A comparison of theoretical Si VIII emission line ratios with observations from SERTS

Recent R-matrix calculations of electron impact excitation rates in N-like Si VIII are used to derive theoretical emission line intensity ratios involving 2s(2)2p(3)-2s2p(4) transitions in the 216 -320 Angstrom wavelength range. A comparison of these with an extensive dataset of solar active region, quiet- Sun, sub-flare and off-limb observations, obtained during rocket flights of the Solar EUV Research Telescope and Spectrograph (SERTS), indicates that the ratio R-1 = I(216.94 Angstrom)/I(319.84 Angstrom) may provide a usable electron density diagnostic for coronal plasmas. The ratio involves two lines of comparable intensity, and varies by a factor of about 5 over the useful density range of 10(8)-10(11) cm(-3). However R-2 = I(276.85 Angstrom)/I(319.84 Angstrom) and R-3 = I(277.05 Angstrom)/I(319.84 Angstrom) show very poor agreement between theory and observation, due to the severe blending of the 276.85 and 277.05 Angstrom lines with Si VII and Mg VII transitions, respectively, making the ratios unsuitable as density diagnostics. The 314.35 Angstrom feature of Si VIII also appears to be blended, with the other species contributing around 20% to the total line flux.

Electron densities in the coronae of the Sun and Procyon from extreme-ultraviolet emission line ratios in Fe XI

New R-matrix calculations of electron impact excitation rates for Fe XI are used to determine theoretical emission line ratios applicable to solar and stellar coronal observations. These are subsequently compared to solar spectra of the quiet Sun and an active region made by the Solar EUV Rocket Telescope and Spectrograph (SERTS-95), as well as Skylab observations of two flares. Line blending is identified, and electron densities of 10(9.3), 10(9.7), greater than or equal to 10(10.8), and greater than or equal to 10(11.3) cm(-3) are found for the quiet Sun, active region, and the two flares, respectively. Observations of the F5 IV-V star Procyon, made with the Extreme Ultraviolet Explorer (EUVE) satellite, are compared and contrasted with the solar observations. It is confirmed that Procyon's average coronal conditions are very similar to those seen in the quiet Sun, with N-e = 10(9.4) cm(-3). In addition, although the quiet Sun is the closest solar analog to Procyon, we conclude that Procyon's coronal temperatures are slightly hotter than solar. A filling factor of 25(-12)(+38)% was derived for the corona of Procyon.

Strong configuration mixing among the fine-structure levels of Cl+

A large-scale configuration interaction (Cl) calculation using Program CIV3 of Hibbert is performed for the lowest 62 fine- structure levels of the singly charged chlorine ion. Our calculated energy levels agree very well with most of the NIST results and confirm the identification of the lowest P-1(o) as actually 3s(2)3p(3)(D-2(o))3d P-1(o) rather than the generally employed 3s3p(5) P-1(o) in measurements and calculations. Discrepancies in the energy positions of some symmetries are found and discussed. Some large oscillator strengths for allowed and intercombination transitions in both length and velocity gauges are presented. Their close agreement gives credence to the accuracy of our CI wavefunctions.

Surface alloying and mixing at the Mn/Fe(001) interface: Real-time photoelectron spectroscopy and modified embedded atom simulations

Structural and magnetic properties of thin Mn films on the Fe(001) surface have been investigated by a combination of photoelectron spectroscopy and computer simulation in the temperature range 300 Kless than or equal toTless than or equal to750 K. Room-temperature as deposited Mn overlayers are found to be ferromagnetic up to 2.5-monolayer (ML) coverage, with a magnetic moment parallel to that of the iron substrate. The Mn atomic moment decreases with increasing coverage, and thicker samples (4-ML and 4.5-ML coverage) are antiferromagnetic. Photoemission measurements performed while the system temperature is rising at constant rate (dT/dtsimilar to0.5 K/s) detect the first signs of Mn-Fe interdiffusion at T=450 K, and reveal a broad temperature range (610 Kless than or equal toTless than or equal to680 K) in which the interface appears to be stable. Interdiffusion resumes at Tgreater than or equal to680 K. Molecular dynamics and Monte Carlo simulations allow us to attribute the stability plateau at 610 Kless than or equal toTless than or equal to680 K to the formation of a single-layer MnFe surface alloy with a 2x2 unit cell and a checkerboard distribution of Mn and Fe atoms. X-ray-absorption spectroscopy and analysis of the dichroic signal show that the alloy has a ferromagnetic spin structure, collinear with that of the substrate. The magnetic moments of Mn and Fe atoms in the alloy are estimated to be 0.8mu(B) and 1.1mu(B), respectively.

Hydrochemical and isotopic tracing of mixing dynamics and water quality evolution under pumping conditions in the mine shaft of the abandoned Frances Colliery, Scotland.

Since 1995, when pumps were withdrawn from deep mines in East Fife (Scotland), mine waters have been rebounding throughout the coalfield. Recently, it has become necessary to pump and treat these waters to prevent their uncontrolled emergence at the surface. However, even relatively shallow pumping to surface treatment lagoons of the initially chemically-stratified mine water from a shaft in the coastal Frances Colliery during two dynamic step-drawdown tests to establish the hydraulic characteristics of the system resulted in rapid breakdown of the stratification within 24 h and a poor pumped water quality with high dissolved Fe loading. Further, data are presented here of hydrochemical and isotopic sampling of the extended pump testing lasting up to several weeks. The use in particular of the environmental isotopes d18O, d2H, d34S, 3H, 13C and 14C alongside hydrochemical and hydraulic pump test data allowed characterisation of the Frances system dynamics, mixing patterns and water quality sources feeding into this mineshaft under continuously pumped conditions. The pumped water quality reflects three significant components of mixing: shallow freshwater, seawater, and leakage from the surface treatment lagoons. In spite of the early impact of recirculating lagoon waters on the hydrochemistries, the highest Fe loadings in the longer-term pumped waters are identified with a mixed freshwater–seawater component affected by pyrite oxidation/melanterite dissolution in the subsurface system.

A survey of [ D2CO] /[ H2CO] and [ N2D^+] /[ N2H^+] ratios towards protostellar cores

Aims.We use observations and models of molecular D/H ratios to probe the physical conditions and chemical history of the gas and to differentiate between gas-phase and grain-surface chemical processing in star forming regions. Methods: As a follow up to previous observations of HDCO/H2CO and DCN/HCN ratios in a selection of low-mass protostellar cores, we have measured D2CO/H2CO and N2D^+/N2H+ ratios in these same sources. For comparison, we have also measured N2D^+/N2H+ ratios towards several starless cores and have searched for N2D+ and deuterated formaldehyde towards hot molecular cores (HMCs) associated with high mass star formation. We compare our results with predictions from detailed chemical models, and to other observations made in these sources. Results: Towards the starless cores and low-mass protostellar sources we have found very high N2D+ fractionation, which suggests that the bulk of the gas in these regions is cold and heavily depleted. The non-detections of N2D+ in the HMCs indicate higher temperatures. We did detect HDCO towards two of the HMCs, with abundances 1-3% of H2CO. These are the first detections of deuterated formaldehyde in high mass sources since Turner (1990) measured HDCO/H2CO and D2CO/H2CO towards the Orion Compact Ridge. Figures 1-5 are only available in electronic form at http://www.aanda.org

Stable hydrogen isotope ratios of lignin methoxyl groups as a palaeoclimate proxy

• Stable isotope ratios of organic compounds are valuable tools for determining the geographical origin, identity, authenticity or history of samples from a vast range of sources such as sediments, plants and animals, including humans. • Hydrogen isotope ratios (d2H values) of methoxyl groups in lignin from wood of trees grown in different geographical areas were measured using compound-specificpyrolysis isotope ratio mass spectrometry analysis. • Lignin methoxyl groups were depleted in 2H relative to both meteoric water andwhole wood. A high correlation (r2=0.91) was observed between the d2 H valuesof the methoxyl groups and meteoric water, with a relatively uniform fractionation of –216±19 recorded with respect to meteoric water over a range of d2H values from –110 in northern Norway to + 20‰ in Yemen. Thus, woods from northernlatitudes can be clearly distinguished from those from tropical regions. By contrast, the d2H values of bulk wood were only relatively poorly correlated (r 2 = 0.47) with those of meteoric water. • Measurement of the d 2H values of lignin methoxyl groups is potentially a powerful tool that could be of use not only in the constraint of the geographical origin of lignified material but also in paleoclimate, food authenticity and forensic investigations.

Objective assessment of cardiopulmonary resuscitation skills of 10-11 year-old schoolchildren using two different external chest compression to ventilation ratios

Study which shows that 10-11 yr olds are capable of effective CPR after a single 2 hour training session using the ABC for Life programme. However they perfrom more effective CPR when using a ratio of 15:2 rather than 30:2 chest compressions : ventilations