Geochemistry at DSDP Leg 92 Holes

The major-element and most of the trace-element data from the different laboratories that contributed to the study of samples recovered during Leg 82 are presented in the following tables. The different basalt groups, identified on the basis of their chemical properties (major and trace elements), were defined from the data available on board the Glomar Challenger as the cruise progressed (see site chapters, all sites, this volume). Most of the data obtained since the end of the cruise and presented in these tables confirm the classification that was proposed by the shipboard party (see site chapters, all sites, this volume). Nevertheless, special mention should be made about Site 564. The shipboard party proposed a single chemical group at this site but noticed significant variations down the hole, mainly in trace-element data. However, the range of variation was small compared to the precision of the measurements. These variations were confirmed by the onshore studies (see papers in Part IV of this volume, especially Brannon's paper, partly devoted to this topic).

Mineralogy and geochemistry of altered ash, pelagic clay, and a clay vein in basalt from DSDP Leg 62 Holes

Volcanic ash was recovered from lower Aptian to Albian deposits from DSDP Sites 463, 465, and 466; pelagic clay of the upper Pleistocene to Upper Cretaceous was recovered mainly from Site 464, with minor amounts at Sites 465 and 466. We present X-ray-mineralogy data on pelagic clay and altered volcanic ash recovered from the four Leg 62 sites. In addition, two ash samples from Sites 463 and 465, a pelagic clay from Site 464, and a clay vein from the basaltic basement at Site 464 each were analyzed for major, minor, and trace elements. Our purpose is to describe the mineralogy and chemistry of altered ash and pelagic clays, to determine the sources of their parent material, and to delineate the diagenetic history of these clay-rich deposits. Correlation of chemistry and mineralogy of ash and pelagic clay with volcanic rocks suspected to be their parent material is not always straightforward, because weathering and diagenetic alteration caused depletion or enrichment of many elements.

Description, geochemistry, mineralogy and isotopes of sulfides from ODP Site 193-1189, PACMANUS field

Chemical and isotopic data for rare massive and semimassive sulfide samples cored at Site 1189 (Roman Ruins, PACMANUS) suggest their genetic relationship with sulfide chimneys at the seafloor. Sand collected from the hammer drill after commencement of Hole 1189B indicates that at least the lower section of the cased interval was occupied by material similar to the stockwork zone cored from 31 to ~100 meters below seafloor (mbsf) in this hole, but with increased content of barite, sphalerite, and lead-bearing minerals. Fractional crystallization of ascending hydrothermal fluid involving early precipitation of pyrite may explain vertical mineralogical and chemical zoning within the stockwork conduit and the high base and precious metal contents of Roman Ruins chimneys. A mineralized volcaniclastic unit cored deep in Hole 1189A possibly represents the lateral fringe of the conduit system. Lead isotope ratios in the sulfides differ slightly but significantly from those of fresh lavas from Pual Ridge, implying that at least some of the Pb within the Roman Ruins hydrothermal system derived from a deeper, more radiogenic source than the enclosing altered volcanic rocks.

Chemical composition of ferromanganese concretions and host bottom sediments from the Black Sea

Ferromanganese concretions spread out on the bottom of the shallow northwest part of the Black Sea are mainly represented by Fe and Mn nodules on shells and substituted worm tubes. Element composition of these formations was measured by methods of chemical, atomic absorbtion, neutron activation, and ICP-MS analyses. It was established that Fe and Mn contents and Mn/Fe ratio in the concretions varied considerably and which controlled occurrence of several associated metals and minor elements; some of them have not been studied in Black Sea concretions before.

Geochemistry of surface sediment samples from the equatorial Atlantic south of the Azores

In order to recognize the distribution of hydrothermal tracers south of the Azores, a series of cores has been sampled during the GEOFAR cruise. The distribution of the Mn concentrations shows that the hydrothermal influence is maximum within and to the north-west of the Lucky Strike segment. North of the East-Azores Fracture Zone the sediments are enriched in Ba which could be derived from different sources. The chemical composition of the interstitial water shows that water advection is limited. Mn, Cu, Ni fluxes evaluated in one site have increased during isotopic stages 4 and 2 and the deglaciation.

Chemical and isotopic compositions of basaltic glasses and crusts from the Mid-Atlantic Ridge rift valley

Data presented in the paper suggest significant differences between thermodynamic conditions, under which magmatic complexes were formed in MAR at 29°-34°N and 12°-18°N. Melts occurring at 29°-34°N were derived by melting of a mantle source with homogeneous distribution of volatile components and arrived at the surface without significant fractionation, likely, due to their rapid ascent. The MAR segments between 12° and 18°N combine contrasting geodynamic environments of magmatism, which predetermined development of a large plume region with widespread mixing of melting products of geochemically distinct mantle sources. At the same time, this region is characterized by conditions favorable for origin of localized zones of anomalous plume magmatism. These sporadic magmatic sources were spatially restricted to MAR fragments with the Hess crust, whose compositional and mechanical properties were, perhaps, favorable for focusing and localization of plume magmatism. The plume source between 12° and 18°N beneath MAR may be geochemically heterogeneous.

Chemical composition of rocks and minerals from the Mid-Atlantic Ridge near 15°20'N

The monograph summarizes results of petrological and geochemical studies of rocks from the ocean floor collected by the authors during expeditions to the Central Atlantic. Detailed work in the Capa Verde transform fault zone gave a large amount of new information about magmatic and hydrothermal systems of the Mid-Atlantic Ridge.

Platinum-group, major, and trace element abundances in ODP Leg 183 basalts

Seventeen basalts from Ocean Drilling Program (ODP) Leg 183 to the Kerguelen Plateau (KP) were analyzed for the platinum-group elements (PGEs: Ir, Ru, Rh, Pt, and Pd), and 15 were analyzed for trace elements. Relative concentrations of the PGEs ranged from ~0.1 (Ir, Ru) to ~5 (Pt) times primitive mantle. These relatively high PGE abundances and fractionated patterns are not accounted for by the presence of sulfide minerals; there are only trace sulfides present in thin-section. Sulfur saturation models applied to the KP basalts suggest that the parental magmas may have never reached sulfide saturation, despite large degrees of partial melting (~30%) and fractional crystallization (~45%). First order approximations of the fractionation required to produce the KP basalts from an ~30% partial melt of a spinel peridotite were determined using the PELE program. The model was adapted to better fit the physical and chemical observations from the KP basalts, and requires an initial crystal fractionation stage of at least 30% olivine plus Cr-spinel (49:1), followed by magma replenishment and fractional crystallization (RFC) that included clinopyroxene, plagioclase, and titanomagnetite (15:9:1). The low Pd values ([Pd/Pt]_pm < 1.7) for these samples are not predicted by currently available Kd values. These Pd values are lowest in samples with relatively higher degrees of alteration as indicated by petrographic observations. Positive anomalies are a function of the behavior of the PGEs; they can be reproduced by Cr-spinel, and titanomagnetite crystallization, followed by titanomagnetite resorption during the final stages of crystallization. Our modeling shows that it is difficult to reproduce the PGE abundances by either depleted upper or even primitive mantle sources. Crustal contamination, while indicated at certain sites by the isotopic compositions of the basalts, appears to have had a minimal affect on the PGEs. The PGE abundances measured in the Kerguelen Plateau basalts are best modeled by melting a primitive mantle source to which was added up to 1% of outer core material, followed by fractional crystallization of the melt produced. This reproduces both the abundances and patterns of the PGEs in the Kerguelen Plateau basalts. An alternative model for outer core PGE abundances requires only 0.3% of outer core material to be mixed into the primitive mantle source. While our results are clearly model dependent, they indicate that an outer core component may be present in the Kerguelen plume source.

Geochemistry and petrology of basalts from Celebes Sea

Major-, trace-, and rare-earth element analyses are presented from a suite of basaltic rocks from the basement of the Celebes Sea. The major elements and trace-elements were determined by X-ray fluorescence techniques, and the rare-earth elements were analyzed by instrumental neutron activation analysis. Compositionally the Celebes Sea basalts are very similar to typical normal mid-ocean ridge basalts, such as those described from the Indian Ocean triple junction. Petrogenetic modeling shows that all of the basalts analyzed can be formed by 10% to 20% partial melting of a light rare-earth element-depleted spinel lherzolite followed by fractional crystallization of mixtures of olivine, Plagioclase, and iron oxide. The Celebes Sea is interpreted as a fragment of the basement of the Jurassic Argo abyssal plain trapped during the Eocene to the north of Australia.