An investigation of the activation process of high temperature shift catalyst

The aim of this work is to address the activation process of a high temperature shift (HTS) catalyst, composed of Fe2O3/Cr2O3/CuO, by analyzing it before activation (HTS-V) and after activation (HTS-A) using complementary characterization techniques. The textural and morphological characterizations were done by transmission electron rnicroscopy (TEM) and nitrogen physisorption at 77 K; crystallographic structure was confirmed by X-ray diffraction (XRD); electronic structure was analyzed by X-ray absorption spectroscopy (XAS) and the chemical composition of the catalyst`s surface was obtained by X-ray photoelectron spectroscopy (XPS). The investigation pointed out that the HTS-V catalyst presents good textural and morphological properties, which are not deeply affected by the activation process (sample HTS-A). The iron oxide phase in the HTS-V catalyst is hematite whereas in HTS-A catalyst is magnetite with Fe2+/Fe3+ ratio close to the expected value (0.5). For both samples, the Cr ions seem to be incorporated in the iron oxide lattice with higher concentration at particle surface. In the HTS-V catalyst, the Cu ions have oxidation number II and occupy in average distorted octahedral sites; after the activation, the Cu ions are partially reduced, suggesting that the reduction of the Cu species is complex. (C) 2007 Elsevier B.V. All rights reserved.

La(2-x)Ce(x)Cu(1-y)Zn(y)O(4) perovskites for high temperature water-gas shift reaction

The performance of La(2-x)Ce(x)Cu(1-y)Zn(y)O(4) perovskites as catalysts for the high temperature water-gas shift reaction (H T-W G S R) was investigated. The catalysts were characterized by EDS, XRD, BET surface area, TPR, and XANES. The results showed that all the perovskites exhibited the La(2)CuO(4) orthorhombic structure, so the Pechini method is suitable for the preparation of pure perovskite. However, the La(1.90)Ce(0.10)CuO(4) perovskite alone, when calcined at 350/700 degrees C, also showed a (La(0.935)Ce(0.065))(2)CuO(4) perovskite with tetragonal structure, which produced a surface area higher than the other perovskites. The perovskites that exhibited the best catalytic performance were those calcined at 350/700 degrees C and, among these, La(1.90)Ce(0.10)CuO(4) was outstanding, probably because of the high surface area associated with the presence of the (La(0.935)Ce(0.065))(2)CuO(4) perovskite with tetragonal structure and orthorhombic La(2)CuO(4) phase.

Study of Water-Gas-Shift Reaction over La((1-y))Sr(y)Ni(x)Co((1-x))O(3) Perovskite as Precursors

The performance of La((1-y))Sr(y)Ni(x)Co((1-x))O(3) perovskites for the water gas shift reaction (WGSR) was investigated. The samples were prepared by the co- precipitation method and were performed by the BET method, XRD, TPR, and XPS. The catalytic tests were performed at 300 and 400 A degrees C and H(2)O(v)/CO = 2.3/1 (molar ratio). The sample with the highest surface area is La(0.70)Sr(0.30)NiO(3). The XRD results showed the formation of perovskite structure for all samples, and the La(0.70)Sr(0.30)NiO(3) sample also presented peaks corresponding to La(2)NiO(4) and NiO, indicating that the solubility limit of Sr in the perovskite lattice was surpassed. The replacement of Co by Ni favored the reduction of the species at lower temperatures, and the sample containing Sr presented the highest amount of reducible species, as identified by TPR results. All samples were active, the Sr containing perovskite appearing the most active due to the highest surface area, presence of the La(2)NiO(4) phase, and higher content of Cu in the surface, as detected by XPS. Among the samples containing Co, the most active one was that with x = 0.70 (60% of CO conversion).

Effects of the partial replacement of La by M (M=Ce, Ca and Sr) in La(2-x)M(x)CuO(4) perovskites on catalysis of the water-gas shift reaction

The performance of La(2-x)M(x)CuO(4) perovskites (where M = Ce, Ca or Sr) as catalysts for the water-gas shift reaction was investigated at 290 degrees C and 360 degrees C. The catalysts were characterized by EDS, XRD, N(2) adsorption-desorption, XPS and XANES. The XRD results showed that all the perovskites exhibited a single phase (the presence of perovskite structure), suggesting the incorporation of metals in the perovskite structure. The XPS and XANES results showed the presence of Cu(2+) on the surface. The perovskites that exhibited the best catalytic performance were La(2-x)Ce(x)CuO(4) perovslcites, with CO conversions of 85%-90%. Moreover, these perovskites have higher surface areas and larger amounts of Cu on the surface. And Ce has a higher filled energy level than the other metals, increasing the energy of the valence band of Ce and providing more electrons for the reaction. Besides, the La(1.80)Ca(0.20)CuO(4) perovskite showed a good catalytic performance.

CuO and CuO-ZnO catalysts supported on CeO(2) and CeO(2)-LaO(3) for low temperature water-gas shift reaction

This paper describes an investigation on CuO and CuO-ZnO catalysts supported on CeO(2) and CeO(2)-La(2)O(3) oxides, which were designed for the low temperature water-gas shift reaction (WGSR). Bulk catalysts were prepared by co-precipitation of metal nitrates and characterized by energy-dispersive spectroscopy (EDS), X-ray diffraction (XRD), surface area (by the BET method), X-ray photoelectron spectroscopy (XPS), and in situ X-ray absorption near edge structure (XANES). The catalysts` activities were tested in the forward WGSR, and the CuO/CeO(2) catalyst presented the best catalytic performance. The reasons for this are twofold: (1) the presence of Zn inhibits the interaction between Cu and Ce ions, and (2) lanthanum oxide forms a solid solution with cerium oxide, which will cause a decrease in the surface area of the catalysts. Also the CuO/CeO(2) catalyst presented the highest Cu content on the surface, which could influence its catalytic behavior. Additionally, the Cu and Cu(1+) species could influence the catalytic activity via a reduction-oxidation mechanism, corroborating to the best catalytic performance of the Cu/Ce catalyst. (c) 2010 Elsevier B.V. All rights reserved.

Language and Identity at School and at Home : Language Shift among Mennonites in Paraguay

This essay has investigated the question of an ongoing language shift from Plattdeutsch and German to Spanish among the Mennonites in Paraguay and the role of the school in this process. The aims of the study were to compare the use of languages among the Mennonites in Asuncion and in the Menno colony and to identify the importance that parents give to the languages and to compare this with a school leader perspective. The aim was also to identify factors that influence the language shift and identify the influence that the shift excerpts on Mennonite values and identity. The results are based on my own observations, interviews with Mennonite women and interviews with key informants who have insight into the school policy issues. The outcome may be used as a basis for educational and language planning. There is a need to consciously sit down and re-define the Mennonite identity and to make the community and the school aware of their responsibility in language maintenance.

Bini Customary law of inheritence : a shift in Igiogbe as a case study

Igiogbe cultural heritage has existed since the founding of Bini kingdom without any controversy; however since the Supreme Court decision in Idehen v Idehen the issue of Igiogbe has assumed new dimensions. Igiogbe - the house in which a Benin man lived and died devolves on his first son absolutely; but since the beginning of 20th century litigation as to the real meaning of Igiogbe and who is entitled to inheritance thereof began to increase. Controversies and increase in litigation over Igiogbe has occasioned a shift in the practice, the Bini’s are not conscious of some of these changes, most of them (Bini’s) still claim Igiogbe practices is rigidly adhered to. This study on Igiogbe inheritance in Bini kingdom is therefore carried out with a view to bringing out the changes in Igiogbe cultural practice using legal and anthropological tools to examine the changes. While laying the foundation for the discussion on the main research object the researcher examined the origin and status of customary law in Nigeria. There after I examined Igiogbe inheritance in Bini kingdom. Igiogbe and the issue of first son were critically analyzed with the aid of the research questions bringing out the changes in Igiogbe concept from traditional practice to modern practice. Study shows Igiogbe practice is still relevant in modern Bini kingdom, however, the shift and changes in practice of this cultural milieu has lead me to ask some fundamental questions which I intend to answer in the broader research work in future.

The sustainability revolution : A societal paradigm shift - ethos, innovation, government transformation

The Sustainability revolution: A societal paradigm shift – ethos, innovation, governance transformation This paper identifies several key mechanisms that underlie major paradigm shifts. After identifying four such mechanisms, the article focuses on one type of transformation which has a prominent place in the sustainability revolution that the article argues is now taking place. The transformation is piecemeal, incremental, diffuse – in earlier writings referred to as ”organic”. This is a more encompassing notion than grassroots, since the innovation and transformation processes may be launched and developed at multiple levels through diverse mechanisms of discovery and development. Major features of the sustainability revolution are identified and comparisons made to the industrial revolution.