Applications of statistical models in proportioning medium strength self-compacting concrete

Self-compacting concrete (SCC) is generally designed with a relatively higher content of finer, which includes cement, and dosage of superplasticizer than the conventional concrete. The design of the current SCC leads to high compressive strength, which is already used in special applications, where the high cost of materials can be tolerated. Using SCC, which eliminates the need for vibration, leads to increased speed of casting and thus reduces labour requirement, energy consumption, construction time, and cost of equipment. In order to obtain and gain maximum benefit from SCC it has to be used for wider applications. The cost of materials will be decreased by reducing the cement content and using a minimum amount of admixtures. This paper reviews statistical models obtained from a factorial design which was carried out to determine the influence of four key parameters on filling ability, passing ability, segregation and compressive strength. These parameters are important for the successful development of medium strength self-compacting concrete (MS-SCC). The parameters considered in the study were the contents of cement and pulverised fuel ash (PFA), water-to-powder ratio (W/P), and dosage of superplasticizer (SP). The responses of the derived statistical models are slump flow, fluidity loss, rheological parameters, Orimet time, V-funnel time, L-box, JRing combined to Orimet, JRing combined to cone, fresh segregation, and compressive strength at 7, 28 and 90 days. The models are valid for mixes made with 0.38 to 0.72 W/P ratio, 60 to 216 kg/m3 of cement content, 183 to 317 kg/m3 of PFA and 0 to 1% of SP, by mass of powder. The utility of such models to optimize concrete mixes to achieve good balance between filling ability, passing ability, segregation, compressive strength, and cost is discussed. Examples highlighting the usefulness of the models are presented using isoresponse surfaces to demonstrate single and coupled effects of mix parameters on slump flow, loss of fluidity, flow resistance, segregation, JRing combined to Orimet, and compressive strength at 7 and 28 days. Cost analysis is carried out to show trade-offs between cost of materials and specified consistency levels and compressive strength at 7 and 28 days that can be used to identify economic mixes. The paper establishes the usefulness of the mathematical models as a tool to facilitate the test protocol required to optimise medium strength SCC.

Crystallization and phase transformation behaviour of electroless nickel-phosphorus deposits with low and medium phosphorus contents under continuous heating

Electroless nickel-phosphorus deposits with 5-8 wt% P and 3-5 wt% P were analysed for the effects of continuous heating on the crystallization kinetics and phase transformation behaviour of the deposits. The as-deposited coatings consist of a mixture of amorphous and microcrystalline nickel phases, featuring in their X-ray diffraction patterns. Continuous heating processes to 300C-800C at 20C/min were carried out on the deposits in a differential scanning calorimetric apparatus. The subsequent X-ray diffraction analyses show that the sequence of phase transformation process was: amorphous phase + microcrystalline nickel, f.c.c. nickel + Ni3P stable phases. Preferred orientation of nickel {200} plane developed in the deposits after the heating processes. Differential scanning calorimetry of the deposits indicates that the crystallization temperatures increased with decreasing phosphorus content, and increasing heating rate. Crystallization activation energies of the deposits (230 and 322 kJ/mol, respectively) were calculated using the peak temperatures of crystallization process, from the differential scanning calorimetric curves at the heating rates ranging from 5 to 50C/min. It was found that the deposit with lower phosphorus content has higher activation energy.

Performance analysis of an improved power-saving medium access protocol for IEEE 802.11 point coordination function WLAN

Wireless enabled portable devices must operate with the highest possible energy efficiency while still maintaining a minimum level and quality of service to meet the user's expectations. The authors analyse the performance of a new pointer-based medium access control protocol that was designed to significantly improve the energy efficiency of user terminals in wireless local area networks. The new protocol, pointer controlled slot allocation and resynchronisation protocol (PCSAR), is based on the existing IEEE 802.11 point coordination function (PCF) standard. PCSAR reduces energy consumption by removing the need for power saving stations to remain awake and listen to the channel. Using OPNET, simulations were performed under symmetric channel loading conditions to compare the performance of PCSAR with the infrastructure power saving mode of IEEE 802.11, PCF-PS. The simulation results demonstrate a significant improvement in energy efficiency without significant reduction in performance when using PCSAR. For a wireless network consisting of an access point and 8 stations in power saving mode, the energy saving was up to 31% while using PCSAR instead of PCF-PS, depending upon frame error rate and load. The results also show that PCSAR offers significantly reduced uplink access delay over PCF-PS while modestly improving uplink throughput.

CaII K interstellar observations towards early-type disc and halo stars - distances to intermediate- and high-velocity clouds

We compare existing high spectral resolution (R = lambda/Deltalambda similar to 40 000) Ca II Kobservations (lambda(air) = 3933.66 Angstrom) towards 88 mainly B-type stars, and new observations taken using the Intermediate dispersion Spectrograph and Imaging System (ISIS) on the William Herschel Telescope at R similar to 10 000 towards three stars taken from the Palomar-Green Survey, with 21-cm HI emission-line profiles, in order to search for optical absorption towards known intermediate- and high-velocity cloud complexes. Given certain assumptions, limits to the gas phase abundance of Ca II are estimated for the cloud components. We use the data to derive the following distances from the Galactic plane (z). (i) Tentative lower z-height limits of 2800 and 4100 pc towards complex C using lack of absorption in the spectra of HD341617 and PG 0855 + 294, respectively. (ii) A weak lower z-height of 1400 pc towards complex WA-WB using lack of absorption in EC 09470-1433 and a weak lower limit of 2470 pc using lack of absorption in EC 09452-1403. (iii) An upper z- height of 2470 pc towards a southern intermediate- velocity cloud (IVC) with v(LSR) = -55 km s(-1) using PG 2351 + 198. (iv) Detection of a possible IVC in Ca II absorption at v(LSR) = +52 km s(-1) using EC 20104-2944. No associated HI in emission is detected. At this position, normal Galactic rotation predicts velocities of up to similar to+ 25 km s(-1). The detection puts an upper z-height of 1860 pc to the cloud. (v) Tentative HI and Ca II K detections towards an IVC at similar to+70 km s(-1) in the direction of high-velocity cloud (HVC) complex WE, sightline EC 06387-8045, indicating that the IVC may be at a z-height lower than 1770 pc. (vi) Detection of Ca II K absorption in the spectrum of PG 0855 + 294 in the direction of IV20, indicating that this IVC has a z-height smaller than 4100 pc. (vii) A weak lower z-height of 4300 pc towards a small HVC with v(LSR) = +115 km s(-1) at l, b = 200degrees, + 52degrees, using lack of absorption in the Ca II K spectrum of PG 0955 + 291.

HST/STIS observations of the high-velocity interstellar cloud HVC 291.2-41.2+80: a warm, mainly ionized high-velocity cloud

We present intermediate-resolution HST/STIS spectra of a high- velocity interstellar cloud ((LSR)-L-upsilon = + 80 kms(-1)) towards DI1388, a young star in the Magellanic Bridge located between the Small and Large Magellanic Clouds. The STIS data have a signal-to-noise ratio (S/N) of 20-45 and a spectral resolution of about 6.5 km s(-1) (FWHM), The high-velocity cloud absorption is observed in the lines of C II, O I, Si II, Si III, Si IV and S III. Limits can be placed on the amount of S II and Fe II absorption that is present. An analysis of the relative abundances derived from the observed species, particularly C II and O I, suggests that this high-velocity gas is warm (T-k similar to 10(3)-10(4) K) and predominantly ionized, This hypothesis is supported by the presence of absorption produced by highly ionized species, such as Si IV, This sightline also intercepts two other high-velocity clouds that produce weak absorption features at (LSR)-L-upsilon = + 113 and + 130kms(-1) in the STIS spectra.

On the nature of the circumstellar medium of the remarkable Type Ia/IIn supernova SN 2002ic

We present results from the first high-resolution, high signal-to-noise ratio spectrum of SN 2002ic. The resolved Ha line has a P Cygni-type profile, clearly demonstrating the presence of a dense, slow-moving (~100 km s-1) outflow. We have additionally found a huge near-infrared excess, hitherto unseen in Type Ia supernovae. We argue that this is due to an infrared light-echo arising from the pre-existing dusty circumstellar medium. We deduce a circumstellar medium mass probably exceeding 0.3 Msolar produced by a mass-loss rate greater than several times 10-4 Msolar yr-1. For the progenitor, we favour a single-degenerate system where the companion is a post-asymptotic giant branch star. As a by-product of our optical data, we are able to provide a firm identification of the host galaxy of SN 2002ic.