Desenvolvimento de uma ferramenta de otimização para avaliar a expansão da transmissão de energia

Conselho Nacional de Desenvolvimento Científico e Tecnológico (CNPq)

Geração de energia renovável em residências: aplicação de tecnologias existentes

Due to the high value of the bill that the Brazilian has been paying, one of the most expensive in the world, is becoming increasingly attractive the option for renewable energy in form of distributed micro and minigeneration. In other words, the renewable energy sources are becoming attractive not only because of environmental concerns, but also due to economic issues. This has become even more relevant and concrete after approval of rules by National Agency of Electric Energy (ANEEL) on 4/17/2012 (Normative Resolution n ° 482/2012 of 04/17/2012) aimed at reducing barriers to installation of small distributed generation, including microgeneration, with up to 100 kW of power, and minigeneration, 100 kW to 1 MW. The Normative Resolution n ° 482/2012 creates the Energy Clearing System, which allows consumers to install small generators in its consumer unit and exchange energy with the local distributor. The rule applies to generators that use renewable sources of energy (hydro, solar, biomass, wind and cogeneration qualified). In this context, this paper presents a technical and economic analysis of installing a residential microgenerating plant composed of photovoltaic cells, solar panels and small wind turbines

Modelagem e simulação numérica de um sistema de refrigeração por absorção utilizando o par H2O-LiBr

The term refrigeration solar refers to any air conditioning system that uses solar energy as a primary energy source. The use of solar radiation for cooling purposes is divided according to their technological possibilities which are distinguished from one another as the way that energy is involved in the cycle, work or heat. The first case is related to vapor compression cycles, in which the work input is provided by the photovoltaic conversion of solar energy into electrical energy. In the second case, an absorption refrigeration cycle is used and the thermal energy collected from the solar radiation is provided at the generator of this cycle.. In this work a system with an absorption cycle using the pair BrLi-water, using solar energy as input is modeled. It is considered a simple refrigeration cycle whose the equations of mass and energy conservation in each component are developed in order to obtain an algebraic equation set and a simulation routine using the EES software. Although the simulation operates under certain specified thermal load it is possible to estimate the necessary areas of heat exchangers and solar collectors

Projeto de recuperação da planta termelétrica do Laboratório de Vapor do Departamento de Energia da Faculdade de Engenharia de Guaratinguetá

Brazil is nowadays the greatest bet of investors for the future due to its stable economy growth. The country has grown side by side with the greatest demand for electrical energy. The international appeal for renewable sources is causing a change in the Brazilian energetic matrix, raising the amount of energy generated by thermoelectric power plants. The construction of new power plants, running on biomass, requires a crescent number of capacitated personnel to run them. The Faculdade de Engenharia de Guaratinguetá – UNESP – has a steam laboratory; witch is deactivated, which has a thermoelectric plant of small capacity. The laboratory reactivation and the return of its activities can be an important tool in order to graduate engineer able to operate on such units. This paper proposes four new experiments to be simulated on the Collage’s Energy Dep. Steam Lab when it gets back to its educational activities

Sistema de iluminação inteligente através de redes de sensores wireless

The objective of this project is to collaborate with the society, working on a subject that is directly linked to issues of sustainability and environmental preservation. For this, a survey is being developed in order to make possible the creation of an intelligent mechanism, with the use of wireless solutions for the control of energy consumption in order to meet the needs of quality of life and reduce the average consumption of electrical energy. An intelligent lighting system can be explained simply, as an interconnected network of lamps in order to meet needs such as light intensity, the location of it, the moment will turn on or turn off the lights, among other possibilities. This network of lamps is controlled by algorithms implemented using microcontrollers, which may or may not have changed its characteristics. This can be automatic (pre-programmed by the administrator) or manual (controlled via a remote control, phones, etc.), and will depend upon the manager himself and also the characteristics imposed on the project. However, it is important to note that after the search is complete, decisions will be consistent with the Brazilian reality, ie, this system can only be feasible if it has all the characteristics described above, but with an affordable price so that people can acquire it

Redução de consumo de energia eletrica a partir de reaproveitamento de energia termica com uso de ciclo rankine orgânico

This paper is proposed the usage of an Organic Rankine Cycle (ORC) along with waste heat recovery from an inconstant heat source. This method of waste heat recovery with intermittent heat source is part of a technical viability study. This paper also brings up the usage of thermal energy storage as heat source for the ORC. This paper is based on a heat treatment company study in which a natural gas furnace is explored. Data such as mass flow, temperature and specific waste gas heat from this furnace are used through calculations. Calculations are made also based on furnace cycles. This viability study considers a series of working fluids such as ammonia, benzene, R113 and R134a. Results point out that ORC with out thermal storage and using refrigerant fluid ammonia is the best alternative

Sistema fotovoltaico interligado á rede eletrica no Campus da UNESP-FEG Guaratinguetá

Solar energy can be considered the largest source of energy available on earth and has attracted in recent decades, attention and interest for its rational use. The use of energy sources in a sustainable manner is essential to the survival of future generations, due to the scarcity of natural resources and their exploitation in a disorderly way. Studies related to the applications of renewable sources becomes then relevant, given its great importance as regards the conscious use of resources provided by nature, with the least possible impact on it. The present study presents an evaluation of generation potential and feasibility of implementing a solar photovoltaic connected to the grid and connected to the roofs of some buildings of the Faculty of Engineering of Guaratinguetá - FEG, to supply the demand of electric energy consumption on campus and attempting to inject a possible surplus power generation in local power grid, increasing network capacity and reducing peak loads

Geração de energia fotovoltaica para cargas pontuais em residências

This work, based in a patent request at INPI, protocol no. 020110035974, presents a system development using solar panels to supply the electricity demand required by punctual loads, without a storage unit or utility grid synchronism, through a control circuit that allows parallel operation with the power grid during low sunlight incidence periods. A study about solar panel construction and topologies for Power generation was done, in a atempt to evalute impacts in project. This development was modular, providing the system the possibility of power capacity expansion and load diversity as well, in an attempt to reduce the total energy requirements from the residential sector drained from the power grid along the day

Cinética de degradação do sistema resina epóxi/fibra de carbono

With the increasing demand for electricity, the retraining of transmission lines is necessary despite environmental restrictions and crossings in densely populated areas to build new transmission and distribution lines. Solution is reuse the existent cables, replacing the old conductor cables for new cables with higher capacity power transmission, and control of sag installed. The increasing demand for electrical power has increased the electric current on the wires and therefore, it must bear out temperatures of 150°C or more, without the risk of the increasing sag beyond the established limits. In the case of long crossings or densely populated areas, sag is due to high weight of the cable on clearance. The cable type determines the weight, sag, height and the towers dimensions, which are the items that most influence the investment of the transmission line. Hence, to reduce both cost of investment and maintenance of the line, the use of a lighter cable can reduce both number and the height of the towers, with financial return on short and long term. Therefore, in order to increase the amount of transmitted energy and reduce the number of built towers and sag, is recommended in the current work substitute the current core material (steel or aluminium) for alternatives alloys or new materials, in this case a composite, which has low density, elevated stiffness (elasticity module), thus apply the pultruded carbon fiber with epoxy resin as matrix systems and perform the study of the kinetics of degradation by thermogravimetric analysis (TGA), dynamic mechanical analysis (DMA) and differential scanning calorimetry (DSC), according to their respective standards

Colheita de energia usando dispositivos baseados em materiais piezoelétrico

Recently, research on energy harvesting has increased substantially. Many researchers have concentrated their efforts to find the best configuration for these systems and to optimize their output power. In the process of energy harvesting, the electric energy is obtained by converting mechanics energy created by an environment vibration source by a transducer, for example, a thin piezoceramic film. That vibration source is, for example, a beam suffering some mechanic force able to generate a vibration in it, an oscillating beam is the best properly used example. Different mechanisms of electromechanical coupling have been developed to harvesting devices, and a particular interest has been given to the use of models that transform the mechanical vibration into electrical current using a piezoelectric element. In this paper we propose a model to energy harvesting from vibrations, from an oscillating beam, including non-linearities in the piezoelectric coupling and a non-ideal excitation in the material. From this model, it was developed a system to obtain some results about the harvested power by the material. It was demonstrated that the power captured was influenced by the effect of the nonlinearities of the piezoelectric coupling, modifying the system dynamic behavior

Viabilidade técnica e econômica na utilização de um sistema fotovoltaico para alimentação de luminárias LED na Faculdade de Engenharia do Campus de Guaratinguetá SP

Solar energy can be considered the largest source of energy available on earth and has attracted in recent decades, attention and interest for its rational use. The use of energy sources in a sustainable way is essential to the survival of future generations, due to the scarcity of natural resources and their exploitation in a disorderly way. This academic work aims to bring a possible alternative to reduce the consumption of eletrical energy, at the University of Engineering – Campus of Guaratinguetá, through the use of a photovoltaic system interconnected to the LED bulbs. For this, the necessary data for the design of the photovoltaic system componentes and their acquisition costs were obtained and three differents configurations were developed to choose the one that bests fits the studied case, considering the return time of the initial investment (payback)

Desenvolvimento de um smart meter: um estudo sobre eficiência energética através das redes inteligentes

Pós-graduação em Engenharia Elétrica - FEB

Aplicação do conceito de geração distribuída a um sistema fotovoltaico residencial

This work presents a study about distributed generation using photovoltaic systems in the context of smart grids. The characteristics of a Smart Grid and the several aspects this concept involves - distributed generation among them - are discussed. There are also examples of equipment, like smart meters, and of national and international projects. The specificities of distributed generation and the rules and standards necessary in this sort of installation are talked through with focus in the solar energy generation method. Regarding photovoltaic systems, the working principles of the panels are presented, along with its main electrical characteristics and the technologies available. Finally there is a study concerning the sizing of a distributed generation system that involves photovoltaic panels in a residential plant. An analysis of the costs and return of investment period is made about the specific case in consideration.

Singular value analyses of voltage stability on power system considering wind generation variability

Pós-graduação em Engenharia Elétrica - FEIS

Compensador série controlado a tiristores na distribuição: Compensação dinâmica

Pós-graduação em Engenharia Elétrica - FEIS