994 resultados para Relative velocity
Resumo:
The interaction between a high-pressure rotor and a downstream vane is dominated by vortex-blade interaction. Each rotor blade passing period two co-rotating vortex pairs, the tip-leakage and upper passage vortex and the lower passage and trailing shed vortex, impinge on, and are cut by, the vane leading edge. In addition to the streamwise vortex the tip-leakage flow also contains a large velocity deficit. This causes the interaction of the tip-leakage flow with a downstream vane to differ from typical vortex blade interaction. This paper investigates the effect these interaction mechanisms have on a downstream vane. The test geometry considered was a low aspect ratio second stage vane located within a S-shaped diffuser with large radius change mounted downstream of a shroudless high-pressure turbine stage. Experimental measurements were conducted at engine-representative Mach and Reynolds numbers, and data was acquired using a fast-response aerodynamic probe upstream and downstream of the vane. Time-resolved numerical simulations were undertaken with and without a rotor tip gap in order to investigate the relative magnitude of the interaction mechanisms. The presence of the upstream stage is shown to significantly change the structure of the secondary flow in the vane and to cause a small drop in its performance.
Resumo:
Modern high performance motorcycles often employ a steering damper producing a moment that opposes the angular velocity of the steering assembly relative to the main frame. When modeling the motorcycle in a conventional manner, the steering damper is included as an integral part of the machine. The reduction in the wobble-mode frequency is caused by the effective increase in the steering system's moment of inertia. The compensators show the potential to significantly improve the damping of both wobble and weave modes simultaneously. The dynamic characteristics of high-performance motorcycles can be improved by replacing the conventional steering damper with a passive mechanical steering compensator. The design methodology adopted uses Nyquist frequency response ideas, root-locus analysis and loop-shaping design to obtain a preliminary choice of parameters.
Resumo:
An experimental investigation of the unsteady interaction between a turbulent boundary layer and a normal shock wave of strength M∞ = 1.4 subject to periodic forcing in a parallel walled duct has been conducted. Emphasis has been placed on the mechanism by which changes in the global flow field influence the local interaction structure. Static pressure measurements and high speed Schlieren images of the unsteady interaction have been obtained. The pressure rise across the interaction and the appearance of the local SBLI structure have been observed to vary during the cycle of periodic shock wave motion. The magnitude of the pressure rise across the interaction is found to be related to the relative Mach number of the unsteady shock wave as it undergoes periodic motion. Variations in the upstream Influence of the interaction are sensitive to the magnitude and direction of shock wave velocity and acceleration and it is proposed that a viscous lag exists between the point of boundary layer separation and the shock wave position. Further work exploring the implications of these findings is proposed, including studies of the variation in position of the points of boundary layer separation and reattachment.
Resumo:
A parametric set of velocity distributions has been investigated using a flat plate experiment. Three different diffusion factors and peak velocity locations were tested. These were designed to mimic the suction surfaces of Low Pressure (LP) turbine blades. Unsteady wakes, inherent in real turbomachinery flows, were generated using a moving bar mechanism. A turbulence grid generated a freestream turbulence level that is believed to be typical of LP turbines. Measurements were taken across a Reynolds number range of 50,000-220,000 at three reduced frequencies (0.314, 0.628, 0.942). Boundary layer traverses were performed at the nominal trailing edge using a Laser Doppler Anemometry system and hot-films were used to examine the boundary layer behaviour along the surface. For every velocity distribution tested, the boundary layer separated in the diffusing flow downstream of the peak velocity. The loss production is dominated by the mixing in the reattachment process, mixing in the turbulent boundary layer downstream of reattachment and the effects of the unsteady interaction between the wakes and the boundary layer. A sensitive balance governs the optimal location of peak velocity on the surface. Moving the velocity peak forwards on the blade was found to be increasingly beneficial when bubblegenerated losses are high, i.e. at low Reynolds number, at low reduced frequency and at high levels of diffusion. Copyright © 2008 by ASME.
Resumo:
The study deals with the length-weight relationship and relative condition factor (Kn) of mahseer, Tor putitora reared for 150 days in ponds. The logarithmic form of equation for the relationship was found to be logW = -1.727+2.875logL or W=O.Ol875U·875 • The graphical presentation of the parabolic and logarithmic forms showed respectively the curvilinear and linear relationships between length and weight of the fish. The mean value (±sd) of relative condition factor was found to be 0.95±0.12. The exponential value 'b' was found to be 2.96 and the coefficient of correlation 'r' was 0.965, which showed strong and highly correlated relationships between length and weight of the fish.
Resumo:
Oreochromis mossambicus (Peters), a common freshwater fish of Bhima river, has high economic value and considerable fishery importance. The length-weight relationship in the logarithmic way for this fish can be written as: Log W = - 4.50241627 + 2.884822741 log L. This is close to the cubic law indicating the isometric growth of the fish in its natural habitat. The correlation coefficient (r) was found to be 0.9865 which showed a good relationship between the two parameters. The mean relative condition factor (K sub(n)) was 1.00 suggesting the well-being of the fish.
Resumo:
The use of microbial induced precipitation as a soil improvement technique has been growing in geotechnical domains where ureolytic bacteria that raise the pH of the system and induce calcium carbonate (CaCO3) precipitation are used. For many applications, it is useful to assess the degree of CaCO 3 precipitation by non-destructive testing. This study investigates the feasibility of S-wave velocity measurements to evaluate the amount of calcite precipitation by laboratory testing. Two sets of cemented specimen were tested. The first were samples terminated at different stages of cementation. The second were samples that went through different chemical treatments. These variations were made to find out if these factors would affect the S-wave velocity- cementation relationship. If chemical reaction efficiency was assumed to be constant throughout each test, the relationship between S-wave velocity (Vs) and the amount of CaCO3 precipitation was found to be approximately linear. This correlation between S-wave velocity and calcium carbonate precipitation validates its use as an indicator of the amount of calcite precipitation © 2011 ASCE.
Resumo:
The microhabitat breadth of Vamanapuram River fish community was studied in detail. The microhabitat variables selected were relative depth, focal point velocity, water column depth, mean water velocity and substrate. Puntius filamentosus had the highest breadth in three dimensions in both stream and river habitats showing a generalistic mode of resource utilization. Garra mullya, Labeo dero and Glossogobius giuris are specialists in the usage of microhabitat variables in the stream habitat while these are G. mullya, Etroplus maculatus and Aplocheilus lineatus in river habitat. Danio aequipinnatus showed extreme variations along focal point velocity variable in both habitats indicating an. opportunistic behaviour.
Resumo:
Horizontal curved, vertical curved and V-shaped otter boards were studied to compare their relative efficiency under identical fishing conditions. The gear operated with V-shaped otter boards performed well followed by the gear fitted with horizontal curved boards. Vertical curved boards were found to be comparatively less efficient, but with slight modification, can be used advantageously for bottom and off bottom fishes. Fishing at various depths with horizontal curved and V-shaped otter boards at different scope ratios showed better performance of horizontal curved boards at a scope ratio of 1:6 and V-shaped otter boards at a scope ratio of 1:5.
Resumo:
Landing data of 21 fisheries from Karnataka (quarterly landings for the period 1956 to 1978 and annual landings for the period 1979 to 1981) were analysed to study the te111poral behaviour of the landings. The relative distribution and secular trends in each of the fisheries are reported. On an average, mackerel and oil sardine together account for about 70% of the annual landings. The fluctuation in the landings in all the fisheries was very high with the coefficient of variation attaining a minimum value of 61.53%. The inverse relationship between the landings of oil sardine and mackerel was found to be statistically significant. It is suggested that fishing effort be further increased in fisheries that have demonstrated a rising trend (about 73% of the total annual landings) as also in the case of the fisheries whose trends appear stagnant (about 21% of the annual landings). However, there seems to be some evidence of a need for regulating fishing in Hemirhamphus and Belone, Caranx and penaeid prawns. Regulations need to be made authentic with the help of sufficient information on not merely the fishery but on the whole population.
Resumo:
The length-weight relationship of Daysciaena albida and Gerres filamentosus were calculated separately for indeterminants, mature males and mature females. The logarithmic regression equation obtained for D. albida - males: log w = -1.5055 + 2.8618 log l; females: log w = -0.9260 + 2.4089 log l; indeterminants: log w = -l.7188 + 3.0616 log l. The regression co-efficients between males and females, males and in determinants and female and in determinants showed significant differences. In G. filamentosus the relationship can be expressed as males: log w = -1.3224 + 2.8740 log 1; females: log w = -1.2874 + 2.8381 log l; indeterminants: log w = -0.8167 + 2.2558 log l. The difference in regression co-efficients between male and female are insignificant at 5% level whereas significant differences were observed between males and indeterminants and females and indeterminants. The relative condition factor (Kn) was calculated for the above two species. In D. albida the reasons for the fluctuations of Kn values can be attributed to both spawning cycle as well as feeding intensity whereas in G. filamentosus it synchronies mainly with spawning cycle.
Resumo:
Three experimental groups from three different fishing villages were selected and administered with three extension treatments on two messages, namely, production of fish wafers and fish pickles. There was a significant knowledge gain in the subjects taught through different extension methods. It was observed that lecture aided with slides induced maximum knowledge followed by lecture aided with charts and lecture alone. Among all, the young and highly educated women gained maximum knowledge.
Resumo:
Retention of knowledge in the preparation of fish pickle, fish wafers and fish soup powder for an experimental group of 20 fisherwomen selected from three fishing villages was studied. The knowledge retention immediately after exposure and also at intervals of 15 days and 30 days after exposure differed significantly.