ecotoxicity and mutagenicity, using Daphnia similis and Salmonella/microsome assays, respectively. The results of this study indicated that chlorination of Disperse Red 1 produced four chlorinated aromatic compounds as the main products and that the degradation products were more ecotoxic than the parent dye. These results suggest that a disinfection process using chlorine should be avoided for effluents containing hydrophobic azo dyes such commercial Disperse Red 1. © 2012 Elsevier B.V..
Resumo:
Incluye Bibliografía
Resumo:
The aim of the present study was to detect progesterone receptors (A and B isoforms), α and β estrogen receptors, luteinizing hormone receptors and aromatase cytochrome P450 enzymes in the corpus luteum of Nelore (Bos taurus indicus) cows using immunohistochemistry. The estrous cycles of 16 Nelore cows were synchronized, and luteal samples were collected via an incision into the vaginal vault. Samples were collected during specific days of the estrous cycle (days 6, 10, 15 and 18) and 24. h after circulating progesterone dropped, after luteolysis had occurred. After each biopsy was taken, all animals were resynchronized so that each biopsy was performed during a different estrous cycle. Our results showed that the concentration of studied proteins vary throughout the bovine estrous cycle. The highest concentration of α and β estrogen receptors and the highest concentration of plasma progesterone were both observed on days 10 and 15 of the estrous cycle. The highest concentration of progesterone receptors was observed on days 6 and 10 of the estrous cycle, and the most intense immunostaining for cytochrome P450 aromatase enzymes was observed on day 10 of the estrous cycle. The highest score of cells with plasma membrane immunostaining for LH receptors was observed on day 15 of the estrous cycle. In conclusion, this study demonstrates the varying concentrations of specific proteins within the corpus luteum of Nelore cows during the estrous cycle. This finding suggests that these receptors and enzymes, and their interactions, are important in regulating luteal viability. © 2013 Elsevier B.V.