988 resultados para Hardness testing
Resumo:
Micro-scale abrasion (ball cratering) tests were performed with different combinations of ball and bulk specimen materials, under different test conditions, such as load and abrasive slurry concentration. Wear modes were classified into two types: with rolling particle motion and with grooving particle motion. Wear rates observed with rolling particle motion were relatively insensitive to test conditions, whereas with grooving motion they varied much more. It is suggested that rolling abrasion is therefore a more appropriate mode if reproducible test results are desired. The motion of the abrasive particles can be reliably predicted from the knowledge of hardnesses and elastic properties of the ball and the specimen, and from the normal load and the abrasive slurry concentration. General trends in wear resistance measured in the micro-scale abrasion test with rolling particle motion are similar to those reported in tests with fixed abrasives with sliding particle motion, although the variation in wear resistance with hardness is significantly smaller. © 2004 Published by Elsevier B.V.
Resumo:
The National Marine Fisheries Service is required by law to conduct social impact assessments of communities impacted by fishery management plans. To facilitate this process, we developed a technique for grouping communities based on common sociocultural attributes. Multivariate data reduction techniques (e.g. principal component analyses, cluster analyses) were used to classify Northeast U.S. fishing communities based on census and fisheries data. The comparisons indicate that the clusters represent real groupings that can be verified with the profiles. We then selected communities representative of different values on these multivariate dimensions for in-depth analysis. The derived clusters are then compared based on more detailed data from fishing community profiles. Ground-truthing (e.g. visiting the communities and collecting primary information) a sample of communities from three clusters (two overlapping geographically) indicates that the more remote techniques are sufficient for typing the communities for further in-depth analyses. The in-depth analyses provide additional important information which we contend is representative of all communities within the cluster.
Resumo:
North Carolina fishery managers are considering methods to offer greater protection to the blue crab, Callinectes sapidus, spawning stock while maintaining a viable commercial fishery for female blue crabs in high salinity estuaries. We tested how effectively wire rectangles, or excluders, of two internal sizes, 45x80 mm and 45x90 mm, would prevent entry of ovigerous female (sponge) crabs into pots relative to control pots (without excluders) while maintaining sizes and catch rates of male and nonsponged female hard crabs. Field sampling among three pot designs (two excluder sizes and control pots) was conducted in Core Sound, N.C., during 2004–06. Median sizes (carapace widths) of mature female crabs were not different among the three pot types. However, median sizes of male crabs and sponge crabs were greater in control pots than pots with either size of excluder. Catch rates of mature female crabs from control pots were greater than from pots with 45x85 mm excluders. Catch rates of legal male and sponge crabs from control pots were greater than from pots with either size of excluder. Results indicate that using excluders involves a tradeoff between reducing catches and sizes of sponge crabs while also reducing sizes and catches of legally harvestable nonsponge crabs; moreover, the reduction in total catch and sizes would be greater for legal male crabs than for legal nonsponged female crabs. In high salinity waters close to North Carolina’s existing no-harvest blue crab sanctuaries, where females typically dominate catches of hard crabs, the benefit of using excluders to prevent entry of sponge crabs may outweigh a potentially modest decrease in landings of nonsponged females.