(Table 1) Estimated e-Nd(0) input calculated using the relative fraction of ODP Hole 105-647A amphibole grains originated from different provinces of the North America

Many marine radiogenic isotope records show both spatial and temporal variations, reflecting both the degree of mixing of distinct sources in the oceans and changes in the distribution of chemical weathering on the continents. However, changes in weathering and transport processes may themselves affect the composition of radiogenic isotopes released into seawater. The provenance of physically weathered material in the Labrador Sea, constrained through the use of Ar-Ar ages of individual detrital minerals, has been used to estimate the relative contributions of chemically weathered terranes releasing radiogenic isotopes into the Labrador Sea. A simple box-model approach for balancing observed Nd-isotope variations has been used to constrain the relative importance of localised input in the Labrador Sea, and the subsequent mixing of Labrador Sea Water into North Atlantic Deep-Water. The long-term pattern of erosion and deep-water formation around the North Atlantic seems to have been a relatively stable feature since 1.5 Ma, although there has been a dramatic shift in the nature of physical and chemical weathering affecting the release of Hf and Pb isotopes. The modelled Nd isotopes imply a relative decrease in water mass advection into the Labrador Sea between 2.4 and 1.5 Ma, accompanied by a decrease in the rate of overturning, possibly caused by an increased freshwater input into the Labrador Sea.

(Table 1) Snow and sea ice thickness, solar heat input and solar heat used for melting at seven ice mass-balance buoys in the Arctic in 2008

There has been a marked decline in the summer extent of Arctic sea ice over the past few decades. Data from autonomous ice mass-balance buoys can enhance our understanding of this decline. These buoys monitor changes in snow deposition and ablation, ice growth, and ice surface and bottom melt. Results from the summer of 2008 showed considerable large-scale spatial variability in the amount of surface and bottom melt. Small amounts of melting were observed north of Greenland, while melting in the southern Beaufort Sea was quite large. Comparison of net solar heat input to the ice and heat required for surface ablation showed only modest correlation. However, there was a strong correlation between solar heat input to the ocean and bottom melting. As the ice concentration in the Beaufort Sea region decreased, there was an increase in solar heat to the ocean and an increase in bottom melting.

Estimation Technique of International Input-Output Model by Non-survey Method

The Asian International Input-Output (IO) Table that is compiled by Institute of Developing Economies-JETRO (IDE), was constructed in Isard type form. Thus, it required a lot of time to publish. In order to avoid this time-lag problem and establish a more simple compilation technique, this paper concentrates on verifying the possibility of using the Chenery-Moses type estimation technique. If possible, applying the Chenery-Moses instead of the Isard type would be effective for both impact and linkage analysis (except for some countries such as Malaysia and Singapore and some primary sectors. Using Chenery-Moses estimation method, production of the Asian International IO table can be reduced by two years. And more, this method might have the possibilities to be applied for updating exercise of Asian IO table.

Application of the Input-Output Decomposition Technique to China's Regional Economies

Structural decomposition techniques based on input-output table have become a widely used tool for analyzing long term economic growth. However, due to limitations of data, such techniques have never been applied to China's regional economies. Fortunately, in 2003, China's Interregional Input-Output Table for 1987 and Multi-regional Input-Output Table for 1997 were published, making decomposition analysis of China's regional economies possible. This paper first estimates the interregional input-output table in constant price by using an alternative approach: the Grid-Search method, and then applies the standard input-output decomposition technique to China's regional economies for 1987-97. Based on the decomposition results, the contributions to output growth of different factors are summarized at the regional and industrial level. Furthermore, interdependence between China's regional economies is measured and explained by aggregating the decomposition factors into the intraregional multiplier-related effect, the feedback-related effect, and the spillover-related effect. Finally, the performance of China's industrial and regional development policies implemented in the 1990s is briefly discussed based on the analytical results of the paper.

Evaluation of Non-Survey International IO Construction Methods with the Asian-Pacific Input-Output Table

This paper presents four non-survey methods to construct a full-information international input-output table from national IO tables and international import and export statistics, and this paper tests these four methods against the semi-survey international IO table for nine East-Asian countries and the USA, which is constructed by the Institute of Developing Economies in Japan. The tests show that the impact on the domestic flows of using self-sufficiency ratios is small, except for Singapore and Malaysia, two countries with large volumes of smuggling and transit trade. As regards the accuracy of the international flows, all methods show considerable errors, of 10%-40% for commodities and of 10%-70% for services. When more information is added, i.e. going from Method 1 to 4, the accuracy increases, except for Method 2 that generally produces larger errors than Method 1. In all, it seems doubtful whether replacing the semi-survey Asian-Pacific IO table with one of the four non-survey tables is justified, except when the semi-survey table itself is also considered to be just another estimate.

Empirical global value chain analysis in electronics and automobile industries :An application of Asian international input-output tables

This study aims to examine the international value distribution structure among major East Asian economies and the US. The mainstream trade theory explains the gains from trade; however, global value chain (GVC) approach emphasises uneven benefits of globalization among trading partners. The present study is mainly based on this view, examining which economy gains the most and which the least from the East Asian production networks. Two key industries, i.e., electronics and automobile, are our principle focus. Input-output method is employed to trace the creation and flows of value-added within the region. A striking fact is that some ASEAN economies increasingly reduce their shares of value-added, taken by developed countries, particularly by Japan. Policy implications are discussed in the final section.

A New Measurement for International Fragmentation of the Production Process: An International Input-Output Approach

The paper investigates the possibility of constructing a new measurement for analysing international fragmentation of the production process. It asserts that the current usage of relevant data, whether the trade shares of parts and components or the index of Vertical Specialisation, is quite unsatisfactory for measuring the phenomenon, since they critically lack the overall perspective of the entire structure of production chains. 　The new measurement is formulated such that it captures every aspect of the vertical sequence of production linkages. It is based on the input-output model of Average Propagation Lengths, recently developed by Eric Dietzenbacher and others, which show the average number of production stages that are passed through for an exogenous change in one industry to affect another. By applying this model to the data of the Asian International Input-Output Tables, the index is able to measure the international dimension of production sharing and division of labour in East Asia.

Input-Output Based Economic Impact Evaluation System for Small City Development: A Case Study on Saemangeum's Flux City Design

The paper aims to develop a quasi-dynamic interregional input-output model for evaluating the macro-economic impacts of small city development. The features of the model are summarized as follows: (1) the consumption expenditure of households is regarded as an endogenous variable, (2) the technological change is determined by the change of industrial Location Quotient caused by firm's investment activities. (3) a strong feedback function between the city design and the economic analysis is provided. For checking the performance of the model, Saemangeum's Flux City Design Plan is used as the simulation target in our paper.